Having problems with your Danby 22 in. DDW396 Free-standing Dishwasher ?

Spray arm problems

\015 My pray arm is not working have taken of arm to clean but still doesn't work. Any hints what to check for?\015

Answers :

MAKE SURE YOU ARE GETTING ENOUGH WATER INTO THE
\015\012DISHWASHER. THEN CHECK FOR A RESTRICTED PUMP
\015\012INLET PORT LOCATED UNDER THE METAL STRAINER
\015\012ON THE RIGHT SIDE. IT IS A SMALL HOLE WITH A PLASTIC
\015\012GRID MOLDED INTO THE WELL, APPROX. 1 INCH IN DIAMETER.BE SURE THERE ISN'T ANYTHING PLUGGING UP
\015\012THE HOLES IN THE PLASTIC GRID.
Repair Help & Product Troubleshooting for Danby 22 in. DDW396 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Both spray arms of my DU943PWKQ0 do not turn or spray. The motor is moving and the it drains without problem. During the wash and rinse cycle I can hear the sound of water, however it doesn't clean at all and the sprays arms stay where they were. It seems the motor only creates no spray, but wave. I powered cycled the dishwasher, the problem remains the same. Anyone know what's wrong with it? Thanks James


Try rotating the spray arms by hand. It should rotate freely. If possible clean the arm rotating place by removing them.Arms rotate by by pump pressure only. finally check the water pump also. ... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

Design Flaw I had the same problem. While under warranty they "fixed" the problem by putting in a zip tie (no joke) to keep top spray arm from rattling. The tech said they were working on a resolution of the design flaw. Then, when the zip tie broke I called them again. This time they replaced a small o-ring where the water line comes into the top spray arm. The o-ring eventually fell off. When that came out for the 3rd time, they re-ordered the same o-ring. Now again, I am having problems with


... GE 24 in. GSD2120C Built-in Dishwasher

No water delivered,or "spinning" of upper spray arm.Serviced @n year ago & worked very briefly. Spray arms & filter cleaned. Using a hose as water source to test.....spray arm isn't blocked. The problem appears to be water isn't being delivered to upper spray arms. What could cause this & how can I correct? Thanks for your time & response. Sincerely, Lee Ballard


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is not filling then it is w ... Avanti DW18 Built-in Dishwasher

Hi, my hotpoint aquarius df61 makes all the noises of washing, i hear the water going in, motor is running, however i dont believe the spray arms are revolving, so the dishes are not getting clean. i have cleaned the individual holes in the spray arms, but i don't think the water is getting up the back pipe and into the top spray arm. it does not spin at all. no problems draining. help please. and were can i get a copy of the user guide, free preferably. thanks


How old is your machine? it is posible to have something in the watwr pump, you hear the water and the motor, but the fan of the pump (washing pump) is blocket. also the pipes hat make connection to the water pump and the arms. at someoane i found gl ... Dishwashers

Water pumps into the bottom of the dw but the spray arm doesn't rotate and spray. It also empties, so the problem seems to be with the spray arm. Any solutions?


Hi,When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher ... Asko 1385 Dishwasher

We have a Frigidaire dishwasher model #FDB634RF bought new. It was used for a not very long period of time but developed problems due to well water with high lime content. now with good cleaning products available it is ready for use again. The problem is the top spray arm that refuses to rotate. I have taken the arm out and thoroughly cleaned it of deposits checked the supply line from the pump and checked the sump for any obstruction. The arm turns freely by hand but water just pours out the


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

Baumatic BDW13 Problem with lower spray arm: arm is not being fed with water and is consequently not turning. (Note: top arm is turning as usual.) Might this be a problem with the recirculation motor? Any help most welcome! Jonathan Drennan


I think that you may be on the half wash setting, check to see if the light labeled as number 4 is on while washing, if it is, then you need to simple turn off this option. Let me know if it isn't. ... Baumatic 23 in. BDW13 Built-in Dishwasher

Dishwasher Repair Dishwasher is a Stoves/Newhome DW616 Rotating spray arms do not always operate. This is an intermittent problem - will sometimes work normally for a few days then arms will not move at all with no water coming from them. Machine appears to go through its normal cycle. Some times cycle starts normaly and spray arms stop working part way through.


It could be a motor or a pump issue. The dishwasher has a motor that attached to a pump which forces the water up into the sprayer arms and during the drain cycle, it pushes the water out of the dishwasher. \015\012The motor (and pump) located beneat ... Dishwashers

If the lower and upper spray arms do not turn what could be the problem? I have a MDB4100AWB and I of course have hard water in our area and wondering what is causing the spray arms to turn.


Next time you are out at the store pick up a product called Lemi-shine. This stuff will be the edge your dishwasher needs to beat out hard water. The biggest problem when dealing with hard water in a dishwasher is it will slowly build-up in the spray ... Maytag 24 in. MDB4100 Built-in Dishwasher

Spray arms The dishwasher is filling properly and water is entering the spray arm however they do not turn. The grinder has been recently cleaned and the waterleverl checked So what could be the problem??


Sounds like the circulating pump is faulty or the spray arms hav become partially clogged. Loss of available water will stop the spray arm motion. ... Kenmore 16872 Built-in Dishwasher

I have a Maytag MDB dishwasher. We recently took apart the spray arm assembly down to the filter to clean out the lime. The problem is that the inside of the spray arm has such a build up of lime and we cannot get inside the narrow space to scrape the lime out. How can I dissolve the lime that is inside of parts?


Have you tried boiling it in vinegar? it might help. no garenties for that particular problem, but that's what I do with my kettle and chunks of lime come out when I do. ... Maytag MDB9600A Jetclean II Built-in Dishwasher

The disk washer doesn't drain at the end of the rinse cycle. There is a humming sound but no water is forced through the hose to the sink/garbabe disposal. At the end of the wash, there is a large amount of dirty water in the bottom of the washer. I removed the spray arms, the spray arm holder and the screen and then removed the water, and found a couple of pieces of plastic. But I don't see how I can remove additional parts from the washer bottom. What could the problem be? Is there a fi


Is the dishwasher drain hooked to the garbage disposer? If so is it new? If so did you knockout the plug in the disposer? If so then you either have something clogging the drain or pump. Or the pump motor is bad. ... Dishwashers

Two problems: the water pressure in the arms is low. If you pop the door, arms are not spinning as it should. Each time you start and stop, the arms move a tiny bit. Have cleaned the filters and the spray arms completely. Also, detergent door no longer pops open.


Hello, Welcome to fixya.\015\012 \015\012I just came ... Bosch SHU3306UC Built-in Dishwasher

This is a past problem posted that I am now experiencing with my Kenmore Elite Model 655.17489300 dishwasher. Looking for any suggested solutions, Rick Past Problem: I have the same problem with my 2004 Ultra Wash Model 665...fills with water, sensing light comes, then stops for a second. Then you can hear another pump kick in (it hums) and just runs continuously but no water is spraying through the arms. When you cancel the wash, it drains perfectly. I've checked the filters, all is c


The symptoms you have mentioned could be linked to the soil sensor which some models come with. The purpose is to run the drain pump and let more water flow through inlet valve if during wash cycle the dishwasher detects soil collection in the accumu ... Kenmore 24 in. 16539 Built-in Dishwasher

Dishwasher, nautilus, doesn't spray water out the top arm? I'm haivng to wash dishes 2 times, and still no better results. I've tried opening the door fast during a water cycle to see which is the problem - can only figure it is the upper arm, the lower arm seems to have water coming out, can't tell if the tower raises completely up.


The jets on the arms can sometimes get blocked with food bits that have got past the filter. This reduces the water flow and rotation of the arms.The arms are easy to remove without tools (they are intended to be removed by the user). ... GE Nautilus 24" Built-in Dishwasher

Spray arm problem


Pump is bad or the screen is clogged ... Dishwashers

I have a gibson quietclean 1 dishwasher and the upper spray arm does not spray. what could the problem be?


... Gibson Dishwashers

The washer is not cleaning properly, I found that the lower spray arm is fairly floppy and will tip enough to hit the element. I put a new spry arm on a couple of months ago but did not replace the cap. Do you think there would be enough wear on the bottom of the cap to cause a problem? Thanks - Bill G.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Maytag 24 in. MDB5601A Free-Standing Dishwasher

I have a Quiet Guard Standard model #587.151524 that is not cleaning the dishes. I took the bottom spray arm and screens out and cleaned them, (they had a heavy buildup of what I would say is calcium. The arm cleaned up fine but the screen still has some areas that will not allow the water to drain. I tried CLR and it helped but the screen is still probably 60% clogged. Do you think this is the problem getting the dishes clean and if so do you have any suggestions about how to clean the screen?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Kenmore 24 in. 15689 Built-in Dishwasher

Maytag Quiet Series 300 dishwasher leaves sediment on dishes (primarily glasses) after running the Autoclean cycle. We've taken it apart, cleaned spray arms, filters, float and replaced some seals, but still have problems. We use Cascade detergent and Jet-Dry (what was recommended when we bought the dishwasher). Our water temperature is 120 degrees (maximum setting we can have without having our tankless water heater modified), but this dishwasher problem was an issue with our old tank water hea


The problem is hard water. www.dishwasherfilter.com has a\012product to solve this problem once and for all. It filters the water going into\012your dishwasher and remov ... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Help! My dishwasher runs thru it's cycles but when I open it I find my second detergent cup still full of soap and my dishes still dirty. I have an older maytag dishwasher but have never had this problem with it. I've tried running a short prewash cycle with the soap despenser open to wash out the soap from the open second despenser but it doesn't wash it out. I know water is coming out of the spray arms but can't see if the arms are spinning although when running it does sound like they ar


Hi,\012There are three common problems that cause the Soap Dispenser or Cup not to open. I have a tip that will explain these problems in detail....Dishwasher Repair Problem ... Dishwashers

I have a Bosch SHU9955UC/14 dishwasher. I am having problems with the top rack not cleaning. The dishes on the bottom rack are cleaning just fine. I have taken the rotating spray arm off and cleaned it out and replaced it. I have also taken all of the filters out of the bottom of the unit and cleaned them. Any other suggestions for fixing this problem?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch SHU9955UC Built-in Dishwasher

My dishwasher runs but does not have enough pressure to clean the dishes or turn the spray arms. Arms spin freely. I have removed and cleaned the screens in the bottom of the dishwasher. I also have removed the large pump and checked it for damage..no problems found. Model SHU43CO5UC / 17


Hi.Below a list of things to check.Check the water inlet at the back, ensure that the hose is not clogged or kinked, and that there is sufficient pressure.Ensure that the machine is not underfilling. Test the water ... Bosch 24 in. SHU43 Built-in Dishwasher

Kudi25ch I have an older kitchenaid dishwasher. The problem started when the dishwasher was leaving a lot of soap on the dishes. I put in a liquid rinse. Now it won't start on my chosen cycle which is "normal and enegery saver. It will start if I put it on soak and scrub. When I press the chosen cycle the rinse light blinks 3 times. I have had this problem before and had a tech tell how to reprogram it. I took off the spray arm and checked the drain screen there was nothing there


... Dishwashers

My Kenmore 587.1410 will not spray. The spray arms are not clogged. The trap and filter are also clear. What else could be causing this problem?


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0892 seconds