Having problems with your Danby DDW1802W Built-in Dishwasher ?

Danby DDW1802W - Dishwasher stopped dead in the middle of wash cycle. Lights are on, but absolutely nothing else is happening. Help, please.


Answers :

Repair Help & Product Troubleshooting for Danby DDW1802W Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Danby DDW1802W - Dishwasher stopped dead in the middle of wash cycle. Lights are on, but absolutely nothing else is happening. Help, please.


... Danby DDW1802W Built-in Dishwasher

We have a model # 1385 Asko dishwasher. For the last few months we have found a film over all our dishes and pans washed in the dishwasher. We have found vinegar removes the film, but the need to constantly wash the already-washed dishes in vinegar to be defeating the purpose of using the dishwasher! We have used Cascade Complete for years, but we have tried different brands now, but nothing solves the problem. Can you please help us??????? Nancy Vocci


Hi \015\012Try running the hot water through the sink faucet, right before you start the dishwasher, so that hot water will instantly be there to run in the dishwasher, instead of it starting cold and having to warm up wh ... Asko Dishwashers

My kitchenaid dishwasher quit working, the hi temp scrub and heat dry buttons light up but nothing else does. The dishwasher makes no sounds and doesn't even try to turn on so I tried bypassing the thermal fuse, safety latch, and replaced the motherboard so to speak and still nothing so PLEASE HELP!?!


... Dishwashers

We have a hotpoint fdf780 dishwasher and at the start of the cycle the machine fills with some cold water a nd then does nothing else .the machine isnt showing any fault code please help as half term


... Hotpoint Dishwashers

My Kenmore ULTRA WASH dishwasher model #1603* does not respond to any command. When I select a desired washing I only get a blinking light on my selection and nothing else. If I select ''Cancel/Drain'' it blinks as well. I receive no response at all if I select ''Start/Resume''. To stop the blinking I must turn off the circuit breaker. When I restore the power, the control board is not lit, however, selecting any of the wash cycles and the blinking starts once again. The manual refers to a blink


Replace timer/program module\015\012Vitally ... Kenmore Dishwashers

My viking dishwasher is blinking normal wash and light china wash and water is on he bottom of the pan. I have tried cancel restarting it nothing is working. The water is very hot also. Thank you... someone please help!


... Viking 24 in. Professional Series DFUD140 (Premium) Built-in Dishwasher

My kitchenaid KUDI01DL dishwasher began making a lot of noise while running, then subsequently decided not to circulate the water around to wash the dishes. It sounds like the motor is running (maybe) but there is no washing action going on. The machine will fill, drain and heat the water but nothing else. Is it likely that the pump/motor assembly has ceased to function properly? thanks...


The problem is very likely in the chopper and/or somewhat possible in the impeller. The chopper is replaceable from the front. Disassemble the pump, the chopper will be on its left side under a cover. That cover is kinda tricky to remove (remove all ... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Further to my open question for my Asko N516 D5131 SS dishwasher I have been able to successfully press the wash setting cycle, which was before frozen on 'rinse and hold' . I then press the on/off. Button the time shows but as soon as I press it to start the dishwasher the screen changes to three horizontal curly lines and nothing further happens... It won't start. Please , I do hope somebody can give me advise. I cannot get to the power plug as it appears pot be located behind the unit whi


... Dishwashers

The dishwasher will not begin wash cycle. When I press the "start" button, the "heat dry" light illuminates and the "washing" light blinks, but nothing else begins.


Hi\015\012\015\012When these lights flash on your machine it is actually transmitting a code which can be read by a technician to help determine where the fault lies.\015\012\015\012However there may be a simple fix that you c ... Dishwashers

My Bosch diashwasher is just a little over a year old. Just recently it started leaving behind a white residue thats hard to wash off even by hand. I've always used the same dishwashing detergent (Cascade) and nothing else has changed has anyone else ever had this problem?


Hard water is the problem. go to www.dishwasherfilter.com and solve your problem once and for all. they offer a product that filters the water before it enters the dishwash ... Bosch SHX43M05UC Built-in Dishwasher

I have a SE6TIE1, FD 8004 090109 Tecnik dishwasher and when i put my dishwasher on it only makes a little sound right at the beginning and then no sound and does not wash the dishes. I opened up the spray arms and took out the fine filter but there was nothing wrong with it. Can you please help me work it again. Thank you. Annahita Mottaghi


... Tecnik Dishwashers

Water enters dishwasher,the unit seems to go on hold, then it will drain. Nothing else works as far as the washing cycle or any thing else.


This could be that the main pump id defective, once water enters the main pump does all the work to throw the water around and clean, once that is done the water is drained etc.so when you dont hear anything this indicates that the main pump is n ... Bosch SHU9925UC Built-in Dishwasher

My dishwasher dwt 10 fills up then stops, two lights flash on the front, the eco and fast wash cycle leds. also makes a humming noise but nothing else happens


Your wash motor is jambed or the motor capacitor is faulty ... Hotpoint Dishwashers

My dishwasher whirlpool model GU1200XTLS3 wont start. When I push the nomal wash button, it will light up for a few seconds then off and nothing happen. Please help!


... Whirlpool GU1200XTLS Stainless Steel Dishwasher

I just bought the Kenmore Ultra Wash Dishwasher model # 665.1389. It worked about 4 times then before the it finished it lost power while it was running. Now it won't turn back on at all. I done everything in the trouble shooting manual and nothing worked. It's not the circuit breaker either. Everything else on the same breaker works fine. What could it be?


... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

My siemens dishwasher bottom arm does not spin to clean the bottom basket of dishes. Everytthing else works fine. I have removed and cleaned out all washing arms and plastic water carrier inside machine. Any ideas please?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Siemens 24 in. SE64A630GB Built-In Dishwasher

Dishwasher is not cleaning well, dirty film all over everything, like its not rinsing. In rinse cycle only, some water comes out of lower left port inside but nothing else. Hear a low buzz underneath unit like a motor or pump is energized but no water getting to the top.During normal wash cycle, buzz from underneath seems to cycle on and off, say every minute or so like its cycling on an overload. Do I have a bad pump and if so how do I get to it?


Hi. This may well be a pump issue, or an obstructed hose assembly, as well. Your symptoms are indicating that the impeller may be damaged. In order to pull the necessary schematics, I will need the entire model number. This ID tag will allow me to pu ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Why does my Diplomat ADP 8902 dishwasher beep twice when i switch it on and the 4th wash program light flash and do nothing else?


Can I say thank you for the above advice. Hit the programme button 4 times and closed machine. Now running rinse cycle. Let hope it works afterwards. Will post ant let you know. ... Dishwashers

Hi, we have an aquarius hotpoint df61 and it goes through the cycle but does not drain out the last few inches of water and the wash is not as good as it should be, have unscrewed the plastic bit under the filter thing to see if there is a blockage there but nothing, have now taken off the top and side panel to try and get to the pump, currently on it's back but hard to access underneath and not sure how to remove the solid bottom of the dishwasher..please help!


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

If i switch on my dishwasher, all lights flash on and off red,and it's makes the beeping noise when it does when the wash is finished... no water is coming in either... please help... it does nothing and you cannot press any of the buttons to use a cycle. it is making a humming noise. i have checked the filter in the bottom of it, and have switched it off at the wall and back on again. cheers,


Un plug it remove bottom drawer. look in back left corner of cabnet on bottom, is it wet dry it out and try again ... Fisher and Paykel Dishwashers

The flashing light blinks 7 times on the clean indicator area , but the dishwasher will not function and when you press cancel it starts running but nothing washes through any cycle at all. please help


Ok well usually it is not sensing a temperature change in the water or\015\012not getting hot enough. so you can reset the dishwasher and try running\015\012the hot water in the sink before starting the dishwasher. if it fails\015\012again there is a ... KitchenAid Dishwashers

I have a whirlpool Quiet Partner II dishwasher that the Hi-temp wash light is continuously flashing and nothing else works


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Please try High Temp->heated dry-> High Temp->heated dry\015\012repeatedly OR heat-dry->norm ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Stopped Working Hi, My Zanussi Aquapulse Dishwasher (DE6744S)has just stopped working. The red on/off switch still lights up when I try to start off a wash but nothing else happens. I know this is probably just a case of "call out a repair guy" but, even though I've had the machine a few years, I'm I bit miffed on the thought of coughing-up to have the thing repaired because I very rarely use it. Any suggestions? Many thanks


The problem is with the PCB, this is the board behind the buttons, you can buy this for £120 or you can get it fixed by QEA for about £45 link below. I am not an engineer but I replaced mine in 10 minutes.\015\012 ... Zanussi 24 in. DE6744S Free-standing Dishwasher

Indesit DV620 HiWhen I turn my indesit dishwasher DV620 on it fills with water for pre-wash with the first button lit and then the first and second buttons flash and nothing else happens!


Check your manual it should tell you what this code means and wether you can deal with it yourself ... Indesit 23 in. DV62 IX Built-in Dishwasher

Bosch aquasensor I have just had a plumber install a second hand dishwasher as above, he left after he heard the water coming in, two mins after it stopped and nothing else happened bar the time still going, he has plumbed it into the cold water, is this correct or am I doing something wrong. Please help, thanks


No it should be plumbed into the hot side... it will not wash untill the water is hot enough ... ... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2794 seconds