Having problems with your Danby DDW496W Free-Standing Dishwasher ?

Danby DDW399W spraying air is moving at super slow speed

\015 The dishwasher was working fine and all of the sudden it now is only moving very very slowly. It does spray water, and if fills and empties like a champ. According to Danby there is no belt, the water is what drives the sprayer. The motor is running, but it seems to be slower now. Thanks!\015

Answers :

Repair Help & Product Troubleshooting for Danby DDW496W Free-Standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Danby DDW399W spraying air is moving at super slow speed


... Danby DDW496W Free-Standing Dishwasher

I have a frigidaire dishwasher 4000 series aqua surge with speed clean. The small spray arm on the ceiling of the washer came off. I found it sitting on top of some cups in the top basket. There is a loose part inside the retainer in the ceiling that moves back into the retainer when I try to put the spray arm back on. How do I fix this and how do I get the top basket out to work on it?


The top arm snaps into place. Simply unscrew the retaining clip from the ceiling of the washer. Inside of there, you will find a small white plastic clip. Make sure the two prongs are pointed down and poking out through the hole in the bottom of the ... Frigidaire PLD4555RFC Dishwasher

Danby ddw399w the ring that holds the spray arm on broke. Am I duced, or can I fix this? I


... Dishwashers

Danby DDW399W dishwasher - drainage and spin arm problems


Hi,Here is a tip that I wrote that will help you with your dishwasher ... Danby 22 in. DDW396 Free-standing Dishwasher

My LG LDF7810ST dishwasher does not spray water from the middle or upper spray arms, therefore the dishes don't wash properly. Even when I ask for a top load only, the bottom spray arm is the only one moving (which I would expect that it shouldn't move at all since I've requested a top load only) I checked the spray arms as best I can to make sure that they're not clogged.


... LG 24 in. LDF7810 Built-in Dishwasher

Makes grinding noise.spray arm on top not moving. spray arm on bottom barely moving. grinds when draining too. removed and cleaned out holes in bottom spray arm, didn't help, but found piece of black plastic/porcelain with rust on it in the lower spray arm that looks like it may be part of a bushing?


Very possible that it is a fin off the impellers or could be a bushing ... Dishwashers

My dishwasher sprays water up into the dishes but the little spray arms don't move when the water sprays up. The arms move by hand when I touch them. What could this mean for my dishwasher?


Hi,\012When my wife started complaining about her dishwasher not getting the top rack clean this is what I found and I wrote a tip about it...Dishwasher ... Whirlpool Dishwashers

DDW399W Danby Power button won't stay in place...washer powers down


I know your post is a bit old. I solved this by opening the outer shell and removing all screws attaching the control panel. The power switch needs to be replaced. I looked everywhere (including radio shack and lowes) but sears parts department is th ... Danby 22 in. DDW396 Free-standing Dishwasher

My maytag dishwasher lower and upper spray arms are working intermittently. Sometimes there is plenty of water spraying around, other times, I can hear what sounds like the motor running but the arms are not moving (or not moving much) and very little water is splashing around. When this happens, the detergent sometimes doesn't even get washed out of its compartment.


Pour 1 Cup of Muriatic Acid (Can be purchased at your local Pool Supply Store) into the bottom of the washer and a little in the soap dish. Run the Dishwasher through 5 cycles. Check to see If this helps. If not Try the same process with CLR house cl ... Maytag 24 in. MDB4000 Built-in Dishwasher

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

Both spray arms of my DU943PWKQ0 do not turn or spray. The motor is moving and the it drains without problem. During the wash and rinse cycle I can hear the sound of water, however it doesn't clean at all and the sprays arms stay where they were. It seems the motor only creates no spray, but wave. I powered cycled the dishwasher, the problem remains the same. Anyone know what's wrong with it? Thanks James


Try rotating the spray arms by hand. It should rotate freely. If possible clean the arm rotating place by removing them.Arms rotate by by pump pressure only. finally check the water pump also. ... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

Dishwasher Water is not going through upper and lower spray arms. Checked overfill protector switch, inlet valve, inlet valve screen, pump blades move freely, Pumb motor is working , Water enters into machine but does not go throught spray arms. Water heats up, Machine will go through all cycles but without water going through spray arms. 650 / 690 series gldb656jso


... Dishwashers

Kudt03ftss3 upper spray arm isn't getting any water, middle spray arm has water coming out but isn't turning, lower spray arm moves but slower than normal.


... KitchenAid Dishwashers

Dishwasher fills with water, but spray arms don't spray water or spin. As the cycle moves forward, water is eventaully pumped out (so the pump is working). i've selected different cycles with the knob on the front of the machine but they all work the same.... no swishing with the spray arms. When the cancel button is pushed, the water is pumped out... as it should. Thanks for the help.


... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Have model dwu7910bab. Water sprays in but doesn't seem to move around the washer after the initial spray.


... Maytag Dishwasher

The water does not spray inside, it does fill but does not spray thus the bottom sprayer does not move


Check your rubber seals to sprayer from back wall of dish washer. if ripped or dried out need to replace them. ... Maytag MDB9750AWS Built-in Dishwasher

GE Quietpower 2 spray arms not rotating. Sounds like pump is working and water is moving inside but arms are still in same position when I check to see if they've moved. Of course the dishes don't get clean. What's up with this?


... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

I have moved my fisher&paykel dishdrawer from the kitchen using a two wheel trolley and tipping it back. It's now leaking water as soon as the spray arm starts to work. Could I have dislodged something when moving it?


On the bottom is big locknut it gets loose sometimes and than dishwasher leaks\015\012 ... Dishwashers

I think I am finding small pieces of the wrap from the tablets in the small holes in the spray arms, one wont move anymore??? This is about 10 yr old maytag machine. I tried to clean out the spray arms but dont really know what I am doing. Bought a new diswasher, dont want to use the tablets if they will clog up the works. please advise.


Just prime the sink before you start the dish washer ... Maytag Jetclean II MDB8551A Dishwasher

Rotary water spray device on roof of d/w has popped off - does not appear to be broken but a plastic piece inside location where spray device is connected appears is loose and moves around Can I fix this myself William


Most spray arms are easily fixable. they are held on by screws or brackets. you can just put them back yourself. sometimes they come loose due the vibration caused by the dishwasher operation. ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

Mod #: MDB6600AWB Ser #: 16505148CG No water comes out of spray arms, checked and cleaned filter-OK. Wash impeller is cracked where it slides onto the hexagon rod but it you take the filter flow plate off and put the impeller back on, when you put the unit on rinse only and quickly open the door you can see it is still turning and moving the water. The unit still fills and drains. it just does not have enough force with the impeller to force the water into the spray arms.


Hi,\015\012 \015\012Please check the bellow link regarding your query....\015\012 \015\012 ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Hi I've inherited a Zanussi DA6142 Dishwasher from a recent house move. It was treated quite poorly by students who I suspect ran it without the filters in place. I've used a dishwasher cleaner and was able to pull out the lower spray arm and rinse out all the crud that was blocking it (small stones, food, plastic, pieces of glass, paper, etc) but I cannot for the life of me work out how to get the upper spray arm out. The PDF manual I've downloaded for this model says DO NOT remove upper spra


... Zanussi Dishwashers

Dishwasher Repair Dishwasher is a Stoves/Newhome DW616 Rotating spray arms do not always operate. This is an intermittent problem - will sometimes work normally for a few days then arms will not move at all with no water coming from them. Machine appears to go through its normal cycle. Some times cycle starts normaly and spray arms stop working part way through.


It could be a motor or a pump issue. The dishwasher has a motor that attached to a pump which forces the water up into the sprayer arms and during the drain cycle, it pushes the water out of the dishwasher. \015\012The motor (and pump) located beneat ... Dishwashers

The dishwasher is not cleaning the dishes at all, so far I have done the following: Checked both sprayer arms and they move freely and do not appear to be clogged (I ran stiff wire thru holes in each The float is not stuck and moves up/down easily The water leavel in bottom of tub does appear to be low - so I added water filiing tub to heating coil - however this did not help and the water did not spray on lower or upper racks - this is an older model Kenmore Ultra Wash WHAT DO I NEED TO CHECK N


Heating element may have burned out. Check water temp during wash--should read between 130 to 140 F.If not the heating element,you may have to replace pump-motor assembly or wash impeller.Hope this helps. ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0773 seconds