Having problems with your De Dietrich Dishwashers ?

I have a built under de dietrich dishwasher approx 4 years old and out of warranty. The various numbers on the identification are 1) 02062A 2) V29996U1/1 3) 36VLDHGB1 4) 9 44 02319. The drop down door has lost it's tension from the hinge/hinges,and crashes down when opened. I have to hold and lower it down when opening. Can this be repaired or do I need a new dishwasher? May Mc Pherson


Answers :

Repair Help & Product Troubleshooting for De Dietrich Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a built under de dietrich dishwasher approx 4 years old and out of warranty. The various numbers on the identification are 1) 02062A 2) V29996U1/1 3) 36VLDHGB1 4) 9 44 02319. The drop down door has lost it's tension from the hinge/hinges,and crashes down when opened. I have to hold and lower it down when opening. Can this be repaired or do I need a new dishwasher? May Mc Pherson


... De Dietrich Dishwashers

My dishwasher door has lost it's tension. If not held while opening it drops open.


... Dishwashers

Kitchenaid dishwasher 8573025 door no longer holds itself open. It falls all the way open when unlatched.


... KitchenAid Dishwashers

Hello, My built-in Jenn-Air JDB5900AWB dishwasher door has lost it's springs and comes crashing open. I am pretty handy and would like to try to fix this myself, is it possible? I have a great parts store here that the plumbers use (I was the only person there who wasn't a professional that day!). Where can I see instructions to fix this? Thanks, Miss Fix It


Hello, Welcome to FixYa.While I don`t have diagram or illustration I can give some insight because this is actually very common.It is a fairly minor procedure to replace it/them. Slide the entire unit out from the cabinet a co ... Dishwashers

Kitchenaid dishwasher door lost its tension.


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Kitchenaid dishwasher door lost its tension.


... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

Dishwasher door When I opened the door I heard a pop and now the door drops to the fully open position. It used to stay as open as I pulled it, but now there is no tension as if a spring broke.


You're right a spring has either snapped or come off of it's anchor point. Should be 2 ...one on each side of the door. you can order parts on line at several appliance replacement part suppliers... have your make and model so you'll get the right pa ... Kenmore Dishwashers

Door Tension How does one adjust the door tension on a SHU43 model dishwasher? The door opens up all the way with no tension from the springs/cables.


Just about the most difficult job to do on a dishwasher, not normally a job for the home mechanic, i am an appliance engineer of 20 years and often shy away from jobs like this,there is often no adjustment, the hinges are sprained, more o ... Bosch 24 in. SHU43 Built-in Dishwasher

On a Hoover hfi 3015 dishwasher what holds the heater element in position? I have bought a replacement element as the old one (still fitted to m/c was open circuit). Does the nut between the connectors have anything to do with holding it in place or is that just to hold the heater assembly together?


... Dishwashers

I have an Equator Mini Maid PLS602S dishwasher. It works fine, but the upper spray arm fell off and the clip and knob holding it in place are missing. Equator said they no longer make this model and don't have the parts. Can you tell me where to get the clip and knob to hold the upper spray arm in place. I know there is a little white clip - I actually had it but lost it, because when I tried to hold the arm in place with that, the next time I ran the dishwasher the arm fell off again. I


There are no parts sources that i can find for this dishwasher, but my suggestion to u is this, locate an appliance repair shop in the local area that has dishwasher parts, bring the portable unit down to the shop and see if they can mat ... Equator Dishwashers

I have an ADB 1200 (or possibly an ADB 2200) according to the installation instructions. I lost the manual. Anyway, the door was becoming more difficult to open. Now it won't open at all no matter how hard I press on the latch. Any suggestions before I try to pry it open and probably break something? Bill


... Amana 24 in. ADB1200AW Built-In Dishwasher

Hello my dishwasher door has dropped down when opened, I bleive there are straps which hold the door when open (these have been replaced when the washer was under warranty) how do you replace these the dishwasher is an intergrated Dedtric Regards Bob


... Dishwashers

Kitchenaid dishwasher model kuds01fl door pops open - it appears the latch is not keeping it closed while the diswasher is operating. We push and hold it closed and it stays for a time and then pops open again - any ideas on how to fix it?? Thanks,


... KitchenAid Dishwashers

My miele dishwasher door all of a sudden drops and stays open half way. If i lift it up to close, it falls back down to half way. Adjusting the tension spring makes the door slam shut and not stay open in the down position


... Miele 23 in. Novotronic G841 Built-In Dishwasher

Kitchenaide dishwasher door won't open. Ran it 3 nights ago and it is holding my dishes captive. Can't open to get model # the latch is floppy and won't release. It's about 12 yrs. old. HELP!


Hello antpitypat.... When this happens, the only way to open it is to use a butter knife and gently move the latch as you pull on the latch. With a little patience and maneuvering of that floppy latch it will open. Once you do get it opened up use ... KitchenAid Dishwashers

Can't open diswasher door. (Triton XL) Tried holding Heated dry button for three seconds and still won't open


Whilst on can you press drain button as if their is still standing water inside then the door wont open give Ginko a try first then check if you have drain button if not try pushing the door in further in case the lock has got jammed pushing the door ... Dishwashers

The flapper that holds the soap in for the next cycle will not open automatically . I have to stop the dishwasher and manually open it. Any suggestions.


Verify the bottom tray is allowing clearance for the door to open, a reveresed tray blocks opening... ... Jenn-Air JDB6510 Built-in Dishwasher

Dishwasher door flopped open and now the door will not hold. I called a repairman and he said he could fix the door but it may not hold. My exact model number is KUD101FLB5. thank you.


Hello, \015\012 \015\012Welcome to Fixya.Based on your description what you`ve likey experienced is a broken door closer/link kit.It is a fairly minor procedure to replace it/them. Slide the entire unit out from the cabinet a ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

The door spring must of came loose or broke off.The door falls open if you don't hold it as you open it. Before I start dismantling the dishwasher to repair this is it inside the door or on the side of the dishwasher.


You can probably change that from the underside Dave. But you may need to pull the unit out. It should be exposed from the side ... Jenn-Air JDB6510 Built-in Dishwasher

I have an ASKO D3251. Door free falls when opened. No longer has tension to control downward movement.


My dishwasher is brand new. I actually have two of them. They both come crashing down every time I open them. Did something go wrong in installation? ... Asko 24 in. D3250 Built-in Dishwasher

Dishwasher door does a free fall when opened. The tensioning device has broken.


... Dishwashers

Door to Kitchenaid whisper quiet dishwasher falls open hard like it has lost a spring


... KitchenAid Dishwashers

OUr LG, LD 14AT2 has a broken spring supporting the door so now it fall open with a crash. How can we fix it please?


... LG Dishwashers

The compartment that holds the detergent doesn't open during the wash cycle.


This could be caused by several things: unit jammed with detergent or other matter, timer issue or even a broken wire. Inspect the latch on the mechanism carefully and, if gummed up, clean it with hot water and a tooth brush. Otherwise, you'll have ... Dishwashers

We lost electricity very briefly today which caused the dishwasher, washing, drying, clean buttons to blink when the electricity came back on. I opened the door to do a load of dishes hours after the electricity came back on and the basin was filled with water which caused water to spill out of the dishwasher. The basin was empty last night when we used it. It seemed to fill up when it was not running.


It seems unit fill valve is stuck open and water is coming in even when machine is off.fill valve opens up only when u start the unit.2 chks this u can open the door and look at the hole inside from where water comes in.if water is coming in with do ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0806 seconds