Having problems with your Delta Model DT2400CS Pressure Washer 5.5HP ?

Honda gcv160 Won't start


Answers :

Repair Help & Product Troubleshooting for Delta Model DT2400CS Pressure Washer 5.5HP

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Home Depot has a lawn mower with the Honda GCV160 Electric start version engine. They also have a pressure washer with the Honda GCV160 engine. I have a disability that makes it difficult to pull the starter rope. I would like to get the electric start on the pressure washer. My local Honda bike shop service center said they use different blocks. Can I get a pressure washer pump mounted to the Honda GCV160 Electric start version engine? If necessary, are there adapter plates that can be purchase


... Karcher 2500 PSI Pressure Washer

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

Honda GCV160 Engine Won't Start


HelloYou should siphon out all the old gas you can. Replace with new gas. Check that the spark plug is good and the air filter is clean. Spray some carb cleaner in the carburetor.. Also, you should check the oil level and change the oil i ... Karcher 2500 PSI Pressure Washer

Honda gcv160 pressure washer won't turn over. pull cord just starts to move then STOPS hard.


... Honda Pressure Washer PSI 3000

Hard to start my pressure washer with GCV160 Honda engine


... Karcher 2500 PSI Pressure Washer

I have a wood splitter that has a honda GCV160 5HP engine, when I choke it to start, it does find, but when I push the choke in, the engine will not run smoothly, it acts like it's not gettingg en


Sounds like debris in the carburettor. The carbs on these are relatively simple things which come apart easily. Check for debris or water in the float-bowl, and ensure both your idle and main jets are clear and you can see daylight through them. ... Karcher 2500 PSI Pressure Washer

NO PRessure i have a Honda gcv160 5.5 dt2400cs CRANKS RUNS FINE AS LONG AS TRIGGER IS pulled to let water trough it has no pressure soon as you let go pressure starts building then it kills the motor will not run unless you hold handel


Hi It sounds to me like your unloader valve is stuck, this is the thing that is meant to move up and down when pressing the trigger.Please remove the unloader valve assembly and check for damage. If no damage is found then grease and lubricate this p ... Honda Pressure Washer PSI 3000

2-yr old troy-bilt pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left running, looks a black plastic pressure relief valve starts blasting hot water. appreciate whatever insight you can give. Thx


It sounds like an air lock. Try this: With the machine off, connect the hose to the washer and let it run for several minutes to get all of the air out of the hose, and to purge any air out of the pump. Shut off the water, and connect the high pre ... Briggs & Stratton Pressure Washers

Hi, My question involves a:Honda GCV160 5.5Chore Master 2400 psi Model CV-2400=4MHC I have very little use on it. I broke the sprayer hose on it the other day and ordered a new one for this model. I connected my water supply, turned it on, started the machine but have VERY little pressure. What do you feel my problem is and how can I remide it? Thank You! Louie [email protected] Boundary Waters Taxidermy, Ely Mn. 55731218 365 6310e


\015\012put in your garden hose \015\012turn on the water\015\012leave it to run for one min.\015\012kink the garden hoes\015\012connec ... Pressure Washers

Honda gcv160 Won't start


... Delta Model DT2400CS Pressure Washer 5.5HP

I have honda gcv160 5.5 pressure washer, after sitting over winter, I went to use it, and I can't even pull the cord to try and start it. What are any reccomendations as to what I can do to fix this?


My power washer started doing that after the pull-cord mechanism broke.I took off the hoses to make sure there was no back-pressure caused by the pump.And pull rope was still frozen.We took off the pull rope cover on top of the mach ... Pressure Washers

Honda GCV160 pressure washers turn off when turn on the gum


... Karcher 2500 PSI Pressure Washer

Honda gcv160 pull handle stuck in


... Honda Pressure Washers

I have a problem with my karcher 2500 pressure washer with honda engine it will not start or stay running. I have used starting fluid to start it it starts but won't stay running.


Carb is mostly likely gummed up and should be cleaned. Best option is to dismantle the carb and soak in solvent or equivelant for a couple hours and replace it. Our use Gum Out. Do make sure you have a good spark plug and a strong spark. If you have ... Karcher 2500 PSI Pressure Washer

Honda GCV160 5.5 on a pressure washer runs only intermittently


The problem is the plastic float in the carburetor, it's not adjustable and after sitting up with gas in it it distorts. Save yourself the trouble and buy a new one, you can get them online for $15-$20. ... Campbell Hausfeld Pressure Washers

Honda gcv160 not maintaining water pressure


... Pressure Washers

Troy-Bilt power washer 2500 psi with Honda GCV160, pump does not work


... Pressure Washers

HONDA GX 240 8HP ENGINE WILL ONLY START WITH A SHOT OF STARTING FLUID. ONCE STARTED IT RUNS FINE.. WHAT'S WRONG ?


Sparkplug needs to be cleaned or replaced. ... Honda 8 HP Engine

Honda GC 160 Engine, I had the carb replaced about 1 year ago, now its doing the same thing. At first it wouldnt start at all, I cleaned the carb, then it started would speed up and die. I then took the carb off and cleaned the jets, now it starts with the choke in the closed position only, at high speed it sputters and dies, but will I run it at med speed it runs but will die with tiller has a load, also when you put the choke to open it always dies. I dumped all the gas, and checked the fuel


This really sounds like a carb problem, good to hear that you are taking the carb all the way off and soaking it, this is the best way to clean a carb. I don't think it would be the fuel pump, they either work or they don't. I would check the governe ... Karcher 2500 PSI Pressure Washer

I have a Troybuilt pressure washer which has a Honda GC160 engine. The engine starts easily but quits after about a minute. One pull and it re-starts, then quits in a minute....... This goes on for as long as I want to keep re-starting it. Anyone know what it might be? I pulled the carb off and blew out all of the various ports I could find. I did not remove the carb adjustment screws as I have not had any luck getting them back in place during previous problems with other gas engines.


... Karcher 2500 PSI Pressure Washer

Honda 8hp motor only starts with quick-start fluid


If you have gas to carb rebuild carb or relace ... Honda 8 HP Engine

Wiring diagram for Honda 5.5hp electric start engine


... Pressure Washers

Rebuilt honda GC160 5hp engine for a power washer and only got the engine to start once. Just took apart and saw that the cylinder and piston was all scored up again.


... Honda Pressure Washers

Honda 8HP GX240 willnot start after working fine.


Your carberator has crud, or rust, or glaze in it. The carberator will have to be removed, soaked in cleaner for three hours and then rebuilt using the proper carberator kit from any auto parts store. If you need to hire this done expect to pay abo ... Honda 8 HP Engine

I have a excell 2600 psi with Honda GC 160 motor I am having problems trying to start it. It will turn real easy for a couple of times, then it get's real hard to pull for awhile then loosens up again and only starts with starter fluid.


Change the Spark Plug. Drain the old fuel out and replace with fresh gas. Prime, choke and start. ... Honda Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0951 seconds