Having problems with your Dewalt 3700 Pressure Washer ?

DeWalt DP3750 pressure washer wont start. The last

\015 DeWalt DP3750 pressure washer: wont start. The last time it started I tried to use the detergent scipher hose and it shut the motor down. Afterwards it would started for a minute or two and then shut off. Now it wont start at all. Before all this happened I had just changed the engine oil and cleaned the filter with gasoline. I keep in my garrage and there seem to be some type of fluid (oil of some type) leaking from somewhere but I'm not sure from where. It may even be coming from the detergent hose. (I know-crazy right?)\015

Answers :

Repair Help & Product Troubleshooting for Dewalt 3700 Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DeWalt DP3750 pressure washer wont start. The last


... Dewalt 3700 Pressure Washer

2050 PSI Gas Pressure Washer - 20244: my excell pressure washer wont start. pull start t...


... Briggs & Stratton Gas Pressure Washer 20244

My dewalt dp2800 pressure washer wont start an the spark plug was full of gas?


... Dewalt Pressure Washers

I have a dewalt 3000 psi pressure washer that runs for 3 to 4 hours great but when i shut it off after that it wont start again


... Dewalt DPD3000IC 3000 PSI 28 GPM Gas Pressure Washer

I have a dewalt dph3800 pressure washer used it one day and the next day wont start. made sure oil and fuel were ok, now what?


Check for spark the coils do fail ... Dewalt 3800 PSI Pressure Washer

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a Karcher K5.86m pressure washer and the electric motor wont start. I've done the obvious like fuse in the plug etc. It was working fine one day, then got it out again and everything seems fine except the pressure pump wont start when I press the on button.


... Karcher Pressure Washers

Dewalt pressure washer dp3750 pump diagram - Dewalt 3700 Pressure Washer


... Dewalt 3700 Pressure Washer

Hi, I have a Dewalt pressure washer 3100 psi. I want to know why the pressure washer works okay for 1 hour then it stop working completely. the oil is fine, the spark plugs are okay, and when I tried to start it again it does not work. Can you please tell me what could be the problem? This pressure washer is almost brand new I have used it for only like 30 hours for 2 years that I have it. I used it couple times lately but same problem it works for 1 hour then it does not work any. I will


There are two common issues that will cause what you are describing. What you need to do is run the machine until it dies as you are describing. Then pull the spark plug and check for spark. If you do not have spark you have a failing stater. It is v ... Dewalt DPH3100 Gas Pressure Washer

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Hello, I own a Honda Pressure Washer (Porter Cable Model) with a Cat pump 2600psi and 6.5 hp. An Excellent machine for the past 7 years. Last fall I noticed it was not producing the full pressure but still Engine was running strong. This past weekend. started it up and used it for about 1 hour still with minimal pressure at full throttle. Then pressure was totally cut off. I stopped and started the engine the engine and it had minimal pressure again. Same thing happened again. I stopped the engi


... Honda Pressure Washers

How do I adjust the PSI on a DeWalt DP3750 Pressure Washer


... Pressure Washers

Troy-Bilt 2550 20293 pressure washer not producing pressure. Worked when last used 2 months ago. Pump pistons are moving up and down when engine is pulled through. Inlet water is flowing through pump but no pressure when engine is started. I have the same problem. Water flows thru the pump when not running, but no flow or goes in by-pass mode when I start the pump. The pump being Troy Bilt Model 020296-01. I replaced unloader valve even. Anything else I can do?


You replaced the unloaded valve. Are you positive you have the unloader screwed to pressure and not turned the opposite way? You will have no pressure if it is adjusted wrong. One other thing I have encountered is that the unloader has a ball bearing ... Pressure Washers

Wont start I've had the washer for many years with minimal problem. Yesterday when I closed the door no light went on and the washer would not start.  After 20 minutes or so it suddenly went on and worked fine.  I thought that it might have not completed its last cycle. Today, however, I had the same problem and it's been over an hour and still hasn't started. (I checked the circuit breaker and it's fine)


Give it a firm push over the door latch once you've closed the door..it might be the door switch not activating. oops.... first and formost isolate from power for 5-10mins and try ... Bosch 24 in. SHU43 Built-in Dishwasher

Honda 11.5hp pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Excell pressure washer wont start - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


Check gas, off/on switch,spark plug and magneto for spark ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

Karcher pressure washer WONT START - Pressure Washers


... Pressure Washers

The last time I used the pressure washer was running fine. A few minutes later I tried to start it up and could barely turn it over. I removed the recoil and could turn it a little easier backwards. The motor is a Honda GC190 on a karcher pressure washer and has 20 -30 hours of running time. Thanks Clint


... Karcher 2500 PSI Pressure Washer

Hondar 2500 pressure washer wont start - Honda 2500 PSI Gas Pressure Washer


... Honda 2500 PSI Gas Pressure Washer

Wont start I have a North Star pressure washer that has been in storage for three years.It has the Honda motor GX 160 5.5 I put in new gas changed the oil, air filter,and spark plug.But it wont kick over. Im not sure how to work the levers upon starting it.Theres one for gas, choke,idle,and of course an on switch.Please help


Tip a cap full of fuel in top of the carb to start intitially, check for spark as common fault is on/off switch, If no spark, link the 2 wires on on/off switch together. ... Pressure Washers

Why wont my generac pressure washer start - Pressure Washers


... Pressure Washers

Troy-bilt pressure washer 2350 psi wont start after use


... Pressure Washers

I have a 2.5 gpm model K2400HH pressure washer that won't sprey with high pressure, it started intermitanly, now won't spray high pressure at all. Last year I removed the valve and cleaned it and put white lithium greese on it and it worked pretty well for a while, but now no high pressure.


I would suggest purchasing a new revised unloader valve, here is the link to purchase one ... Karcher G2650HHR Gas Pressure Washer

Troy-Bilt 2550 20293 pressure washer not producing pressure. Worked when last used 2 months ago. Pump pistons are moving up and down when engine is pulled through. Inlet water is flowing through pump but no pressure when engine is started.


Ok I wasnt satisfied w/ the previous answer so I did some digging. I took off all the hose attachments and drained the line. I then checked for any clogging in ALL the screens. As usual the wand screen was clogged. this is an easy fix w/ a safety pin ... Pressure Washers

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1459 seconds