Having problems with your Dewalt 3700 Pressure Washer ?

On my 6 hp dewalt pressure washer, the unit runs really rough in the off choke position, when i move it a little bit away from the off choke position, it runs really close to the way it should. any recomendations?


Answers :

Clean all the fuel system:lines,carb,etc.. also a new coil will be better.
Repair Help & Product Troubleshooting for Dewalt 3700 Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

On my 6 hp dewalt pressure washer, the unit runs really rough in the off choke position, when i move it a little bit away from the off choke position, it runs really close to the way it should. any recomendations?


Clean all the fuel system:lines,carb,etc.. also a new coil will be better. ... Dewalt 3700 Pressure Washer

Honda GC 160 Engine, I had the carb replaced about 1 year ago, now its doing the same thing. At first it wouldnt start at all, I cleaned the carb, then it started would speed up and die. I then took the carb off and cleaned the jets, now it starts with the choke in the closed position only, at high speed it sputters and dies, but will I run it at med speed it runs but will die with tiller has a load, also when you put the choke to open it always dies. I dumped all the gas, and checked the fuel


This really sounds like a carb problem, good to hear that you are taking the carb all the way off and soaking it, this is the best way to clean a carb. I don't think it would be the fuel pump, they either work or they don't. I would check the governe ... Karcher 2500 PSI Pressure Washer

My soap cap remains in the closed position at all times. The clasp mechanism works fine, if I cycle through with the door open I can see and hear the catch release when it should. But the door remains closed at all times. I leave it open to run, and sometimes it's closed when the wash cycle finishes! Is there an easy way to take the cap off and clean it? Or do I need to WD-40 around it?


There is a little spring in there that flips the door open, just take the screws off of the side of the door, you'll see the broken spring by the door, make sure power is off to dishwasher ... GE Nautilus 24" Built-in Dishwasher

Hello i have a Honda GX160 and the engine will only run on choke if i close it the engine just splutters and thats it. it wont run at the norm i have replaced the carb the tank the air filter and the spark plug and know luck i have no more ideas as to what the problem really is thanks jord


Ii know you must have replaced the fuel filter. Did you replace the fuel line? It is obvious it is not betting enough fuel or it is out of time. Have you tried adjusting the jets on the carb? Have you checked the timing? There is a crankshaft key-way ... Honda Pressure Washer PSI 3000

Door wont close. I checked to be sure nothing is in the way. I have tried running thru the cyles to see if i could un hinge the spring but with no luck. the open button is locked iin the open position.


The door latch is broken and can be replaced. Look up the part on searspartsdirect.com and search that part number on ebay for better prices if available.Eric ... Kenmore 16522 Built-in Dishwasher

Pressure washer has been sitting up for about 2 years.. worked perfectly before I parked it.. lol.. But, I put a new spark plug on, cleaned the filter, sprayed carb cleaner in it drained the gas tank and added new gas.. But it still does the same thing.. It starts in the choke position, runs awhile, and then shuts off. While its running, I tried to put the switch in the run position and it kills. Just wanted to see what an expert would say about the matter before I Brake it down. thanks


... Briggs and Stratton 020275 Elite Series 3400 PSI Portable Gas Pressure Washer

I have a 5HP Honda engine installed on a Excell pressure washer. While the engine readily starts, it will not continue to run unless I keep the choke setting nearly completely closed. When I activate the pressure gun, it seems to generate adequate pressure, however, when the trigger is released, the engine continues to run at the same rpm instead of the normal variable rpm that most engines operate at during idling periods. The engine will always cease running when I push the choke rod all the w


... Honda Pressure Washers

Motor will start on choke setting and then it immediately dies when moving the choke lever to the run position. Cleaned carb, new plug new air cleaner and checked all linkages. the motor has new oil and runs rough on choke like it should. any help


You say you cleaned the carb. If you did that by spraying cleaner in through the choke, that's good, but it doesn't get to the root of the problem. The problem is getting the gas into the carb. Try this. drain the gas. Put a small amount of c ... Honda Pressure Washers

Runs great when you first start it in the choke position, wont run once the choke is disengaged and it backfires then shuts down. what would cause this?


... Briggs & Stratton 3000 PSI Pressure Washer

My honda gx160 motor only runs at low revs when the choke is on, when i turn the choke off it dies straight away. roger


... Honda 8 HP Engine

I have a Craftsman power washer model 580 752020. When I start it up, turn on the switch the electric motor runs fine until I either close the trigger to the spray nozzle or press the trigger for power spray. The electric motor just shuts down, if I take my finger off the pressure and let the water run with no presssure the motor runs fine. My question is this. Is the capasitator on the electric motor the probable cause and is there a way to check out the capasitator to see if it is malfuncti


I doubt that it has anything to do with the capacitor on the motor. i think you are having a problem with the actual Motor Drive circuitry. What is happening is when you close the switch, this tells the Motor to "Ramp Up" to pump the water out, what ... Craftsman Pressure Washers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

When I start my pressure washer on full choke it works fine when I place choke in wide open position gas runs out of the carburetor.what could be wrong.the engine issas by Briggs and Stratton.


You need to take the float bowl off the carb from the bottom . You haven't given a lot of information about who did what to the carburator but somebody must have screwed with the float pisition for this to be happening . The way all carburtors work i ... Simpson WS4050V Water Shotgun 4000 Psi Cold Water Electric Start Gas Powered Pressure Washer W/ Vanguard Engine

My miele dishwasher door all of a sudden drops and stays open half way. If i lift it up to close, it falls back down to half way. Adjusting the tension spring makes the door slam shut and not stay open in the down position


... Miele 23 in. Novotronic G841 Built-In Dishwasher

Whirlpool ADG993 Hi -Had several issues with the door similar to those posted, coming away at the hinge, not sitting flush so wont close. New issue - the latch has given way, it sounds like it works but the catch is not holding, the door then falls to the floor. Any suggestions for making the latch hold the door closed? - thanks..


Dear friend,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam at you service!\015\012\015\012If its new your warranty is for 12 months!If the dishwasher is 10 years or older its not worth inve ... Dishwashers

Can't disconnect the dishwasher from the water supply -- the faucet starts running the moment I disconnect it. I've closed the faucet all the way (as best I can, with a plier), and it still runs.


You can turn the water off using the main water valve that is located under the sink -- this will close all water off to the dishwasher and to the faucet.\015\012\015\012c... ... Dishwashers

5.5 HP Honda on a Karcher pressure washer. Will only run in full choke mode. When choke is closed for normal operation, motor conks out. I have removed Air filter and inspected operation and butterfly is operating correctly. What to check next?


Fuel mixture screw ... Pressure Washers

The Frigidaire Professional Series Dishwasher is leaking dishwasher detergent ( during the wash ) all over my tile floor and staining my grout. It seems like the door will not shut all the way. If I push on the door all little, you can really tell a difference in the noise level. Is there a way to adjust the closure to close the door more?


Hi linsley.\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: Is there a way to adjust the closure to close the door more?\015\012\015\012First lets back up a little . You say it's le ... Frigidaire Dishwashers

My dishwasher smells like fish really bad when its not running...then it runs and smells like fish still...and when its done the dishes smell like fish...what do i do to make this smell go away?


... Whirlpool Dishwashers

We have had a problem with our dishwasher since "winterizing" it to close the cottage for the winter. We were told to run it for a few minutes with antifreeze in it and then turn off and let it overwinter with the antifreeze in it. Now the machine leaves everything coated with a white film, even though we have a water softener and use jetdry. How can we fix this and is this the proper way to winterize our dishwasher if we close down our cottage and turn off the heat for the winter?


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

I heard metal drop sound when dish easer door was open in down position. Seems that door does not close same way- it there a spring on door to help close that could have broke? Y I have the kitchen aid - kud102frsso. Thanks


... KitchenAid 24 in. KUDI02FR Built-in Dishwasher

Miele Dishwasher Model G1040, Type HG03, NR: 32/65143704 The machine is three years old. The cycle reaches almost to the end, then all three LEDs merge together, and the pump runs continuously, even with the master switch off. I have taken the machine out and removed the base plate. When I first took the machine out of its position, I tipped it backwards and water came out of the bottom. All hoses and parts in the bottom section seem perfect in every way but the inside of the bottom plate indica


... Dishwashers

I have a Whirlpool DUL300XTLQ3 Queit Partner III. The cleaning blades stopped moving-started it-waited awhile-opened it-the blades were in the same position. Took the bottom blade+filter cover off. Then I held down the metal piece on the case and switched on the micro switch on the door to see it running with the door open. The water shot straight up about 4-5" that's it. This does not seem to be enough pressure for the water to get all the way up to the top spinner. Am I looking at a new pump


If there is not enough water, the dishes would not get cleaned. Thiscould be caused by a partially closed water shut-off valve (locatedunder the sink), or a faulty dishwasher water valve (located at thebottom of the dishwasher, behind the kick panel, ... Whirlpool Dishwashers

It is difficult to close our d1716 dishwasher. We need to push really ******* the front panel to make the latch 'click'. Is there any way to adjust the latch? Or is there possibly some other remedy?


The latch is welded on check to see if its broken also check the catch in the door or is there something in the way like the door seal etc also are the hinges bent if the latch is broken you can get a repair kit with a nut and screw cut the old one o ... Asko Dishwashers

Dishwasher seems to run but does not wash dishes. Recently had to take the door apart to fix the latch that was stuck in the closed position, causing the door not to lock.


I've got the same problem and will watch for your answer. My landlord says "its fine." However, my dishes are not clean. ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0799 seconds