Having problems with your Dewalt Pressure Washers ?

Please confirm the right gas for my Dewalt 3100psi max pressure washer and also the type of oil ?


Answers :

You can use cheaper grade gas at the pump and for oil use 10w30.
Repair Help & Product Troubleshooting for Dewalt Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Please confirm the right gas for my Dewalt 3100psi max pressure washer and also the type of oil ?


You can use cheaper grade gas at the pump and for oil use 10w30. ... Dewalt Pressure Washers

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a coleman powermate pw0912500 pressure washer and cannot determine if there is a choke. Also need to know what the right side oil reservoir is for. Also need basic starting procedure instructions. What are two front sliding levers.


... Coleman Pressure Washer PW0881800

I cannot remember the type of gas or the fuel mixture (gas to oil ratio if required) for my pw2050 2000psi pressure washer,last used 2006 cannot locate the manual,


Pump regular gas and no oil mix. Your engine has a dipstick which means its a four stroke engine.\012\012The oil goes inside the motor. For summer use I recommend 30 weight non-detergent oil.\012\012Change it out once a seas ... Campbell Hausfeld PW2102 Gas Pressure Washer

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

What type of motor oil - Honda Black Max 2600 PSI Pressure Washer


4-Cycle Engine Oil (SAE 30 or SAE 10W30)\015\012\015\012Here is a link to the owners manual, should you need it.\015\012\015\012 ... Honda Black Max 2600 PSI Pressure Washer

I have a Quantum XTE Gas Pressure washer and need to know what oil type to use


... Briggs & Stratton Pressure Washers

What type of oil can i use - Honda Black Max 3000 Psi Pressure Washer


The engine and the pump can use the same oil. SAE 30 non detergent oil. No need to pay more for speciality oil. Check oil often and look for any unusual signs such as milky or foamy oil in pump which would indicate water leaking past seals. Good luck ... Honda Black Max 3000 Psi Pressure Washer

PW2200V4LE engine oil type - Campbell Hausfeld PW2102 Gas Pressure Washer


... Campbell Hausfeld PW2102 Gas Pressure Washer

Husky Model HU80833 Pressure Washer. Just took it out of the box, starts right up runs about 1-2 minutes washing then dies. I checked the oil, and made sure it has fresh gas. Help


Send it back under warranty ... Pressure Washers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a model PW 2200 gas pressure washer. It suddenly lost it's high pressure the other day after working fine for @10 minutes. It's getting plenty of water, but the engine doesn't seem to rev up to give it the high pressure. The operating instructions say to check the oil in the engine, and the PUMP before starting, but I haven't found any place to check for an oil level in the pump????Any ideas, I'm very confused.


... Pressure Washers

I have a excell 2500 psi max honda 5.5 ho vr2522 2.2 gpm presser washer and has been stored for about a year, still looks brand new and has only been used twice before, it has oil and was stored with no gas in the tank, i put fresh gas in the tank and blead the fuel bowl until fuel ran out like it should, the washer wont start, ive checked the turn on switch as well and the fuel cut off knob, i spayed gas in the carb and it fired up but stopped running as fast as it began to run, its not getting


... Honda Black Max 2600 PSI Pressure Washer

I have a dewalt dp3100 pressure washer, i was using it for about an hour then it ran out of gas. After adding some gas it refuse to stop, it start for a few seconds then it would stop. its full of oil (but the oil is a little dirty) and the gas is half full. what could be the problem?


... Dewalt DPD3100 Gas Pressure Washer

No pressure McCullough pressure washer has no pressure after siting all winter. I took apart the assembly and the oil leaked out, also I noticed yhe o-ring that seals the two pieces together seems to have been blown out. Where can I get parts and oil. Thanks for any advice.


... McCulloch FH140A Electric Pressure Washer

What type of oil does pressure washer use? - Briggs & Stratton Pressure Washer Projectpro Spray Nozzle


... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I cannot get my Karcher 2600 psi gas powered pressure washer to start. Got gas oil no pressure build up in hose.


... Karcher 2500 PSI Pressure Washer

New honda pressure washer maybe had it 2 years and only has about 3 hours on it, I was using it yesterday and it started fine and after running for about 10 min it shut down like i turned the kill switch, it has oil and gas but seems to have lost compression. It is a Honda overhead cam GCV 160, pressure washer is a Troy Built model


... Pressure Washers

Hi. I have a Briggs & Stratton 2800PSI gas pressure washer. I can get it to start, but after about 5 min, then it quits. I have cleaned the carb, change oil, changed plug, new gas, cleaned/checked air filter. Nothing will keep it running. Wondering if it may be not enough water pressure, but would that cause it to stop like that? When it runs, it does a good job, but it stops just as you get going. Do you have any other suggestions? Thanks!


If it wont start, check for spark.how you do that,ok take the spark plug wire out put it close to the sparkplug(use some gloves or something to insulate your self from get electric shot from the spark) find some one who pull the start rope, if you do ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

Remove the lower wash arm (1) by turning the nut (4) clockwise (right) lift the arm off, there is a bearing (3) (small thin plastic washer) under the arm, be sure not to loose it. Lift the tab on the back of the feed tube cap (2) and swing it to the right and lift up, this may need a bit of pressure to release it This is for my Whirlpool dishwasher DU1100XTP. I'm putting it back together and can't remember if the plastic washer goes on top or underneath the feed tube cap. Also how do I remo


This is not a tuff job plastic washer goes on top . and torx screws . you use a proper torx tip for the screw size . ( you can go to sears parts .com and put in model # and see a good break down of the wash arm s and t ... Dishwashers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Power Washer has no pressure, any ideas - Psi Blue Max 2200 High Pressure Gas Power Washer


1. If you have an inlet chemical injection valve make sure that the hose is intact and that the valve is closed. \015\0122. Purge all air from the line by holding the nozzle actuation lever open until all air has been purged. When you conne ... Psi Blue Max 2200 High Pressure Gas Power Washer

Oil plug on troy bilt 020240 pressure washer - Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Gas in oil in pressure washer - Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0883 seconds