Having problems with your Dewalt Pressure Washers ?

Will not run without choke on half way - Dewalt Pressure Washers


Answers :

Repair Help & Product Troubleshooting for Dewalt Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Will not run without choke on half way - Dewalt Pressure Washers


... Dewalt Pressure Washers

On my 6 hp dewalt pressure washer, the unit runs really rough in the off choke position, when i move it a little bit away from the off choke position, it runs really close to the way it should. any recomendations?


Clean all the fuel system:lines,carb,etc.. also a new coil will be better. ... Dewalt 3700 Pressure Washer

HAVE A DEWALT PRESSURE WASHER WITH 6.5 HONDA ENGINE THAT WAS STORED FOR A COUPLE OF YEARS. IT WILL START BUT ONLY RUN FOR3-4 SECONDS WITH CHOKE ON THEN KILLS. WAIT A MINUTE OR SO, PULL ROPE AND WILL RUN FOR ANOTHER 3-4 SECONDS. WON'T RUN CONTINUOUSLY. PUT FRESH GAS AND CLEANED BOWL UNDER CARB. ANY OTHER TIPS? THANKS, FOREST


Look for plugged filter anywhere in fuel line. ... Pressure Washers

Won't run without choke on - Honda Pressure Washers


... Honda Pressure Washers

Will not run with choke all the way off - Pressure Washers


Dirty carb. ... Pressure Washers

I have a 5HP Honda engine installed on a Excell pressure washer. While the engine readily starts, it will not continue to run unless I keep the choke setting nearly completely closed. When I activate the pressure gun, it seems to generate adequate pressure, however, when the trigger is released, the engine continues to run at the same rpm instead of the normal variable rpm that most engines operate at during idling periods. The engine will always cease running when I push the choke rod all the w


... Honda Pressure Washers

Pressure washer wont run unless choke is on


I have a Karcher pressure washer w/ a 5hp Honda engine. It only will run while the choke is pulled out and only runs at about half the rpm's. When the choke is pushed in.. it coughs, sputters and shuts off. Can you tell me how to fix this.... ... Karcher 2500 PSI Pressure Washer

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

My pressure washer is 3 years old, never had a problem with it until now. It runs for 2 seconds only on choke. It will not start or turnover at all with out the choke on. Please help, I miss my pressure washer. Thanks Andrea M. Conzet


It sounds like could be one of the problems listed below or a combination of those things.1) The exhaust is partially blocked. Check the screen covering exhaust port for carbon and dirt build-up. High-speed exhaust air must pass freely. W ... Honda Black Max 2600 PSI Pressure Washer

I have a Generac pressure washer, model #01450-0, with a Honda 5hp motor. The motor runs fine, but the pressure hose pulsates as if the pump is intermittently making pressure, and the pressure out of the sprayer is about half of what it should be. A friend suggested replacing the seals in the unloader. I bought an unloader kit, replaced everything and it still runs the same. It will build a small amount of pressure, spray for a few seconds, then the pressure dropps to almost nothing. Any help ap


Take a small diameter wire and poke thru the discharge hole of the spray head to clean out.\015\012Second time in 6 months that I had the same problem. The problem is alway in the spray head. ... Pressure Washers

My pressure washer will not run unless it is in full choke


... Ridgid Pressure Washers

Dewalt dpd3300 pressure washer - runs for 2 minutes, when pressure builds it shuts down. It i keep the trigger on the wand depressed it runs fine...


... Dewalt DPD3300 Commercial Pressure Washer

Pressure washer only starts and runs on full choke. throttle open. The pressure washer turns off when we press the trigger to start washing. Is this because the throttle isnt set high enough?


... Briggs & Stratton Briggs Stratton 2550 Psigaspressure Washer

Honda pressure washer 5hp will only run with the choke on. Was running fine for about 1 hour


Always burn FRESH number 1 fuel in this engine and make sure there is a screen on the spout of the can or plastic jug. ... Pressure Washers

I have a Briggs & Stratton Pro 3400 pressure washer that I got new last year and used for maybe 5 hours and it worked great. Have had it stored since then with stabilizer in the gas (I didn't run it dry) and now it won't run for more than a minute or two without dying. A dealer said it was probably bad gas and I now know that even with the stabilizer I should have run it dry last year before storing. Everything is like brand-new including plug and air filter so it must be the gas/carberator gunk


... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

When I plugged my pressure washer in the motor switch was on and the unit started to run without water hooked up. Before I could get to the unit to shut it off it stopped running and will not run now.


Didn't the instructions say to make sure water was hooked up before starting? This is the reason for the warning. ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Pressure washer has been sitting up for about 2 years.. worked perfectly before I parked it.. lol.. But, I put a new spark plug on, cleaned the filter, sprayed carb cleaner in it drained the gas tank and added new gas.. But it still does the same thing.. It starts in the choke position, runs awhile, and then shuts off. While its running, I tried to put the switch in the run position and it kills. Just wanted to see what an expert would say about the matter before I Brake it down. thanks


... Briggs and Stratton 020275 Elite Series 3400 PSI Portable Gas Pressure Washer

I have a Craftsman power washer model 580 752020. When I start it up, turn on the switch the electric motor runs fine until I either close the trigger to the spray nozzle or press the trigger for power spray. The electric motor just shuts down, if I take my finger off the pressure and let the water run with no presssure the motor runs fine. My question is this. Is the capasitator on the electric motor the probable cause and is there a way to check out the capasitator to see if it is malfuncti


I doubt that it has anything to do with the capacitor on the motor. i think you are having a problem with the actual Motor Drive circuitry. What is happening is when you close the switch, this tells the Motor to "Ramp Up" to pump the water out, what ... Craftsman Pressure Washers

New pressure washer runs starts and runs for 30-45 minutes with no problems then dies and will not restart. Once it cools for a few minutes it will restart but will die again quickly. If it is allowed to sit for 30+ minutes it will run for another half hour but then dies again. Changed oil, gas, checked all obvious areas. Any suggestions?


Try removing the carb bowl and check for dirt/water etc , also if the machine is over heating it may be getting vapour locked ... Honda Pressure Washer PSI 3000

I have a Dewalt 3800 pressure washer fitted with a 67DX39G11 pump. Started unit up for the first this year, has pressure for 15 seconds then nothing. Water is flowing through okay, everything seems in order but no pressure. Unit is 2 years old but has only 15 hours of total running time. I think the pump has failed, is it normal for a pump to fail with only 15 hours on the clock?


... Dewalt 3800 PSI Pressure Washer

DIY Noob With A Pressure Washer Choke Isssue


You need to remove the carb and take it apart soak it in a cleaner then replace the needle valve and seat ... Karcher G 2600 VH 2,600 PSI Gas Pressure Washer

Solution for ''PRESSURE WASHER MOTOR KILLS AFTER A COUPLE MINUTES WHEN YOU PULL TRIGGER RUNS FINE WITHOUT PRESSURE''


The bypass valve that relieves pressure when not in use is sticking.Try to back flush pressure washer to see if you can clean some of the gunk that may have built up inside.Sometimes it gets sand in the inlet that sticks it open.. ... Pressure Washers

Why will my pressure washer only run with the choke on? Dies as soon as turned off. Runs rough when no load or idle and sometimes dies.Did not remove carb buy did spray with cleaner.


... Pressure Washers

My pressure washer will run when the choke is on. As soon as I turn off the choke the engine stalls.


... Honda Pressure Washers

Pressure washer will not stay running. Have put in new fuel, new plug, new oil. Will not start until I spray some ether in carb, then it will start and run for about 3 seconds, then stall. will not restart without another shot of ether. What should I try next? thanks


... Briggs & Stratton Gas Pressure Washer 20244
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1355 seconds