Having problems with your dishlex 302 ?

not drying

dishes not drying at end of cycle

Answers :

Repair Help & Product Troubleshooting for dishlex 302

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Triton dishwasher. Last cycle, it completed washing then started drying and started beeping and the drying light is flashing. When I finally opened the latch, the beeping stopped, but the drying light is still flashing. The dishes were clean and warm - they air dried the rest of the way. I have not been able to get the drying light to go off. I have turned the breaker off over night, and flipped back on. The dishwasher goes back to flashing washing, and then clicks to drying and th


Hi,\015\012Make sure the salt level is ok - add 1Kg of salt if you have not done it in a while, and check rinse-aid level if apliccable.\015\012\015\012If this does nothing, then remove the lower kick panel for access to a data shee ... GE Dishwashers

Our Bosch and our Electrolux stainless steel dishwashers fail to dry. Dishes must be towel dried and the inside of the dishwasher stays wet and must be towel dried and left open to thoroughly dry. I can't seem to find a setting to dry the dishes. Help Please


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers…Dishwasher Problems The Heating Element not Working ... Dishwashers

My accusense light keeps coming on and blinks continuously. I tried the heat-dry, normal sequence and it would reset to 2 minutes. After the 2 minutes cycle, the accusensor blinking would begin again. Then I tried holding the heat-dry button in for 5-seconds. This looked like it worked so we set a normal cycle without heat-dry. Äll looked good, but a few minutes in, the normal light was off, the accusensor was blinking again and the heated-dry was on again! Is the unit possessed? Other id


... Whirlpool GU2400XTP Built-in Dishwasher

I have a whirlpool gold quiet partner 3 n the cancel button won't go off n the normal wash button won't go off either. I can do a quick wash cycle on it but then goes right to sani rinse afterward n don't shut off itself it just keeps on going. Solution? Is there a reset for it because I have an air dry button but not a heated dry button so I don't kno if I should push sani rinse/air dry two times over as opposed to sani rinse/ heated dry or if there's a diffrent solution for it. This all starte


... Dishwashers

We use jet dry drying agent and dishes don't seem to dry very well and can't tell if drying agent reservoir is empty or not.


... Amana 24 in. ADB1500AW Built-in Dishwasher

Dishwasher fills tub continuously until float turns it off whether in cyle, during drying or after cyle complete. That means during drying when the dishwasher is trying to dry the dishes the tub fills up preventing drying. This is a new dishwasher that I've never used. I allways noticed the tub was full of water, but thought that was just to keep the seals moist so they don't rot. I've been in my house 5 years and only hand washed my dishes because it was more convienient. Now that there ar


Ayacht, the fill is a timed fill controlled by the control board (part number 99003158). The float is a safety device designed to cut power to the valve in the event of a failure. The fact that the float is doing it's job and stopping the fill tend ... Jenn-Air 24 in. JDB1080AWS Built-in Dishwasher

Model SHE68P02UC/60 There does not appear to be a drying heating element in this dishwasher or did we miss connecting something up during the installation? Unsatisfactory drying on both "normal" cycle and "auto wash" cycle.Drying agent is in machine. What is "condensation drying"? Is this just blowing cool air through the machine and out through the vent? If so it is unsat. How to get the machine to actually DRY the dishes? I'm going to be very disappointed and out over $1,000.00


I am assuming you have the dishwasher connected to the hot water tap which can give water at about 40deg c (120deg F).\015\012\015\012The dishwasher uses steam from the water (after heating it further). So if the inlet water temperature i ... Bosch Dishwashers

Drying Our brand-new Ariston LL65 SNA dishwasher will not dry dishes. It goes through the drying cycle, but nothing is dry.


... Ariston Technologies LL65 Built-in Dishwasher

Drying problem Hi Our 3-day old LG dishwasher is not able to dry our dishes. After the cycle is finished 2 hours later, I open the door to find that water is everywhere. As if the washer is skipping the dry sequence completely. The "vent" on the inside of the door doesn't seem to have an outlet--why is this a vent if nothing can escape? The owner's manual says to use a rinse aid to help drying. I don't believe in using band-aid's; something else is wrong. Any help/advice is appreciated. Thanks,


Hi,\015\012\015\012As I had the same problem, I worked on my machine and found out the heater unit was not working (it is a brand new machine ! - remark : as I moved overseas, LG did not cover it with their warranty).\015\012\015\012But b ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I have a Whirlpool Gold Quiet Partner III (Model GU1200XTKB0). I have used it previously on "Normal" cycle and I always keep it on Air Dry. Last night I used the "Pots and Pans" cycle and it seemed to work fine. But this morning the Air Dry light is flashing and if I press a cycle key the Rinse Only light starts to flash as well. Nothing works. I have made sure that the console is not locked. Any suggestions? I do not have a Heated Dry button, only Air Dry. Thank you.


... Dishwashers

Whirlpool quiet partner reset ( heated dry, normal , heated dry Normal) nor is (heated dry, high temp wash, heated dry, high temp wash) neither combination is staying on. I have to turn the breaker off & on each time to do combination. What can I do?


... Dishwashers

I have a whirlpool dishwasher Quiet Partner IV. Every 3/4 months I have to reset it because it will not turn on and perform a wash cycle. The appliance repair people only reset it and charge me $40.00 and do not give me the code. I found the code on the internet but now that code is not working ''High Temp, Air Dry, Air Dry, High Temp, Air Dry, Air Dry.'' Any other suggestions?


... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

Dishwasher runs and cleans but does not dry. I have tried numerous differend kinds of drying agents but none help and the level of drying agent does not go down or down very little.


Hi,Check your heating element.. Dishwasher ... LG 24" Built-In Dishwasher - Black

The dishwasher is in the middle of the cycle air dry indicator goes out lock indicator goes air dry goes out. Then dishwasher hesitates lock light goes out air dry indicator comes on. This is repeated throughout the cycle


... Kenmore 15634 Built-in Dishwasher

I have an old free standing Maytag portable dishwasher, model number WC504. I just need to know what the differences in the drying options are. What is the difference between Power Dry, Temp Boost, and Energy Saver? Also, If drying plastic or Tupperware in the dishwasher, Which setting should be used?


Power Dry uses a little more electricity when drying but does a good job.Temp Boost will raise the wash temperature to clean better, this uses very little extra energy and works well, it may add a little time to the cycle Ener ... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

Poor drying, mold building up in the tub. The condensing drying system is not working well. I pulled the unit out and removed a panel on the left side (facing washer). Saw that the plastic box that appears to be set up for moist air removal and vents to the tub had considerable mold in it at the top of one of the passage ways. Looked like it might be blocking air flow. Could this be a cause of poor drying? Can this unit be removed and cleaned? Also soap isn't dissolving. Bad board controllin


Hi.Poor drying is often caused by a faulty moisture sensor. If there is mold covering the sensor housing , that can be cause for the problem. Regarding the door detergent drawer problem, that is often caused by a defective doo ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Maytag MDB 8600 AWB dishwasher Wouldn''t start... just a Heated Dry light. Replaced (already broken) door handle with complete latch assembly. Still, Heated Dry flashes. Tried various suggested combos of 5 or 6 quick button pushes followed by Start. Only get a 50-=countdown that repeats endlessly. Sometimes alternates with the letter L. Once by luck I guess it went into Heavy Wash mode, or at least the diagnostic for it. Completed this fine, then back to the stubborn Heated Dry light.


... Maytag 24 in. MDB8600AW Jetclean II Built-in Dishwasher

I have a Fisher & Paykel 913T soft touch dishwasher. On all types of washes when the wash cycle starts there is no 230 volts on the element & after 5 minutes the wash cycle finishes & then goes onto to the next cycle. None of the wash or rinse cycles heat the water but on the dry cycle their is 230 volts onto the element & dries the dishes OK. Is my problem the power supply PCB or could it be the Controller PCB? Does the 230 volts to the element on dry cycle come from the same cicuit on the po


Have you considered the possibility the water temperature sensor may be faulty.\015\012\015\012If the controller is getting false water temp reading then it may never turn the heater on.\015\012\015\012Generally with FP dishwa ... Dishwashers

Wont dry Hello, I have the Asko D3112 dishwasher. It washes great, but does not dry completely. After a wash everything is still drenched as if i splashed in a bucked full of water. I know it drains properly (i hear it draining down the sink), and it attempts to dry (hot air). I also am using the rinse aid as specified in the manual. Any tips would help. thank you Andrew


Make sure you select a high temp wash and the heated dry as well Also, dont put too many plastic items in there at once, they dont dry very well in anything. Check the amount of soap you are using, it shouldent be more than 2 tablespoons (way less th ... Asko 24 in. D3112 Free-Standing Dishwasher

KUDU03STSS2 The dishwasher won't start and you cannot select a cycle. Hiting cancel twice will turn a small steady light on in the time window were the spining light normally is before a cycle starts, at which time closing the door will drain the dishwasher. Tried using the reset combos: hot wash, heat dry, hot wash, heat dry - all lights came on but nothing reset. Also tried same sequence doubling the heat dry. Unpluged for ten minutes, still nothing. Can select rinse, but unit does not start,


... KitchenAid Dishwashers

Frigidaire FDB1502RGC0 dishwasher set for normal wash and heat dry option, both leds are on. dishwasher cycles through wash, but never makes it to dry cycle. After wash, the leds for OPTIONS high temp wash and dry cycle start blinking and do not stop blinking until I hit cancel - which cancels everything. Open unit and water sitting in bottom. Is it a bad operator panel? Water pump did seem to be working during wash cycle. NEED HELP.


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

I just purchased an LDF6920. It does not dry the dishes. In fact, there is water remaining in the bottom, and all the dishes and drum and door are beaded with water. It suggests putting some sort of water removing chemical, but I have never owned a dishwasher that did not made some effort to dry the dishes. I have to hand dry or have spots on everything. I am very, very disappointed with my new, and expensive, purchase.


First off, there should not be any (visible) water standing in the bottom of the dishwasher after the cycle is done. If yes, check the drain, installation of drain line, etc. \015\012Second: The LG is a very energy efficient dishwasher, but ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

I have mold in my dishwasher. This happened about 6 mos ago and I used the vinegar and scrub method to get rid of it...it was a pain in the fanny! Now the mold is back...the dishwasher has also not been drying the dishes very well either, although in truth it never has. There must be some other reason that the mold is back! Oh, and I've used Jet Dry since I bought the machine 7 years ago, and have tried the ''leave the door open to dry the dishes'' .... any thoughts?


Get rid of the mold - Pour about 2 cups of bleach in the dishwasher with about 1 cup of salt, and a gallon of cold water, use the light wash, not heated. Make sure when you start the cycle it doesn't drain first or you lose the bleach. Also I don't ... Dishwashers

MAytag dishwasher MDB7100AWW doesn't dry. AFter dry cycle dishes are wet but there is steam so heater element seems to work. COuld there be a vent for steam that is blocked? Is there a fan for drying that might not be working?


HiThanks for using FixYa. If the dishwasher is draining properly and is working perfectly fine then you'll need to open up the Dishwasher and check the heating element as that could have gone bad. You ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

We built a home last August and our appliances are Whirlpool. We were very happy to know that we would be having Whirlpool applicances bacause we've always heard how great they are. But, we have not been pleased with our dishwasher. We called Metro Builders in Tulsa, Ok who provided the dishwasher for our house and asked several times to come check on it because it will not dry our dishes. They told us to just use Jet Dry and that would take care of it. I told them we use Jet Dry and make s


Hey guys, what is the model number of your dishwasher?The people/person that installed it could have wired it wrong.There is also a high limit (saftey device) that has tripped therefore not letting the element heat.As for the refrigerator it sounds l ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0334 seconds