Having problems with your durabuilt pressure washer ?

how to put together pressure washer

how do I put my power washer together

Answers :

Repair Help & Product Troubleshooting for durabuilt pressure washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Just bought a jet usa 7.0HP 3950 PSI pressure washer, put it together and put oil in it and i cant pull the pull start cord out at all?


... Pressure Washers

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

I have a 1994 3005 super hot pressure washer made by mi t m corp,i had pics of my thermostat system but my computer crashed i have a new gauge and probe ,module,and thermal stat i need to find a repair manual so i can put it back together,also i get pressure and then i lose it .is this my valves or unloader problems?


... Mi T M Mitm 3500 Psi Hotcold Portable Gas Pressure Washer

Remove the lower wash arm (1) by turning the nut (4) clockwise (right) lift the arm off, there is a bearing (3) (small thin plastic washer) under the arm, be sure not to loose it. Lift the tab on the back of the feed tube cap (2) and swing it to the right and lift up, this may need a bit of pressure to release it This is for my Whirlpool dishwasher DU1100XTP. I'm putting it back together and can't remember if the plastic washer goes on top or underneath the feed tube cap. Also how do I remo


This is not a tuff job plastic washer goes on top . and torx screws . you use a proper torx tip for the screw size . ( you can go to sears parts .com and put in model # and see a good break down of the wash arm s and t ... Dishwashers

How to put together pressure washer 1700w


... Black & Decker 1700 PSI Electric Pressure Washer

We are trying to put together a Simoniz 1300 PSI Pressure washer and we cannot get the hose installed do you have instructions for this unit


Use a little vegetable oil (or water, or spit) around the "o" ring, wiggle the center-part (the hose) in first. Meaning don't try to use the screw-on ring to force the hose in, grasp the hose itself and wiggle downward. Once you feel it seat, then sc ... Omega Simoniz 1300 Psi Pressure Washer

I took the front off to try and clean. When i did the wiring came unplugged. They are not color coded. So i don't know what wire goes where. Need diagram to put back together. This is on a Mcculloch fh160b pressure washer.


... McCulloch Pressure Washers

Diagram put back together - Karcher Pressure Washers


... Karcher Pressure Washers

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

Just bought a new Briggs Stratton 6 75 pressure washer. i put in a half a tank of gas in the tank and it started up. i ran the pressure washer until it was out of gas. put more gas in now it will not start.


Assuming you tried choking it when you tried to start it, verifiy its getting gas,if not tap lightly on the bowl of carburator. if it is getting gas, check for spark ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

I have a Simoniz 1900 presure washer and had to take it apart to fix it. I need to know how to put it together again as it has been awhile since I have had a chance to work on it. Can anyone tell me how to put the engine and water pump assembley together again?


I took my pressurewasher simoniz s1900 apart, i had to take off the pump and all oil leaked out.\015\012how and where can i fill the oil in to the pump\015\012and what type of oil would i use\015\012thanx ernte ... Pressure Washers

I have a 2.5 gpm model K2400HH pressure washer that won't sprey with high pressure, it started intermitanly, now won't spray high pressure at all. Last year I removed the valve and cleaned it and put white lithium greese on it and it worked pretty well for a while, but now no high pressure.


I would suggest purchasing a new revised unloader valve, here is the link to purchase one ... Karcher G2650HHR Gas Pressure Washer

PRESSURE WASHER WON'T PUT OUT FULL PRESSURE WHEN SQUEEZING TRIGGER, THIS HAPPENED A OF A SUDDEN. USUALLY WHEN THE TRIGGER IN THE HANDLE IS SQUEEZED THE ENGINE NOTE CHANGES & THE PRESSURE GOES UP. NOW THE ENGINE SPEED STAYS THE SAME & PRESSURE GOES UP SLIGHTLY, NOT ALL THE WAY.


... Pressure Washers

Pressure washer will not put out any pressure


Hi Ken and welcome to FixYa. I am Kelly.\015\012These pumps are notorious for seasonal problems. \015\012Tip the unit to the point you can pour engine oil into the water inlet connection. What your attempting to do is free up the ball s ... Karcher 2500 PSI Pressure Washer

No pressure McCullough pressure washer has no pressure after siting all winter. I took apart the assembly and the oil leaked out, also I noticed yhe o-ring that seals the two pieces together seems to have been blown out. Where can I get parts and oil. Thanks for any advice.


... McCulloch FH140A Electric Pressure Washer

My honda pressure washer runs put there is no pressure when i pull the trigger. we have checked the oil and everything, the water comes out just no pressure.


Check to see if you have an obstruction in the hose or tip. If clear you have a problem with the unloader valve. This valve sometimes gets stuck and continually recirculates the water not allowing you to build pressure. Sometimes you can remove and c ... Honda Maxus Pressure Washer MX5222

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

I put 2 cycle gas in my 4 cycle Honda gcv190 pressure washer


... Honda GCV190-N5AP 187cc GCV190 Series OHC Vertical Shaft Engine with

I put 2 cycle gas in my 4 cycle Honda gcv190 pressure washer


Remove and empty the carburetor bowl, remove the spark plug, pull the start rope seweral times to get rid of the faul fuel from the cylinder, fitt new, or clean and fitt the old spark plug back, drain the fuel tank and fill up with clean fresh fue ... Honda GCV190-N5AP 187cc GCV190 Series OHC Vertical Shaft Engine with

Water pump I have a porter cable pressure washer model# 2425. I let my presure washer in the garage during the winter(no heat) and now i have a probem with the pump. I start the motor everything is find but when i put the water in the motor stop. Can you help me


... Pressure Washers

Rockworth Powertask Pressure Washer : model no AROW4P seems to rev flat out, hav to put choke in middle to use so not to fast revs. Im sure it used to rev higher and lower according to use of lance. could it be something to do with 3 valve things if so how could i tell if ok. put clean fuel in. oil level ok.another problem is when switched on water comes straight through lance,trigger makes no diffrence. please help


... Pressure Washers

Karcher K386M-I was using the washer and the pressure hose popped off the outlet of the unit. I put it back on and it popped out again. The second time I noticed the oring was gone. It was on there when I first put the hose on. Why does the pressre hose pop off.It was on tight?


... Pressure Washers

Wand was leaking. took apart wand, found bad washer and put new one on.....how does one put the @#%!! thing back together? Thankyou, Tony


... McCulloch FHH18A Electric Pressure Washer

What type of oil do I put in the high pressure pump and how much? Porter Cable PC2525SP pressure washer.


Regular motor oil ... Pressure Washers

Runs fine gc160 wont give me any pressure. i took the pump apart and cleaned it then put it all back together the pressure was intermediate but now nothing at all


If you give us a bit more information we may be able to assist!is it a pressure washer you are trying to get running.the number you give is the model number of the honda engine. 5.5 hp honda domestic use.what does the pu ... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0938 seconds