Having problems with your Earthwise PWO2200 2,000 psi 1.6 gpm Electric Pressure Washer ?

Power washer will only run when sprayer is on low pressure as soon as sprayer switched to high the pressure washer quits


Answers :

Repair Help & Product Troubleshooting for Earthwise PWO2200 2,000 psi 1.6 gpm Electric Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Power washer will only run when sprayer is on low pressure as soon as sprayer switched to high the pressure washer quits


... Earthwise PWO2200 2,000 psi 1.6 gpm Electric Pressure Washer

I have a Pressure problem on my PowerCraft pressure washer. On initial switch-on the machine runs at low pressure. If I then rotate the end of the lance to detergent application mode and then rotate it back to high pressure mode the high pressure kicks in and all is well. Is the lance faulty?


... Pressure Washers

When the washer is at rest with water on and power on the pump runs on and off on its own but when i pull the trigger the washer works fine in low pressure and high pressure


... Pressure Washers

I have gcv 160 5.5 hp power washer my problem is that the high pressure pump is not working properly when the engine is running the output pressure is very low so i would like to know could be the possible cause of that problem


look for a black plastic cover with a silver snap on top; pry off the silver snap and lift off the plastic cover; next remove the two screws on the top plate then pull out the piston inside - if unable to lift out, start unit and watch it pop ... Karcher 2500 PSI Pressure Washer

When I turn on the shop force 1750 electric power washer I get water pressure in intermittent time frames. For example, it may run for a second then stop for ten seconds, then start again for three seconds then stop for 3 seconds then start for a half a second then stop for five seconds etc. until ?. This type of pattern continues for at least ten minutes, which is when I give up. I have tried adjusting the the water hose pressure, high, low. middle, nothing changes. This happen when I have the


The usual cause of this is sticky Orings in the water admitance valve.\015\012\015\012Take the valve apart and clean the bore with crocus cloth wrapped around a rod and replace the Orings and lube with a bit of plumber's grease and reasse ... NIB Shop Force Universal Pressure Washer Accessoriesnib

Karcher B402 pressure washer Motor runs as soon as power supply connected, on/off switch does not seem to make a difference and no pressure at outlet? Was working fine, stopped for half an hour, came back and wouldn't work. Thanks Bob


Bob I had this happen to my Karcher, the pressure seals have blown. $Au200 for service and replacement from karcher dealer. tyhey would not sell the parts for a DFY ... Pressure Washers

Karcher 520M Pressure washer won't operate at high pressure


I had the same problem - good water inlet pressure, no output pressure, even though the lance and handle seemed to be clear and working find.\015\012\015\012I found that the electrical switch wasn't being operated correctly by the spill valve a ... Karcher 2500 PSI Pressure Washer

EX-CEL PRESSURWE WASHER MODEL EXH2425. HONDA 5 HP GC160 ENGINE. THE ENGINE STARTS EASY. RUNS WITH GREAT HIGH PRESSURE. WHEN WAND IS RELEASED ENGINE WILL QUIT IN 30 SECONDS OR LESS.


... Devilbliss DeVILBISS Devap DVH2600 Gas-Powered Pressure Washer

Turn water on then actuate wand trigger. Pressure washer leaks when wand trigger is actuated and has very low pressure/flow output. After releasing trigger the pressure cycles on - off at approx 1 second interval. I suspect that the plasstic oulet tube is leaking causing low pressure leak out of bottom when trigger is actuated and causes pressure switch to cycle when the trigger is released. Any Help? This pressure washer is approx 18 months old!


You gave a very close solution yourself for the problem. But other leakages can cause such symtoms.Forexample a leaking head or a leaking chemical inlet. These can be caused because the spill valve (pressure control valve) is stuck. When this valve s ... Karcher PSI Electric Pressure Washer

Quits Running Pressure washer will run for 15 or 20 min. then quits running. If I let it sit for 10 min. it will start and run fine for another 15 or 20 min and quit running again. Whats causing this problem?


... Honda Pressure Washer PSI 3000

I have a karcher 3.80 md electric pressure washer that keeps running when not in use and the pressure is low. Any help please?


... Pressure Washers

Pressure Washer quit running


I have owned four of those units. Every one of them did what you are experiencing or just wouldn't give me any pressure after only a few uses. The company was certainly no help. I gave up after four and bought a heavier gas model from Lowes. Hope thi ... Karcher 1750 psi Electric Pressure Washer

My simoniz 2900 pressure washer revs high low.


... General Pressure Washers

I have an older Landa Pressure Washer. The burner is not working. Once I get the machine running and water flowing to the pressure washer, with the wand pressed, I flip the burner on switch....and nothing...I have no idea how to work on a pressure washer burner. I have been told it could be the igniter, but I don't know how to fix it if it is. Any help is appreciated.


Check for 12V at the igniter connector with the unit running. If you have 12V and no igniter it may be stuck or bad. Thrun the unit off and read continuity across the DISCONNECTED igniter plug / terminals to the igniter. No resistance = open ignit ... Pressure Washers

My Karcher K3.48M pressure washer remains in the low pressure mode even when I return the pressure nozzle to the high pressure position. How can this be corrected. The pump seems to build up the pressure because when I release the handle the pump motor stops. This is a fairly new pump which was purchased in the latter part of last year(2010). Could this have been caused by the detergent I have been using which is an automotive shampoo? Please help I love this washer and for the times that I u


... Karcher PSI Electric Pressure Washer

I have a campbell hausfeld 2450 pressure washer with water coming out of a brass hose nozzel right next to where you screw the high pressure to the pump as soon as you turn the water on from the house, start it up and high pressure comes out of it and the hose about half pressure, any ideas?


This is called the chemical injector which enables you to insert the hose for you to dispense the soap and or chemical by utilizing a soap nozzle .apparently inside this barb you will find a ball a spring and a o-ring,find the replacement parts or ki ... Campbell Hausfeld Pressure Washers

Craftsman pressure washer with honda engine. low pressure and volume on high pressure setting. lots of water volume on low pressure setting. Screens not clogged.


Sounds like pump is not making pressure. Thats why you get flow, but no pressure.\015\012If it sat for awhile, check shaft connection to pump. Sometimes the impeller or shaft will shear partially due to corrosion when stored. Seals on pump valv ... Pressure Washers

Brute high pressure washer low pressure - Briggs & Stratton Pressure Washers


... Briggs & Stratton Pressure Washers

I have a tpw 2200 pressure washer that has lost high pressure. i have low pressure but not high pressure.rn The machine i have is a titan tpw 2200 if some body can tell me what is wrong please help. Thank john


Pour a large amount of liquid TSP into the fresh water inlet where the garden hose connects and let is sit for a couple of days.\015\012This is how I fixed my pressure problem ... Pressure Washers

I have a power washer that needs a wand for the high pressure, the low pressure wand is part number PA6630GF. I need the part number and where tp urchase the high pressure wand.


... McCulloch FHH18A Electric Pressure Washer

Excell vr2500 pressure washer ,no pressure, took off high pressure hose at bottom of washer , get water flow, but flow does not change when engine is running full throttle


Check the water filter ---high pressurehose must have bbackpressure to develop pressure so disconecting it wont acheive ,much ,if you have agood water supply ,oil in the pump--- adjust pressure by srewing the brass fitting that the pressure hose atta ... Pressure Washers

I have a Karcher K3.48M electric pressure washer which used to shut off when you weren't using the cleaning wand. This no longer happens and there is alot of water running out of the bottom of the unit. (This didn't used ot be the case) I expect a leak somewhere inside the unit, but I'm wondering even more if there is a pressure switch which has failed that cased the leak. In other words, if I find and repair the leak and there is a failed pressure switch, it will likely only break again. I can'


Hi you will have a 8 digit number on a silver plate on the machine with a number like 1.141-470.0\015\012Then go to www.karcher.com then on the left click on Europe, then you ... Karcher PSI Electric Pressure Washer

020272 pressure washer will not spray high pressure water running or not running same amount of pressure comes out


... Karcher 1550PSI Pressure Washer

Sca petrol pressure washer just stopped. How does the low oil switch work?


... Pressure Washers

My pressure washer let out blue smoke then quit. Wont stay running. What could it be?


... Honda Pressure Washer PSI 3000
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1619 seconds