Having problems with your Electric Pressure Washers ?

We have a Pressure washer 2600 PSI it is hooked up to the water line and we have a bucket of mix of 50% bleach and 50% water there is no suction coming from the line into the washer to mix with the water Why?


Answers :

You need a soap nozzle to lower the psi is call downstream injection.
Repair Help & Product Troubleshooting for Electric Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have a Pressure washer 2600 PSI it is hooked up to the water line and we have a bucket of mix of 50% bleach and 50% water there is no suction coming from the line into the washer to mix with the water Why?


You need a soap nozzle to lower the psi is call downstream injection. ... Electric Pressure Washers

How do i get the pressure washer to pull up cleaning solution into the suction line so that i have a water cleaning solution mix.


... Briggs & Stratton Pressure Washers

My dish washer is not draining the water, I have a garbage disposal but its junk I am going to get a new one in a month or so it has a hole in it, I took the line going to the disposal off it had a lot of stuff in it but no water was coming out, I then took a vaccum and some water started coming out but did not continue any guesses?


If there is no blockage then the pump impeller or the motor has failed. Only disassembly will locate the real issue.Eric ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Troy Bilt pressure washer 2600psi. Engines running fine with supply line, wand, and pressure line hooked up but no water or pressure is coming from pump. pressure line is limp. What is the problem?


... Troy-Bilt Pressure Washers

Can you change the temp of the water coming in the dishwasher? Other than the temp from the hot water line. The temp to the sink is very hot but when you open the dish washer the water just seems very warm. I didn't know is there a temp setting for the dishwasher?


THE WATER LINE TO THE DISHWASHER SHOULD BE FROM SAME HOT WATER LINE TO THE SINK. RUN THE HOT WATER IN THE SINK UNTIL HOT THEN TURN ON DISK WASHER AND CHECK THAT THE TEMP IS CLOSE TO SAME TEMP. HAVE SEEN COLD WATER LINE USED. YOU SHOULD BE ABLE TO SEE ... Samsung DMR78AHS Builtin Dishwasher

We have a Hobart dish washer in our bar area and when it sits over night there is a pool of water on the floor in the morning. When we open the door and look at the upper right corner in the rear of the machine we have a steady flow of water running down the rear wall. When looking at thge machine where the black 1 inch water hose comes up from the floor there is a plastic T in the line with an electric wire the goes into the side of the T. I am guessing tha that is a sensor valve that is suppos


The model is most likley a lx18,lx30,lx40.The fill solenoid valve is stuck open.Remove the 2 screws on the bottom front where the pressure gauge is.Turn the circuit breaker off.When you remove the cover you will see a bronze valve with a red hose goi ... Hobart Dishwashers

For Mi-T-M pressure washer Model WP-2402-SWHB: Honda engine runs fine, but only a trickle of water comes out of pressure line when trigger engaged.


... Pressure Washers

Hi my L G dish washer is coming up with E1 . It comes on after about 2 min it takes water into the washer then it hummes for about 30 seconds then comes up with E1 and pumps water back out. I have checked the hoses which don't appear to be leaking -I read somewhere in your answers about this problem that it could be the Water Level in Drum lowering, this means there is a leak on one of the pipes. More likely it is the Circulation Pump, which is responsible for pushing the water to the Spray


Hello aderry -\015\012\015\012\015\012I'm a bit short of time as I'm on my way out to a service call, but I've uploaded the service manual to Rapidshare for you to download. \015\012\015\012\015\012Rapidshare download inst ... LG Dishwashers

Husky HU 80522 pressure washer - some pressure to the spray gun. water coming from the pump goes straight to the sifon hose used for detergent. Can this line be clamped of if not used?


... Pressure Washers

Water is coming out of the soap suction hose - Karcher PSI Electric Pressure Washer


There should be a ball check valve in the soap suction hose lets soap in keep water out poke a paper clip in the hole a few times soap will build up there and make the ball valve leak ... Karcher PSI Electric Pressure Washer

Husky HU 80522 pressure washer - some pressure to the spray gun. water coming from the pump goes straight to the sifon hose used for detergent. Can this line be clamped of if not used?


This unit has a Faip pump on the unit, no water should come out the chemical injector. The chemical injector can be closed off with no problem by installing a plug where the chemical injector hose bard is currently located.You can also replace th ... Pressure Washers

I have kenmore dishwasher model no. 665.1371 I'm getting a leak just under the door area the connects to dish washer are good, there is white plastic unit the water line is hook to is dripping from that area but I can't see were it is coming from sometimes it stop on it's own for a couple of weeks and starts up again. Thank you your time


... Kenmore Dishwashers

Disconnected dishwasher and moved out in order to tile the kitchen floor. Ten days later reconnected dishwasher. Turned on water supply to leak check -- no water is getting into the washer. - Ran hot water from sink side to see if that would help, no such luck - Disconnected water line and water is in the line up to the connection point at dishwasher. Looked inside valve of dishwasher for obstruction - no such luck - Disconnected both ends of water line and blew in line to check for obst


... Bosch Evolution 500 SHE45M05UC Stainless Steel Dishwasher

I have a Bosch Diswasher that is not draining. I have disconnected power for 35 minustes and used shop vac to excess water out of drain line. i also pulled all water thru the drain line from the tub itself. i assume that because i could pull the water, all baffles and lines are clear as i emptied the tub from drain line. you can hear the pump come on to drain water but no water is moving. What would be my next step. If it is to replace the pump, how do i easiest access the pump to remove and rep


Either the selector switch or pump is faulty. If there is not any clogs anyways. The system may need to be reset. Most resets are done by entering a series of numbers on the touch pad to enter diagnostic/test mode where the machine can be reset. This ... Dishwashers

Hi my L G dish washer is coming up with E1 . It comes on after about 2 min it takes water into the washer then it hummes for about 30 seconds then comes up with E1 and pumps water back out. I have checked the Filters and hoses are OK and its not lecking. Cheers Darryl


Hi Darryl_mi579,\015\012\015\012The E1 you are seeing means the following: Water Level in Drum lowering, this means there is a leak on one of the pipes. More likely it is the Circulation Pump, which is responsible ... LG Dishwashers

We have had this dishwasher for approximately 2 years. Dishes do not clean well. For example, I put a mixing bowl in that I just mixed brownie in--and the bowl did not come clean (simply a thick chocolate mix). Glasses do not come clean. They always have a fine residue on the outside (food). My husband just took the (blades) out that spin and dispense water and cleaned them. The water volume seems better now. Still, if I remember correctly, the dishwasher cost around $900. It definitely


Check if the water gets hot . \012\011check if motor spins enough to give pressure water on arms to clean dishes.\012\011clean the filter regulary . ... GE Profile PDW8480JSS Built-in Dishwasher

No water is coming thru the water valve to fill the dishwasher. The water is turned on. I had a Kenmore portable dishwasher and we just converted it to a built-in. The electricity is on and the water line installed. When I turn on the dishwasher, it comes on ok but no water is coming into the machine.


Most probable cause a faulty intake solenoid. OK start simple and go from there.If your have power and light etc come on then we know you are good for power. I'll assume that is OK. If\012you are not getting any li ... Dishwashers

Karcher K6.50 Water coming from body of washer resulting in loss of pressure. Leak slows down when washer is used - ie water is coming out of jet


... Pressure Washers

Bad smell This is more of a general question. When I run the dishwasher there is a bad smell as it fills with water. It comes out of the sink/garbage disposal. I have cleaned out the line that comes from the garbage disposal to the drain and that doesn't stop the smell. Is there a line that needs to be cleaned from the dishwasher to the sink or how can I fix this issue? My dishwasher, at the drain, has water standing and it smells. I think it is there from condensation as the dishwasher, unknow


Smell is not the fault of the dishwasher but your waste disposal unit - they stink!it may be awkward, but arrange your drain so that there is a water barrier. better still. install a standpipe for the drain, again with a water barrier ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

Model FDB4315LFC2 Serial TH80658596 It is only 20 months old but Does not load with water. I have checked water line into white valve and water is flowing, but it does not come into the dishwasher. If I manually put water in the bottom of the dishwasher it works fine through the cycle until it is time to pump in more water. There is a sound but no water comes through the valve.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. As you have already checked the water line for clogs/obstructions and the water is flowing but wont fill ... Frigidaire Dishwashers

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

Bought suction hose for karcher in order to use water from bucket. Have attached hose but there is no water being sucked from the bucket . One side of hose attached to washer the other dropped in bucket is this right? The end in the bucket has no suction, and a depressable valve that seems to be impeding the water suction. Do I remove this valve ?


... Karcher 26408500 Pressure Washer 25Foot ExtensionReplacement Hose

I have a Bosch SHU9915UC/U11 dishwasher, installed in 2002. Recently, our hot water heater had to be replaced, and we were without hot water for five days. Air got into the hot water pipes, and dried out all the debri in the lines. When we got the new hot water heater going, all of the sediment in the pipes ended up in the in-line screen filters in various appliances (clothes washer, etc.). I have cleaned these out, and these appliances are fine. Since then, the dishwasher has been shutting


All inlet valves have a screen built into the valve itself,shut off the water remove the entire valve and you will be able to see built in screen,if you flush out the debris from it and re-install the valve it should work fine.  ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Our bosch dishwasher runs but no water is spraying on the inside. Is there a water filter clean out or is there a water pump that might be broken? I checked the line coming in and it isn't plugged. I made sure where the stainless line goes into the electric valve that it wasn't plugged to that point. I could see anywhere else to check if it was plugged. I figure there has to be a water pump, but I guess I'm not sure of that either. Thanks for any help..


Hi, welcome to Fixya. \015\012 \015\012By the description you've provided, it sound's like the wash motor is either seized or just stuck, let's hope it's the later. \015\012 \015\012Bosch had issued a service tip about this ... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1602 seconds