Having problems with your Electric Pressure Washers ?

John deere A 16 pressure washer electric, pump faltering, intermitent pressure changes, motor seems okay running independently. Are parts for A16 pumps available?


Answers :

Repair Help & Product Troubleshooting for Electric Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

John deere A 16 pressure washer electric, pump faltering, intermitent pressure changes, motor seems okay running independently. Are parts for A16 pumps available?


... Electric Pressure Washers

I have a CDA CW494 dishwasher, which is a rebadged Whirlpool. The pump has been changed by a service engineer, using a Whirlpool part instead of the original, apparently it is superior. It seemed to work OK, but now the main jets only squirt for a short burst when the motor stops or starts. The rest of the time the motor can be heard running, but no water comes from the jets. Could the motor be running in reverse?


I would check to see if there is any blockage in the area of the dishwasher where the water collects to be recirculated through the pump back into the washer. It sounds as though the water isn't being allowed into the pump enough to continue the was ... Dishwashers

Upper & bottom arms are not turning even though the motor seems OK, pump for draining seems OK too. rcently I changed the pump kit plus some gasket and seals. My Maytag is about 14 yold and was very good for me untill I changed the parts. Could it be a weak motor pump. The water splashes very much in the machine but no arm turning!? Help me thank you Ben


Hi Ben, had the motor impellor shattered in the old pump ie-chunks broken off ? if so there is every possibility that these pieces have lodged in the wash delivery pipework at an elbow or indeed at the arm boss itself -i would try to check as much of ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

GSD2200G00WW. When starting washer, part of the time the machine will not start, other times if machine has been running for a while and you open the door and try to restart the machine it will not restart. You can hear the motor humming as if it wants to go but it will only restart if you turn the motor shaft even just a little. I am wondering if the electric motor is dying??


... GE GSD2200G Built-in Dishwasher

Obtained this haier hdp18pa portable dishwasher, thought I would give it a try. The unit will not fill with water, turn the power on you can hear the motor or the pump running but no water comes in. THe 4 display lights flash and beep a series of times and then stop only to repeat the sound off in a every few second sequence. I have tried the remedies offered online, tilting the unit does not seem to work for me on this one. I changed out the water inlet valve but nothing changed and I got the s


HiYou need to clean the filter that is in the tube that gets water in the dishwasherin case you can not find it pls ask me to send you a diagram ... Haier HDP18PA Stainless Steel Free-Standing Dishwasher

I have a Quantum pressure washer and it is smoking right between the motor and the pump after it runs for a couple minutes!? It seems to run fine but I shut irt down when I see the smoke and the smell?


... Briggs & Stratton Quantum Lawnmower Lawn Mower Pressure Washer Head 691160

My pressure washer is bogging out and shutting off. It will run fine for a bit then it starts sputtering and shuts off. I changed the oil right before this started happening and yesterday i changed the sparkplug and it seemed to be working fine until I used it today on the driveway.


SOUND LIKE FLOAT IS STICKING ... Dewalt 3800 PSI Pressure Washer

My pressure washer doesnt seem to run properly. i have changed the fuel,air filter,spark plug and the oil. It will start but runs poorly.


Ok the first thing you need to check is if the spark is fireing. To do this you need to remove the plug plug it into the spark plug cap hold it on the cylinder head pull the engine over it will pull easy and see if you have a blueish spark jumping th ... Briggs & Stratton 2200 PSI Gas Pressure Washer

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

My 6 hp honda motor has become very hard to pull. It is on a pressure washer. I even removed the pump but still pulls hard.it runs if you can get it started but dosnt seem to be running at full power.I pulled the spark plug and it spins easily. Help!


When you remove the spark plug and it turns easily that means that the valves aren't opening properly. When the spark plug is installed and its hard to turn over, its because the valves (possibly just the exhaust valve) are sticking shut and the pre ... Pressure Washers

My kenmore dishwasher will run part way thru the wash cycle, stop and the hi temp and heat dry lights will flash back and forth and not do anything else. When you open the washer it will have water in it that has not pumper out. It seems that the light wash cycle will work after trying the regular or heavy wash. The washer is 1 1/2 years old. model # 587.15259402


First cut power for ten minutes by unplugging power cord or tripping circuit breaker.If that does not work try the following reset.Press in succession:High temp-air dry-high temp-air dry - High temp-air dry-high te ... Dishwashers

Motor hums but never starts. Washer appears to cycle normally and pump seems to be running OK. Just sewems to be the motor.


It sounds like the disposal is blocked up take of spray arm and use a screw driver maybe a spoon or fork is causeing it to be stuck make sure you unplug unit.thanks ... Kenmore 24 in. 17594 Built-in Dishwasher

Maytag dish washer makes loud humming sound, I removed kick plate and can feel motor shaft turning. tapped motor with hammer no sound change. no loose or binding parts


Itcould be something caught in the impeller or filter area ... Maytag MDB9600A Jetclean II Built-in Dishwasher

I have a Husky gasoline pressure washer. The honda motor starts but stalls because the pressure by-pass (not the right term) doesn't seem to open and builds up pressure. I haven't tried to remove any parts yet. I think grit has got in but don't know for sure. The pump looks pretty simple and the part I want to remove for cleaning looks like a plastic hexagon nob. Will this access the by-pass or is it something else.


I think you're right about the knob, but try this:Open the water to the washer. Leave the line open, and hold the trigger down to get all of the air out of the supply and discharge lines. While still holding the trigger down on the spray gun, ... Pressure Washers

I have a new Ariston LKF720 dishwasher. In part of its wash cycle it is very noisy - not water noise, but a grating motor-like noise. Is there anything I can do? Is there anywhere I can watch a dishwasher do a run and listen to its noise, Ariston or other brand? We bought the present one off the floor and did not expect any problem, having had other dishwashers for years, they being quiet. The poor technician already changed the motor, but it is still just as noisy. I am even considering sellin


... Ariston Technologies L63 Free-Standing Dishwasher

We have a Honda GCV 190 gas pressure washer. It starts up okay and runs for 20-45 seconds and then stops. We have changed bot the gasoline and the oil but run into the same problem.


Check that the fuel tap is on ... Honda 2500 PSI Gas Pressure Washer

Grinding The situation: I have had my Whirlpool DU915PWPB1 for 2 1/2 years, it isn't the greatest dishwasher but does the job good enough. Recently, the water will fill, the washing cycle will run but then when that part stops it goes into a whirring that seems like a motor is going but nothing is moving. I have removed the Filter Modual in an attempt to find out what the grinding would be. There doesn't seem to have anything in the way or under the filter. I have ascertained that the grin


Noise probably not from there when reassembled the plate will not be direct contact with screen noise is probably from wash motor itself..suggest checking owners manual for warranty info ... Dishwashers

My Karcher K3.48M pressure washer remains in the low pressure mode even when I return the pressure nozzle to the high pressure position. How can this be corrected. The pump seems to build up the pressure because when I release the handle the pump motor stops. This is a fairly new pump which was purchased in the latter part of last year(2010). Could this have been caused by the detergent I have been using which is an automotive shampoo? Please help I love this washer and for the times that I u


... Karcher PSI Electric Pressure Washer

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Our Frigidaire dishwasher model # FBD421RFR4 is running but the motor seems to be making a loud noise. I think part of a toothpick may be stuck in there somewhere. I need to know how to access from the inside of the dishwasher. Any suggestions??


... Frigidaire 24 in. FDB421RF Built-in Dishwasher

Won't run...... Dishwasher fills.... and will empty okay but it doesnt wash. There is no cycling of the washer blades. Is this a motor problem? Any ideas? I hate Sears. Contacted them and all they wanted to do was sell me a service contract. Thanks Drew


Hi,\015\012It sounds like the main pump isn't running - either it is jammed with something, burned out or has a power supply problem. If you can disconnect the machine from everything and turn it onto its side and look at the base you may be ab ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Bosch dish washers Bosch Logixx Dishwasher . BOSCH SGS0922gb /06 the screen on the machine seems to show not started i can get the info to change if i partly turn off the power switch then it shows the main options , any reset procedure i should follow to put machine in a full reset ?


... Dishwashers

I have a Frigidaire Dishwasher model #FGBD2431KBO. The problem is when I push the start button it fills with water and then will not start wash cycle. If you push the start button again to stop and again to start then the washer will empty the water. So it seems that the motor runs only in one direction.


... Frigidaire 24 in. FDBB540 Built-in Dishwasher

2000 epw Northstar Item # 157942E 230v 2000 psi 3.5 gal/min #5 nozzle Problem: No pressure. Motor running...seems to be in bypass. Checked starter...but not finding power to the pressure regulator. May need a new starter/relay/contactor. Was working fine..May wish to order a starter and a possibly a pressure regulator...I have photo's of the complete set up if needed. Need to know part numbers to order and what company to order from. Thanks, Greg Scott


... North Star Stainless Steel Under Car Cleaner 16in
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1738 seconds