Having problems with your Electric Pressure Washers ?

When I turn on the kranzle 1700 it seems like it wants to start but then it will trip the electrical breaker but if I turn on and off the power it sometimes will run


Answers :

If you have it plugged into an extension cord that is not rated for the Kranzle,then it will trip the breaker. Also, the breaker may not provide enough amps to run the machine or there may be someting else plugged into the same circuit that is causing it to trip when you start up the Kranzle. And of course, if water is present on the connection, this wil cause it too.

Good Luck!

Jim
The pressure relief valve is probably sticking. The compressor isn't able to turn against residual pressure and stalls. The starting current is roughly 3 times the running current so trips the breaker.
\015\012Take the pressure release valve apart and replace O Rings and clean the bore and lube with plumbing grease.
Repair Help & Product Troubleshooting for Electric Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

When I turn on the kranzle 1700 it seems like it wants to start but then it will trip the electrical breaker but if I turn on and off the power it sometimes will run


If you have it plugged into an extension cord that is not rated for the Kranzle,then it will trip the breaker. Also, the breaker may not provide enough amps to run the machine or there may be someting else plugged into the same circuit that is causin ... Electric Pressure Washers

Our Dishwasher is not draining. We tried to run a test cycle and noticed there is no power. We checked the Electrical Panel and noticed that an unmarked breaker was tripped. We turned it on but still have no power. All other electrical items are working in the house. Is the power being cut off as a fail-safe function due to the water not draining? How do I fix the drain/pump? Please Help!


Hi,No, the water is a result of the dishwasher going off mid-cycle...Take the front kickplate off and see if you have power at the makeup box...you will need an electrical meter to check that...if there is power there then you have ... Dishwashers

I have a karcher power washer electric. residential use. WHen I turn the switch to on it immediately trips the curcuit breaker on the karcher plug. Out of the blue moon sometimes it works.


This could well be just needing a new motor capacitor as this helps the motor to start. ... Pressure Washers

Own a Frigidaire Dishwasher Model Number FDB4315LFSO and now after about 2 years suddenly the display will not light and function anything. Without pulling the power panel off the whole line circuit seems to have power as they have my disposal unit tied into same electric line and that runs and so does everything else and no breaker is tripped. Is their a reset somewhere to check or any ideas what can casue the display panel not to function any commands at all. Nick


... Dishwashers

I have a Craftsman power washer model 580 752020. When I start it up, turn on the switch the electric motor runs fine until I either close the trigger to the spray nozzle or press the trigger for power spray. The electric motor just shuts down, if I take my finger off the pressure and let the water run with no presssure the motor runs fine. My question is this. Is the capasitator on the electric motor the probable cause and is there a way to check out the capasitator to see if it is malfuncti


I doubt that it has anything to do with the capacitor on the motor. i think you are having a problem with the actual Motor Drive circuitry. What is happening is when you close the switch, this tells the Motor to "Ramp Up" to pump the water out, what ... Craftsman Pressure Washers

POWER LOST turned off breaker to do electrical work within the kitchen, when i turned power on the dishwasher now will not even come on????? Chekced breaker and GFI, any ideas


... GE 24 in. GSD3620Z Built-in Dishwasher

I was using the washer and it was running fine for a couple of hours and then it quit like there was a current sensor or something tripping. I would turn power on and press trigger on wand and then it will run for a few seconds and then quit again. I have to turn the power swich off then on again and then it does the samething.


Your preasure regulater ,remove and clean you will be back in action ,can I borrow it to clean my shop.lol ... Northstar Electric Wet Steam & Hot Water Pressure Washer 1700 PSI

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

Karcher 3.86M Electric pressure washer. Plugged it into outlet. Unit started running. turned it to off position. Attached hose. Turned on water valve. Turned on switch. Squeezed trigger. Nothing happened. Will not run. Ciruit breaker was reset.


... Karcher PSI Electric Pressure Washer

I have a Beaumark Wisperwash IV Model #405010, it was running when we had a recent power outage, once the power came back on, it continued to run. Next time I went to turn it on, it appears that there is no power!!! Have checked the circuit breaker, it is on...any suggestions?


... Maytag Dishwasher

Hi - my Viking dishwasher has developed a problem where the pump runs continuously, whether the power switch is ON or OFF. After the power is turned ON, the troubleshooting guide indicates that there is too much water in the dishwasher. (One of the pot symbols on the display flashes continuously to show this indication.) I am unable to switch between programs, e.g., from quick rinse to pots & pans. I cleaned all the filters to no avail. I had to secure the circuit breaker in order to turn t


If you open the kick plate, you'll see the pan below the motor and check for leaks. The leaks will trigger the sensor to pump water out. Once you dry out the pan, the pump motor will stop and you should be able to reset the program. ... Viking DFUD042 Built-in Dishwasher

I was using my Karcher 350M pressure washer working fine but it just stopped having tripped the power boards circuit breaker. The breaker now trips each time I switch on the washer. There is no smell of burnt motor and the electric did not get wet when last in use. Appreciate any suggestions or tests that can be made. I have a decent multimeter. Thanks.


... Karcher 1750 Psi Elec Pressure Washer

We have an Asco type DW 95.5 built-in, model 1885. During operation, it stops, all the lights across front panel flash. Code F2 flashes. Although stopped, something electric still runs. When I pop the circuit breaker, all is stopped. However, when power is restored, the lights and code flash as above, and, again, something electric runs. My email: [email protected] Thanks for any help...


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Based on your description " During operation, it stops, all the lights across front panel flash. Code F2 flashes. Although stopped, something electric s ... Asko Dishwashers

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

My ge 7880 dishwasher keeps tripping the circuit breaker. display lights up with no problem but when trying to run the machine it just trips the breaker and cuts off power. is there an issue with the control panel or something else?


... Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

My dishwasher won't turn on and makes a high-pichted ringing noise. The problem began when our power went out during a storm. The circuit breaker works as the disposal is connected to the same breaker and still works. The nosie stops when I trip the breaker. The unit is almost 6 years old and is a Profile.


... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

My asko dishwasher ran great until recently. after finishing a load, the pump just continues to run (even when all water has been pumped from the unit and it's running dry) and the display isn't flashing anything (not codes, etc). Worried about destroying the pump, I shut off the washer at the breaker, and it's been a few months since we've had a dishwasher. Every once in a while I'll turn the power on and it just continues doing the same thing - it's stuck in this position/state, so I have to s


The IC that controls the pump seems to have gone kaput. Change the IC. ... Dishwashers

I have a GE Quiet Power 3 dishwasher that was working fine last week. Over the weekend I ran it and we could hear a banging noise, so my boyfriend opened it three or four times in a row (during the cycle) to figure out what it was. The fourth time, it went dead. I checked and it had tripped the breaker. I reset the breaker and the dishwasher seemed to be working again, however the lights on the front were flashing (they hadn't previously), and now it will run for about 10 minutes but no water ru


Were you able to figure this out? We have the same problem here! ... Maytag Dishwasher

My ge nautilus roll away dish washer and just stopped running. no breakers were tripped. I t just stopped like has no power. Does have breaker built into it? it is about 4 or 5 years old


... GE Dishwashers

The electronic panel on the top of the door doesnt light up anymore and is unresponsive, when the power is turned on, the machine makes a sound like its running or draining or something, but nothing is happening. This all started after a potential electrical disruption following a power outage. Perhaps there is a fuse or some relatively easy way to fix this? or am I screwed and should just call a repair man. Thanks for your suggestions, Brodie


... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher

No Power? I opened the dishwasher one day to find that it had only run half of the cycle. There was still water at the bottom of it. When I drained it, I attempted to turn it on...nothing. I have turned the breaker off and on, but still nothing. What could be wrong?


I would start at the junction box at thee bottom of the d/w behind the access panel to see if a wire nut may have burnt off. Be sure to turn the breaker off before you check this. Next I would check the door switch. ... Dishwashers

I've got a GE model GLD4408R00WW front load dishwasher, which was not filling, even though you could hear the motor running. Tried resetting it by turning off the power at the wall switch, and then from the breaker itself, but now, see the "Normal" wash cycle and Heated dry lights blinking when power is returned...


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Tr ... GE Dishwashers

Bosch SHV 4300 Dishwasher stopped in mid cycle Power Lights now don't come on No Power Will not run. Main fuse in electrical box not tripped.


... Bosch Dishwashers

Smeg dishwasher water is leaking out from underneath when washer is turned on . we have checked pipe with water going out and this is not blocked. Also when turned on it is tripping our electric circuit breaker.


The second problem is almost certainly a symptom of the first - leaking water is reaching some of the electrical terminals and shorting them to earth.\015\012\015\012First thing to do is to make sure the strainer in the bottom of the cabi ... Smeg 24 in. DWF1 2 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0901 seconds