Having problems with your Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher ?

Water keeps running

\015 I turned on the dishwasher before I went to bed last night and woke up to the sound of water running in the dishwasher. It is coming from the built in hole on the left hand side of the dishwasher. I tried pushing buttons, opening the door, and the water runs with the door open or shut.\015\012\015\012Please help!\015

Answers :

Check electro-valve must be broken,you must
change it.
Hi
Sounds like the inlet valve has failed. You need to replace the part that the inlet hose is attached to
Repair Help & Product Troubleshooting for Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

Asko dw20 pump keeps running even with door open and turned off... The machine got to the final cycle then the pump just keeps running and the glass icon (L2) keeps flashing. All the water is not evacuated from the washer. When I power off from the front the drain pump still runs (and water is still not draining). When I power cycle from the mains (waiting 10 seconds) the pump engages again and the water level drops a bit and then stops draining. I have done this until all the water is empty an


... Asko Dishwashers

I have a Honda GC160 5 horsepower power washer with 2400 psi. When its cold it is easy to start but after it has been running for a while the only way to start it is to have the water shooting out of the wand. Once it is hot and running if i stop the stream of water (release the trigger on the wand) then the machine shuts off. It seems like the only way to keep it running is to constantly have water running through the wand. Please help


... Pressure Washers

Smasungdishwasher DMT610RHS error codeCE showsup. eventhough the is not locked in, it still runs with error code CE, but the water is not coming in. but the motor is running. unless I plugged out, it keeps running. I shut off, but not responding power ONOFF.no response to any button on the control pannel. but keeps running.


... Samsung Dishwashers

Bosch built in dishwasher shu4302uc The dishwasher appears to run through the cycle but the cycle keeps running. I have checked the screens and they were clear. I have a Bosch Dishwasher SHU4302UC and I can't figure out how to cancel the cycle it's in. It keeps running and running. It pumped all the water out and the LED indicator are lit for the rinse/dry.


There is a recall on the control board of many of these models. I have written a guide to help. It is here. Look for the phone number near ... Bosch 24 in. SHU43 Built-in Dishwasher

Newly installed dishwasher will not fill with water. Runs through cycle with no water. Have checked water supply, it is on, when it runs the normal and heated dry light keep flashing and when I pull the power line it does not reset.


Look for a styrofoam spacer under the float switch (the mushroom shaped thing in the bottom.) ... Dishwashers

I received a second-hand as-is Akso D3530 (model #107353001) dishwasher. It washes perfectly fine, but at the end of the cycle, it keeps running. It does not seem to be the drain that is running, but rather the circulating pump. I have fully emptied the pan of water (there was only a little in it (you couldn't see it until you removed the sieve) using a turkey baster and it keeps running. I also checked the float sensor in the bottom. The float sensor is not tripped, and when I manually trip it,


Hi.The float switch is not a water level switch, but an overfill switch. The control board uses the input from the pressure sensor to decide when to stop the pump.When you open the float switch circuit the machine 'thinks' that ther ... Asko 24 in. D3530FI Built-in Dishwasher

Bosch Dishwasher . The pump keeps running and will not stop. The hoses have been cleaned and there is no flooding of any sort. The machine takes in water runs for a while the expels water and continues to run pump out motor.


... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Asko 1605 cycle stopped, pump keeps running, water pumps out but will not progress to the rinse and wash cycles. Timmer will turn and detergen dispenser will open. Pump keeps running


Thanks my Asko did the same and tilted it forward, drained excess on the floor, even though I thought i'd bailed the whole lot and woolaa fixed - thanks x ... Dishwashers

Hi I have a problem with my Bosch SHU43CO6UC/22 dishwasher. using "power scrub plus" and "regular" cycles it will continue to fill and overflow the door, after the cycle has run even when the power button is off. I am using the quick wash cycle at the moment .After the cycle has run i open and check if the water has drained or not,If it has it does not continue to fill and flood.If there is water in the bottom after the cycle has finished it will keep rising untill I push the rinse hold button


The bosch dishwashers use a fill valve that is attatched to the inlet hose. yours is stuck in the open position. this usually happens when you have hard water, as the minerals build up on the sealing surface of the water valve. there is no easy ... Dishwashers

Float does not shut off the water when dishwasher is being filled. IWater keeps running, fills up and runs out of the front of the dishwasher. Also it will not pump the water out at end of cycle.


Check the float to make sure it moves freely up and down, and it should click when it moves. Remove float and clean around the float tube-you may need to do this from below, through the access panel. Use white vinegar to scrub the float and ... Maytag MDC4650AW Built-in Dishwasher

The oil in my gc160 Honda pressure washer is getting water in it some how. Could it be something with the water pump gasket or what? And I can get it started but can't keep it running un less I keep spraying starter fluid in the carbar. Please help ?


... Karcher 2500 PSI Pressure Washer

I have a brand new whirlpool DU1055XTV5 dishwasher, installed two days ago. After the cycle completes there is about 1/2" clean standing water left in the bottom. It is not just down in the well area, the whole bottom is covered with water. This is after running a normal cycle with no other options such as sanitize or heat dry. I called Lowes, the store that sold/installed it, and they said this is normal in new dishwashers to keep the parts wet. They said as long as the water does reach th


... Whirlpool DU1055XTS Built-in Dishwasher

My dishwasher 4000 series Model #PLD4375RFC3 isn't working right, when it starts the water runs in than I hear a click like it's trying to start then it doesn't. The timer just keeps counting down it doesn't wash a thing... in order to get the water out I switch to rinse only and it drains the water. What's wrong with it serial # TH91579830.


... Frigidaire Dishwashers

Our Miele DW just keeps going through cycles constantly and will not shut off on its own. It has gone all day. When we turned the dial manually to "OFF", the water keeps filling until it overflows the machine onto the floor. So far, our only option has been to turn the machine back on and let it keep running. Any suggestions?


Hi,\015\012\015\012sounds like a faulty electronic unit as i have seen this before where the unit continously fills with water. \015\012you will probably need a service call to repair the unit unless you are happy to fix it yourselv ... Miele 24 in. G865 Built-in Dishwasher

Dishwasher water keeps running and leaking


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is overfilling its\015\012wa ... Maytag MDB8551 Built-in Dishwasher

Water keeps running into dishwasher causing overflow


Had the same problem with my Bush dishwash..fixed it by pushing the float up and down a few times to break up the salt etc in the plastic float chamber now works great. ken Torrevieja Spain cas ... KitchenAid Dishwashers

Bosch dishwasher motor keeps running no water


Hola Lewis!This is such an easy repair, you'll be shocked and surprised! The reason this is happening is that the computer or timer has detected a "flood" condition and has permanently energized the drain pump to clear the "flood". ... Bosch Dishwashers

Water Diver Series pressure washer, model WGV1721 shut off when running and the pump gets so hot I can't keep my hands on it.


... Briggs & Stratton Pressure Washers

Karcher pressure washer keeps running when water stops


... Karcher 1750 psi Electric Pressure Washer

Water keeps running


Check electro-valve must be broken,you must change it. ... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

The water keeps running inside the dishwasher slowly like a valve will not close all the way, water will overflow if I dont turn it off


You are on the right track...On Comerical Dishmachines this happens when mineral deposits build up in the rinse or fill solenoid blocking it from closing all the way. We install a rebuild kit and delime the solenoid itself.\015\012\015\01 ... Hotpoint Dishwashers

I have a Briggs & Stratton gas power washer. This is the 1st time this year that I have used it. I put in fresh gas, hooked up the water supply. The engine started and then quickly stopped. I had to release the water pressure in the hose before I could pull start the engine. The only way to keep the engine running is to hold down the spray nozzle trigger. Once that is released the pressure in the hose builds up and the engine stops.


Sounds like the unloader is not working correctly. Try replacing it and see what happens. ... Briggs & Stratton Prosumer 20324 Gas Pressure Washer

I have a Diplomat ADP8242 Dishwasher that continues to run during its wash cycle. The machine starts and heats up correctly but will not switch to its rinse cycle and just keeps running with 2 intermitent beeps. I have tried to reset the programe which does pump the water out and resets the control panel, but unfortunatly does not clear the fault. Can you help?


... Dishwashers

Bosch Dishwasher SHV4313GB/17 Wont switch off ! The machine keeps running even when you open the door The pump is trying to drain water away (even though there is no water left in machine ) Have tried to reset it as instructed but to no avail. It has beeped like it has finished cycle but the pump wont switch off HELP PLEASE !


Introduction: This may work for your problem, but only if you're finding that you cannot get further water to flow into your machine. If your machine fills OK, then this ISN'T a solution to your problem. If your machine doesn't fill but your drain m ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1380 seconds