Having problems with your Electrolux Dishwashers ?

Dishlex 302 Dishwasher. How to dismantle top

\015 Dishlex 302 Dishwasher. How to dismantle top spray arm.\015

Answers :

Repair Help & Product Troubleshooting for Electrolux Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishlex 302 Dishwasher. How to dismantle top


... Electrolux Dishwashers

MY DISHLEX 5OOE IS WORKING PERFECTLY EXCEPT FOR THE RAILS OR SLIDES OR TRACKS ON TOP ARE BROKEN AND DRAWER WILL NOT SLIDE IN AND OUT.CAN I BUY SPARE PARTS AND IF SO WHERE? THANK YOU MAY LEAHY(MRS)


... Dishwashers

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

Looking for top and bottom dishwasher baskets for dishlex 450 global series dishwasher


... Dishwashers

When I try to start the dishwasher, I can get the light to show I want it do do a normal load. Then when I hit the start button, it lights up but the machine will not sstart. Then in a few minutes the lights on the control panel at the top of the door go out. What can I do to fix this? The model # is KUDS011JBS0 tHE 0'S HAVE A SLASH ACROSS THEM THE TYPE IS 577-0 SUPERBA


Hi,\015\012\015\012Your control board has gone bad... you will need to replace it.\015\012The replacement is not very hard, just make sure that you mark where all of the wires go before removing them.\015\012\015\012Here ... KitchenAid Dishwashers

I removed the top cover on the of my dishlex global 300 and a black wire became disconnected i don't know where it goes the wire is made of two one wire has what dots (short lines) and then a continuos line the two wires go into a slightly transparent cover which has a small round opening for it to be plugged into something the wire comes from the cercuit board that controls the start/stop and mode


The wire that came disconnected goes to the door switch. If the wires came out of the switch then you need to replace the hole switch. If you still have some wires coming out of the switch then you can just wire nut ... Dishwashers

Dishlex dx320wb PCB. I just used your website to fix my dishwasher. You have saved me hundreds of dollars and lots of time. The pictures and instructions were bloody excellent. Thanks very much. You are now on top of my favourites. Gary from Australia


... Electrolux 18 in. ESL4114 Slim-Line Built-in Dishwasher

I have a Dishlex Global 300 and sometimes the detergent was not empying out when i did a wash cycle (seems that the top rack would prevent the door of the detergent holder to open fully) I just purchased the tablets for the first time and 90% of it is still there after a full normal cycle...what could be wrong


It could be your water preasure or the water is hard,,,but like with most dish washers the tablets dont desolve all the way,,,you need more of a liquid soap type of a cleaner ... Dishwashers

Dishwasher top arm not moving freely


Hi,I guess the dishwasher may be clogged.There's a\015\012spray arm at the bottom of your dishwasher--it may have a tall spray\015\012tube mounted to the center of it. There may also be a spray arm located\015\012directly beneath the uppe ... Dishwashers

Soap is left in the dispenser and the top rack doesn't get clean.


The inlet water pressure need to check i think there is weak level of water , check 1st nearest tap to sea normall flow of water is good or not ?\015\012 > if it is weak so the problem outside the dishwasher it is ... Whirlpool GU2400XTPS Built-in Dishwasher

How long should a normal wash cycle take for a kitchenaid dishwasher type 577 0


... KitchenAid Dishwashers

Not cleaning on top rack. Pump, fill tube asm. & spray clean. Has any seen if this issue could be the deverter motor in the pump or the control board?


Just to review, the LG dishwasher family, including the LDS5811 has the Verio motor and the check valve that diverts water from the bottom rack to the top rack. If the valve is blocked/jammed, this would cause the symptom you describe. T ... LG 24 in. LDS 5811 Built-in Dishwasher

Micro switch on Dishlex Global 450 dishwasher.


... Electrolux Dishwashers

Kenmore dishwasher type 573-D, model 665.16034402. Items on top rack don't get washed. Items on bottom rack are washed fine. Appears top sprayer and maybe middle sprayer aren't getting water. At rear of washer, top rubber flapper valve (which feeds middle sprayer when top rack is in raised position) is stuck open, bottom flapper valve looks OK. We use top rack in raised position so this doesn't seem to be the problem.


... Kenmore Dishwashers

TOP ARM HANGING DOWN-Dishwasher's working fine, problem is that the wash arm/spray thing at top is lower than it used to be, we only noticed because when pulling out the top rack the top arm/spray thing at top gets hit by the rack. Work around has been lifting rack up at angle to get past this, but everyone at some point forgets to do this and we are worried eventually something will break. HELP???


... Dishwashers

I'm having my kitchen counter tops replaced with granite. I have a GE Model GSD700 dishwasher that is now attached to the existing counter top. The granite counter tops will not accept having a dishwasher attached. I need installation instructions for the dishwasher which do not include being attached to the counter top. [email protected]


You can attach a block of wood using silicone adhesive to hold it in place on the underside of the granite top. After the silicone has cured (usually 24 hrs) you can use the same mounting clips as before. Just be sure to use shorter screws than the ... Dishwashers

The top rack dishes do not get cleaned. I have run the vinegar rinse. The bottom rack dishes get cleaned. It doesn't even look like the top rack dishes get wet. I ran the washer without the top rack in and I think water was coming down from the top. What can I do?


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Water drips out of top (roof) sprayarm but arm does not spin and items in top rack have dirt & grit on top. can I remove sprayarm from inside or must I remove woodblock top to get to problem? I suspect a blockage. Mod. GSC3200GOOBB portable Mike in Md.


... GE 25 in. GSC3200GWW Free-standing Dishwasher

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Kirkland Signature dishwasher produced by GE. The dishwasher is leaking from the top of the tub, where the water enters into the top sprayer. Should the top water inlet hose be tight to the top of the wash tub, and if so what can I use to make it tight?


... Dishwashers

Our Whirlpool dishwasher, DU1145XTPBA, has almost quit cleaning the dishes. It started with dishes on the top rack. My husband was told by rep to replace the top unit. That did not help at all. Now the bottom dishes are almost as dirty and gritty as the top rack. This dishwasher is too new to have to be replaced and we've already spent $50 on the top rack. Is there anything else to check at this point?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

How do I adjust top drawer height? The seal around top drawer appears to be leaking and there is a lot of dried residue around the top edge of the drawer. Water appears to be leaking from the top.


Not sure if adjusting top drawer height will fix the leak. The only way to fix the drawer seal leak is to take the drawer out and check what is wrong with the seal which is located around the top edge of the cabinet from inside.\015\012\0 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Lock Control I don't have a manual for my dishwasher. The Lock button is on (top of dishwasher). I have pushed that top button for 3 seconds. The button on the top and the "L" then both blink. The button on the top then stays on and the "L" light goes off. Since I can't get the lock light to go off - - my dishwasher won't tun on. Thank you very much.


First try unplugging the washer from powerpoint for 30secs..this may disable lock.if not, some washers will still work on lock if you hold the buttons you need. for 5seconds. eg try starting washer as normal but hold the button for 5secs....(Ps you m ... Jenn-Air 24 in. JDB1050AW Free-standing Dishwasher

Hi, we are trying to install our new Bosch dishwasher model: SMU68M05AU. I am surprised to see packing foam and flimsy edging across the top edge that meets up to the stainless steel door edge when its closed. I can not find detailed installation instructions. Is there not a strip that goes across the top to meet the door as the top looks very ugly? The dishwasher door protrudes from the under bench cupboard space so the top part is in view and exposed.


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Bosch Dishwashers

The top spinning paddle on my simpson silencio dishwasher 950 came off. I was able to re-attach it but I notice that there is no hose for the water to enter the top paddle from - can someone please tell me where this hose would go and where I should be looking. There is an opening at the top of the machine but no attachment from there to the top paddle. thank you.


The end of the spray arm should plug straight into the hole at the back of you machine when you push the top basket in. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0642 seconds