Having problems with your Electrolux Dishwashers ?

My electrolux ex302 not working the water is not

\015 My electrolux ex302 not working the water is not heating some times\015

Answers :

Hi. This is an issue with these dishwashers. You will most likely have a blown circuit track on the control PCB- re solder the connection and away you go. (7 years in a service company parts dept) If there is not a blown track then most likely the tachometer sensor on the motor thinks there is no water in it and so won't turn on the element- ironically it'll still wash etc perfectly fine in cold water! Problem is the tacho is not available seperate from the motor..........The cheats way is to just plumb it to hot water and use it til it dies.
You may have an issue with the heat element or thermostat (if applicable). Contact an appliance service company.
Repair Help & Product Troubleshooting for Electrolux Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My electrolux ex302 not working the water is not


Hi. This is an issue with these dishwashers. You will most likely have a blown circuit track on the control PCB- re solder the connection and away you go. (7 years in a service company parts dept) If there is not a blown track then most likely the ta ... Electrolux Dishwashers

My dishwasher will not start. It is a frigidaire / electrolux FDB1050REQ. I have checked thepower....and reset the circuit breaker.......then pushed the start button.....the light comes on on the front of the washer like normal but no water starts filling. I have jiggled the anti water overfill device but still nothing. HELP!!! The front of the dishwasher says Frigidaire, however, the inside of the door where the model# is says Electrolux


... Frigidaire Dishwashers

Electrolux Dishwasher 24 " not enough water new fill valve new float hot water Water lines clear. water too low float never rises amd the dishwasher runs water barly covers the top of the filter straner Model FDBB2455FS0


If i was at your home as a repairman this is what i would do.if your water pressure was good at the kitchen sink,i would turn water off to dishwasher undo water connection at the fill valve,and place water line in a bucket and turn on wa ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

I have an Electrolux ESI 6104x. Regularly just after starting the dishwasher as it starts to fill for the first time the water inlet cuts out. If you turn the water off at the mains disconnect the inlet pipe (spilling a bit of water in the process) reconnect the inlet pipe and turn the water back on the dishwasher fills and runs perfectly. This fault used to happen occasionally and now happens regularly.


Disconnect the fill pipe from the back of the machine and you should see a small mesh strainer in side the dishwashers inlet valve. Check that this is not dirty - to clean it pull out the strainer and rinse under the tap. ... Dishwashers

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

I have an electrolux slimline dishwasher model number esl 4115.On every cycle it starts with pumping out any excess water but will go no further.I have tried putting water in and all it does is pump out the water and continues with a humming noise.once opened the humming noise continues and the programme light continues to flash.there is another simble which is -] but with an arrow rather then a line that flashes 3 times.It seems to be stuck on empty.In the handbook it states that the anti-flood


... Electrolux 18 in. ESL4114 Slim-Line Built-in Dishwasher

Brand new high end electrolux dishwasher perfomring horribly - likely due to hard water issue. Cloudy glass and resident left on dishes. Have the rinse agent set at max and hot water is at 150F...is the only solution a water softener??


Dishwashers have a water softener incorporated but this needs salt to regenerate. have you put salt in? ... Dishwashers

I have an Electrolux dishwasher model ESF489, and I can't get water to go into it.the water goes as far as the machine then the inlet hose just pressurises up.I know the hose is clear .The machine tries to go through its cycles but because the water will not flow,it just cuts out after a few seconds.????


Assuming the control card is working ok, the most likely problem is the water inlet valve which may have a faulty solenoid. Do you not get any indication of beep or fault lights on the dishwasher.\015\012You can find a possible replacement at ... Electrolux Dishwashers

Electrolux esl 6115 integrated dishwasher.Water not being pumped/ draining away. Have tried laying drain hose flat on the floor water drains away fine and water runs clear but with hose connected cycle does not complete and water remains in bottom of dishwasher. Is there a drain pump in this model


... Dishwashers

I have an Electrolux EIDW 6105GB1. The washer fills with water then immediatly drains back out, the lights all flash and the trouble code light under the kick panel indicates the wash pump. It has done this before and I took the pump out and checked it with power direct, then returned it to the main control board plug and it was working and pulsing it's speed as it should. It worked fine for several weeks and now it's doing it again. Is it possible that there's a problem with the water float ins


Hi\015\012\015\012The issue is either with the wash pump that is going bad or\015\012the motor itself that is unable to run. As the washer fills and then drains\015\012immediately so the pressure/float switch should also be checked. Hope ... Electrolux EIDW6105GW 24 in. Built-in Dishwasher

H, My AEG Electrolux Favorit 50760 dishwasher appears to be 'stuck' on empty. I f I add water manually it empties it but will not stop trying to clear water that is not there. Any suggestions?


... Dishwashers

Electrolux Dishwaher ESL424 Water going to appliance. Program selected, door closed, sounds like its starting up and then makes a "racket". Door opened and no water in appliance. Any advice


The inlet water system apears to be causing the problem.\015\012This model has a water softener unit which should provide the water to run the dishwasher.\015\012\015\012See this ... Electrolux Dishwashers

Electrolux esi6104 wont fill with water but pumps water out


... Electrolux 23 in. ESI6104 Built-in Dishwasher

I have a 2 year old Electrolux ESL 63010 dishwasher, and it worked perfect until a few days ago, when it did not wash cleanly and the dishes came out cold. I read a few forums and it seemed to indicate the heating element. So I ordered one a fitted it, but still the water is not getting hot, or drying the dishes after the complete cycle. I have done a visual check of the PCB board, which looks clean and good. No error sounds, and it completes all programs, but with cold water and no drying. W


... Electrolux Dishwashers

Hi i have a zanussi electrolux zdf601k dishwasher and the anti flood keeps kicking in, it happened after the inlet water pipe froze but it now ok and works fine when i tip the water out of the overflow tray, the machine then runs fine but i am having to tip it everytime i go to use it to reset the anti flood


... Dishwashers

Electrolux dishwasher eidw6105 error 01...no leaks noted under unit. 3 yr old unit. Also leak detector light is green under kick pan. Not responding to Electrolux CSR instruction to hold Heavy Wash button down for 10-15 seconds or other poster's recommendations to hold down any two buttons down for 8 seconds. Currently have a space heater running air under to hope to evaporate any water or condensation.


... Electrolux EIDW6105G 24 in. Built-in Dishwasher

I have an Electrolux EWDW6505G Dishwasher. Had started a cycle, then opened the door midcycle when water was in the tub -- and accidently pressed "cancel." When I try to start a new cycle now, I was getting an "Error 01" message. After trying to get out of it, I'm now getting a "water serv" message. How can I reset?


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

Got an electrolux esi 602 dishwasher. Water feed supply ok,but will not take in water, any ideas, does it have a solenoid valve on the inlet?


... Electrolux 23 in. ESI602X Built-in Dishwasher

Electrolux built in ESL4115 Dishwaser:- Starts the programe briefly but stops with two intermittent audible signals when you open the door the cycle has not really started and there is water at the bottom of the dishwasher(when u refer to manual says the sink spigot is blocked or water drain hose has not been correctly laid or is bent). I have had this for just over 1 year working ok up to this point, tried to see if there is a blockage, taken pipes out doesn't appear to be any blockage also th


... Electrolux Dishwashers

We have a new Electrolux EWDW6505GSO dishwasher. It is not cleaning properly. We have increased house water temperature, run hot water before use, made sure detergent was shaken and not old, and nothing has worked. Any other ideas?


Is it not cleaning properly from the day it was installed or is it just started doing that recently?\015\012\015\012Please provide some information on what things happen to the dishes. Does the dishwasher fully drain out at the end of the ... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

I have an Electrolux ESL6115 dishwasher model and although there is water coming out and the spray blades seem to be turning the dishes are always wet after the cycle has finished and there appears to be no hot water??


Its possible that if you live in a hard water area that limescale buildup is causing this problem if salt levels got low. The first thing that can be done is to run it with 2 or 3 cups of vinegar added & see if it cures it. If it won't accept opening ... Electrolux 23 in. ESL6114 Built-in Dishwasher

Dishwasher electrolux esf 6121 when it broke out the hot water pump, and then not to receive water. Blinking light bulbs to washing and light bulbs for a given program.


... Dishwashers

Water won't drain - Electrolux Kenmore 24 in. Built-In Dishwasher with 5-level Precision Direct Water Delivery System Dishwasher


First check that there isn't anything blocking the drain area inside the bottom of the dishwasher. Sometimes plastic wrap, a small Tupperware, etc. top gets sucked against the drain and blocks discharge. If nothing is there, (look really good, by get ... Electrolux Kenmore 24 in. Built-In Dishwasher with 5-level Precision Direct Water Delivery System Dishwasher

No water entering electrolux esi 602 - Electrolux 23 in. ESI602 Free-standing Dishwasher


... Electrolux 23 in. ESI602 Free-standing Dishwasher

Electrolux ESF 489 water sensor - Electrolux Dishwashers


... Electrolux Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0944 seconds