Having problems with your Electrolux Dishwashers ?
How do you clear a delay time on the dishlex DX302?
Repair Help & Product Troubleshooting for Electrolux Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
How do you clear a delay time on the dishlex DX302?
... Electrolux Dishwashers
Dishlex global 450 _ how do i fix fill level time fault? displaying oF? Hi There, I have the above dishwasher and saw your advice on fixing fill levels - my display is showing the oF message and the pump to drain remains on whilst mains is connected. turning off mains does not clear message. holding eco button down does not clear message? is there anything else i should do in terms of removing parts to assist the process? I have cleaned out all of the drainage bowl and all is clear. i would pref
I have a dishlex dx302 dishwasher. Was working fine last use, but this time getting error message 1H, then all lights go out and nothing happens. Can you help?
... Electrolux Dishwashers
Dishlex DX302 dishwasher: cycle pauses and readout flashes "20" until program/clear button is pressed. This happens several times during a wash. How to fix?
Hi thereIs the machine emptying completely? It may have a blocked waste hose causing the drama ... Dishwashers
The dishwasher (Dishlex DX302) is not drying the dishes any more. I thought I must have put it on the wrong cycle last time by accident, but have tried another cycle and it still won't dry and the dishes remain wet. Any clues?
Have you selected the eco wash cycle.it wont dry on an eco cycle. ... Electrolux Dishwashers
I wanted to heat up a cup of tea. As I've done many times before, I pressed Time, then 1:20 seconds, then I pressed Auto Start, but fear I may have touched the button below it, which says Start in small red print. The oven wouldn't switch on, and I noticed a small green u-shaped mark had appeared at the base of the 1: I pressed Clear, and repeated my movements, making sure this time that I pressed Auto Start. Again, nothing happened. I've cleared the touchpad several times, but the oven won't
... Danby 22 in. DDW399 Free-standing Dishwasher
Model IGV 659.1 Dishwasher When switched on the 'time display' takes longer than 2 minutes to display the planned wash duration. The display works fine to set a delayed start. After cycling the start delay round to 0, or after RESET (buttons A and C pressed) the unit is then 'nudged' into displaying a time. After, at last, a time is displayed the unit works fine.
... Kuppersbusch Dishwashers
Trigger delay I have the dewalt 3800 and there is a ten second delay between the time I pull the trigger and the time it starts spraying.
... Dewalt 3800 PSI Pressure Washer
8 years ago we bought a model 665 Kenmore Limited edition Stock #575-0 if you need that. A certified kenmore tech. has been out here 3 times with still no clear answer. The problem is when you run a standard cycle of 95 minutes it counts down to 78 minutes and stays at that time for about 45 minutes then stars counting down again till 42 minutes then stops at that time for about another 45 minutes then coutinues till it finishes the wash and drying cycle. It runs and sounds fine the entire time
Sounds like timer prob.would rec. replacing timer ... Dishwashers
Whirlpool dishwasher gu3600 The pots & pan, normal light and delay lights flash all the time. Also the time remaining screen has two horizontal lights on. The dishwasher won't start
... Whirlpool Dishwashers
Dishlex global 460 fault.. Always stays on and makes a pumping sound while 'of' is displayed. Only way to turn it off is at the power point. Have tried turning it off at the power point for some time and re setting by pushing start & program at same time with no luck. According to the manual the code says "incorrect fill levet or time " and contact service for help. Any ideas?
Reset dishwasher my dishwasher is stuck on delayed timing..I have held down the start button several times and its still on delyed timing
... Asko D1876 Dishwasher
I have a kenmore elite dishwasher model # 665.1392 I had set it for a wash with th 4 hour delay and that shut off and now the complete blue button is flashing 4 times with a pause and then flashes 4 times again. If I open or shut it, it beeps 15 times. I tried doing the normal wash - heated dry back and forth trick but no luck with that. Any suggestions?
My Whirlpool ADP 6515 ix has delay start program. It is stuck on 3-hour delay and I am unable to disable the the program. I've turned the power off to clear the memory but it is still not respond
Can't set time delay.
Would your start button be stuck? check to see if there is something keeping it pressed in? if not your control star button could be shorted...let me know ... Kenmore 24 in. 16462 / 16464 / 16469 Built-in Dishwasher
Subj: ge dishwasher mod/gsd3960looss - 1yr 4 mos old. problem: will not drain only used 6 times. last use after cycle done, water remained. had to hand drain. removed cover and checked drain area, no debris found. drain tube is connected to disposal by clear plastic tube; no clog in tube. the sink drains are clear and the disposal works normal. dishwasher drain seems to be stuck in closed position. this model has the touch pad controls. any solution????
... GE Dishwashers
Vulcan Dishlex Executive 14-10 Dishwasher leaking onto floor from right hand side when it was filling at start of cycle. Husband has checked the following: both pumps (main and waste) hoses, solenoid switch (inlet). Where can we find the float/level valve? Could this be the problem? What else to check? This is the second time it's happened - I don't use it that much. The previous time my husband replaced the inlet and outlet hoses. What is the proper level for water fill - never above the
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Dishwashers
Hello, I have a Neff Dishwasher S5453X1GB/74 and it's not draining the water out at the end of the cycle. I have unscrewed the filter and released the impeller. I have also cleared the waste pipe that runs to the sink waste and put loads of cleaner in the dishwasher. The pipes seem to be clear as water goes somewhere during the cycle but backs up at the end. A few times when I started a cycle the water did not spray out but I could here the drainer or motor? running. I jetted water through th
... Neff 24 in. S5453X1 Built-in Dishwasher
Time delay how do i use the delay feature to make the machine come on afetr midnight?
1.Position the rotary switch to reset.\015\0122.Press the RH button, with the clockface on it, once for every hour of delay required. The display will change to 1H, 2H etc.\015\0123. reposition the rotary switch to the number of the requi ... Indesit 24 in. DE73 Evolution Free-standing Dishwasher
GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you
... GE Dishwashers
I have an electrolux edw5505eps dishwasher. The control panel start button does not function, the delay button does noy cycle thru the delay time. Does the panel need to be replaced?
Check out my thread on a similar issue. If your power button doesn't light and delay button does not light? Is the LCD screen display anything? check out my post several really good check lists. ... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher
Our whirlpool ADP 6565 dishwasher stops very close to but short of the end of the cycle, with the on-button flashing. If we press that button for a few seconds, it starts again and completes the cycle. I have cleared the filter on the inlet hose because we use tank water which does have particles in it frm time to time, but this made no difference.
It appears that you have a timer malfunction. at the point that the timer stop, you need to listen closely to any sound from the timer. if no sounds emerges, repalce timer ... Whirlpool Dishwashers
My Dishlex Global 450 leaks, I have narrowed it down to the door seal and have replaced this. It appears to overfill during it's operation BUT not evry time? Sometimes it soaks the floor other times no leaks at all. How do you adjust the level the water fills up to during operation?
Mine did the same thing. I cleaned the door seals, mostly the bottom one which collected a lot of grime & didn't provide a solid seal.\015\012\015\012Hope this helps. ... Dishwashers
My built in dishwasher ser no sm843049B-Model number GSD696ON1OSS will not reset. I mistakenly used the delay wash setting. It is set at 1 hr. I have used the start/reset button several times and the delay continues to show 1 hr. I don't see that the timer is moving in any way. It seems to be "stuck" at 1 hr . Is there a way of "erasing" the previous input? D Bafkas
Hi,\015\012\015\012Try to do a hard reset by unpluging all the cords for 1hour and then plug it back.\015\012\015\012Goodluck,\015\012Please don't forget to rate the solution ... Dishwashers
I have a Teka DW6 55 FI Dishwasher which as the following fault, The frist 4 cycle indicator lights are on and it beeps about 6 or 7 times and the water pump is running,It then starts beeping again, all the time the pump is running.It dose empty the water.I tried holding down the program key and turning on but that didnt clear the error. Many Thanks Paul Luhman