Having problems with your Electrolux Dishwashers ?

How to refit thedoor seal on dishlex dx320

\015 Rubber door seal\015

Answers :

Repair Help & Product Troubleshooting for Electrolux Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to refit thedoor seal on dishlex dx320


... Electrolux Dishwashers

I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an


Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your mod ... Dishwashers

Replace bottom door seal on Dishlex Global 300 Dishwasher - Model DX300SA


HI - i just replaced the bottom seal yesterday. The guy at the spares shop advised me to replace both (bottom of door and bigger seal ) at the same time to ensure no leaks - i did that. The bottom door seal come out when you unscrew the screws - (N ... Dishwashers

How do I change the door seal of my dishlex global 500 model DX500IKA*o5 I have the part. I also need to change the main door seal which I have and the light.many thanks


... Electrolux Dishwashers

Electrolux Dishlex DX302 lower door seal replacement


... Dishwashers

Dishlex 302dx seal leaking


... Dishwashers

Dishlex global 450 is filling above max level then stopping & flashing nf. Have just had new hoses & door seals to fix leak. Hoses not kinked. How do I reset fill levels?


... Dishwashers

How to replace electrolux dishlex dishwasher door seal


... Electrolux Dishwashers

How to replace door seal dishlex dx302 - Dishwashers


... Dishwashers

Our Dishlex Global 300 appears to be stuck in Pre-wash. The Eco light is flashing and the water has drained. All other buttons are unresponsive. I have just replaced the seals and handle assembly.


If your getting 120 volts to your dishwasher, I would first ohm out\015\012your thermal fuse for continuity, turn your breaker OFF to your\015\012dishwasher first. ... Dishwashers

I have a Dishlex Glendale Deluxe and need a new seal for the bottom of the door. I cannot find what model number it is to source the part. Do you know what the part no. or model no. would be?


I have a Dishlex Glendale dishwasher and the model no is 10014380092 if that helps you. ... Dishwashers

Dishlex DX302SJ*4 door bottom seal leaking - Dishwashers


... Dishwashers

I have a disintergrating rubber seal on the door of a dishlex global 300 dishwasher. There is black rubber and grime in the dishwasher every time I do a load.


... Dishwashers

I have a Bauknecht dishwasher GS 835 S purchased in 1986. Since moving it while having kitchen refit there are two small leaks. One is from the hose that goes into the bottom of the machine towards the front, and the other is a drip that comes down between the front facia panel and the machine door. Possibly the door seal is slightly perished? I do not want to pay the earth for callout charges etc; if spares are not available. If they are where can I get them, and will they be very costly. I


Hi there,you can get the spare parts for your dishwasher on ... Bauknecht Dishwashers

My Dishlex Global 450 leaks, I have narrowed it down to the door seal and have replaced this. It appears to overfill during it's operation BUT not evry time? Sometimes it soaks the floor other times no leaks at all. How do you adjust the level the water fills up to during operation?


Mine did the same thing. I cleaned the door seals, mostly the bottom one which collected a lot of grime & didn't provide a solid seal.\015\012\015\012Hope this helps. ... Dishwashers

I have a dishlex global 300 on which I removed the front cover a black wire came loose and I didn't know where it came from thanks to jyackle5 I have fixed that issue. The problem I have now is the eco light flashes and that's it (nothing else functions). I removed the front panel as the bottom door seal had blown and junk oosed behind the front panels I washed the junk out and cleaned the hole washer while I was at it the bottom of the washer (where the heating element is) over filled so I tipp


Easy fix, Use a bit of force and pull the dishwasher out.Get a few towels and tilt to the left. Water will drain out. Push back in. wait 10 mins and turn on.\015\012\015\012\015\012\015\012Regards ... Dishwashers

Hi, my dishlex dishwasher dx300iww(paperwork) or dx403sb (model # inside door) is leaking on the left hand side edge about 150mm in from the door. The seals look alright. Any ideas what could be the problem?


... Dishwashers

I have a Bosch SGI4005 AU/12 dishwasher that needs a new door seal, is this a common seal, or is it a seal for this model only? can I use any other type of seal? regards Peter


... Bosch Dishwashers

I had to clean out the chopper and clean out the screen. I had to clean it all out and the seal to the sump got broken. do i have to replace the sump(parts.com) says sump with seal. you cant buy just the seal. Is there anything i can do to stop it from leaking around the seal?


... KitchenAid 24 in. KUDI02IR Built-in Dishwasher

My Maytag model mdb9600aws motor shaft seal is leaking. How do I remove the seal and replace a new one. I am a novist, but I have taken the motor completely out and replaced the seal / gasket that the motor sits in, but there still is a leak. I am afraid the leak is going to destroy the motor as it has corrosion / salt like stuff about the motor. I have attempted to pry the shaft off with the use of 2 screw drivers. I was thinking since I am going to replace the whole motor shaft seal and chop


You are wise to realize the leak would destroy the motor.Take a close look at the diagram to see everything that gets placed on the motor shaft. That should give you a good idea what can/must be removed from that shaft. ... Maytag MDB9600A Jetclean II Built-in Dishwasher

Dishwasher leaking my GE Natulus dishwasher is leaking from the bottom seal, Is the two pieces that are at the very bottom that hold the motor where the seal is? I'm not seeing a seal. I'm not sure if that is where it is leaking. I've got the thing torn apart so it is difficult for me to say where it is leaking. I'm going to give it a whirl. Don't know if the repair is worth the trouble. The GE dishwasher is only 7 years old. What is the avg life of a dishwasher. I'm sure it's not top of the lin


There is a front door seal that may be the issue. It seals along the door sides/top and continues under the door to seal the bottom surface when closed. Mine pulled out of the seal channel under the open door where you can't see it without a small mi ... GE Nautilus 24" Built-in Dishwasher

I have a dd605 disher. The bottom drawer is leaking to the laower chassie causing a F1 code. The clear seal does have sand in it that I cannot get the sand out without removing the seal. Does anyone know how to remove this seal? Thanks


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

A built in whirlpool dishwasher is leaking around the door seal, right side to be more specific. cleaned the seal, and along the bottom and it still leaks. Is there an adjustment that can be made to tighten the door. I wouldnt think it would be the seal itself do to being less than 2 years old. Thankyou for this service.


Hi,There is no adjustment per say on this door or seal. If water spray directly on the door it can cause this, what I mean by that is if the spray arm, either the upper or lower is stuck and continually sprays in one place it can cause th ... Whirlpool Dishwashers

I have a fisher & Pakel dishwasher and it appears to have brown a fuse inside the machine which means it does not work at all and the problem occurred during the wash cycle. This means the seal (which is a top piece that's lifted and lowered by two motors. When the seal is in the lowered position it creates a complete seal but it also locks the drawer (single drawer dishwasher) so it cannot be pulled out. I repaired the dishwasher two years ago. One of the lifter motors didn't work. I replaced t


According to the service manual there is no problem in manually forcing open the drawer in the situation where the power has failed part way through the diswasher cycle.\015\012\015\012The problem is that once you force the lid open, you ... Fisher and Paykel Dishwashers

Model ADP 4665 WHM purchaswed 2007. Small pool of water at end of cycle coming from l/h side of door. Seal is split at three regular intervals. Is this how should seal should be? Can I instal a new seal myself if it is fact damaged?


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0321 seconds