Having problems with your Electrolux Dishwashers ?

Misread model number! should be AEG Electrolux Favorit 65011 IM. goes through cycle but everything stone cold and wet at end.


Answers :

Repair Help & Product Troubleshooting for Electrolux Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Misread model number! should be AEG Electrolux Favorit 65011 IM. goes through cycle but everything stone cold and wet at end.


... Electrolux Dishwashers

My dishwasher has stopped cleaning plates properly. It makes everything wet but at the end of the cycle the detergent block is half dissolved at the bottom. I have just run a cycle and opened the door during this. The bottom is full of soap suds and water and the top spray bar is dripping water after I open the door but when I close and then reopen a few secs later the top spray bar has definetly not rotated. The water is also not hot, this dishwasher is a cold fed only machine so I guess the el


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Zanussi 18 in. ZSF4123 Slim-Line Free-standing Dishwasher

Bosch SHE55P05UC Used it maybe 10 times in 10 months (long remodel underway) and noticed it didn't work properly. Powers up, but doesn't always fill with water...just "runs" until I shut it off. Or it fills, runs most of cycle, but the soap doesn't open, and I end up with a hard soap "cake" at end of cycle...Or it washes..with soap, but during drying...never turns off...and I'm not sure when the problem occurs, but that everything is wet. At least with this one....I can do


... Bosch Evolution 500 SHE55P05UC Full Console Dishwasher - Stainless Steel

ARISTON LSI 45/50 UK ALL COLD CYCLES ARE PERFECT ON HOT CYCLES IT GOES THROUGH ALL THE STAGES BUT NEVER ENDS THE CYCLES AND ALSO I THINK THE ELEMENT TEMPERATURE IS NOT BEING SENSED TO ALLOW HOT WASHES TO CONTINUE AND FINISH I ALREADY REPAIRED THE INITIAL FAULT WHICH WAS A RED 2 PIN CONNECTOR WITH A WHITE SOCKET GOING IN TO IT BOTH WITH 2 RED WIRES ON WHICH WAS VERY BADLY BURNED / CORRODED I REPLACED THIS WITH A 15 AMP CONNECTOR BLOCK BUT NOW I HAVE THE HOT WATER CYCLE FAULT


I tried to look up your model dishwasher ( aristion lsi 24/50uk ) by whirplool / can not find in data base / also you stated that all cold cycles work/ most d/w only use hot and there is no cold cycles . so there is always time to ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Dishwasher seems to run completely fine, but the load definitely was not clean. Lights light up through the cycles; water goes in and out (everything is wet); soap dispenser opened and was rinsed on the 2nd run, but not the 1st time. To rack glasses still milky (but wet). Thank you!


I ran a load with 1 quart white vinegar; everything is clean now. Diagnosis: holes in sprayer arms were clogged. ... Dishwashers

Bosch sgs43eo2gb dishwasher. wash programme completes, water drains out, but machine goes on draining, forever, stuck at around 50 minutes on the facia clock. there is no leak on the machine and everything else has been cleaned and operates perfectly. ie,fills correctly,heats correctly and drains fully but won"t stop draining & refill. Cancel programme and reset and it works perfectly until end of wash cycle again, when it continues to drain even with the door open. There is no leak in the machi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. Please once again check that the hoses are not kinked or drain pump and filter ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

My KDS 19 Kichenaid dishwasher goes thru the wash cycle, but at the end there is about 1/2" water still in the bottom. The punp work OK druing the wash and rinse cycles, but at the end of the drying cycle there still is watere in the bottom.


Would you have the model number at all? It should be on the left edge of the dishwasher's door. Thanks. ... Dishwashers

Hello, I have a Neff Dishwasher S5453X1GB/74 and it's not draining the water out at the end of the cycle. I have unscrewed the filter and released the impeller. I have also cleared the waste pipe that runs to the sink waste and put loads of cleaner in the dishwasher. The pipes seem to be clear as water goes somewhere during the cycle but backs up at the end. A few times when I started a cycle the water did not spray out but I could here the drainer or motor? running. I jetted water through th


... Neff 24 in. S5453X1 Built-in Dishwasher

Model Number 87378918 TD Soft Touch ( 12 years old ) no previous problems. Dishwasher will not complete normal wash cycle or any other fast wash cycle etc. The electronics may be the issue, as the cycle appears to start , then stops and goes to an end beep to advise cycle complete.However, nothing has actually happened. Dishwasher in very good condition otherwise. Will an on site visit be necssary? Cannot locate original guide at present, so cannot refer to any troubleshooting issues. Any a


Hi\015\012\015\012Terry...as the motor works fine then you are right the issue\015\012is with the main board of the unit also known as the electronic control board.\015\012Please check this link and enter your zip code in order to locate ... Fisher and Paykel Dishwashers

Cycles improperly My dishwasher does not cycle properly. It races through the cycles, even when set to pots & pans, in about ten minutes. At first I thought it not filling properly, checked the fill switch, it's fine and water does come in. Then when it's finished it does not always drain completely. I have checked everything on the drain end as well. It seems to have a mind of it's own. I replaced the $145 computer control with no luck. It actually sped up from the original 16 minute ful


Hi there,\015\012\015\012please let me know the make and full model # off your d/w.\015\012\015\012thanks ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Prima lpr 601 does the prewash cycle and drains it and then 4 beeps and goes to the end of cycle and shuts down tried ion different heats but only does the pre wash cycle any help please


... Dishwashers

Hello , we have a blanco BFDWC65 dishwasher supplied to us by our builder , The dishwaser fills with water ok then once in cycle it starts (with all operating lights ) then stops , it continues to start then stop for the rest of the cycle , Quiet some time later it finished and then drained the water ok , now it struggles to get to the end of the cycle. have checked all filters , water pressure and for clogged hoses , everything is ok in that department. Any help would be apprieciated


I would suspect the control board in this type of behaviour. As the machine is new I advise no interference, but to open a claim under warranty. You would have all the warranty papers for this unit, or should have received them from your builder. The ... Dishwashers

Candy cs455m the dial goes through one cycle but it stops when it gets into another cycle and there seems to be no heat because when we stop the cycle and open the door the plates are cold and the water has not been dried off


\015\012\015\012\015\012Welcome to fixya.\015\012\015\012I'm Huuum at your service.\015\012\015\012You said, The dial goes through one cycle but it stops when it gets into another\015\012cycle and there seems to be ... Candy 17 in. CS455 Built-in Dishwasher

We have a GE Profile Dishwasher Model GSD4430X66WW. It runs through the all cycles but at the end displays code PF and there is a couple of inches of water left in the bottom. If I hit the run cycle and then the reset, the water will drain and the code goes away. Any suggestions?


Pf means power failure. you may have a loose connection underneath where main wiring ties in in box. ... GE Dishwashers

I am getting a clicking/ticking noise (1 click/second) from my Maytag (model MDB9100)dishwasher after it goes through its auto clean normal wash cycle. At the end of the cycle the arrow = clean and the clicking sound is there. I opened the washer door for about 1 minute noted the soap containers are empty, dishes clean, machine still hot/steamy. Closed the washer door and the clicking sound resumes. Please advise.


This is the heated dry timer going through the drying cycle until the dishes are dry. The dry cycle runs on a timer and it will click through the cycle until it finishes the amount of time preset on the timer to dry the dishes. ... Maytag MDB9100A Dishwasher

Our LG dish washer leaves the dishes wet at the end of cycle. There is verry little to no water in the bottom, just on the dishes.the dishes are clean and warm when done, but wet. we use a rinse aid.


... LG LDF6810ST Stainless Steel Built-in Dishwasher

Dishes not washed properly. Have tried universal plus at 65deg, the water does not seem to get hot until it is in the main wash cycle. Used to use the universal cycle at 55deg with no problems. Also the dishes are still wet at the end particularly on the top shelf.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Check the water temperature by using a thermometer inside\015\012the dishwasher to measure the wat ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

Dishwasher The dishwasher detergent door opens during cycle but powdered soap remains in tray. At end of cycle glasses and dishes are wet. a little water is left undrained at bottom. This is a Frigidaire model FDB510LCS1. Checked upper and lower spray arms and they seem ok and pump seems to be working


I have seen this problem before on a couple of dishwashers.\015\012\015\012How are the dishes doing? Are they coming out clean, or do some of them "fail". \015\012\015\012If you rinse the dishes before putting them in the di ... Dishwashers

I have a Kenmore dishwasher, model 665.17019401 (serial number FS1002610). It goes through all cycles, drains out water, periodically, and dries the dishesat the end. But, when it ends, there is water at the bottom of the tub, at least 1 quart of water. I have to drain out the remaining water in the dishwasher. What is wrong?


Either the drain or screen is somewhat plugged, or a clog or jam in water pump. Many machines do leave just a little bit of water just so the sewer fumes don't come up. ... Kenmore Dishwashers

Does not seem like the dishwasher is drying like it used to. After it has gone through its entire cycle the is steam condensation on all the dishes and the inner door. Previously, at the end of cycle everything was bone dry when it was finished.


Have you run out of Rinse Aid ?This has a large effect on drying as well as how clean the dishes come out. Rinse aid [breaks up] the water dispersion, so at the end of the final rinse, the water just falls off the dishes, takes the sediment wit ... Kenmore Dishwashers

Westoint Dishwasher I have looked in the manual under troubleshooting tips, but didn't find anything on the problem. The dishwasher goes into cycle,but during the wash cycle it stops,makes alarm and the wash and rinse ligts come on. And now I can't even find the product on this site.Westpoint Dishwasher WQP12-9240. Thankyou My dishwasher is stopping at stage 2 of the programme after beeping once. Quite often the detergent flap doesn't open. Am at my wits end and threatening to leave home!!!! Th


Hi again,\015\012\015\012That should be OK. Just get in touch with your sales rep or his boss. Somebody there will be able to look up the record of the purchase. If they ask for model & serial numbers, you have them. You will find ... Dishwashers

Wet dishes At the end of the cycle, the dishes are consistently wet. I am not using the energy saving dry.


If the dry cycle has a problem, check these:Heating element ... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher

I have model 363.14779100 that has a problem. When a drain cycle is at the end and the fresh water starts coming in, the draining won't stop therefor all clean water goes right back out the drain. I can open the door latch and reshut it and the cycle will complete but the same thing happens on the next drainout. Is there a switch that needs replacing??


... Kenmore Dishwashers

Frigidaire model F71C12PHS0 is not washing, it goes through the cycle and when the door is opened the soap container is open with soap still in it. We have run it with the door open to see if it is spraying and it is. The heat is working because when we open it at the end of cycle it is hot. Yet soap is still there and dishes are not clean. Thanks to anyone who can help me trouble shoot this.


... Frigidaire 18 in. FDR252RB Built-in Dishwasher

Kenmore dishwasher. The upper rack is not getting clean. Even very light residue remains. And, detergent is left in door at end of cycle. The bottom is filling up, so I don't think it's the intake valve. Also, all the blade openings appear clear. I am noticing that hot water is not filling the dishwasher when I first run the cycle. Even if I have hot water running in the sink, the dishwasher fills with cold or warm water. So, I think this is the problem. What should I do? Thank you in advance!


I find it odd that the dishwasher is filling with cold water if the water is hot at the sink. It sounds like the dishwasher is connected to the cold water line rather than the hot. Check under your sink; if you've got standard plumbing, the dishwas ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1392 seconds