Having problems with your Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher ?

Motor noise I have this dishwasher since July, model # PDL2855RFC3, and lately there is a loud motor noise whenever the washer is in wash mode. Unrelated to this, I don't know what the symbol "HO" means. This comes up in the monitor during operation.


Answers :

Repair Help & Product Troubleshooting for Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Motor noise I have this dishwasher since July, model # PDL2855RFC3, and lately there is a loud motor noise whenever the washer is in wash mode. Unrelated to this, I don't know what the symbol "HO" means. This comes up in the monitor during operation.


... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Ok I didnt buy this Ariston dishwasher it came with the house I rented, They didnt have the manual and I dont know what the symbols mean


... Dishwashers

My fisher paykel DD603 fills with water at the start of the cycle and stops with the following error code and a beeping noise: - error U1 spanner symbol - crossed out faucet symbol. The water level is high enough that the spray arm is floating in the water. I am able to drain the water by entering the hardware diagnostics mode and running the motor in the drain direction. By removing the filter plate and examining the impellers I am not able to see visible damage. All filters are clean. The


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are spot on as error U1\015\012indicates that the dishwasher has twice tried to fill with the required amou ... Dishwashers

What do the symbols mean on my diswasheri have a slimeline carlton white dishwasher that i got form my gran and i dont know which setting to use


... Dishwashers

I have just aquired a Proline Logic dishwasher DWF1250 P but have no manual for this. I have no idea what all the symbols under the buttons mean so I dont know what wash to put it on. Please can you help, I cant find a manual to print. Thank you.


... Dishwashers

Baumatic (BKD62SS or BKD62W .3) Dishwasher will not do a normal load but will run in a strange start up mode I found. When I press the power button, select a cycle, then press start the dishwasher will no longer do anything. 5 seconds after pressing start it will make a light hum noise, a little like heating water. After about a minute the dishwasher won't have done anything. It will then beep 30 times with the third led on the set of four (don't know what it means) will flash a lot. The beeps t


... Dishwashers

My kenmore/whirlpool dishwasher makes a noise, sort of a grinding noise, throughout most of the cycle. I have removed the pump and motor thinking that their might be something in the pump, but there is nothing there. My guess is that the motor is making the noise, but I do not know how to tell other than by replacing the motor and seeing if the noise goes away.


Hi Thank You for usingFixYa. To start with check the pump and try to clean it out, then check drainhose for any obstruction. Also check for a bad bearing on the spray arm. Ifstill the is ... Dishwashers

Burning smell from our Dishwasher. I opened it up and found a little square brown thing attached to the motor - It has a terminal at one end that a white with a coloured stripe cable attaches to via a slip on terminal and 2 terminals to slot the little unit directly into the motor. Anyway, this little unit has obviously burnt out and this is the problem. Except my problem is that I dont know what this little unit is, so dont know what to ask for at the spare parts centre. Can anyone identify


... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

The same problem as everyone else with the motor continuous running, but it keeps happening about every 5 months. Know I have done the normal procedure it is making a fairly loud noise while running.


... Asko 24 in. D3112 Free-Standing Dishwasher

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

Operations manual Need to know where i can get a manual for my dishwasher as when we bought the house, one wasnt provided. Dont know what the cycles are all i know is how to turn it on and do a full cycle..dont know what the other buttons are for and I LOVE buttons...but...need to know what they are for


Get the model number from the dishwasher. Most brands have websites where you can find owners manuals and print them off. ... Dishwashers

The eco light is flashing constantly on my Dishlex Global 300 dishwasher, it is making a noise like a pump is running continously, but the unit will not operate. Can you give me some possible faults and solutions. Regards Dave I have the same problem. The Eco light flashes and there is some sort of noise, not sure if it is a pump or a solenoid, but thats as far as it goes. A friend gave me the machine after aservice tech told him the main washer motor was gone. i have fitted a new motor, but


Its an overflow of water into the base of the machine.There is a float switch in the base of the machine in a small plastic dish.There is a metal cover with 2 small bolts that have to be removed to get to it.get the overflow c ... Dishwashers

One of the lid actuator motors died on my F&P DD603 dishwasher and was replaced by the serviceman. He put the machine in a test mode and pressed a code to try the operation while the drawer was open. I witnessed the lid closing properly. Now it appears that the other actuator is faulty. To save an extremely expensive service call, how can I put the machine in test mode and verify the actuator operation with the drawer open?


To test the lid operation first pull the drawer forward of the cabinet\015\012by depressing the lugs on each side rail and pulling the drawer\015\012forward. Then go into diagnostic mode. Once there press power once and\015\012the lcd will display "H ... Dishwashers

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

I have a Kenmore diswasher model 587 1525. I can hear the water filling and rinsing, but during the wash cycle I do not hear the motor. At the end of the wash cycle and when I open the door I see the detergent tablet is sitting on the floor. The dishes are not cleaned. Does this mean that the motor has failed or is it the control card. I can hear some clicking noise while the motor should be running. Maybe solenoids cycling.


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

5.5 HP Honda on a Karcher pressure washer. Will only run in full choke mode. When choke is closed for normal operation, motor conks out. I have removed Air filter and inspected operation and butterfly is operating correctly. What to check next?


Fuel mixture screw ... Pressure Washers

Dishwasher fills with hot water. Float OK - water feed stops when full. Motor humms but no water spray (in all opperating modes). Cancel selection (with cancel button) and close the door. The water drains then the unit shuts off. Water feed OK. Drain Cycle OK. Looks like spray pump hung but do not know. Cannot find a reset button (as with disposal) or way to free hung pump motor. I did see glass pieces in the drain. Possibly a small piece hanging the motor.


If you found broken glass inside the machine some has likely migrated to the pump. about the only way to fix that issue is to remove the pump and either replace it or disassemble it and clean it out. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

I have purchased the midea dishwasher WQP 12-9011, but i dont have the user manual, i dont know how to operate? please help.can you send user manual?


... Dishwashers

Hi, i want to have a manual of the whirlpool dishwasher coz we dont have manual on it and we dont know how to operate,we just bought this yesterday and the electrician who install this he bring the manual/guide, please give me the site where i can get it. thanks.


MAy I get the make and model # to help you find the manual ... Whirlpool Dishwashers

Dishwasher fdw60g fault lights i have the eco and prewash light flashing. i know that this means the filter is blocked. i have cleaned the filters and checked the hoses for blockages and they are all clear and kink free. i have tipped the machine on its side and checked the pump , which is clear aswel. i dont know what to try next to get the machine working and the lights to stop. thanks


... Dishwashers

On my Dishwasher screen it say's AL10.And i dont know what it means that happens when finishes washes ,and i don't know what the fault is . could u possibly help?


... Hotpoint 18 in. DC28 Slim-Line Built-in Dishwasher

Bosch Dishwasher I have just moved into my flat where there is a Bosch dishwaher installed in the kitchen. I have tried on a number of times to get the dishwasher to start a programme but for some reason it fails to start. It does switch on but I dont know how to operate it. I dont have a manual for it so have not a clue what to press to get the programmes running. I would be grateful if you could help. Bosch Dishwasher logixx Model Number SGS6952GB/13 Installed 2001


Dear Saps,\015\012Go to https://portal.bsh-partner.com/portal(bD1kZSZjPTAwOQ==)/PORTALFRAME.HTM for a pdf download for an Intr ... Dishwashers

The wash cycle seems to take hours. the water wont drain away and i get a little blinky light on the front. i dont have the manual either so i dont even know what the arrow buttons mean on the front of the machine


... Zanussi 24 in. IZZI ALU Built-In Dishwasher

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

I have a slimline CDA dishwasher, when i turn it on it makes a noise like it is draining but doesnt start. My son put it on in my absence. i dont know what he did but when i came to it it was full of suds and making a draining noise.


... CDA Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0702 seconds