Having problems with your Equator 20 in. PLS602 Free-Standing Dishwasher ?

My Equator door hinge broke to. Where can I get parts for the little PLS602S? I ordered a door for it once before about six years ago. But do not still have the information on the place where I ordered it.


Answers :

Repair Help & Product Troubleshooting for Equator 20 in. PLS602 Free-Standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Equator door hinge broke to. Where can I get parts for the little PLS602S? I ordered a door for it once before about six years ago. But do not still have the information on the place where I ordered it.


... Equator 20 in. PLS602 Free-Standing Dishwasher

Double dash on display and when put in service/maintenance mode, all the lights came on and stayed on overnight. Still not working until I tested the door switch. It looks like poor engineering on the design. Plastic bar that depressed the door switch was not pushing all the way. It appears that the bar was bent to compensate for the too close tolerances and after the depressing of the switch for six years it did not reach anymore. So I got hair dryer, heated the plastic bar and bent it down to


... Kenmore 24 in. 15932 Built-in Dishwasher

My SHE43 Bosch DW will not pump the water out after the last cycle. The service guy said the Door latch was broken and replaced it. but the problem still exist. He now say that the water lines are freezing up because the DW is on an outside wall. The Thermador DW that was replaced never had this problem during the 15 years it was located in the same place. Could this be a bad design? Help!!!


I\015\012\015\012\015\012\015\012 the water doesn't drain from your dishwasher, check these:Drain line/air gap ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Top spray bar had stopped spraying - can open door quickly and the bar is not turning -- also can put bar in one place and run machine, when you open door bar is still in exact same place.


Means either water line from pump to upper bar is clogged or pump is broken. My guess is the first ... Maytag Dishwashers

Leaking This is a problem that I have when the dishwasher is in drying mode. I will find a 5X5 and sometimes smaller, size water spot under the dishwasher after the dishwasher has stopped. I was told it was the vent were the steam comes out and I had that replaced. It still leaks, then they told me to replace the rubber around the door, still leaks now they order a whole new plastic interior door. Please if you have any ideas what could be causing the problem, please let me know. Thank you


\015\012open the bottom panel 2-4 screw\015\012take a flashlight and turn the machine on\015\012see where it come from\015\012if you need take the unit out a bit f ... Jenn-Air JDB4000AWS Stainless Steel Dishwasher

Hi...I have a Westinghouse Freestyle 921 Dishwasher...9 years young...Model SB921SG...that has recently been leaking from the bottom right hand side front corner of the door when performing its usual heavy duty cycle...It appears that the main door seal has significantly perished and is causing the problem...Therefore I have purchased a new Door Gasket part no.0208400069 from a recommended spare parts agent in Brisbane and after several attempts to re-fit this gasket/seal to the door...I still h


... Dishwashers

We have a Kenmore portable Dishwasher one and a half years old. It ran fine for about 6 months then we saw a water leak from the lower right hand corner of the door. I cleaned the door gasket. It stop leaking for a while. It started leaking again. Cleaned and rest the door gasket again. It is still leaking. Unit drains fine and all other functions are correct. What is the fix?


... Kenmore Dishwashers

Model no. MDB6100AWW. Just unloaded the dishwasher. Shut the door and immediately heard clicking (regular cadence). All indicator lights (arrow-shaped) for clean, dry, wash and heating delay were blinking. Opened the door, waited a few minutes, closed the door. Now, just the "Clean" and "6 Hour" arrow indicator lights and "Heated Dry" button light indicator are still blinking continuously. Cannot override. What's going on? Dishwasher came with the house when we purchased it 6 years ago. Proba


Hi Thanks for using FixYa. To resolve this you will have to reset the console. Do this by closing the door and press these buttons in sequence...-high temp wash-heated dry ... Maytag 24 in. MDB6100A Built-in Dishwasher

I have a westinghouse SB916 dishwasher - 2 years old. It is not disssolving the powerball.When the cycle is finished the un dissolved powerball is still sitting in the open door. So I re run the cycle putting the powerball in the cutlery holder - sometimes that works sometimes it is still not fully dissolved. I have tried putting it straight into the cutlery holder but it still does not dissolve. Any ideas?


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Westinghouse Dishwashers

We getting the error message LE on the dishwaser model #LDF6810ST. The repair Official repair man that came out to supposedly fix the dishwasher called LG to find out what was wrong with it and they told him to tell us that we need to replace the motor and wiring harness and the Technician told us to order the "motor and wiring harness" charged us $100 and left and the dishwasher that is only 2 years old and we paid a little over $800 for is still broke. Now when trying to order the "motor and w


Motor assy pn# 4681ED1004A is the motor you will need. ... LG Dishwashers

A built in whirlpool dishwasher is leaking around the door seal, right side to be more specific. cleaned the seal, and along the bottom and it still leaks. Is there an adjustment that can be made to tighten the door. I wouldnt think it would be the seal itself do to being less than 2 years old. Thankyou for this service.


Hi,There is no adjustment per say on this door or seal. If water spray directly on the door it can cause this, what I mean by that is if the spray arm, either the upper or lower is stuck and continually sprays in one place it can cause th ... Whirlpool Dishwashers

Kudc10fxss4 I have a KitchenAid KUDC10FXSS4 w/o any power. Circuit breaker is on, and it's getting power. But there are no lights on the display. I called a parts place to see if I could order a thermal cut off fuse. But the representative stated there is no fuse listed for this model. Any ideas on what would be causing a loss of power? Seems odd/wrong to me that there wouldn't be a fuse. If there is a fuse, would it be located in the door (the control is built into the door, such


... KitchenAid Dishwashers

I have a Bosch Model SHE43F Dishwasher, only 1.5 years old. The door will not lock all the way like the latch is broke. But the dishwasher still works as normal without locking the door. The last time I used everything was ok. Looks like a programming problem, or latch mechanism broken.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. From what you have described the\015\012issue seems to be with latch mechanism as the Dishwasher is worki ... Bosch 18 in. SRV43M03 Built-in Dishwasher

We have the same problem. At first, we were getting a horrible detergent film on everything. We thought that was because the detergent cup wasn't opening or the water was too hard or not hot enough. We kicked up the rinse agent as high as possible, switched to a liquid detergent, and only placed shorter items towards the door. The cup still wouldn't open consistently and our dishes still needed to be re-cleaned. We stopped closing the cup. No change. Why would liquid detergent leave a powder fil


You dont need a new dishwasher. it is your water that is causing the film and residue. go to www.dishwasherfilter.com. they have an awesome product that is affordable and g ... Dishwashers

Can i order new door springs for a single door dish washer approx 7 years old


Yes,\015\012Follow this tip and it will guide you on how you can order parts for your dishwasher online...\015\012\015\012http://www.fixya.c ... Fisher and Paykel Dishwashers

The door on my Frigidaire dishwasher recently began opening too far. It slants toward the floor, a few degrees past level. Looking at it, however, nothing seems to be broken or missing. The springs are still in place just fine. The door stops when the metal arm hits the stopper, so I don't know how it ever stopped at the level.


I have the same problem. The springs look intact. Maybe some stepped on the door when it was opened and it stretched the springs. I'm going to replace them and see what happens ... Dishwashers

My dishwasher emits a dead animal smell immediately after filling. I have a 20-year-old KitchenAid KUDS220T3 dishwasher. The racks are a little corroded, but it still cleans dishes just fine. About two months ago, it started smelling like a dead animal immediately after the dishwasher fills with hot water, during the time the water is being heated, but before agitation begins. The smell appears to be coming from around the door. If I open the door, everything inside the dishwasher smells fine.


This vent that you are describing is to allow air to flow in for the heat/dry cycle. Some times little creatures want to "mark" their territory by "spraying". Spray some type of cleaner like ammonia into it and **** it out with vacuum a few times. Mo ... KitchenAid Dishwashers

My 20 year old dishwaher just broke its lock. Somehow it seized when I locked the door. My husband took it out but we still cannot open its door and take out the dishes. The handle fell out when he tried to open it. How can we access to open it?


YOU HAVE ELIMINATED THE EASY WAYS, ARE YOU PLANNING ON REPLACING IT OR REPAIR, IF REPAIR CALL A TECH. IF REPLACE, THE LOCK MECHANISM IS AT THE TOP CENTER OF BODY. ACCESS WOULD REQUIRE REMOVAL OF D/W, AND ASSOCIATED CLEAN UP OF THE WATER LEFT. JUST RE ... Dishwashers

Our maytag is about ten years old. No big problems that a little vinegar wouldn't solve once in awhile. Lately, we ran out of water softener salt and a white film was on dishes and not getting clean. I filled the water softener again, and did the vinegar wash, which helped a little. Now dishes not getting clean. I got desperate and did an empty load with CLR in it. Still, not effective. I feel as if something is clogged with lime or calcium since a pan placed in there on bottom shelf still had


The problem is hard water. www.dishwasherfilter.com has a product to solve this problem once and for all. It filters the water going into your dishwasher and removes the ... Maytag 24 in. MDB4100 Built-in Dishwasher

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

I have a Whirlpool Dishwasher model number DU8400XB-1 it has leaked at the bottom left side for a while and now all the way across. I removed the inside of the door and saw that the splatter shield had come loose. I put it make in place but still have leaking. any advice


Drum maybe the problem ... Dishwashers

I need a 7022-140a02 power switch for a McCullouh high pressure washer FH180B. Every were I have tried to order, I am told the part is not available anymore. This is a maintenance part in the McCullouh parts manual. I thought parts were available for 10 years, they are still selling this pressure washer;


I need a 7022-140a02 power switch for a McCullouh high pressure washer FH180B. ... McCulloch FH180A Electric Pressure Washer

Nasty dishwasher there is nasty wet grunge at the bottom of the door, around the place the heating unit in the bottom of the dishwasher. half the time the dishes are clean in the bottom of the dishwasher. half the heating element is melted..for some reason...what do i do. the dishwasher still works, if we make sure the dishes are clean before they go in. using more for a sanitation thing than a dishwasher. can ya'll help me?


Sounds like your heating element is broken and you should replace it to prevent a possible fire hazard. \015\012You can replace the element easily for not alot of cash. You'll need to pick up a new one at an appliance parts store, just bring them the ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

My dishwasher is 6 years old it started making clicking and knocking sounds about a week ago. The display is blinking crazy at about 37 minutes left in washing cylce it blinks 37, HO, and CL. It blinks other numbers also. The water still seems to be flowing in and out fine. It's heating up and draining when canceled. I'm running it on normal wash and high temp. cycle. It sounds like the sensing parts in the door are going off and on.


... Frigidaire 24 in. PLDS9999CC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1088 seconds