Having problems with your Fagor LFA-073 IT Dishwasher ?

F2 Hello, i have figor lf 073it dishwasher. wen i start it it says F2 water not entering the maschine. someone can help me with that? thanks !


Answers :

Repair Help & Product Troubleshooting for Fagor LFA-073 IT Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

F2 Hello, i have figor lf 073it dishwasher. wen i start it it says F2 water not entering the maschine. someone can help me with that? thanks !


... Fagor LFA-073 IT Dishwasher

We just hooked up our old built in GE dishwasher and the water is shooting out the left side of the unit where the black water hose enters the tub. Shouldn't the water be entering into the wash arm? The hose isn't clogged. It attaches to a white plastic piece that is part of the unit itself. The water is entering both the tub but also shooting out of 2 slits approx 1 1/2" each. located right below where u attach the hose.. Any help would be greatly appreciated!


... GE GSD5130 Dishwasher

Got a hoover hed 6612/80 been working fine today all four lights flashing and beeping. manual says too much water inlet. one soltion on here says to check water inlet sensor. How do i do this. please help.


... Hoover Dishwashers

I own a karcher water blaster 449M and needs an expert to solve the pomblem It does not bring out the presure required to the right job and makes a noise as well when you start it can someone please let help me in solving the delema my self or by repairing it by an expert I LIVE IN SYDNEY AUSTRALIA IN THE SUBERB ROSELANDS CAN SOMEONE LET ME KNOW OF A DEALER OR REPAIRER CLOSE BY THANK YOU FOR YUOR TIME AND HELP IN READING


Sounds as if you have a pump problem. your best bet is to go online to maker or a dealer near you for service help.you may wind up having to replace pump. ... Karcher 2500 PSI Pressure Washer

My dishwasher will not start. It is a frigidaire / electrolux FDB1050REQ. I have checked thepower....and reset the circuit breaker.......then pushed the start button.....the light comes on on the front of the washer like normal but no water starts filling. I have jiggled the anti water overfill device but still nothing. HELP!!! The front of the dishwasher says Frigidaire, however, the inside of the door where the model# is says Electrolux


... Frigidaire Dishwashers

Dishwasher sounds as if it starts cycle, then stops, bleeps, and Fat and prewash lights come on. Manual says to turn off machine, turn off tap, wait 30 seconds and turn it all back on, but it doesn't make any difference. Manual says 'If the above does not solve the problem, check that the water feed pipe is not blocked' however, it doesn't say where this is, or how to do it. Please help!


Hi.You need to check the water inlet hose, that is the hose connected to house water faucet at the back of the dishwasher.Checck for blockage in the hose and ensure that the inlet hose is not blocked or kinked.If t ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have the Whirlpool washer model # wtw5300vw2. What is the accurate amount of water this washer should use PER FULL LOAD/COMPLETE CYCLE on the super load with NO extra rinse? Reason being... Google isn't helping me here. I check my mention before and after I washed it says I am using 145 gallons of water PER COMPLETE CYCLE. Is that right, or no? That seems very high to me. I called the water company to have them check our meter. The meter is working fine. Guess we was comparing it with our


... Dishwashers

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

I NEED HELP CLEANING OUT MY FILTER ON MY HOTPOINT DISHWASHER..... WHEN WE GO TO RUN IT THE WATER STAY'S IN THE BOTTOM AND WILL NOT DRAIN OUT SO PLEASE HELP ME FIX MY PROBLEM CUZ I CANNOT AFFORD RIGHT NOW SOMEONE COMING OUT TO LOOK AT IT SO IF I CAN FIX IT MYSELF THAT WOULD BE GREAT AND WITH YOUR ALL'S HELP IF YOU WILL THANKS ALICIA


I f you have warranty on this please call them, you have a defective\015\012D/W.Unless there is no charge for repairs ,don't spend a dollar on what\015\012is going to be a on going problem ahead.To explain how to fix this is\015\012what the manufactu ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a brand new Miele dishwasher which has worked grate since it was installed 2 weeks ago. It keeps shutting itself off & indicates an F13 fault. I looked in the manual, see that water is going in fine & pressure is good. It then says to clean water intake filter. How do I get to that ? I don't have a user maintenance manual. I'm on city water & doubt that the filter is clogged but My wife will kill me if I don't get it fixed today. Can anyone help. Glenn


On my Miele 1220 dishwasher, the inlet filter is inside the inlet hose connector, where it screws onto the water supply. To clean it:\015\012\015\0121. Turn off the stopcock.\015\0122. Unscrew the inlet hose.\015\0123. Remove the black rubber s ... Dishwashers

2 weeks ago, I had a plumber come and put in a new garbage diposer and since then somewhat old/dirty water seems to be sitting at the bottom after all cycles are done. I calle dhim back and he says that there is no problem in the plumbing but more with the pump. I even use the wt/dry vac and removed water and ran it but still comes back with water at the bottom. also the dishes smell like soap. Help!!!


The plumber did not make an air gap in the dishwasher drain hose when he reattached it to the new disposal. Look under your sink, does the hose (attached to the disposal) go down and through the cabinet? If so, that is definitely the issue. Simple ... GE 24 in. Profile PDW7800 Built-in Dishwasher

I have an Indesit IDL 42 dishwasher. It has entered a state in which it behaves like this: as soon as I turn it on, it starts swishing the water around (it doesn't pump it out) and it does that regardless of whether I press any buttons (I have tried Start, Reset, turning the program knob, no difference at all). When I open it in the middle of this cycle, the water drips, and there is plenty of water (about 1 in) at the bottom. I have checked the filter, it is clean. Can you please help?


... Dishwashers

My dishwasher is SHU 3000 series and over 10 years old. The problem is SUDS that will not go away. I have used on-line methods such as vinegar. I have gone through 6 bottles of "Dishwasher Magic" and have put it through cycles not using soap over 30 times and am still getting suds even at the end of the rinse cycle. I have called a local repairman and he says he cannot help me..that I should continue running the dishwasher time after time till the water is w/o suds. Any help for me?


... Bosch Dishwashers

My SHE43 Bosch DW will not pump the water out after the last cycle. The service guy said the Door latch was broken and replaced it. but the problem still exist. He now say that the water lines are freezing up because the DW is on an outside wall. The Thermador DW that was replaced never had this problem during the 15 years it was located in the same place. Could this be a bad design? Help!!!


I\015\012\015\012\015\012\015\012 the water doesn't drain from your dishwasher, check these:Drain line/air gap ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have been running into alot of ge /hotpoint dishwasher with a little water near the pump screen the drain hose is tied up and the check valve in the bottom back appears to be good is that normal help please customers are saying they have never seen water in it before


Hi,This is a common problem. In most of the Hotpoint dishwashers, right at the back of the tube, there is a long screen. You need to take that off. You would see the piston and the nut -it's what is causing the problem.Tap the nibs to loo ... Dishwashers

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

Hi, I get a problem reading " E4". I have now switched the machine off and on again, but still it says the same. Incidentally the machine has already pumped the water out, so the 'overfill" is actually not supposed to be a problem. It is KELVINATOR EXTREME CLEAN DISHWASHER, model KD14SS. Please help, how am I to get rid of this problem, I really do not have the time nor the money to get outside help! Anita Kleynhans


... Kelvinator MDP531RF Dishwasher

Viking dishwasher code says water line problem, but water enters the dishwasher 1st cycle then stops.


... Viking DFUD142 Built-in Dishwasher

Hello I just borrowed a k archer k 2.87 water blaster from a friend and forgot to turn water on before starting motor. Motor stopped after a few seconds and now won't start. Online guide says to change fuse but nz version doesnt have fuse in plug. Do i have to take machine apart?HELP Please!


Most of the time it is the GFCI on the end of the plug that goes bad. If it were me I would cut off the GFCI and wire in a standard 120v plug. If it still doesn't work after that then there is a good chance that something electric internally has gone ... Karcher PSI Electric Pressure Washer

My aeg favorit integral dishwasher is flashing 20, and there is water still in the bottom that will not drain away please help. and every time i put the dishwasher on it starts but after a couple of minutes it stops beeps intermittently and says code 20! please help thanks


... AEG 24 in. Favorit 60830 Free-standing Dishwasher

My viking dishwasher is blinking normal wash and light china wash and water is on he bottom of the pan. I have tried cancel restarting it nothing is working. The water is very hot also. Thank you... someone please help!


... Viking 24 in. Professional Series DFUD140 (Premium) Built-in Dishwasher

Indicator lights say there is no water entering the machine. The pipe sounds and feels like there is water flowing but it is not getting into the machine itself


If water is flowing, then you should see water enter the DW. You should also feel the water line becoming warm or hot, depending on if metal (copper), insulated metal (copper), or plastic.If the water valve is partially restricted due to accumu ... Fagor LFA-073 IT Dishwasher

LCD control panel keeps on beeping and saying to check water supply. We have plenty of water and I am not sure what to do. Thanks for the help! Heather


... Bosch Evolution 800 SHE98M05UC Stainless Steel Dishwasher

Hello everybody, I hope that you gona a give me some tips for repairing my dishwasher mashine. A few days ago, the error F2 appears on my dishwasher machine (Baucknecht GSI 5894) I checked the pump for the waste water is ok. the tap water is not taking in,I checked the hoses they are ok as well I turned off and on and same time pressed the button reset and choosing the programm on the dishwasher few seconds trying to start and again apperas F2 . Hopefully someone can help me. Best regard


Possible the inlet valve has given up and is not allowing water in.\012Also possible there is a slight leak enough to shut the water off (safety feature) - Check underneath for a float mechanism and any water there. ... Bauknecht Dishwashers

New dishwasher hotpoint lft114 model just installed, however no water is going in machine, yes have checked all pipes etc , you can hear water then the lights all flash . on calling engineer they said u have to programme it first time? though does not say this in manual ??? HELP !!


... Hotpoint Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1666 seconds