Having problems with your Fagor LFA-073 IT Dishwasher ?

FAGOR DISHWASHER LFU073IT WITH F9 COMING UP ON DISPLAY


Answers :

Problem with the distributor motor. It is a small white plastic part which receives water from the heater, and alternatively distributes water to upper or lower difussors. If the motor locks, or the internal sensor doesn't sense the position well, it will show F9. Motor can be repaired in most cases, and at last, it can be swaped
Repair Help & Product Troubleshooting for Fagor LFA-073 IT Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

FAGOR DISHWASHER LFU073IT WITH F9 COMING UP ON DISPLAY


Problem with the distributor motor. It is a small white plastic part which receives water from the heater, and alternatively distributes water to upper or lower difussors. If the motor locks, or the internal sensor doesn't sense the position well, it ... Fagor LFA-073 IT Dishwasher

Fagor LFU073IT INTERGRATED DISHWASHER F6 FAULT COMING ON ASO WATER IN BOTTOM


... Fagor Dishwashers

Fagor dishwasher Model 2LF-013SX-was working till last week. Now, putting on the main switch, a sound is heard at the bottom of the machine even without switching on the machine.The display is not coming on. Please advise on what to do. My e-mail address is: [email protected] bought in Dubai & I am at present residing in Bangalore, India


... Dishwashers

I have a Maytag QuietSeries 300 dishwasher. My original problem was with the control panel lights not coming on. Another repair website recommended replacing the circuit board. We replaced the board, but it did not solve the problem & the dishwasher would not work. Replaced the control panel. Lights come on, but when the start button is pushed "21" flashes on the time display. What do I do?


HI,Just visit this link HERE and your problem will be solved.Goodluck,Please don't forget to rate the solution. ... Dishwashers

Fagor Dishwasher My Fagor DW suddenly has no water coming in but the motor is running. The cycle starts for about 3 mins then sounds a bit painful followed by all the warning lights coming on and beeping. I live in Spain and am not good with the lingo so am worried about calling anyone out. I've checked the water in pipe which is OK. Help!!!!!!!!!!!! (Please)


Ok if you have a volt meter then remove the bottom kick-plate locate the water valve take the connector off the valve set the meter to ac volts plug the leads into the connector turn the timer to fill if y ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

I have a Frigidaire Model Number GLD4355RFS1 Serial Number TH80493988 Dishwasher. It quit working when the Rinsing Agent Low light came on. We filled the rinding Agen dispenser with hopes that it would come back on. The Rinsing Agent Low light went off but the unit never came back to life. When the room is totally dark, you can just barely see the lights in the LED display and other lights. It will not come back on. I tied turing the power off and the "PH" alert is displayed in t


... Frigidaire Dishwashers

I have a bd 1681 60cm electronic dishwasher, set dishwasher to rapid setting, dishwasher starts water and then drains again code e1 will then come onto display. could you source problem please


... Baumatic Dishwashers

No Water Coming Into SHU43C05UC/12 Bosch Dishwasher: We have a Bosch Dishwasher, model number SHU43C05UC/12. It has been working for more than 4 years, but yesterday I notice that although I hear a motor sound, there is no water in the dishwasher. The LED display on the panel seems to be working all right. I ran a diagnostic pressing and holding Power Scrub and regular wash button then pressing the on/off button. Got C1 at start then P0 and the Regular wash and Quick wash flashing on/off. How c


... Dishwashers

I have a Frigidaire 1500 series with fully electronic control dishwasher. When I try to start it all the lights come on the display but not water enters the dishwasher. I have tried various settings including delay start but still the same outcome. The over-fill protector in the bottom of the dishwasher moves freely. What else should I try?


... Frigidaire Dishwashers

I have a Bosch Dishwasher, Model Number SHX46L, Serial Number 860200524 that is no working properly. After running a cycle, it did not pump out all of the water, though the water is very clear, and the dishwasher does not display that there is any electricity going to it. I have verified the is 120 Volts AC at the appliance junction box. However the dishwasher will not turn on, and no lights will come on? Do you have any suggestions? I would appreciate it if you would let me know what you


... Bosch SHX46L1xUC Dishwasher

My Frigidaire dishwasher keeps showing the Er uo codo on the display. It used to would finish a load even though it would stop for a while when the error message came up, but now it will not run at all when the error message comes up. I read on this site that the Er uo has to do with the vent. I pulled the dishwasher out and removed the vent. I turned the dishwasher on and the vent opened and closed about three times when the cycle started, then it stopped and the error message came up. Is


Hi. This code is in reference to the vent assembly. This may also be a control fault, as well. To isolate the culprit, you will need to make sure that the vent assembly is not blocked. If it is blocked, it must be replaced. Restricted air flow will c ... Dishwashers

I have a dishwasher model number FGHD2433KWI...I have no display showing but I do have power. It is not coming on and am wondering if the button to start is not working properly. Needing to know how t


... Frigidaire Dishwashers

Fagor lff024 dishwasher displays fault f4


... Dishwashers

Lights on Dishwasher light up but nothing happens. When I reset power it lights up the high temp and sanitize button light up and LED displays PF. After I open the door they stop flashing. the far left five buttons light up when I push them and a corresponding number displays on the LED screen. the only lights that do not come on are the Delay button and power button. Don't know if they are working or just don't light up. No matter what lights up the unit does not turn on....:( ? help can't fin


Pf is power failure\015\012 your loosing voltage to the unit \015\012it may just be the door switch or it could be in the control\015\012 try starting the unit but keep your hand on the unit pushing the door in place,, its not a g ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher

I have a necht dishwasher, i use all in one tablets but after using the dishwasher for 7 months, the fill the salt and rinse aid sign has lit up on the display, also E4 comes on when i turn it on


... Dishwashers

John Lewis JLDWW906 Slimline Dishwasher, White. Hi all, have a problem with my dishwasher. The display is showing an error of i30. Can't reset it. Have checked the filter etc and everything seems fine. John Lewis technical advice not open till Monday and engineer can't come till Thurs. Help? Thanks


... Dishwashers

I have a Bosch SHU43C05UC diswasher. Last night, I put it on before going to bed as usual. I was awakened a couple of hours later to a loud grinding sound (like a pump being run dry), and found the noise coming from the dishwasher. The display read "0" time remaining, so I opened the door and the dishes seemed clean, so I left it shut off. Tonight I have been trying to troubleshoot the problem. The dishwasher will turn on, but it will not seem to fill with water. I have verified that the


Ok well before you can do anything you must obtain a service manual, link below.\015\012\015\012http://allrepairmanuals.com/bosch ... Dishwashers

Hotpoint Dishwasher: HLD404M15SA. I installed the never used dishwasher and the Display Lights don't work. The unit operterates just fine. I tried the reset and powering off a few times, still not even a blink. It didn't come from a dealer, so I don't think the warranty would be an option.


... Dishwashers

Hello, I've been working on a Bosch Dishwasher. It has no display of any kind, and there's a strange grunting sound coming from the wash motor when power is applied (like if you had just plugged it in), as if it's trying to start. The junction box is getting 120V, all connections to the junction box are fine, and the display board and the main control board are all getting the proper voltage. Now, we've already replaced the main control board and the problem persists. The tech line suggested


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

I have a white lg dishwasher model no. LD-14AW3. Our dishwasher is not cleaning our dishes properly. We have put a Finish cleaner through it but it still has bits left on plates cutlery etc. We don't hear the water splashing up against the door as much as what we used to. Other than that there are no strange noises coming from it. no error messages/codes appear on the display either.


... Dishwashers

Maytag dishwasher model MDC4650AWW. Light display comes on except for start button and delay button. Will not start.


... Maytag MDB9600A Jetclean II Built-in Dishwasher

Dishwasher appears not to have power. No lights come on panel display and water was collected on bottom of washer that I manually removed. What could be the problem with panel?


There may be a problem with your panel yes.\015\012however the first thing to check is the main power supplied to the unit under the right front side and make sure that all the wires are connected properly\015\012as well as you circuit br ... Dishwashers

LFO 73 IT Fagor dishwasher - will not turn on, display will not light up properly to register programme. Any ideas?


... Fagor LFA-073 IT Dishwasher

GLDB958AQ0 Lights on panel light up then go off after a few seconds upon startup. Sometimes they stay on and the timer in the display window counts down the minutes, but in either case no sounds come from the dishwasher nor does any water enter the unit. The water is turned on and there are no kinks in the supply line. I removed the water valve and could not blow through it. Upon applying current to the valve I could blow through it but it still seemed restricted. Should I be able to blow thr


... Frigidaire 24 in. GLDB958A Energy Star® Built-in Dishwasher

Bosch dishwaser I have Bosch 5306 dishwasher, the display has H2 that comes on when sycle starts.


WHAT IS WRONG WITH YOUR DISHWASHER? For a detailed Dishwasher illustration, click below. ... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1944 seconds