Having problems with your FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length ?

I have two questions and would greatly appreciate some help: - What oil to use in the pressure pump of a Ryobi Pressure Washer RY80030? - How much to put in? The pump model is MTP092150 from FAIP. As per the manufacturer, the oil is not to be changed or topped up by the end-user, I know, I know, but brought to a service center instead - I certainly don't want to do that, and there is none close to my place anyway. The reason I need this is that I had to take the pump apart and a


Answers :

Repair Help & Product Troubleshooting for FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have two questions and would greatly appreciate some help: - What oil to use in the pressure pump of a Ryobi Pressure Washer RY80030? - How much to put in? The pump model is MTP092150 from FAIP. As per the manufacturer, the oil is not to be changed or topped up by the end-user, I know, I know, but brought to a service center instead - I certainly don't want to do that, and there is none close to my place anyway. The reason I need this is that I had to take the pump apart and a


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

I have a sears pressure washer, model 580752300. The pump on the underside vibrated lose and broke a couple screws. It came off and the oil drained out. I replaced the screws and it's ready to go except I can't find out how much replacement oil to put back in. Sears has larger containers but won't tell you how much oil to put in. However, there's a pricey pre-measured container they want to make you buy. Anybody know how much oil goes in that pump?


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

Starts but does not keep running. checked oil & its full. do you need water pressure at the pump? I know it has a low oil pressure cut off.


First: check and change the spark plug and do a oil change (OIL IS NOT THE PROBLEM BUT IS GOOD TO DO IT) then do a test with fresh gasoline.\012Second:check all fuel components (LINES,CARB,ETC...)\012Third:if any of this fix the problem ... Dewalt DPD3100 Gas Pressure Washer

I need to know what kind of oil the pressure washer takes, I noticed it has a place for oil on the engine and another neat the pump. The product is a honda pressure wave 220 PSI Model NO 2225cwh-2


... Honda Maxus Prosumer MX5223 Pressure Washer

I bought a troybuilt pressure washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight glass. Does anyone know whats wrong?


If you left it sit for a while & did not turn the fuel tap off,it may have flooded and therefore the oil level would have risen causing the oil to over flow.\015\012\015\012always turn the fuel tap off when not using your pressure wahser. ... Honda Pressure Washer PSI 3000

I have a troy build pressure washer model number 020337 Do I need to change the oil in the pump, and if yes how do I drain it and what kind of oil. I know how to change the engine oil


The pump requires no maintenance and no oil change. It is lubricated for life. ... Karcher 2500 PSI Pressure Washer

I have a GENERAC brand pressure washer.I am not familure with these.I have no manual.So,what my question is....Do the pumps require oil or not?If mine does,where in the heck do you put it?And what type is it of oil is it?I need to know! THANKS!


I would love to help you ,but unless we can get an idea what size it is how much pressure it does etc its abit hard ,it will reqire oil, non foaming oil.my suggestionwould be to go to a shop that deals in these things and see if you can see one like ... Pressure Washers

My dishwasher is not draining. i have inspected and cleaned what I can. the drain tube into my plumbing/and my plumbing is not restricted. i dont know if the psi pump is the same as the drain pump ,but I have lots of pressure while the washer is running.


Hello there:\015\012 The water doesn't drain from the machine \015\012\011 \015\012 ... Whirlpool GU2400XTP Built-in Dishwasher

Pressure washer pump oil


... Apache Pressure Washers

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

I have a power mate black max 1800 psi 5.5 hp ohv pressure washer i need to know what kind of oil for the engine is used and the pump fluid thank you


... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

What kind of oil do you use in a Campbell Hausfeld pressure washer pump? We are using my dads and we dont have an owners manual thanks


The pump uses SAE20 or SAE 30 non-detergent motor oil that fills up about half wayThe engine uses 10-W30 motor oil that comes a bit ... Campbell Hausfeld PW2102 Gas Pressure Washer

I have a Pressure Washer VR2500 , 6.5 horsepower / 2500 PSI number on side 123K12-0134-E Residential - Excell. I do not know which is the oil drain plug for the Pump on the bottom. There is an Allens Wrench plug on the side. However when removed nothing comes out. There is also an Alans Wrench like plug towards the back, that does not want to come out. Which one is the correct plug and do you have a picture as I could not order an Owners Manual on-line? Please Advise!


Hi and welcome to FixYa, I am Kelly \015\012First here is the owders manual: \015\012http://www.excellpressurewasher.com/documents/p ... Comet GXD2527G Pressure Washer Pump

I need to know what kind of oil & how much to fill a Giant pressure pump model # hr20


... Pressure Washers

I have a Briggs Stratton Model# 020228 Gasoline Pressure washer with a Faip Brand Pump. The engine starts, the water supply goes thru the pump under its' own pressure. When I pull the trigger on the handle, there is not increase of force nor does the pump engage. I had this same problem several years ago and sent it to a dealer for service. His service tag indicated a stuck unloader. Where is the unloader located on this pump. The indentification on the pump is MTPV90736 191693 Order # 52


... Briggs & Stratton Pressure Washers

I have a G 2400 HH-R and I need to replace the pump oil, I know I need Karcher Pump Oil 6.288-050.0 but I don't know HOW to drain and replace the oil. Thanks, Bill


... Honda Karcher G2400HH-R Pressure Washer

I have a model PW 2200 gas pressure washer. It suddenly lost it's high pressure the other day after working fine for @10 minutes. It's getting plenty of water, but the engine doesn't seem to rev up to give it the high pressure. The operating instructions say to check the oil in the engine, and the PUMP before starting, but I haven't found any place to check for an oil level in the pump????Any ideas, I'm very confused.


... Pressure Washers

I have a John Deere 3800 psi pressure washer, it stopped having pressure in the middle of a job. No restrictions and still turns on and sounds great. Checked pump oil and it was a milkshake green. Changed pump oil and still doesn't have pressure.


... Pressure Washers

I have a Karcher model G 2401 HB and need to know what type of oil to use in pump ?


I fixed mine works good too, watch my video step by step i put it on youtube ... Karcher 2500 PSI Pressure Washer

I temporarily misplaced (not lost for good) the owners manual for my honda pressure washer : engine and pump. I do not want to run my machine again until I verify the pump oil content/level. On the pump itself, at the top, there is a black, unscrewable oil cap, with blue-ish oil in it, BUT NO DIP STICK! How do I check the level? What kind of oil, specs etc? Thanks!


Http://www.ultimatewasher.com/download/honda-engines/gc160.pdf ... Karcher 2500 PSI Pressure Washer

Have a LG model LD-14AW2 dishwasher which has done good service for many years However, it now sems not to have enough water pressure to operate all the rotary sprayers at the one time - thereby not cleaning properly Have purchased a manual and raken the whole machine apart looking for a partial blockage of the water ways - non found - all looks perfect - still no water pressure I would suspect the pump - however, would have thought a pump either gave full service or stopped - not parti


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Dishwashers

Changing pump oil on pressure washer


... Pressure Washers

North star eletric hot 2000 psi 3.5 gal per min oil pump had blown shaft seal. replaced with new pump. put small allen plug in return port. I have oil flow to the pump but none comes out port leading to burner even with shutoff switch removed and pump turning. Installed test gage 0 pressure. Took off bypass line and ran into can. pumps small amount of fuel into can that way but with uneven flow & small bubbles. nomatter what I do I just can't get fuel outlet port to burner. pump # A2VA-7116 pl


... Northstar Pressure Washers

I bought a HILMORE PUMP 309515003 for my pressure washer. My old pump had an oil fill port on top and this pump doesn't. Does this pump use oil if so where do I fill it? Thanks


... Karcher Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1529 seconds