Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

Motor noise when starting cycle

\015 Motor noise when starting either drawer, but the sounds are different (could they be from different pumps or motors). \015

Answers :

I think I just resolved the same problem. On ours, it was a broken plastic fork prong that had gotten pulled into the bottom part. When I removed the broken plastic fork prong, it still made the same noise. After inspecting the "fins" on the bottom part of the "pump", I could see that the broken fork prong had caused a "burr" on each of the fins. These "burrs" were rubbing the piece that is supposed to keep large object from being pulled thru the drain. I took a knife and cut the burrs off each fin, put everything back together, and the tested it. It works perfectly.
\015\012
\015\012To get to the pump:
\015\012
    \015\012
  1. remove the bottom dish basket
  2. \015\012
  3. remove the rotating sprayer arm by just lifting it up
  4. \015\012
  5. remove the drain screen by just lifting it up
  6. \015\012
  7. remove the big round metal disc by turning the inner plastic clip counter clockwise about one inch and lift it out.
  8. \015\012
  9. remove the "pump" by turning the base counter clockwise about one inch and lift it out. Note that when this goes back in, there are three prongs on the sides of the pump that must fit back into the molded slots where the pump goes.
\015\012Remove any obstacles that you may see. There is a small tunnel that the pump sucks water thru. Check that. For me, I used a cup of water to flush mine out. Be careful, it could be a piece of glass that is causing your issue. Once the obstacle is removed, check the "fins" on the bottom of the pump. If you see any "burrs", cut them off with a knife (or file them down). Reverse the steps above to put everything back together. As a note, you can check that this resolves your issue by just putting the pump back in & starting your dishwasher.
\015\012
\015\012Please note that I'm just a DIY'er and not a professional. I hope this resolves your issue!
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch Shu43C02UC dishwasher fills with water but the washing won't start. As the filling nears complete, a double clicking noise occurs to start the washing motor but nothing happens. The time continues to countdown but the machine is silent. When I open and close the door, the click click noise is heard but the machine is silent. I can cancel the cycle and drain the water but none of the washing or rinse cycles will activate but the timer works. The soap door even opens if the timer is left to


Have you checked the inlet water temperature is at the correct level for the dishwasher.\015\012\015\012Please provide the full model no. of your dishwasher -- Shu43C02UC /??\015\012\015\012I think the problem is linked to th ... Bosch 24 in. SHU43 Built-in Dishwasher

Motor makes noise shortly after starting, makes normal sound level during main body of wash, then makes noise again during what I'm guessing is the rinse cycle. Not sure if it is a pump or motor problem. Slight electrical smell noticed after finishing the ''cancel/drain''. Water does not seem to be sprayed around washer during normal cycle, even though water has been in the washer.


Make sure the sprayer arm is turning freely, check for something stuck in the base of the sprayer arm (food or utinsel) preventing it from turning. ... Dishwashers

After 3 years it just started making a loud noise, I am no expert but it sounds like a fan in a motor. I have only heard it today, but I am betting it will still happen next load too. I didn't change any of the settings, have been running the same way forever. When I did hear this noise I started pushing buttons to see if I could get it to stop, no good, no change. The cycle has completed and everything looks ok, waiting on the dishes to dry. Drainage has never been a problem for me either.


I would say this is a build up of lime.try changing your tablets and checking your salt levels.there is no fan .try what i say and see what happens.have you found a glass broken it could be as simple as that but i dont think its serious.adrian,,,, ... GE Nautilus 24" Built-in Dishwasher

I have a Bosch SMU2046UC/14 dishwasher that makes some noise but will not start the wash cycle. I found that the noise was from the timer motor by removing the front of the door. The timer continues to run and but only advances until half way through the wash cycle where it stops permanently. Is this a problem with the timer or could something else be causing this problem.


HI. The timer motor mechanism regulates the length of time power is to be routed to each component. If the timer motor does not advance properly, it can result in a wide range of problems. Common symptoms will usually include sticking in a cycle(fail ... Bosch 24 in. SMU40 Built-in Dishwasher

When I start my GE Quite Power 1 dishwasher it makes a rumbling sound eminating from the base probably the water spin mechanism that sits on the motor is my guess? As the cycle advances the noise continues, any idea what is causing the rumbling noise to occur during the wash cycle?


Your issue could be one of the following:\015\012\015\012* motor\015\012* water pump\015\012* vibration from some source \015\012\015\012Contact an appliance service company. ... GE Dishwashers

Motor noise when starting cycle


I think I just resolved the same problem. On ours, it was a broken plastic fork prong that had gotten pulled into the bottom part. When I removed the broken plastic fork prong, it still made the same noise. After inspecting the "fins" on the bottom p ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have the Kitchen aid KUDS01DL dishwasher. It was working fine until last week. When starting a cycle, the washer fills with water. Once filled, the motor makes a humming noise and does not circulate the water. I end up stopping the cycle and the discharge pump empties the water. I took apart and cleaned the basin this morning. I did find some random garbage but it did not seem blocked. Do you have any ideas?


... KitchenAid 24 in. KUDS01DLSS Built-in Dishwasher

Whirlpool Dishwasher detergent door not operating properly. Main wash door opens immediately after starting dishwasher. No pre wash cycle. Loud humming noise coming from bi-metal switch or wax motor attached to the detergent cup assembly. I just replaced detergent cup assembly including the wax motor and I still get a loud vibrating humm from the actuator. model number du1055xtp3


Pdemaio,ngafm at your serviceI believe the loud humming you describe is an electronic problem. And is not worth changing parts randomly and spending unnecessary funds in this fashion!my advice is a hands on experi ... Whirlpool Dishwashers

Sounds like there is a piece of broken glass in motor section upon start of cycle and any other time water enters. Just started happening. Noise coming from bottom of unit. Do we need to have unit serviced? Thank you, lauri


... Miele 24 in. G653 SCVi Plus Built-In Dishwasher

BDW45.1 starts as normal you can hear water running then about 30 seconds into cycle everything stops and then you can hear a buzzing noise (best way to describe it is it's like the noise you hear when a motor has power but won't turn)


... Baumatic 23 in. BDW5 Built-in Dishwasher

When it starts the wash cycle it justs makes a buzzing noise and the motor does not start.


Check inlet water flow. Try pouring water from the front into the wash chamber. Run the cycle. If it works, it is air trapping problem in the pump. It should become alright after this. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Bosch dishwasher SGS46E22. Making strange noise as soon as the appliance is switched on and cycle not progressing or progressing very, very slowly. Ran test cycle (held in Auto and Eco buttons together and pressed start) - E6 appeared in display. Suspect pump or motor problem - how do I tell which needs replacing? Thanks.


... Dishwashers

Our Kitchenaid dishwasher is nine years old and just started making a grinding noise during the wash cycle. It's coming from near the pump motor / capacitor area. How can I tell if I need to replace the motor or the capacitor?


You might want to check the wash pump inlet for junk ... Dishwashers

Kenmore UltraWash QuietGuard 4 making horrible buzzing/grinding noise when the motor is running - it starts as soon as the tub is full of water and begins washing - and remains until the wash/rinse cycle is over and drying starts. Help!


You have a peace of glass or plastic stuck in bottomaround the sprayer arm ... Kenmore 24 in. 15689 Built-in Dishwasher

Strange noise after about 30 seconds when washing starts. this last until cycle ends about hour or so later. then stops once drying kicks in. checked foliters seem ok. could it be loose motor parts etc


... Bosch 18 in. SRV43M03 Built-in Dishwasher

The dishwasher will fill with water but when it trys to start the wash cycle it just makes a huming noise like you would hear when an electric motor is frozen. you can cancel and and it will drain with no problems. i checked the chopper and it spins freey and it appears that the shaft driving the chopper is not frozen. just curious what parts i need to purchase. thanks very much. richard lester


... KitchenAid KUDS01FKSS Dishwasher

My Maytag Quiet Series 200 is making loud noises. It appears to be continuing the cycle. When we stop and start the washer, it sounds like the motor is working hard (high pitched sound). It sounds serious. I'd like to troubleshoot myself if possible. Also, what is the criteria for an 8 year old washer when it comes to the decision of fix vs buy new?


... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

My fisher paykel DD603 fills with water at the start of the cycle and stops with the following error code and a beeping noise: - error U1 spanner symbol - crossed out faucet symbol. The water level is high enough that the spray arm is floating in the water. I am able to drain the water by entering the hardware diagnostics mode and running the motor in the drain direction. By removing the filter plate and examining the impellers I am not able to see visible damage. All filters are clean. The


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are spot on as error U1\015\012indicates that the dishwasher has twice tried to fill with the required amou ... Dishwashers

I have a Frigidaire Gallery dishwasher with model # GLDB958JB0 and it started to make a screeching noise only after a few mins into the wash cycle. I took out the filter and made sure there was noting stuck. Does this sound like I need a new motor?


Hello &\012Welcome to FixYa\012\012The problem\012is with the impeller or the chopper assembly that is causing this screeching\012noise. You can take apart the bottom front access panel and clean the drain\012pump a ... Frigidaire Dishwashers

Bosch SHU 43C 05UC/22 Has a very loud Groaning noise at start up midway and at end of cycle. Have cleaned and changed the DW Hose to the DW drain assembly under sink. Drains better but, I suspect the drain motor has been overtaxed because it's a long way to the sink - about 8 ft. under the kitchen in crawl space and up to sink.


... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

Service Manual Dear Sir, We are in the UK and although my double drawer dishwasher is branded Whirlpool ADG2900, I see that it is made by Fisher & Paykel. The top drawer motor started making a different noise about 3 months ago and now there is some dirty water left in the drawer after the cycle completes. The pots remain dirty. If you could get me the service manual I could try and sort it out. Please help! Thanks, RP.


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

The dishwasher started making horrendous noises. I removed the bottom panel and narrowed the noise down to the motor (the noise starts and stops when the motor kicks on and off). How do I remove the motor to visually check it out? I thought I had all of the screws removed, but it feels like something is still holding it in place. thanks My model number is GSD4060N10SS (GE Dishwasher)


... General Electric GSD4060NSS Built-in Dishwasher

The washer cycle stopped without warning, i thought the timer or the timer motor but it is not the timer works fine and so is the motor. but the timer motor runs til the washer motor starts than is the timer stops and the washer is working but not cycling so no rince or drain or soap etc... just pumping water. if you can tell me what might be the problem, thank you. like i said the timer stops when the washer motor start.


... Jackson JPX-300L Dishwasher

My Dishwasher stops in the middle cycle. This happens after about an hour of work and it stops when the machine starts spraying water and there is a hump noise


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1390 seconds