Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

Dual dishdraw bottom Ok, top one wont start cycle,F2 comes up

\015 F2 sign comes up after a few secnds, makes a Knocking sound first.\015

Answers :

Try swapping the motor rotors between the two drawers and see if the fault changes drawers, also check for anything stuck under the motors or and damage to the plastic of them. cheers
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dual dishdraw bottom Ok, top one wont start cycle,F2 comes up


Try swapping the motor rotors between the two drawers and see if the fault changes drawers, also check for anything stuck under the motors or and damage to the plastic of them. cheers ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I am having the a problem with the bottom drawer on my Fisher & Paykel DD 603SS. Top drains just fine. I cleaned both the drain filter and the hose and it still won't drain. I had a service tech come out and he couldn't figure it out either...he thinks its the "computer" and the "sensor" and he wants me to order new ones - cost is like $210! I really don;t think it's the computer...the electronics seem to work fine...any ideas? Before this all started, a fork fell down and stopped the arm fro


The good thing is that you have a double drawer which means you have somethnng to continue cleaning dishes while you are fixing the other drawer and if necessary, you have a set of spares to try out as part of fault finding. That is the positive side ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Blanco BIDW60 dishwasher and when I depress the ON/OFF button to start it before choosing the cycle, only the top pilot light comes on, instead of both. I noticed one of the springs has fallen off the bottom of the door. Could this affect it?


... GE Nautilus 24" Built-in Dishwasher

We have a built in GE dishwasher. It has worked fine for about 4 years but now the glasses in the top rack will not come clean. I have cleaned all the holes where the water comes out but I think the sprayer that is beneath the top rack (the one that is attached to the bottom of the top rack) is not rotating. We had someone out to take a look at it and they said it was fine. It isn't fine as it is not cleaning the dishes. Is there a reason that the bottom sprayer is not turning?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Maytag Dishwasher

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a kitchenaid Model KUDW03CTBL2 dishwasher. It is pumping water, but the top sprayer and the one under the top rack just have a little water coming out. Not enough to make them spin. We also noticed the water in the bottom when opened is not as much and it is cool not hot. The dishes on the top rack will not clean, and the bottom is not completely clean. We have checked water pressure and water tempurature through the house, All is operating fine. This dishwasher is only 1 year and 10month


... KitchenAid Dishwashers

NEFF S4443 top spray bar not rotating, no water. Bottom spray bar rotates and sprays water. Checked and replaced fine/course mesh filters. Will pump to empty and refill on pre-wash (rinse). Seems the pump may have two outlets one feeding the bottom spay bar (nearest from of machine) and one just behind which feeds the upper spray bar. Running without spar bars attached (including mechanism feeding to bar, water is only being forced out of the from outlet. Any ideas before I start taking it apart


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

My dishwasher was not getting the dishes clean, so i started taking the lower end apart to clean, got to a gray wheel looking object with a screw in the top which was recessed and still the wheel looking object will not come off, it will spin but will not come off, I need to finish taking it off because I dropped a screw down in the bottom area where the water settles.


If there is still standing water in the bottom of the dishwasher, remove it with a wet vac then look for the missing screw. It might be in the vac.\015\012\015\012If no luck, try using a good small stick magnet to retrieve the screw. The ... Maytag 24 in. MDB4000 Built-in Dishwasher

Hello I have a built in DCS dishwasher - width 24" heigh 35". It started smoking out the front and the repair man said it needs a new control board. Is that possible or should I buy a new one. IT is not a dishdrawer its a full dishwasher. the top rack is also broken. If I need to buy a new one - where from - new jersey area


Http://www.thefind.com/appliances/browse-dcs-single-dishwasheryou can purchase online from here... ... Dishwashers

Dishwasher won't start. Bottom one is working but the top one isn't. Red light keeps beeping continuously


... KitchenAid 23 in. KUDD01DPPA Stainless Steel Dishwasher

I have an almost brand new husky pressure washer (one of the big ones). It has been a life saver so far. just the other day it shut its self off. its gas powered so of course i checked the gas and oil. then tried to start it back up. but when I try to pull the pull string it wont come out more than about 3 inches. i payed 400$ cash for it to use on the trucks. does anybody know how to fix that? thanks


IT SOUNDS LIKE YOUR FLY WHEEL IS BAD OR NEEDS TO BE ADJUSTED ... Pressure Washers

Brand new ge GDF540HSD0SS dishwasher just installed this week has a middle arm that is not spinning. This is the one that is attached to the bottom of the top rack, and sprays water up. Water is coming out fine but no spinning. As a result, the inside of dishes on top rack are not getting clean.


... GE Dishwashers

The top rack is not cleaning. The dishes on the bottom rack come out clean but the ones on the top rack don't look like they have even seen water?


\015\012Hi\015\012 \015\012 \015\012If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it ... KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher

The cycle did not complete,the bottom spray arm (the tip) melted along with some plastic utensils (knife handles). Water come out of thee front door.When starting the washer again, the top and bottom spays do not turn.


The handles slipped down keeping the spray arm from rotating thus causing it to rest against the heating element. It won't wash because of the hole in the bottom spray arm. You have to replace the spray arm before nything else can be determined. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

The water is not getting up to the middle spin bar or the top one, so nothing on the top rack is getting cleaned and everything is left with soapy film, so it is not rinsing properly. There is water coming in at the side for the intial fill and from the bottom to wash.


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Kenmore 17369 When cycle starts... it sounds terrible (crackly sounding).... doesn't sound like the water is coming into the dishwasher. If I add water to the machine during a rinse cycle...it will wash and drain on its own.... Then I hit cancel. Please help.. I can't locate the owners manual.. Do you know where I can get one.. I understand that you can open the bottom up and see if there is anything lodged in the bottom of the dishwasher. Please help! thanks Cheryl


The problem is your water inlet valve. If you remove the panel at the bottom of the dishwasher you will see\015\012either a copper hard pipe, or a flexible steel hose leading into the\015\012water inlet valve.BE SURE TO CUT OF ... Kenmore 24 in. 17362 / 17364 / 17369 Built-in Dishwasher

Bosch exxcel 5600040998/07/227/6:39 only 2 years old check water light stays on cycle wont count down some water comes into bottom...but not from top I need to cancel to get the water to pump out any ideas? Thanks :)


... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Dishdrawer The top drawer of our dishwasher has stopped working. It has been working fine for about 18 months but now it seems to have no power coming through to it. The bottom drawer is still working fine. There have been no electrical surges that we are aware of.


Hi there,\015\012\015\012If you have no power to the top drawer and it is difficult to open it may be that your heater plate has blown and requires replacing. If it has no power and opens easily you may have the child lock on and need to hold the loc ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Some of the dishes on the top & bottom are not coming clean. Is there a filter that gets plugged? I am not cramming dishes in & I run the hot water to really hot before I start the washer. I also rinse the dishes before putting them in. HELP!


It sounds like water supply problem hose may not feed enought water ... Kenmore 24 in. 15079 Built-in Dishwasher

My top dishdrawer stopped working half fill of water. I put it on rinse cycle and it drained the water. I found a bit of sand in the bottom of drawer. I wiped the sand out and then put onto a cycle. After a couple of minutes the dishwasher started flashing a tap symbol with a slash through it and stopped working. Any help please:) Jacki


... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Leaving more water in than bottom than used to. I cleaned the silver cap on top of the sink (overflow or air)? Water comes out the cap which enters into the sink. Just a little bik. I recently replaced the old and my wife think started then. I install new host from dishwasher up to the plastic "Y" the silver cap sits on above the sink. Any suggestions Mdoel lokks like 665 but there i another number right below FH50022184


Hi, yes this Y and chrome cap is the air vent for the dish washer, If you have any water coming from this cap at all, you do have a blockage in one of the hoses. I'm not sure which one you replaced, but here is how the hoses work.From the dishwasher ... Kenmore Dishwashers

My 12 yr old KitchenAid -Sculptura-Model KUDR24SE starts to fills with water and then does nothing else. It will eventually go through the cycles on the panel, but nothing is happening inside. End result is still dirty dishes with water sitting in the bottom that has to be baled out. Cups on top rack don't have any water on the indentations, so it's obvious that the thing filled with water and that's it. I had the motor replaced (supposedly with a new) one 2 years ago so I find it hard to bel


... Dishwashers

Maytag MDB5000AWW started making noise when cleaning. Bottom arm working , but water isn't pumping with much force. No water coming out of top hole (removed arm to make sure there is no obstructions. Checked down to the impeller (didn't remove), and didn;t see any blockages, etc.


HI\015\012Motor malfunctions usually call for service by a professional. There are three main causes of motor failure: lack of lubrication, a defective motor switch, or worn or frozen bearings. A humming sound can be related to a burned-out mot ... Maytag Dishwashers

DD603HSS Hi from France. i'm the owner of F&P dishdrawer DD603HSS for 5 years and half. (New Zealand made) yesterday, the top drawer looks with no power, no lcd , nothing. like no power alimentation. as you know, for a 5&1/2 years appliance, there is no more warranty... have you any idea for the cause of this trouble. is there a fuse and the location of this one ? i know each drawer is autonomous, then i suppose each drawer is protected by a fuse. - i precise "The bottom drawer works fine".


There is only one power supply or input so you need to find out where the power stops from the bottom to the top drawer ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

KitchenAid KUDPO1IL dishwasher has a buzzing noise during wash (and rinse?) cycles. Recently had to replace the top spinner (and connecting screw), as it had fallen off, but I think the noise was happpening before that. Today I re-clipped the flat pipe at middle back; one side had come loose. That might have helped a bit. Previously, I took out the bottom spinner and found a 1-2" string-like strip of gray nylon under that. I wanted to check a grinder, to see if something was trapped in that, but


... KitchenAid 24 in. KUDP01IL - Multiple Color Built-In Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1249 seconds