Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

How to clear f1 symbol

\015 The f1 symbol along with a wrench on it stated flashing and i dont know how to switch it off\015

Answers :

The flood switch has been activated. This can happen if a hose busts or something, but more often than not it's because you put something too tall in, and the lid that seals the drawer could not close all the way.

If you don't want to pay a technician you can probably solve the problem by drying it out yourself.

Switch the unit OFF at the mains.

Open the lower drawer. There is a tab on each side that you click and then can slide the drawer off its runners.

Use a towel to mop up as much water as possible, and then get a hair dryer onto it to dry any remaining moisture.

Then slide the drawer back in and let the tabs click back into place.

If the F1 still shows there may still be some water, OR you could have a busted hose or something.
F1=flood water leak
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How to clear f1 symbol


The flood switch has been activated. This can happen if a hose busts or something, but more often than not it's because you put something too tall in, and the lid that seals the drawer could not close all the way.If you don't want to pay ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Bosch Sgv46m43gb, it's just stopped working mid cycle and come up with a tap symbol on the display. Tried re-setting but it wont move. Water at bottom wont clear. Can anyone help


... Bosch Dishwashers

Cycle just continues with the pot symbol blinking


Disconnect the hose and run it into a bucket, is it pumping freely?.did you check the trap for a blockage?You may have a leak in the pump housing area below the unit, this would cause the drain pump to run continually. ... Viking Designer Series DFUD041 (Premium) Built-in Dishwasher

I have a Whirlpool GU1100 built-in diswasher that will not clear the pot & pans selection. It is stuck with the pots & pans and the cancel buttons lit and blinking. It will not start or clear. I have tryed to shut the power off for awhile and this has not helped. Other buttons can be pushed and will light but the other two remain blinking. If the clear button is pushed it will clear the other button but not the pots & pans or itself. Is this a problem I can fix myself?


... Whirlpool Dishwashers

My Bosch dishwasher stopped the other day for no reason, the bottom still has water in it, I just tried to start a full wash again and all that happens is the red light below the brush symbol lights up, then after a couple of minutes the red light below the tap symbol lights up, also the red light below the drying symbol is also lit, but nothing happens after that? Any ideas?


... Bosch Dishwashers

I have a Miele Turbothermic dishwasher which is nearly 3 years old. The Inlet/Drain (red) light is flickering and the washing cycle was not completed. I cleared the strainer but have not been able to clear the the dirty, stagnant water. I tried re-starting it with everything out of the washer but nothing has changed. Is there a way to clear the water and get this machine working again? Many thanks. Loretta


Please provide the full model number of the Miele dishwasher.\015\012\015\012Have you checked that there is no blockage in the kitchen drain especially if you use insinkerator (disposer unit) in the sink. ... Miele Dishwashers

Ariston L 63 dishwasher does not drain. Hoses appear to be clear. Underneath dishwasher there is a clear plastic container attached to the salt container? that looks to be clogged with debris. How can I clear it out? Many thanks.


DONOT EVEN TO TRY TO DEAL WITH SALT CONTAINER , YOUR PROBLEM IS OUT OF THIS AREA,\015\012YOUR M/C MAY NEED TO DEAL WITH DRAIN PUMP\015\012IT IS ALSO UNDERNEATH>\015\012 THANKS ... Ariston Technologies L63 Free-Standing Dishwasher

My bottom drawyer is randomly flashing symbols...it will show 5 min cycle with rinse symbol, then stops and flashes symbols..top drawyer is working fine


This sounds like you need a new control board. Click on the link below to see how to service this double dish drawer. ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

The light is on between the symbol of a tap and rince aid. The symbol is of two arrows going the opposite direction of one another. What is this symbol?


... Neff 24 in. S5555X0GB Built-in Dishwasher

Bosch dishwasher won't drain...it washes the dishes great but there is water remaining in the bottom after the wash cycle is finished. I have done the following with no results: 1. checked drain hose to sink and it was clear of debris 2.removed filter and cleared it out as well as removed the bottom cover and checked there...looked clear. please help


Hi\015\012\015\012There are a few things to check with this problem on Bosch Dishwashers. \015\012\015\012As always for safety reasons disconnect the dishwasher from the mains supply before carrying out these checks.\015 ... Bosch Dishwashers

Dishlex global 450 _ how do i fix fill level time fault? displaying oF? Hi There, I have the above dishwasher and saw your advice on fixing fill levels - my display is showing the oF message and the pump to drain remains on whilst mains is connected. turning off mains does not clear message. holding eco button down does not clear message? is there anything else i should do in terms of removing parts to assist the process? I have cleaned out all of the drainage bowl and all is clear. i would pref


... Dishwashers

Overfilling fault I have an Asko D3530 reporting an overfilling fault. I checked the outlet hose and found a blockage. I cleared the blockage and the unit pumped the water clear. The unit however continues to opperate the pump with the message "Overfilling" diplayed. The manual indicates "call for service" Does anyone have any idear how to clear the fault? Thanks Steve


I believe the washer has had a flood type situation.there is normally a flood switch in the very bottom of the dishwasher right at the very floor,if water get into the bottom tray it floats a piece polystyrene foam wich triggers a little micro switch ... Asko 24 in. D3530FI Built-in Dishwasher

We have just purchased an IQ100 SE26N250G Dishwasher and are having problems in setting the washing programme. We have followed the instructions in the leaflet but the dishwasher will on wash on 40 degrees and cannot be cleared or changed to any other programme. Also, the information in the instruction manual that accompanied the dishwasher is not at all clear and is rather confusing as it shows that to clear an existing programme you simultaneously press and hold the 2nd and 4th buttons out o


... Siemens Dishwashers

MY KITCHEN AID DISHWASHER MODEL #KUDS25SH CHIKD LOCK IS ON AND WONT GET CLEARED. I TRIED HOLDING THE ENERGY SAVER DRY BUTTON FOR FOUR SECONDS AS SAID IN THE TROUBLESHOOTING SECTION BUT DOES NOT CLEAR. PLEASE HELP I CANT AFFORD A NEW DISHWASHE


Try turning off the breaker to the Dishwasher...See if it resets ...Good luck.,.. ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

G7856 showing Fault Code F26. Have cleared filters of all debris, including drain impellar (sp?) cover. Code still not clearing. What do I do next?


Hello there again I dont know if you got disconnected or just left the chat room but please try this take out the bottom white basket so you can see the\015\012bottom inner of the dishwasher, then take out the centre filter and\0 ... Miele 24 in. G638 Plus Free-standing Dishwasher

Machine is not washing very well....Leaves residue. recently the drainage pump was blocked but I managed to free it and it works well now, but I noticed a clear plastic container full of orangey coloured salts. Is this normal or do I need to clear it somehow?


The orange coloured salts is normal leave that.\015\012Is the water getting hot?\015\012\015\012if it is try adjusting the rinse agent so it lets more in ... Smeg 18 in. DWF410SS Slim-Line Free-standing Dishwasher

Whirlpool DU915PWPTO wont drain leaving water in the bottom what does drain is slow, disposal clear,hose clear, pump runs to wash dishes,water in bottom is more than normal


... Whirlpool Dishwashers

Clear glass dishes are cloudy. What is causing it? We have checked the arms--they seem to be working fine. Some days it does better than others--today they were extremely cloudy. I washed the glasses by hand and dried and it cleared most of the cloudiness off. I have tried two different dishwasher detergents.


You can determine the cause of cloudy glassware by soaking a glass in vinegar for 5 minutes. If the cloudiness is removed it is due to hard water deposits; make sure the salt reservoir is topped up. Do not worry about over-filling it.\015\012If ... Dishwashers

I have dishwasher (Electrolux) model ewdw6505gs. How do i clear a code of 01? I fixed the disposal clog and the dishwasher automatically drained the water in the bottom. I just can figure out how to clear the error code.


I should inform you that that is a "leak detection error".\015\012You should check some of those hose clamps, they may not be tightened properly.\015\012\015\012Regards ... Electrolux Dishwashers

Subj: ge dishwasher mod/gsd3960looss - 1yr 4 mos old. problem: will not drain only used 6 times. last use after cycle done, water remained. had to hand drain. removed cover and checked drain area, no debris found. drain tube is connected to disposal by clear plastic tube; no clog in tube. the sink drains are clear and the disposal works normal. dishwasher drain seems to be stuck in closed position. this model has the touch pad controls. any solution????


... GE Dishwashers

I have a purple rubber band looking seal and a clear round seal laying in the bottom of my dish washer...where do they go? The clear round seal looks broken. thanks


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Brand new Samsung dishwasher is not draining. Drain hose is clear. I can siphon the water through the drain hose, the connector under the sink is clear as well. Could it be a defective drain pump? How can I check?


... Samsung Dishwashers

Newish Nilfisk P150.1 Power washer won't lift detergent from bottle. I have stripped the hose /pump fitting and the ball and spring are in good condition and the calibrated hole is clear ! The regulator valve is also clear and in working order.


Do you have it set to low pressure to dispense soap? ... Pressure Washers

Danby DDW396W-2 Spray arm won't turn have checked pump, appears to work, spray arm is clean, drain hole clear, lines clear, HELP


I have had a similar problem numerous times, a couple of which required\015\012manoeuvreing it into a place I could work on it, and a laborious\015\012removal of the covers. Each time, up until this current incident, the\015\012solution that worked, ... Danby 22 in. DDW396 Free-standing Dishwasher

Water remains in the bottom of the dishwasher (18 months old). Disposal is clear, glass trap is clear. What should I look for?


First : if this started after a new disposal was installed then you need to check the Knock out on the disposal located inside the pipe that sticks out of the disposal where you conect your dishwasher drain hose. ((((( Common Problem )))))\015 ... Frigidaire PLD4555RFC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0315 seconds