Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

DD603 upper drawer pump rotor will not turn - F2 error. Was completely siezed. Removed rotor and got the shaft to turn with pliers. However it does not spin freely and still shows an F2 error. Does anyone have a repair manual so I can figure out how to remove the pump? Lower drawer had an F1 error (due to the upper leaking/F2 error) and this website helped me fix that problem.


Answers :

Maybe you dont have to remove anything else.. try the rotor from the bottom drawer first. If this works just buy a new rotor..
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DD603 upper drawer pump rotor will not turn - F2 error. Was completely siezed. Removed rotor and got the shaft to turn with pliers. However it does not spin freely and still shows an F2 error. Does anyone have a repair manual so I can figure out how to remove the pump? Lower drawer had an F1 error (due to the upper leaking/F2 error) and this website helped me fix that problem.


Maybe you dont have to remove anything else.. try the rotor from the bottom drawer first. If this works just buy a new rotor.. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The note by FixAllPhil entitled "Poor cleaning or noisy pump on Whirlpool or Kenmore dishwasher" has a significant error. The first step should be to "Remove the lower wash arm (1) by turning the nut CLOCKWISE (right)". I damaged the threads on my dishwasher nut by trying to turn it counterclockwise. Once that error is corrected, please remove this post.


Thank you! ... Whirlpool Dishwashers

The upper and lower dish drawers leaves a puddle of water under each (maybe 6" in diameter) after the shortest cycle. There is a small amout of water left in the clear protective housing on the underside of the upper drawer. There is a hole at the bottom of the housing that lets the water out. Maybe there is a slightly loose hose? If so how do you get the housing off and tighten it? I presume the lower drawer may be doing the same thing, but I can't see it with out removing the drawer. How do yo


The drawers slide on a pair of rails on each side of the housing.\015\012\015\012see installation manual pag ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

I have a frigidaire dishwasher - model number PLDB998AC1. There are two spray arms in this dishwasher - lower and upper. The lower works fine but the upper spray arms are not spinning. There is what I think adequate water pressure coming in from the top but no movement on the upper spray arm. Here is what I know: 1) The water pressure and spray arms alternate between top and bottom. 2) The upper spray arm moves freely when I push it gently. 3) I have removed the pump and cleaned out an


... Frigidaire 24 in. GLD2162RDC Stainless Steel Built-in Dishwasher

I have a dd603 and i cannot remove the rotor from the stator in the lower drawer. when i disengaged the locking ring to pull the rotor out the impeller broke off and now i cannot remover the rotor by pulling up on the rotor shaft.


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Upper spray arm is not turning and I don't think water is coming out. Dishes on top are not coming clean. Dishes on bottom are clean (as clean as they get with this dishwasher). How do I remove upper spray arm. Also I'm not sure how to remove lower dish rack to access upper spray arm. Any help appreicated. Kitchenaid model KUDP01FLSS5 Chris


Hi Chris,It sounds to me like a restriction in the pump. I put together some information here on cleaning it out. If you try these please give me some feedback as to if they help or not.Thanks! ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

Kenmore BuiltIn Dishwasher Stock 17512 Model 17512200 Type 575-0 Serail FM3309375 Probelm: Water sprays out of lower arm weakly, and not out of upper arm at all. Action taken: Unscrewed the 4 screws holding down the item underneath the lower spray arm, and then the small item under that. Found major refuse from years gone by, removed, cleaned. Reassembled, same issue. I suspect I have to get 1 more level down, to the intake for the pump? found 2 screws to remove, but was not suc


... Dishwashers

I ran a load of laundry in whirlpoo[ duet ht, model ghw9400pl4, error code p-09 was indicated. water was overflowing from door, and water was continuing to fill the tub. I turned off the faucets, unplugged & restarted in drain mode it hummed but would not drain. I turned the faucets back on and retried to drain but it would only hum. I manually removed the water by losening pump filter. There was no debree in filter except for a little bit of hair. The pump & vain was free & clean, and I co


It is your mixer value that is malfunctioning. ... Whirlpool Dishwashers

When I replaced my garbage disposal I forgot to remove the knockout tab that would have allowed my my bosch SHE58C05UC dishwasher to drain into the disposal. I discovered my error the first time I ran my dishwasher and discovered that none of the water had drained. I then removed the knockput plug and reattached the drain line. My dishwasher now drains correctly but makes a loud sound whenever the pump turns on. Have I ruined my pump or is there something I can do to eliminate the loud noisy pum


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thank You for using\015\012FixYa. To start with check the pump and try to clean it out, then check drain\015\012hose for any obstructio ... Bosch Dishwashers

I have a dishdrawer (2) and following the use of a dishwasher cleaner, the bottom drawer appears to have developed a blockage. It will not empty, gets to the pump out part of the cycle and shows the red error code F3, to which there is no reference in the trouble shooting guide. The top drawer has also developed minute leak, sufficient enough to leave dribble marks on the lower drawer and over time, a white deposit on the floor. Is there anything we can do for the blockage problem before reso


Remove the small basket from each drawer and lift up the removable plastic cover and take the drain filters out , empty them of food by products and try it again.. If you've never cleaned them then that's your problem with the drain process.. Hope th ... Fisher and Paykel Dishwashers

Bottom rotor not rotating. When I remove rotor there is no water coming from bottom tube. Upper rotor working OK. There is no blockage in filter or pump vanes.


... Asko D3152XL Built-in Dishwasher

I have a Kenmore model 665.15835791 dishwasher. I suspect that some plastic packaging has clogged the pump. I've removed the lower sprayer and the circular plastic cover that is held in place with 8 torx head screws. I'm trying to remove the black circular object with a 1 inch hex counterhold held in place with a screw with a 1/4 inch hex head. I have applied some torque to the screw first CCW and then CW with no results. I'm concerned about turning the head off of the screw. Which is the


... Kenmore Dishwashers

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

AFTER A BRIEF POWER OUTAGE DUE TO ELECTRICAL STORM THE F1 CODE FLASHES AND PUMP RUNS CONTINUOUSLY. TURNING POWER OFF ONLY STOPS IT FOR SEVERAL SECONDS. TURNING OFF POWER TO DW AND BACK ON DOES NOT RESET. I HAVE REMOVED THE BOTTOM DRAWER AND CHECKED FOR WATER, BUT UNIT IS DRY. IS THERE ANOTHER WAY TO RESET THE SWITCH?


Hi there,The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB.The main reason this happens is putting cups on the drop down s ... Dishwashers

How do I change pump filter on Maytag EQ Plus MDB7130AWW ... one site instructed me to rotate lower spray are counterclockwise and remove it .... ten minutes of counterclockwise turning and it is stil


... Maytag MDB7100AWB Dishwasher

Lower drawer drains into upper drawer.


You are most likely correct,they tend to give out over time. ... Dishwashers

Lower drawer F1 error code, I suspect possible seal leak. Very small amount of water on floor. Upper washer control panel cycles rapidly through all programs and back light is burned out. I suspect control board malfunction. Repair facility, or tack it myself?


Yes this means that the machine is detecting water under the bottom drawer. Pull the bottom drawer out and soak up the water with a towel and then the error will go away. This happens often because something gets put in the drawer that's too ta ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dishwasher fix water does not go through the spray,. the upper hand an lower hand are clean , the pump does operate to empty the dishwasher . I do smell like some burning smell when I turn the dishwaher on, the water start running for 1 minute or 2 than stop shortly and doesn t reach the arm then the dishwasher becomes hot inside . Thank you


Something has gotten passed the screen and is jamming your pump impeller pull lower spray arm pull screen and see if you can find what is jamming the impeller and remove it drain pump is separate ... Maytag MDB7100AWB Dishwasher

KitchenAid KUDG25SH stopped running, won't drain. Took off upper pump housing, trying to remove 5/16 impellor mounting screw, but it won't turn even with considerable force.


Maybe a peanut or piece of bone stuck in it. What have you been eating that may have gone thru filter trap.\015\012Remove pump and blow back with outdoors hose - worth a try.\015\012PS Was it a peanut? ... KitchenAid 24 in. KUDG25SH Built-in Dishwasher

F2 code. Followed listed guidance of removing assmebly and checking...unfortunately, however, my impellar has separated from the rotor assembly and the rotor assembly is stuck in the drawer. I tried to pull up on the shaft with some pliers, but that didn't work and I didn't want to pull too hard and cause damage. Please advise as to how to remove the broken rotor assembly from the drawer. Thanks


There are no wires underneath the rotor - it is just suspended in the cavity. So you cannot do any damage except make scratches around that area. Maybe take a straightened wire coat hanger and insert from the side hole in the filter sump area. You mi ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force.rnPROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump o


... Kenmore 24 in. 16193 Stainless Steel Built-in Dishwasher

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force. PROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump or i


... Kenmore 15529 Built-in Dishwasher

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force. PROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump


... Kenmore 15529 Built-in Dishwasher

I have a 13 year old Siemens SE64630GB. It isn't cleaning items in the upper basket and I believe it's due to lack of water pressure in the upper spray arm leading to little or no rotation of the arm. Have cleaned out the drainage pump and removed and cleaned both the water feed pipe to the upper arm (a lot of gunk in there) and the spray arm itself (which also had blocked nozzles) - no apparent blockages now. Could there be a blockage in the circulation pump and if so how do I access this pump


... Siemens Dishwashers

Inlet/Drain light is on. I have cleaned the drain pump and non-return valve, rinsed under water, removes all foriegn objects, turned the drain pump impeller (which turns freely) and carefully replaced the non-return valve and secured it with the locking clamp. I tried turning off the dishwasher and teuned it back on. No warning light shows but as soon as I try the dishwasher on a wash cycle it fails to pump water into the machine and release the washing tablet door. The programme unit makes a no


Is the water inlet turned off by chance? Is there no water at all inside the dishwasher? ... Miele 24 in. G643Vi Plus Built-In Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1417 seconds