Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

Top unit is leaking water from top of the tub and as if the top gasket is not sealing.


Answers :

1-Top gasket is not sealing since the 2 actuators on the left and the right side are not pulling down.\015\012
\015\0122- If the seal is bad, then the lid needs to be changed. The seal is attached to the liid, so seal can not bought by itself.\015\012
\015\012Go to diagnostic mode to turn on the actuators:\015\012If you see the lid going down evenly from both sides, then the actuators are still good, replace only the seal.\015\012If the lid is not going down then replace the actuators ( both sides) only.
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Top unit is leaking water from top of the tub and as if the top gasket is not sealing.


1-Top gasket is not sealing since the 2 actuators on the left and the right side are not pulling down.\015\012\015\0122- If the seal is bad, then the lid needs to be changed. The seal is attached to the liid, so seal can not bought by itself.\0 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Model- kudm25shwh1 leaking under door when draining. I have replaced the gasket-for the tub, door seal, tub spacer. checked the top vent (cleaned the gunk out). checked the screws on the main sprayer. unit is 9 yrs old. is it time to replace?


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Water is leaking from the top of the top drawer, mainly on the right side of the top drawer. Is there an adjustment to raise the tub so that it would have an even seal to prevent the water from leaking. I noticed that the top drawer has a bigger gap on the right side or has more give-in/movemenet when the tub is lifted compare to the left side. This casue the flooding error at the end of the washing cycle.


I have had similar problems with my DD603SS. The leakage leads to the water detection in the bottom of the unit and the resulting F1 error. The movement and height of the lid is controlled by the lid actuators. There is one on each sidewall. The draw ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

My Maytag Quiet Series 300 (Model #MDBTT79AWW) leaks about cup of water a minute. I've removed everything from inside the dishwasher. It looks like the main seal is replaced from the bottom, possibly necessitating pulling the unit out first. Is it possible to apply some sealant to top of the seal to stop the leak? Thanks, John


... Maytag PDB3600A Built-in Dishwasher

My GSD5940Do1ss leaks from what appears to be a tube that is in the middle left of the underside. There are no leaks from the hoses or pumps. It only leaks when it is adding water during the wash or rinse cycle. The part it is leaking from looks like a plastic tube that is part of the tub enclosure. There are four of them and I think they are really the mounting guides for the tub enclosure, which means the water is probably flowing down the tub to this spot. I'm assuming that means my seal arou


Other than seals, and you're sure the hoses themselves are intact, i would suggest looking at the fitting for each hose... Are these hoses PEX, or just standard plastic tubing? ... GE 24 in. GSD5940 Built-in Dishwasher

My GSD900G-01 dishwasher leaks where the hot water is supposed to go into the tub. There's a plastic fitting that seems to be glued to the side of the tub and the hose from the inlet valve goes to the top of this fitting. There are no visible cracks or other damage but there is some rust inside the tub at the fitting. The fitting has two open gaps on it's side which is where the water is leaking out. It looks like the water is supposed to flow past these gaps (which I'm guessing are there to


Hi, I seen where this posted on premium. If you still need assistance, please let me know. I can help you through this.\015\012\015\012Vic ... Dishwashers

I have a Kirkland Signature dishwasher produced by GE. The dishwasher is leaking from the top of the tub, where the water enters into the top sprayer. Should the top water inlet hose be tight to the top of the wash tub, and if so what can I use to make it tight?


... Dishwashers

We have a Kenmore portable Dishwasher one and a half years old. It ran fine for about 6 months then we saw a water leak from the lower right hand corner of the door. I cleaned the door gasket. It stop leaking for a while. It started leaking again. Cleaned and rest the door gasket again. It is still leaking. Unit drains fine and all other functions are correct. What is the fix?


... Kenmore Dishwashers

How do I adjust top drawer height? The seal around top drawer appears to be leaking and there is a lot of dried residue around the top edge of the drawer. Water appears to be leaking from the top.


Not sure if adjusting top drawer height will fix the leak. The only way to fix the drawer seal leak is to take the drawer out and check what is wrong with the seal which is located around the top edge of the cabinet from inside.\015\012\0 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

During wash cycle water leak appears on the floor at the left side of the unit. this is a new unit model #Kuds301vwh #FO1114221 purchased and then installed on 3/25/10. Gasket was replaced on door by factory repair man and leak continues. unit appears to be level.Unit is covered under warrantee.


... KitchenAid KUDS30IV Builtin Dishwasher

I have a Bosch SGS43A22 Dishwasher approx 8 years old. When I start a cycle it fills, runs for about 15 minutes, then drops out about a litre of water from the bottom of the door, then completes the cycle without any more leaking. I have run the machine with the front panel off and can see that water bypasses the top of the seal and fills the well of the seal then pours out. It only happens the once. The seal is fitted correctly. Any solutions?


After 8 years service the seal may have perished, so you should feel for a crack by stretching the rubber where you noticed the leak. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Kenmore model#587(Frigidaire) leaks under door. New install. Had machine for a year plus before install. took off front panel- can see water squirting past lower door gasket as wash arms rotate. cause is water running down door during wash cycle piles up in the channels molded into the lower left & right side of the wash tub and pushes out the sides of the lower gasket. looks like a design issue- called SEARS, they just want to sell me a new gasket! go figure. any ideas on a fix?


It does sound like an inner door seal ,however If you get upset at Sears and complain they may help you as they say the squeaky hinge gets the oil..And with Sears the more you squeak the better your chances of results ...Good Luck ... Dishwashers

Whirlpool dishwasher leaking from bottom of door between inner and outer door. Replaced door gasket. float and float switch working. Pump working, tub draining properly. leaks without adding soap or dishes too. Will a bad pump gasket cause water to get between inner and outer door?


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

The overflow air drain on top of the sink that is connected to two hoses under the sink is leaking. It leaks out the top onto the counter. I took it abart but am afriad I did not put it back together right. There is a rubber ring that I think must be for sealing and I put it directly on the counter and then screwed down the air valve over this and water s coming out of the air flow valve and all over the counter.


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Fisher Paykel DD603 both drawers are leaking F1 code bottom drawer is not as bad as top. Can sometimes make it through a load with no F1. There is water underneath lid seal on both at end of cycles or in the case of the top half way through. Checked hoses not leaking.


Change your detergent, high foaming detergents leak through the overflow, highly unlikely that both drawers developed a leak at the same time. ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

My Kenmore under counter ultra wash dishwasher model 665.15825691 has started leaking at the lower corners of the door. The leaks seem to occur during the final rinse while the water is being heated. I have tried cleaning out the door bottom and the tub edge where the door and tub interlock. There is no gasket in this area.


Happened on my dish washer too. Remove lower rack, remove lower spray arm by removing the center plastic nut, check screws (torx) on outside edge of pump. Tighten these as necessary, mine were loose causing water to spray forward against the tub c ... Kenmore Dishwashers

Tub leaks, with a partially filled tub (2.5 inches measured from the lowest point over the pump assembly.) Promblem occured after the washer was idle for 3 weeks. Have just replaced the main water inlet valve. The fill tube is not the source of the leak, the top arm feed is fine also.


I am assuming leaking when it is running, not sitting idle. Leaking from the door? Fill and run unit for 1 minute with no detergent. Open door. Are suds present? Suds turn into water when they drop to the floor. Suds can flow over the lip of the tub ... Maytag MDB7100AWB Dishwasher

The lid of the top drawer leaks. I've examined the seal and it appears sound. Water is on the top edge of the drawer.


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Model 17372300. Water leaks somewhere from top of door. Lots. Am I missing a gasket?


... Kenmore 24 in. 17372 / 17374 / 17379 Built-in Dishwasher

Noticed water on floor. Found both heater nuts cracked and letting water by the rubber gasket and tub. Water leaking into the heater power supply wires. Bought new nuts and want to know if this is a constant issue. Nuts are just cheap stampings and it seems likely it will happen again. Any suggestions Don


Change out your heating element as well. Sounds like you need a better seal. \012\012Thanks ... Dishwashers

Water leak My model is a GU2400XTPB1 The tub of diswasher has small hole where a screw is mounted on bottom of dishwasher. Leak is severe during cycle. I have tried epoxy but it will only hold up for a few washes. Will anyhing seal the leak and hold up? The dishwasher is only 2 years old..


Mine also started leaking. Element also too hot. Mine has a 20 year warrenty on the tub (which I was NOT aware of) Repairman came today and the whole tub unit and element will be fixed for free! Look in your whirlpool instruction book to see if your ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Door seals for dishwasher lds5811bb it is leaking water and all I want is a diagram of parts so that I can order the right ones. I need the tub seal and the door seal.


Hi,\012That is not that hard to fix and you can easily buy the parts yourselfonline...Here is a tip that will help you with the online buying...How to Buy ... LG 24 in. LDS 5811 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1126 seconds