Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

The backlight on Fisher and Paykel DD603SS has gone out

\015 The backlight on our top Fisher and Paykel DD603SS has gone out. Not sure if we pushed a button/series of buttons, but the backlight used to come on when buttons on front were pushed. Bottom's backlight works fine. Dishdrawer still works, just backlight is off when drawer "on".\015

Answers :

There is some reason the LCD needs to be reset. Un plug the cord. Remove the front panel, on the top right you will see the small circuit board. On the right of the circuit board there are a few connectors. Disconnect them all and leave for 30 minutes. Put it back then plug in the cord. It will work again. If not then it needs to be replaced. Unplug alone the cord didn't work for mine. Good luck
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The backlight on Fisher and Paykel DD603SS has gone out


There is some reason the LCD needs to be reset. Un plug the cord. Remove the front panel, on the top right you will see the small circuit board. On the right of the circuit board there are a few connectors. Disconnect them all and leave for 30 minu ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel M#DD603SS - While not running F1 repair mssg


Actually the part is called a Link Actuator. There is one for the upper drawer and one for the lower. When the drawer is shut, it will actuate and the dishwasher will lift the drawer up against the upper lid. When the actuator is broken, this will ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Current service manual for the Fisher & Paykel DD603SS dishdrawer


Http://www.fisherpaykel.com/admin/pdfs/pdf_usecares/527971B_DD_user_guide_USw.pdf ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My dishwasher (Fisher Paykel #D17-603-2W) electronic control panel has gone crazy. How can I reset it? Repair is $200 and I don't have that right now.


... Fisher and Paykel Dishwashers

ERROR CODE F1 MODEL #DD603SS - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

I have a fisher&paykel dd603ss the lock symbol on the top drawer


If it is beeping "F-1" this is a flood condition usually caused by the lid (s) not sealing. You would need to replace the link supports and possibly the mains filter board. Try unplugging it and letting it dry out for a day or so. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and paykel DD603ss ,bottom draw does not slide out easy,,,,


Hi- Most likely the lid is stuck in the down, or partially down position. This is usually caused by the lid actuators (motors) not returning the lid to its full up position and therefore the drawer top is dragging on the lid gasket. Replacing t ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and Paykel Dishwasher not getting dishes clean


Had the same problem and took out the inards and cleaned them. Also found that a lemon seed was blocking the drain channel - I used a piece of wire to snake it out. Seems like it needs periodic cleaning to keep it cleaning properly. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and Paykel Soft Touch F1 error and full of water - leaking


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Code u1 fisher& paykel model 920 - Fisher and Paykel Dishwashers


Hi, this tells you everything you need to know about a \015\012 fisher& paykel model DW820 and DW920 modelsi was also looking for the u1 error, and im sure my problem is being a male i use to much detergent (powder) that creates extra foam ... Fisher and Paykel Dishwashers

Fisher and Paykel f1 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


Hi\015\012\015\012Error F1 on your fisher & paykel means an overfill condition. One of the most common causes for an overfill fault is that the dishwasher cannot pump out the dirty water due to a plugged drain hose. Check the drain ho ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Fisher&paykel dishwasher wont work says F1 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB. The main reason this happens is putting cups on the drop down shelves and whe ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Flood sensor location fisher & paykel DD603 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

How do you remove a fisher paykel dishwasher - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


If you are just going to fix it you dont need to remove the hole thing WARRING UNPLUG THIS THING B 4 YOU EVEN TAKE OUT ANYTHING ON IT there is power to stuff even when it's off what problem r u having ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and paykel diswasher f1 fault code - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


F1 fault code means the flood switch is activated. There is moisture at th e base of your dishwasher.\015\012 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

We purchased an expensive top of the line Fisher and Paykel 2 dryer dishwasher when we did a total Kitchen rehaul over 1 year ago. We have been noticing water sitting in the bottom of the bottom drawer that smells like sulfur dioxide and now see water is making its way through the maple cabinet to below the sink. None of the plumbing under the sink is leaking. We also purchased a Fisher Paykel gas oven/range at the same time. We notice the oven does not appear to close completely with a tigh


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Fisher and Paykel Dishwashers

Fisher and paykel dishwasher won't drain - Fisher and Paykel Dishwashers


SOLVED! Remove the white plastic shield under drawer, look for the small green U-board circuit board near the center. If it's loose, that's the problem because the board has a sensor that detects the rotor spinning and if loose the computer gets con ... Fisher and Paykel Dishwashers

Fisher paykel dish drawer f9 - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

FISHER PAYKEL DISH DRAWER U3 FAULT CODE - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


LP is a setting for Low pressure. To reset your pressure to HP, hold the Programme and Eco touch switches simultaneously for 5 seconds. Once the setup mode is entered a beep is emitted andthe LCD is red with ‘HP’ or 'LP' displayed. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Fisher paykel dishwasher not draining well - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


Check the drain hoses by removing the dishdrawers from the machine and pulling on the hoses. I installed a Fisher Paykel DD602 about a month ago and the bottom drawer was not draining. I removed the drawer and freed up the drain hose and the machine ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel Hi I have a fisher paykel dd603 dishwasher. when I run the bottom drawer on its own ,,it also fill the top drawer with water ! so after the dishwashing cycle , im left with water in the top drawer. im guessing that a valve should close on the top drawer to stop this happening? is there a part I could order and replace myself? thanks [email protected]


Check your email ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Fisher paykel I have a Fisher Paykel DD603. It is rarely used. It is blinking F2, and is 'clanking'. I try to figure out your forum and cannot find answers. Thank you


Looks like another older post unanswered, but for the sake of info I will answer it anyway.F2 is a "motor not sensed to be rotating" code. This can be a simple as the rotor not being seated in the base properly, or it can mean you need a ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

E6 code on fisher and paykel dishwasher - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

Fisher and Paykel Error code Ho - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & paykel dw681es wh - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0206 seconds