Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

Getting and F1 code on both drawers and a beeping sound


Answers :

That is the code for water in the drain pan. If you access the bottom pan you will notice water in it. This happens when the lid does not seal properly usually. Check the lid seals and also listen to the acuator motors to see if they are straining. I have replaced quite a few of these motors. They must be replaced in pairs for each draw.
\015\012www.appliancehelponline.com
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Getting and F1 code on both drawers and a beeping sound


That is the code for water in the drain pan. If you access the bottom pan you will notice water in it. This happens when the lid does not seal properly usually. Check the lid seals and also listen to the acuator motors to see if they are straining. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi My F&P dishdrawer flooded. Dried it all out etc, the top drawer doesn't complete the cycle and it beeps continually even when it's not running. I am wondering if I can reset the drawer using the front buttons to get it back to factory default. Bottom drawer works fine. There is no error code on the screen only the lock icon which won't go away. Any ideas?


Not sure if you tried turning the power off at the main switch. Lock icon can gone away if you press the necessary keys as shown in the user guide. Also the sequence of keys to press for getting factory defaults of different options is also in the us ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Drawer won't open and get beep code 2 short 1 long


The drawer door seal is locked in. This could be either because the controller has lost power or the seal actuator motor is faulty.\015\012\015\012You will have to force open the drawer before you can do anything. (Turn off the mains powe ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

DD602I USA v2. Runs approximately 10 min then beeps continuously and on the front panel the middle light is red and on the inside panel the "Del" "Fast" and "Rinse" lights are red. What is this fault code indicating? I have made sure spray arm, impeller assembly, are clean and not blocked. No kinks in drain line. Induction motor sounds a bit noisy. This is only a problem with lower drawer, top drawer works fine. Thanks, Keith


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Have a Kenmore Freestanding Dishwasher that was working when hooked up to the sink. When we plumbed it in and connected the electrical directly, we now get an "F4" flashing on the panel with a beeping noise and the pump sounds like it wants to drain but just get a sucking noise. I've tried putting water in it to prime the pump, but still doesn't want to work. Do the codes mean anything, or point to a specific part?


... Kenmore 24 in. 16332 / 16334 / 16339 Free-standing Dishwasher

Westinghouse dishwasher displays code 'i10' and repeatedly sounds 1 beep. Water is not getting into dishwasher and after 60 seconds program stops.Has anyone had a similar problem?


... Westinghouse Dishwashers

I am getting a flood switch activation code on my Kitchenaid kudd01dppa. The pump on the top and bottom drawer keeps running and they continuously beep with the rinse light on.


... Dishwashers

When I press start I get a double beep sound and dishwasher wont go. There are no other codes or anything. Its an Lg ld1204mi dishwasher


... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Kitchenaid kuddo1dppa I own a KitchenAid KUDD01DPPA, 2 drawer dishwasher. I am not a technician, however I have had a lot of experience in repairing various appliances and am savvy with electronics and mechanical technical issues. Here's the problem: I was getting rinse error codes in both drawers, pulled the bottom drawer out, removed the cover to the circuit board and used a dryer to dry up the moisture on the flood switch. Now I am getting Fill Failure error code on both drawers. I have g


Test this steps and fix it. God bless you\012 \012 Water Inlet Valve\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Beeping sound mode electronic panel for both drawers sounds


... Dishwashers

Danby ddw497w will only be about 5 min into cycle when digital code E2 appears it then starts beeping 2 min after this it just stops the unit is only one day old it ran once yesterday fine now i get this code no matter what cycle it is on I bought mine new off the internet and it's been running great for about 2 months. Now I can't get it to drain and E2 shows, I can't get my money back because I've had it more than 30 days, if the solution is a pump, I'm tossing it and getting a good one from


E2 is a hose issue. There is either a kink in the hose, the hose is too high to drain or the pump is faulty.1-800-26 DANBY ... Danby DDW497W 22 in. Countertop Dishwasher

Fisher & Paykel dishwasher drawer won't run, beeps F2 error code


Craig, we had virtually the same situation.  The repair man  came and it took 2 minutes to fix.  The problem was that the bottom drawer had not been used for a couple of years and thus the impellor had jammed.  to fix it take out ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Beeping sound There is a constant beeping sound coming from the dish hinge area. The control keys on top are not functional and are not lit. The only way to get rid of the noise is to unplug it or turn it off at the breaker. Thanks Moreno


... GE 24 in. PDW9880LSS Stainless Steel Built-in Dishwasher

My fisher dd6031 bottom drawer doesn't seem to get rid of all the water,,and it keeps beeping and will keep beeping through the night if you don't catch it...we have been putting it through another rinse cycle to get rid of the water....can you help? Thanks, Maria


You will have to take the filter plate out the motor rotor out. Then clean the rotor cavity and replace in reverse order.\015\012\015\012Are you getting any error codes?\015\012Does the beeping stop if you turn the power off and on? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Dishwasher not getting enough water in either drawer, although top drawer gets more. Dishwasher keeps beeping during cycle and reads not enough water and then stops running until you press the start button. Need Help, any ideas?


This sounds like a hard water deposit problem.Check your water inlet valve for a screen and see if its clogged. Also it may just be a water valve/solenoid problem. As in, it's too crusted up to float up and down.Some models have a water f ... Fisher and Paykel DD605FD Stainless Steel Built-in Dishwasher

Hi, I have a Fisher and Paykel DD603 dishwasher. The bottom drawer works fine but the top drawer doesnt work at all. It appears normal until the start button is pushed and then I get 3 very quick beeps followed but a 4th slightly longer beep. Then nothing happens, any ideas or help would be much appreciated. Thanks Neville.


... Fisher and Paykel 24 in. DD603MFC Built-In Dishwasher

Intermitttent beeping on bottom drawer of dish washer no error code only cycle to work all the way through is rinse cycle. Have turned off power supply over night did not fix problem. When you press pause button restarts for about five minutes then beeps again. No problem with top drawer. All inside cleaned using correct powder and rinse aid.


Panel control board Call Encompass Parts 1-800-638-3328 ... Fisher Dishwashers

Error E1 Just moved to a house where a Fisher & Paykel EZKleen Stainless Steel DD605SS - 2 drawer is installed. Tried to get it going and both drawers show a plate icon and 38 and 45 mins respectively, then there are some sounds and we get Error E1 on both of them. There was no manual and the video they left didn't help. Any ideas? I would also be interested in a link to a User's guid. Thank you, Julia.


There is no e 1 error in dd603 , maybe u1 or f1 , u can call 1800650590 nd ask hem to send the use nd care manual , or download it from fnd p website ,\015\012If it is U1 its saying taps not turned on , more than likey u have a F1 fault which i ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel 2 drawer dishwasher: I too cannot get power to top drawer. 4 days ago we had an F1 code. My husband pulled out drawer, wiped up water, and dried it out. Put it back in overnight, and both drawers worked fine. Now the bottom drawer is okay, but no power to top. Help!


He might have unplugged something in the proccess of drying the bottom ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Have a Fisher & Paykel diswasher model DS603 runs till gets to about 60 minutes and then stops and beeps . No codes. i have to press start again and then finishes washing. What is the problem..


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi, I have a problem with my Electrolux ESF66811X dishwasher. It stops after 15-30 minutes and the progress indicators all start flashing blue and there is also a beeping sound (6 beeps-pause-6 beeps etc). The display indicates code i60. What could be wrong?


... Dishwashers

On our double drawer dishwasher, we are getting a code--which illustrates no water--this is for the top drawer, the bottom drawer, works fine--and the water supply is on--please help.


Sorry to read about your problem, I hope this helps you out.you must have a defective water inlet valve, for the 2nd drawer. or a bad control relay for the valve.I tried to help you. Please help me and Rate/Vote on my response ... Fisher Dishwashers

I have a dishdrawer (2) and following the use of a dishwasher cleaner, the bottom drawer appears to have developed a blockage. It will not empty, gets to the pump out part of the cycle and shows the red error code F3, to which there is no reference in the trouble shooting guide. The top drawer has also developed minute leak, sufficient enough to leave dribble marks on the lower drawer and over time, a white deposit on the floor. Is there anything we can do for the blockage problem before reso


Remove the small basket from each drawer and lift up the removable plastic cover and take the drain filters out , empty them of food by products and try it again.. If you've never cleaned them then that's your problem with the drain process.. Hope th ... Fisher and Paykel Dishwashers

I keep getting a beep and believe it is a Fault Code


Try turnning the unit of at the plug the the controll panel holde the program botton in and trun unit on try this on both draws ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1120 seconds