Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

Fisher and paykel DD603ss ,bottom draw does not slide out easy,,,,


Answers :

Hi- Most likely the lid is stuck in the down, or partially down position. This is usually caused by the lid actuators (motors) not returning the lid to its full up position and therefore the drawer top is dragging on the lid gasket. Replacing the lid actuators should resolve the problem. You'll need a F/P tech to change those for you. Hope this helps.
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Fisher and paykel DD603ss ,bottom draw does not slide out easy,,,,


Hi- Most likely the lid is stuck in the down, or partially down position. This is usually caused by the lid actuators (motors) not returning the lid to its full up position and therefore the drawer top is dragging on the lid gasket. Replacing t ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel DD609 diswasher - top draw does not drain properly. Water build up in bottom of the top draw even when bottom draw is used.


It is usually due to a small piece of broken glass or plastic blocking\015\012the little propellor that pumps the water out, (think of the little\015\012paddle in Nemo's tank)\015\012You need to remove the bottom of the machine, undo one screw ... Dishwashers

Fisher Paykel control panel to far left side has a film on it that chipped off - showing a shinner stainless steal under it. I guess this is a coating of some sort. Dish draws are 4 1/2 yrs old. Mild det on them only. Only bottom draw has the cracking on it. -- can that be fixed or just has to stay ugly.


You can buys the parts that look chipped/ broken and replace them. Panel parts are very easy to replace.\015\012\015\012Check out which parts you need from the parts manual and order from the local fisher and paykel distributor.\015 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Cannot turn my fisher and paykel dishwasher off..keeps beeping and motors are running in both draws. I have taken the bottom draw out and it is dry.. I can only turn it off if I turn the house mains off (then everything else is off!!)


I am assuming you infer that the bottom of the dishwasher is dry when you took the bottom drawer out. This means the floodswitch located on the power filter board at the bottom of dishwasher might be faulty. Do you get any Fault code on the display. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel M#DD603SS - While not running F1 repair mssg


Actually the part is called a Link Actuator. There is one for the upper drawer and one for the lower. When the drawer is shut, it will actuate and the dishwasher will lift the drawer up against the upper lid. When the actuator is broken, this will ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

While unpacking my new Fisher Paykel Dishwasher, the top draw slide out and now is not closing properly. What can be the problem and how can it be fixed.


The cause of drawer not sliding properly could be a few. \015\012Please provide the full model number.\015\012\015\012Also please note down what you see on the display if anything when you turn power on and try to shut the drawer. ... Dishwashers

Bottom draw noise - Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher


Usually means rotor or motor is getting ready to fail ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

How much is service and maintenance of Fisher Paykel bottom draw that does not work


THere could be lot of reasons for the drawer not to work. Need some description of what is happening before making any suggestions. If there are no lights on the panels then the controller or controller power is faulty. Could cost upto $300 to fix th ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

F2 error on bottom draw screen - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Anyone have experience with a Fisher Paykel double draw dishwasher (model DD24) getting stuck in wash mode? Once it hits exactly 48 minutes it stays there. Only several hours later it cycles through OR you have to turn it off put it in rinse mode to complete. Already tried all the basics (unplugging, no fault codes, cycled through the diagnostics everything good and working). Did the quick diagnostic cycle of 14 minutes and everything cycled through fine. Next step will be to put the bottom cont


... Fisher and Paykel Dishwashers

Bottom draw displaying U1 error message - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher


There is no water coming to the drawer.\015\012\015\012This could be due to several reasons. The tap must be on as I presume the top drawer is working.\015\012\015\012Could be one or more issues like Inlet solenoid,controller ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Dishwasher error have a fisher paykel ds603i, top draw is receiving an error, constantly beeping with red light showing, bottom drawer is running


The error was a flood fault, water was not draining from either of the drawere, I removed the bottom drawer, dried drip pan and used hairdryer to dry fault sensor, the dishwasher then reset itself and works fine. ... Fisher DS603W / DS603B / DS603I Dishwasher

We purchased an expensive top of the line Fisher and Paykel 2 dryer dishwasher when we did a total Kitchen rehaul over 1 year ago. We have been noticing water sitting in the bottom of the bottom drawer that smells like sulfur dioxide and now see water is making its way through the maple cabinet to below the sink. None of the plumbing under the sink is leaking. We also purchased a Fisher Paykel gas oven/range at the same time. We notice the oven does not appear to close completely with a tigh


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Fisher and Paykel Dishwashers

Fisher & paykel double dish drawer top draw just beeps...


The controllers get very brittle & can break away from their housing, the reason it's rapidly beaping is because it thinks the door is open. PLEASE TURN IT OFF FIRST AT THE POWER POINT. Take the front draw panel off by pulling the plugs situated ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The backlight on Fisher and Paykel DD603SS has gone out


There is some reason the LCD needs to be reset. Un plug the cord. Remove the front panel, on the top right you will see the small circuit board. On the right of the circuit board there are a few connectors. Disconnect them all and leave for 30 minu ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Is there anyone out there that can HELP!!!!.I have the f/p dd603h model and have had nothing but problems with it the latest being the bottom draw is a struggle to pullout+top draw keeps beeping very very annoying!!!!.Have tried to locate actuators by pulling out bottom draw but not quite sure what I'm looking at,and are they easy to replace?


The source of the problem could be the power filter board at the base of the dishwasher under the bottom drawer. This supplies power to both the drawers as well as operates the actuator motors for the drawer lid seal. You could replace the power ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and paykel twin draw


Both draws are identical in size, its only the draw fronts that are different & yes they will but a lot of messing around. ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Fisher Paykel DD602 removing bottom drawer - Fisher and Paykel 24 in. DS603H I Built-In Dishwasher


You can view the following video to check how to take the drawer out. The steps are shown half way into the video. Make sure the mains plug is pulled out from the socket before w ... Fisher and Paykel 24 in. DS603H I Built-In Dishwasher

Fisher paykel Hi I have a fisher paykel dd603 dishwasher. when I run the bottom drawer on its own ,,it also fill the top drawer with water ! so after the dishwashing cycle , im left with water in the top drawer. im guessing that a valve should close on the top drawer to stop this happening? is there a part I could order and replace myself? thanks [email protected]


Check your email ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

We just purchased a used Fisher and Paykel DS 603-i. After installing and running the normal cycle there was a lot of water left on the bottom of each drawer. We ran the bottom drawer (water stil siiting on the bottom of the top drawer) and part way through the main wash cycle we got what I think was a F1 error code (we do not have the LCD version but the Rinse light was activated). I took out the bottom drawer, dried out the basin and then took out the washer and reattached the drainage pipes t


Hi\015\012\015\012\015\012Thanks for using FixYa. F1\015\012error means that the flood switch has been activated. You’ll need to reset it by poweri ... Fisher and Paykel 24 in. DS-603 Built-in Dishwasher

Hi, I have a Fisher Paykel DD603I (integrated) dishdrawer unit. The bottom drawer soap dispenser has water in it after it runs (and leftover soap), and there is a small amount of water sitting in the bottom of the drawer. The dishes don't get totally clean. I have removed and cleaned the spray arm, drain filter, filter plate and bottom of tub. Found nothing clogged or particularly dirty. Put all the parts back in and everything moves freely. Ran it empty, and same problem occurred.


Hi Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doe ... Fisher and Paykel Dishwashers

Hi, I emailed sometime ago about my fisher @ paykel dishwasher not working. This will be the first time I've used your service and I'm just a little unsure how effective it will be. I guess I'm a just being sceptical but i really want it fixed without paying call out fees and the like. So how much do i have to pay. The top draw will not turn on. At the time the draw was hard to open so i went through the procedure to recalibrate the draw when i was holding down the buttons to get it into self t


Please confirm if you still have a problem with the dishwasher. It is unclear from the thread of your responses as the statements of the other expert will be visible only to the client. \015\012Also please confirm what you mean by "buttons stop ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

On 2 door dishwasher model DD603 bottom draw is very hard to slide out or in. Can i remove draw to inspect and oil draw runners?


Hi- Most likely the lid is stuck in the down, or partially down position. This is usually caused by the lid actuators (motors) not returning the lid to its full up position and therefore the drawer top is dragging on the lid gasket. Replacing the l ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Greetings. I have a Fisher & Paykel dishdrawer - the top drawer appears to have lost power mid cycle and the lid has not retracted - no led display - no response from the buttons. The bottom drawer functions ok. I have tried turning the power off at the wall for 30 seconds and on again. I have tried swapping the top and bottom controllers and the bottom still works but the top does not, so the controllers must be ok Not sure where to find the model number sorry. Any suggestions?


Describethe inside of unit,any wear on it anywhere, the rack the dishes go on is it plastic coated? is it wore with rust comeing though on tips here and there? ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0830 seconds