Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

It keeps running and shutting off. The repair symbol is lit on the screen that shows a little wrench


Answers :

Is this problem with both the drawers or just one of them.
\015\012
\015\012Do you get any other code in the display along with the wrench symbol?
\015\012
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

It keeps running and shutting off. The repair symbol is lit on the screen that shows a little wrench


Is this problem with both the drawers or just one of them.\015\012\015\012Do you get any other code in the display along with the wrench symbol?\015\012 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Our ESD310 has a message of OP on the screen. It will come on and run on its own if the door is shut, counting down from 2. When I can get it to turn on and start a cycle it runs a bit, skips a bunch of time, runs a little more, and then skips time again counting down from 2. The high temp wash button will light up on it's own while running. The cancel button does not work. It acts as if it has a short, makes funny noises, and I'm afraid it's going to catch on fire.


... Haier ESD310 24 in. Dishwasher

Dishwasher Dilema Hi, Can someone help me solve this problem. Last time I had a problem with my dishwashers I was pretty successful in solving it on this site. I was running a reg wash on the top drawer of my Fisher&Paykel when I suddendly had to stop it in the middle of a wash to add more dishes (something I do all the time) suddenly both screens started beeping with an F1 along with a wrench. It sounds like both motors top and bottom are running full blast. I tried shutting the power for a few


You need to remove the bottom drawer and dry out the water with towels and a hair dryer when this is done it should operate normally. most likely when you pulled out the drawer the water sloshed back and out of the drawer making the dishdrawer think ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Fisher & Paykel DD24DCX6 Double Drawer DW shuts off at approx 2 minutes into cycle and again at about 24 minutes showing a water spigot symbol on the LCD screen


... Dishwashers

Both drawers keep running, wont shut off F1 appears as error message with a small wrench showing


Water leak into the base, wrench means call service engineer. You can remove the bottom drawer by pushing in locking clips at side of rails after you pull the drawer out and lift it off the rails. DISCONNECT from electric supply before attempting to ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Hi I have a Bosch dishwasher . The red tap symbol is showing . The little filter pump is spinning but not pumping . It continues to run when door is opened . Can you help please


Sounds like you have a water leak. The machine is fitted with a leak detection device that runs the drain pump constantly as a safety mechanism. If you want to look your self you will need to pull the machine out and tilt it back and if possibl ... Bosch 24 in. SHV55M03GB Built-In Dishwasher

Miele G842SC - opened the door while the dishwasher was running, the washer kept running and when I shut the door it stopped working. I have un-plugged the power and tryed to re-start but no luck. The Canada center says it is going to be 2 week for a repair and I have to wait to the day of to find out when the repair person is going to be there. I cannot believe the lack of service and support for this product.


... Miele Dishwashers

Dish washer will not run through cycles. No error appears on screen. Time display shows on led screen, however dishwasher will not run. How can I solve this problem?


Have u tried turning off the power to t and see if it reset and then trying it again ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Bosch built in dishwasher shu4302uc The dishwasher appears to run through the cycle but the cycle keeps running. I have checked the screens and they were clear. I have a Bosch Dishwasher SHU4302UC and I can't figure out how to cancel the cycle it's in. It keeps running and running. It pumped all the water out and the LED indicator are lit for the rinse/dry.


There is a recall on the control board of many of these models. I have written a guide to help. It is here. Look for the phone number near ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a GE Potscrubber 1230 dishwasher and the closing latch seems to close properly but unless I jam a piece of folded cardboard under the latch when it is closed, the unit will not run through cycles properly. Is there a down-loadable diagram that would show how to disassemble this mechanism and show how this works? I wish to attempt to repair. Thanks


... GE Dishwashers

The power is going to the dishwasher. The on off buttons work. No error codes. The salt light is lite (has been for 5 years) but now I get zero response when shutting the door (after selecting any of the 6 run options). There is no noise, no water, nothing happens. How do I repair this dishwasher so that it will run again?


Door switch failure. This will shut down all other start options. Inspect and possible replacement. See if you can activate it with something with door open. Give it a good close look... ... Dishwashers

We heard our bosch dishwasher just running last night but not circulating any water. I took out the drain screen and there was some dirty standing water so I used my shop vac to remove. It is still just running and no water is flowing. I was told it is the flood shut off? Please advise ASAP. Thanks


Hi\015\012\015\012The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The wa ... Bosch 24 in. SHX46A05UC Built-In Dishwasher

My garbage disposal had something stuck in it. i did not know and the sink was backed up. i started the dishwasher and it sounded like the motor was running like a drain emptying...i thought it would stop but continued. i unplugged the dishwasher, freed the garbage disposal and the drain is now clear. i turned on the dishwasher and the sound is the same. the large POT light is lit up and when you try to shut it off it doesnt stop running. i unplugged it for fear of breaking something. HEL


Hello,Welcome to FixYa.Based on your post, the ... Asko D3251HDSS Stainless Steel Built-in Dishwasher

WHEN YOU PLUG THE UNIT IN , YOU HAVE TO HIT THE RESET TO MAKE OT RUN. tHEN WHEN IT START IS RUNS SHUTS OFF AND YOU AGAIN HAVE TO HIT THE RESET. THIS HAPPENS OVER AND OVER. iT ALSO LEAKS, i HAVE HAD THIS FOR LITTLE OVER A YEAR AND REALLY DECIDED ITS A PIECE OF JUNK. iT APPEARS FIORM THE SERVICE CENTER I TALKED TO, ITS COST MORE TO FIX IT THAN A NEW ONE. WHAT A RACKET.


Hello Dennis,You are looking at 2 possible causes for the resets. First is that the GFI adapter has become defective, or water has found its way inside. Either way, it will need to be replaced if it defective. Second, the GFI may be do ... Karcher PSI Electric Pressure Washer

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

Hi, I have an ASKO D3250 dishwasher and it keeps stopping during the wash cycle and flashing the heavy pots and pots symbol simultaneously. I tried cleaning the filter basket and found a little plastic part floating in there that has printed on it PP-T20. I don't know where this piece goes or if it's even the culprit. There is a little bit of water not draining from the filter area when I unscrew the outer filter basket, I cleaned it out, but when I re-run it, it still stops and gives the dual f


The part is a cap for the drain pump. You can put it back into position by removing the filters and placing it to the left of where the circular filter would be positioned. The part goes in with the part numbers on the bottom facing down. When posit ... Asko 24 in. D3530FI Built-in Dishwasher

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

I have a Kenmore dishwasher, and when we shut the door, without starting a ccyle or anything, the motor will start going!! When we do start a cycle, it will get stuck at some point during the cycle and won't sanitize or show the "clean" display light as being lit.


... Kenmore Dishwashers

A red ligth is on, and on the screen I can se a wrench and a symbol of a crossed water tap, what should I do?


... Fisher and Paykel 24 in. DS603H SS Free-standing Dishwasher

The dishwasher beeps and shows a little wrench and F2, it will not cycle


Looks like you do not have the user manual for this dishwasher.Refer this site.on page 24. F2 means the motor is having s ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Asko D3120 I have resolved the problem of pum always running by tilting the dishwasher but now I have a new problem of the pump not draining the water in the bottom of the dishwasher. I thought it was clogged so I removed the screen and filters but did not stick my hand in the hole to clean... I used the plunger for at least 30 mins. Then I tried to pour a little CLR because I have hard water. NOTHING please help me


In the bottom where the filter are, you can see a yellow 'thing'. Remove this and stick one finger in an try to rotate the pump wing. Try to remove particals that is blocking the pump.\015\012Or there is something in the drain hose. Try to drai ... Asko 24 in. D3120 Dishwasher

Hello, We need some assistance with our Kenmore dishwasher. Last night after I started a load, the dishwasher just stopped and then the washing and drying lights started flashing red, sanitized and green are flashing green and the 6 hour delay button is flashing red. I have pushed the start/cancel button but to no avail. My husband shut the power from it to see if it would reboot, it does not help either. It runs a little bit then quits and does not clean the dishes. Could you give us sugg


Hold the start button for 3-4 seconds and see what that does ... Dishwashers

Water does not drain. does not sound like pump is running. drain lines are clear. do i replace, do i repair. one other problem is the ge profile pdw 9980n00ss does not show up in your database.


After every wash/rinse stage you should hear the pump pulling water out of this machine. I guessing it is hooked to your sink, therefor you should hear a gurgling sound when the washer is discharging waste water. If you don't hear this water discharg ... Dishwashers

Dishwasher turns on without anyone pressing the start button. Wrench symbol is on the screen of both drawers. Thanks, Bill Hewitt


This is a message indicating that there may be a water leak in the unit casing. You can open the bottom drawer and left it off it's tracks and take a look with a flashlight to see if there is any water in the casing. I would put a paper towel and s ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Pressure washer Honda Craftsman pressure washer 2400 PSI that runs for a little bit and then shuts off for no reason.


... Karcher 2500 PSI Pressure Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1305 seconds