Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

My DD603 is flooding onto the floor and F1 is flashing/not turning off.


Answers :

You have probably figured out by now that the only way to stop it is to unplug it. The F1 code means that the Mains Filter flood sensor has been activated. There are a few reasons this may occur. 1. there was a large pan or dish that prevented the lid from closing fully, thus flooding. 2. the lid actuators, motors, did not close the lid completely and they need replacing. 3. the Link Support (holds the wires and hoses in place behind the drawer) has broken and is impeding the lid from closing fully. It and the lid would have to be replaced. These are the normal causes for the F1 error code. You will need to get a Tech out to have a look to determine the cause. Good luck.
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My DD603 is flooding onto the floor and F1 is flashing/not turning off.


You have probably figured out by now that the only way to stop it is to unplug it. The F1 code means that the Mains Filter flood sensor has been activated. There are a few reasons this may occur. 1. there was a large pan or dish that prevented th ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Today, dishwasher started overfilling, and spilling water onto the floor. We turned off the water supply and let the dishwasher finish its cycle, turned on the water, started another cycle and it began to overfill and spill onto floor again.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is overfilling it’s ... Whirlpool 24 in. DU920PW Built-In Dishwasher

I've had a Miele G892 SCU PLUS dishwasher for a long time. Today a problem started that results in a flooded floor. Water keeps flowing into the dishwasher - even when the unit is turned off. It seeps in very slowly, but within15 minutes there is enough to overflow & flood the floor. My guess is that there must be some kind of sensor that isn't working, or the coresponding mechanical switch that shuts off the water is worn or slightly stuck open a bit? Anything I can do / check, short of the re


... Miele Touchtronic G892 Built-in Dishwasher

Dishwasher flooding Hi my Asko D1716 Super Cleaning System Dishwasher has started to have a flooding problem. When the cycle finished last night it seemed fine then in the morning the machine was full of water, I scooped out the water and by this evening the machine had flooded onto the kitchen floor. I tried other solutions I found on this website but they didn't suit my dishwasher as it doesn't have the appropriate buttons. Any suggestions would be appreciated!


When you say that you tried other solutions.. it's hard to know which you've tried and which you haven't so I will suggest some basics first.. ( if you've tried them, then disregard)...\015\012Have you checked or addressed the following:\ ... Asko D1716 Built-in Dishwasher

Water flooding onto floor when running.


The most common cause of this is a loose clamp on the pump discharge hose. It could also be a cracked hose, the hose came off (again, loose clamp). Check both ends - where the hose connects to the dishwasher AND where it connects to the sink drain. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Our Miele DW just keeps going through cycles constantly and will not shut off on its own. It has gone all day. When we turned the dial manually to "OFF", the water keeps filling until it overflows the machine onto the floor. So far, our only option has been to turn the machine back on and let it keep running. Any suggestions?


Hi,\015\012\015\012sounds like a faulty electronic unit as i have seen this before where the unit continously fills with water. \015\012you will probably need a service call to repair the unit unless you are happy to fix it yourselv ... Miele 24 in. G865 Built-in Dishwasher

The clean water fill will not shut off and water overflows from the dishwasher onto the floor. We had to turn off the water supply to the dishwasher to get it to stop.


Fill valve is shot , new one required \015\012\015\012Ps \015\012\015\012Does it still run when you remove the power if so the above applies \015\012\015\012If it shuts off then the problem sits with the pressure s ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I have a single draw Fisher and Paykel dishwasher. I stupidly put washing up liquid in the dishwasher which resulted in a F1 problem. Water started leaking under the draw and onto my floor. I turned the dishwasher off at the power point and have cleaned up the leak. Have I damaged my dish washer? How do I fix it?


Ok , F1 means your flood switch has activated, which is underneath the drawer. now they show the F1 fault because of 2 reasons.1st there is still water underneath drawer causing switch to activate. 2nd your activator board which has the flood switch ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Hi, I have a Kleenmaid Dishwasher and the anti-flood system is being triggered (when I tilt the dishwasher, water runs out onto the floor). I am quite sure the leak is coming from the pump as the dishwasher stops during a drain cycle. How do I take of the panels to check what the problem is?


... Dishwashers

Dishwasher won't drain. Floods out onto the floor. How do I clear the drain, I have already cleaned out the filter


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa.\015\012Dishwasher not draining properly or not draining at all issues can arise due\015\012to different reasons. Usually, these issues are related to kinked hoses,\015\012knocked o ... Bosch 24 in. SHU43 Built-in Dishwasher

I bought a used 7 1/2 year old fisher paykel dd603 for my tenant, it worked fine the first time. second time she got F1 code on both drawers. water was in lower pan, we sopped it up and dried it out. also drawer was not seating level but was lower on left side, and insulation had fallen off left wall. all now corrected. but now the top drawer leaks onto floor on left side. it did not leak before repairman came out, we checked thoroughly. repairman says top lid not seating properly and i need ne


I have the same model F&P and just experienced similar problems. My top drawer was leaking due to that "not important" thin white tube. It really sounds like you called a general appliance guy and not a trained F&P repairman. The guy who fixe ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?


You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

I HAVE A BOSCH SHU5305 DISHWASHER THAT WHEN IT IS TURNED ON IT WILL NOT DRAW WATER FOR THE WASH. IT JUST SITS THERE AND HUMS. HAD A BIT OF WATER FROM THE SINK BACK UP IN THE DISHWASHER AND SPILL OVER ONTO THE FLOOR YESTERDAY. I CLEANED THE DISHWASHER FILTER WHICH WAS COMPLETELY CLOGGED. I THINK THE DISHWASHER WORKED FINE PRIOR TO THIS INCIDENT BUT THIS COULD ALL BE COINCIDENCE. I DON'T KNOW IF I HAVE A PLUMMING PROBLEM OR A WASHER PROBLEM. THE SINK WATER WORKS FINE. I CHECKED THE ON/OFF WATER VA


If the solenoid valve is humming and calling for water, you probably have a plugged screen in the valve, some you can get to and clean, some you have to replace. ... Dishwashers

In the early cycle before the soap even opens water begins to pour out tof dishwasher and onto the floor. Lots of water. Then I turn it off clean up the mess, restart and it runs fine. What do you think it is?


TO MUCH SOAP BULD UP RUN A FEW TIMES WITH NO SOAP ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

I recently had the e4 error code on my new world dw60 dishwasher. I have since opened it up and replaced the heater element, which appears to have resolved that issue. However, in the process of doing this I incorrectly installed the flood switch back into place, meaning that it was in its closed position (i.e. the position it would be when activated by a flooded base) when I went to turn the dishwasher back on. I have since opened it back up and correctly installed the flood switch, but I ca


... Stoves 27 in. DW60 Built-in Dishwasher

Hi I have a Nemo Dishwasher and the top spray arm is not turning. The bottom one is going fine and there is certainly plenty of water getting into the washer as I opened the door with the washer going and it flood me. I can see the water getting into both spray arms - the bottom one has a excellent upward spray and turns - the upper spray arm has water getting into it but it will not turn. I have cleaned the dishwasher out and any internal parts that I could find so it is spotless - this is so f


... Fisher and Paykel DS602 Dishwasher

Fisher-Paykel DD603 DishDrawer shows F1 fault code. The Flood Switch has been activated. I need instructions on how to re-set the flood switch. I have two drawers that are possitioned one above the other and the are both giving the error of the activated flood switch. Any advice or instruction is greatly appreciated.


Fisher-Paykel DD603 DishDrawer shows F1 fault code. The Flood Switch has been activated. I need instructions on how to re-set the flood switch. I have two drawers that are possitioned one above the other and the are both giving the error of the activ ... Dishwashers

Our KitchenAid KUDS011JBS1 dishwasher sometimes leaks water on our kitchen floor. It seems to drip from the bottom edge of the door onto the floor. It's not a huge amount of water, but is enough to be a concern... it leaves a small puddle on the floor. What should I check and how do I fix this? I'm hoping it's an inexpensive and easy fix. Note that we've had this dishwasher for 8 years and have only noticed leaking during the past 6 months.


... Dishwashers

Float switch dripping water onto floor while dishwaser running


You will find that the flood switch will be operating due to the leak, it will most likely be from one of 2 places:1. Around the door seal, Give it a clean and check for splits/damage, and make sure screws on door hinges are tight. 2. Check t ... Dishwashers

Contunuous draining turned into a flood when unit powered off


The fill valve is governed by the float switch. I doubt that your fill valve (solenoid) has failed. Focus on replacing the float switch and you should be all set.Good Luck! ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Dishwasher flood I have a whirlpool "Queit Partner I" type dishwasher. When I used it for the first time it flooded my kitchen floor. I had to stop in the middle of everything. What do I do from here. Not sure if I put in the correct detergent or if I put too much in. Never had one of these things before. I was always the dishwasher...help...I can be reached at [email protected] Thanks for your help.


... Dishwashers

Continuous beeping and lock is intermittentyl showing on DD603, have tried turning off power, holding in lock button, turning off for 10 mins etc. CAnt stop it and driving us insane!! Can anyone hlpe us out please? Cheers, EFC_Blue


You need to Call the Fisher & Paykel customer service line and tell them that your Unit is Experience a Power Malfunction Usually its related to water leaking. ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

XL30 Hi temp. Two problems: 1) Hi temp booster not working...worked on and off for awhile, now won't get up to 180. 2) Turned on today and water flooded out. Water overfilled machine, turned off and heard pump drain unit.


To attempt to solve the over filling, clean the probes in the back right corner. Use a green scrubby pad.\015\012\015\012There is also two probes under the front screen. Clean them too.\015\012\015\012As far as the booster not ... Dishwashers

My AEG dishwasher will fill up fine but will not move onto the next stage. It will dispense the cleaning tablet but then won't move onto the rinsing cycle, staying on main until i manually turn it off?


Hi,\015\012The highest percentage of the time, the heating element is failing (or not heating)causing the the timer to not advance.\015\012\015\012Try and find a 'reset' switch inside the machine, if no joy, a serviceman may have to ... AEG 24 in. Favorit 60820W Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0833 seconds