Having problems with your Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher ?

DD601ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the s


Answers :

Check for restriction in sump. ie remove rotor, push pipe cleaner or similar from filter sump into rotor sump
Repair Help & Product Troubleshooting for Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DD601ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the s


Check for restriction in sump. ie remove rotor, push pipe cleaner or similar from filter sump into rotor sump ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dd601 ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the


I had the problem with the top draw not draining properly and the dishwasher showing the U3 fault code on my DD601 v.1, I did'nt have a copy of the dishwasher manual so it took the following steps, this is best done out side to save on messing your k ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel DD609 diswasher - top draw does not drain properly. Water build up in bottom of the top draw even when bottom draw is used.


It is usually due to a small piece of broken glass or plastic blocking\015\012the little propellor that pumps the water out, (think of the little\015\012paddle in Nemo's tank)\015\012You need to remove the bottom of the machine, undo one screw ... Dishwashers

Greetings. I have a Fisher & Paykel dishdrawer - the top drawer appears to have lost power mid cycle and the lid has not retracted - no led display - no response from the buttons. The bottom drawer functions ok. I have tried turning the power off at the wall for 30 seconds and on again. I have tried swapping the top and bottom controllers and the bottom still works but the top does not, so the controllers must be ok Not sure where to find the model number sorry. Any suggestions?


Describethe inside of unit,any wear on it anywhere, the rack the dishes go on is it plastic coated? is it wore with rust comeing though on tips here and there? ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a F&P Model DD602I. I had a repairman out to change out hoses that were bad and now I have this problem: When I just run the bottom unit, it works fine, but a bunch of water ends up in the top unit that I have to drain out. If I just run the top unit, water collects in that unit causing a default. Now if I run both units together and I start the top unit about 3 seconds after starting the bottom unit, both units work fine! When I look at the hoses under the sink, they loop down quite a bi


Try to isolate the drain hose of the top drawer by disconnecting from the U hose. Run the bottom drawer. \015\012\015\012Similarly isolate bottom drawer and then run top drawer.\015\012\015\012See if problem is linked to back ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Hello, my Bosch Classixx dishwasher SGS43E42EU/21 has me stumped. It starts by taking in water but when "filled" pumps out for a couple of seconds then refills for say 10 seconds more before another 2 or 3 seconds of pumping out. This cycle continues for ages without starting to wash. I've tried various things: - checked the Auto Stop valve isn't being activated by leakage (removing the polystyrene float and bottom tray makes no difference - there's no leak) - the valve seems to operate it


Hello Dave,\015\012\015\012Sounds like an overfill problem - the symptoms are consistent with a failed pressure switch. Water enters the dishwasher through a chamber which has a float arm connected to a small microswitch -this is the pres ... Bosch Dishwashers

My Kenmore Elite dishwasher (model 665.17462300) is not spraying the water from the basin in the bottom up through the rest of the dishwasher. The basin fills with water, then just makes a humming noise and appears to splash a little of the water around the very bottom of the dishwasher. When we cancel the cycle, it does drain out the water from the basin. I cleaned all the gunk and debris out of the basin in the bottom, but it didn't make any difference.


... Dishwashers

WHEN RUNNING A CYCLE ON TOP DRAW THE BOTTOM DRAW WILL FILL UP WITH WATER NOT DRAIN


The drain hose going to the kitchen sink is blocked. If you have an insinkerator in your kitchen sink then run it first. Otherwise take the dishwasher hose out from the sink outlet and run straight into sink to see if any difference. ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

After wash cycles are completed there is about 1/2 gallon of water remaining in the bottom of the washer. I checked the drain that exits into a disposal and that is clear. All around the bottom of the washer base is clean and I can find no obstruction. Nothing in the owners manual gives me a clue as what else to do. I don't want to start taking things apart unless I have to.


Hi and welcome to FixYa. I am Kelly. Most dishwashers are connected to the sink / garbage disposal via an Air Gap. The Air Gap gets debris inside it that blocks the drain passages. Check out this video on how to clean it: ... Maytag 24 in. MDBH950AW Built-in Dishwasher

I have a F and P 603 dishwasher with a similar problem as to a recent post here. My top drawer doesn't turn on and my bottom drawer does. Well it just has after I swapped the "blue" motor inside from my top one. Now, I have tried and opened as far as the translucent "X" plastic from the bottom of my bottom drawer showing the motor and it looks fine. I have even swapped the control board from my top drawer to try and see if it works and it actually does. So, problem persists. Top drawer do


Alright, open up the outer panel of the machine. Note the positions of the wires on the switches and\015\012remove them, unclip the switch housing from the base panel. The\015\012switch housing contains one switch for each drawer. The switches are\01 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Frigidaire FDB125RHD1 and it has a round white plastic drain in the bottom, I want to take it out to clean it. It moves around, but doesn't seem to unscrew, how do I get it out without breaking it?


Hi\015\012\015\012Please check the part of hose which is in contact with panel. You'll be able to see a clamp, press the top of the clamp inwards and pull out the clip using a screwdriver. Next, you'll need to remove the two screws at the ... Frigidaire 24 in. FDB1250RE Built-in Dishwasher

I am installing drain hose to dish washer, model # 6651382 & affraid to pry loose the thin gray box where hose is clamped to take hose off. Has like cupped hands over hose on top. Open on bottom


... Dishwashers

Just installed fisher paykel model 88270 dishwasher, bottom drawer has no power,and top drawer does not fully drain. Cant find another power cord, is there a second one? Cant locate the manual.


... Fisher Dishwashers

Dishwasher is 2 years old. Top shelf dishes not getting clean even on on heavy duty and sani rinse cycle. All arms move freely,tried the 2 cups white vinegar in an open container and run cycle. I thought that helped but a few days later we are back to the same thing. No debris around drains. Tried loading differently. I have called for a repair person,but is there anything else I could check on my own?


Sometimes the holes in the arms get blocked up,sweetcorn,rice etc, this then stops the arm spinning and water being sprayed onto plates etc, unscrew it and run water through the centre hole and see what happens. ... KitchenAid Dishwashers

I have a Maytag dishwasher, Model MDB4100. Are there directions for removing the cleaning equipment in the bottom of the dishwasher? I do have the manual and there are no instructions to do this. I am getting scummy buildup around the drain and suspect it needs a good thorough cleaning that I can't do without taking it apart. I have tried to clean away the "gook" but it reappears after a few washes and I can't reach the back. Thank you, Cara


... Maytag 24 in. MDB4100 Built-in Dishwasher

Need to know how to take the see through cover off under the top draw on the DD603 dishwasher to replace the drain hose on Fisher and Paykel


I think you are referring to the wiring cover at the bottom of the drawer. I will assume you know how to get the drawer out.\015\012\015\012To remove the wiring cover \015\0121. Carefully release the four wiring cover clips from the ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Blockage (i think) top draw - seal orginally locking draw


After you remove the rack you can also remove the large stainless cover( it unscrews, and then under that id the rotor assy , it also unscrews, giving you access to the ports that would be blocked if any, you can refer to your manual for ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Top draw dead bottom draw works fine


The heter plate has a fuse molded in it change the heater plate ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Bottom drawer drains into top drawer


I can offer a PERMANENT fix for this! That machine has never been installed properly since day 1 I would bet, and a series of techs have come thru unable to fix it right, or they keep selling you those "flappers" that fix the issue for a short period ... Fisher DD603B / DD603W / DD603H Dishwasher

Top drawer is draining into bottom drawer and bottom drawer is draining into top drawer


Hi, Make sure that the drain hoses are looped at least as high as the top washing part. With no loop the water is free to pump from one drawer to the other. I simply tied the hoses up under the sink with twist ties. That was over 2 years ago and have ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Two drawer dish washer ... Both drawers drain fine when operated individually but the top drawer will not drain fully if the bottom drawer is operated at the same time (bottom drawer drains fine in these conditions). I am guessing that this is a setting issue rather than a clog, but what is the mechanism that is tripped when both drawers are cleaning? Perhaps a mother board issue?


You have a clog in your line from the top basket somewhere in between the bottom of the dishwasher. ... KitchenAid Dishwashers

We have a built in GE dishwasher. It has worked fine for about 4 years but now the glasses in the top rack will not come clean. I have cleaned all the holes where the water comes out but I think the sprayer that is beneath the top rack (the one that is attached to the bottom of the top rack) is not rotating. We had someone out to take a look at it and they said it was fine. It isn't fine as it is not cleaning the dishes. Is there a reason that the bottom sprayer is not turning?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Maytag Dishwasher

Kitchenaid Dishwasher model # KUDS25SHBS1 has started making noise. Noise happens when unit is draining so perhaps its the same mechanism that houses the grinder. Can definetly hear a clicking as something spins around to drain the unit. I have removed the washing armature and plastic skirt around bottom and felt underneath the skirted area, but don't feel anything caught or jammed. Noise is getting louder as more draining cycles are being utilized (i.e. as we use the machine more). Anyone have


Looks like motor noise. Check the pump. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1667 seconds