Having problems with your Fisher and Paykel 24 in. DD603H W Built-in Dishwasher ?

Fisher and paykel DD605SS

\015 The top dishwasher doesn't work and when we turn turn the dishwasher on ti makes the beeping sounds but somehow the bottom dishwasher works fine. when we turn the top one on then after about a minute it stops and starts to make the noise again and it continuous shows the lock. any help would be greatly appreciated\015\012\015\012The same thing happened with my Fisher and Paykel DD603 dishdrawer, however because I am in a small flat I only have the one drawer.I have tried reseting it by holding down the three buttons, but it didn't help. Occassionally the cycle will start after doing this - but will stop quarter or halfway through, the lights flashing and constant beeping.\015

Answers :

I can talk you through finding the fault on live chat. cheers
Repair Help & Product Troubleshooting for Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water does not empty from the draws DD605SS - Fisher and Paykel DD605SS Stainless Steel Dishwasher


The pump may have something lodged in the impeller and will not allow it to pump. To access the pump, the drawer must be removed and turned 90 degrees to the left. Unplug the wire harness to the pump. Loosen the clamp on the drain hose and then remo ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Fisher and paykel DD605SS


I can talk you through finding the fault on live chat. cheers ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Soft touch shows f4 code - Fisher and Paykel DD605SS Stainless Steel Dishwasher


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Dishes have soap residue despite using rinse aid. Machine is quite abrasive on coffee mugs etc. Unit is Fisher & Paykel DD605SS


Use less soap.....excess soap in the rinse cycle will not allow the dishes to rinse properly causing white etching on the glasses and the dishes will have that gritty feeling ... Dishwashers

Machine displaying f1 - Fisher and Paykel DD605SS Stainless Steel Dishwasher


The F1 error refers to 'internal flood.'You may wish to reset the power of the unit, this may clear the error code.One\015\012common cause is too much or 'wrong' detergent causing too many suds. In\015\012this case, giving the ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Dishwasher setting is stuck on heavy - Fisher and Paykel DD605SS Stainless Steel Dishwasher


Please provide some detail about the problem. does it work on that setting. clean the panel with damp clean cloth. ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Lower draw does not drain. - Fisher and Paykel DD605SS Stainless Steel Dishwasher


The drain hoses on these dishwashers are very small check you y connection at your drain point for blockage if this is ok listen to the motor when it is suppose to drain if you can hear it trying to pump out dismantle spray arm and filter assembly an ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Fisher and paykel DD605SS


Hold all three bottons: power, pause and start and power cycle the unit, it will reset the dish washer. ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Dd605 f9 error - Fisher and Paykel DD605SS Stainless Steel Dishwasher


... Fisher and Paykel DD605SS Stainless Steel Dishwasher

Error E1 Just moved to a house where a Fisher & Paykel EZKleen Stainless Steel DD605SS - 2 drawer is installed. Tried to get it going and both drawers show a plate icon and 38 and 45 mins respectively, then there are some sounds and we get Error E1 on both of them. There was no manual and the video they left didn't help. Any ideas? I would also be interested in a link to a User's guid. Thank you, Julia.


There is no e 1 error in dd603 , maybe u1 or f1 , u can call 1800650590 nd ask hem to send the use nd care manual , or download it from fnd p website ,\015\012If it is U1 its saying taps not turned on , more than likey u have a F1 fault which i ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Code u1 fisher& paykel model 920 - Fisher and Paykel Dishwashers


Hi, this tells you everything you need to know about a \015\012 fisher& paykel model DW820 and DW920 modelsi was also looking for the u1 error, and im sure my problem is being a male i use to much detergent (powder) that creates extra foam ... Fisher and Paykel Dishwashers

Fisher&paykel dishwasher wont work says F1 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


The f1 fault is cased by a leak on the dishwasher.It is activated when water gets to a dangerous level in the base of the appliance near to the PCB. The main reason this happens is putting cups on the drop down shelves and whe ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Fisher and Paykel f1 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


Hi\015\012\015\012Error F1 on your fisher & paykel means an overfill condition. One of the most common causes for an overfill fault is that the dishwasher cannot pump out the dirty water due to a plugged drain hose. Check the drain ho ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Fisher paykel dish drawer f9 - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

We purchased an expensive top of the line Fisher and Paykel 2 dryer dishwasher when we did a total Kitchen rehaul over 1 year ago. We have been noticing water sitting in the bottom of the bottom drawer that smells like sulfur dioxide and now see water is making its way through the maple cabinet to below the sink. None of the plumbing under the sink is leaking. We also purchased a Fisher Paykel gas oven/range at the same time. We notice the oven does not appear to close completely with a tigh


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Fisher and Paykel Dishwashers

Fisher & paykel dw681es wh - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

How do you remove a fisher paykel dishwasher - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


If you are just going to fix it you dont need to remove the hole thing WARRING UNPLUG THIS THING B 4 YOU EVEN TAKE OUT ANYTHING ON IT there is power to stuff even when it's off what problem r u having ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel Hi I have a fisher paykel dd603 dishwasher. when I run the bottom drawer on its own ,,it also fill the top drawer with water ! so after the dishwashing cycle , im left with water in the top drawer. im guessing that a valve should close on the top drawer to stop this happening? is there a part I could order and replace myself? thanks [email protected]


Check your email ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

FISHER PAYKEL DISH DRAWER U3 FAULT CODE - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


LP is a setting for Low pressure. To reset your pressure to HP, hold the Programme and Eco touch switches simultaneously for 5 seconds. Once the setup mode is entered a beep is emitted andthe LCD is red with ‘HP’ or 'LP' displayed. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Fisher and paykel dishwasher won't drain - Fisher and Paykel Dishwashers


SOLVED! Remove the white plastic shield under drawer, look for the small green U-board circuit board near the center. If it's loose, that's the problem because the board has a sensor that detects the rotor spinning and if loose the computer gets con ... Fisher and Paykel Dishwashers

E6 code on fisher and paykel dishwasher - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

Fisher and paykel diswasher f1 fault code - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


F1 fault code means the flood switch is activated. There is moisture at th e base of your dishwasher.\015\012 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel dishwasher not draining well - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


Check the drain hoses by removing the dishdrawers from the machine and pulling on the hoses. I installed a Fisher Paykel DD602 about a month ago and the bottom drawer was not draining. I removed the drawer and freed up the drain hose and the machine ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel I have a Fisher Paykel DD603. It is rarely used. It is blinking F2, and is 'clanking'. I try to figure out your forum and cannot find answers. Thank you


Looks like another older post unanswered, but for the sake of info I will answer it anyway.F2 is a "motor not sensed to be rotating" code. This can be a simple as the rotor not being seated in the base properly, or it can mean you need a ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Flood sensor location fisher & paykel DD603 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0153 seconds