Having problems with your Fisher and Paykel 24 in. DD603H W Built-in Dishwasher ?

NOISY fisher paykel DD603 motor Problem. pulled the impeller,center ring and outer ring and discovered there was wear on the bottom spindles. do I need a new motor assembly?


Answers :

It could be as simple as something just poking out of the pipe from the filter to the impellor, big enough to get through the filter, but not big enough to be moved out by the impellor, remove the filter, and the impellor, and poke something through the pipe, a drinking straw or such like will work...
It depends on how bad the wear is. You can trim the roughness off the impellor with a craft knife. Also check the stator impellor housing for damage as well and try to flatten or scrape off any bits of roughness where it shouldnt be. Make sure the motor impellor is pressed firmly together before re-fitting to the stator.
\015\012
\015\012Hope this helps
Repair Help & Product Troubleshooting for Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

NOISY fisher paykel DD603 motor Problem. pulled the impeller,center ring and outer ring and discovered there was wear on the bottom spindles. do I need a new motor assembly?


It could be as simple as something just poking out of the pipe from the filter to the impellor, big enough to get through the filter, but not big enough to be moved out by the impellor, remove the filter, and the impellor, and poke something through ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

The wash pump is leaking, not at the larger joining o-ring seal, but through the vents in the bottom of the motor just past the blade/rotor. Is there a small o-ring inside that is on the shaft that may be leaking? Is there a schematic breakdown of this motor somewhere? I already ordered a new one, and will "play" with the old one to see if I can fix it, just looking for some direction.


The shaft seal has failed. Often the top ball bearing becomes noisy after having the water leak through it. The seal is probably a lip seal rather than an O ring. ... Frigidaire 24 in. PLD3465REC Stainless Steel Built-in Dishwasher

I have an lg ldf7811st and the bottom arm will not turn. I purchased the part 1267558 (motor assembly, vario spray valve) to repair it and I need instructions on how to install this part. Please advise.


You need to uninstall dishwasher and tip it backwards on the bottom of the dishwasher you will see a square panle remove the 2 screwsand replace the part then proceed in revers to put together ... LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher

Our church has a Toastmaster Commercial Dishwasher with a Franklin Electric recirculating pump assembly that is making a bearing noise. We may need a new pump motor or pump. Do you know where we might get one?


... Hobart 41 in. AM14-255 Free-standing Dishwasher

I have a Kenmore Dishwasher Model #665.168790000 and the water fills just fine and empties fine when cancelling cycle but when pressing any wash cycle the pump/motor just makes a loud humming noise and does nothing. I took apoart the lower assemblies to clean everything out but the problem hasn't gone away. Do I need to replace the motor or the whole motor assembly (also contains impeller kit)??? Also, I don't think I need to replace the whole sump & motor assembly do I???


... Kenmore Dishwashers

We need to replace the locking ring in the bottom of our Asko 1716 dishwasher.(It's cracked) I can only find one kind of replacement ring for that,but it looks like the right size. I need to know if Asko uses one ring for more than one model of dishwasher?It's a 5" locking ring for the bottom well of the tub. Thanks for your help!


Only 1 size ... Asko D1716 Built-in Dishwasher

Have a Kenmore Elite Dishwasher (66513123K701). Was not cleaning dishes very well so we ran diagnostics on it and found a problem with the diverter motor (W10155344) so we replaced it. Now, the dishwasher is leaking from the diverter. There was a o-ring from the original diverter that we had to keep since the new motor did not come with it. Wondering if we should get a new o-ring/seal, but I cannot find mention of such a part anywhere. Is there a certain way to seat the o-ring? Is it ok to


I have experienced the same diverter motor leaking problems. I have the whirlpool gold with the diverter motor (w10155344). I bought the unit new 4 years ago. The fix is remove the the two screws that hold the diverter motor and pull the motor. ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

If motor needs replacement, is it better to get a NEW dishwasher?


Replacement usually costs about 250.00-450.00 usually.. you can look at partsdirect.com or repairclinic.com for the parts.. both even dive you a schematic so you can see how they both go together ... Neff 24 in. S5443X2 Built-in Dishwasher

KitchenAid dishwasher Hi I have kitchen aid kds 20 dishwasher around 25 years old it has a broken motor and I was trying to put a new motor in it,the old motor has 3 wires white,black and ground but no extra startrelay. the new motor (partno: 4171686 from whirlpool) has 4 wires white,black , yellow and ground , also in package was startrelay but no wiring info for this motor. I Need wiring info if someone can help. Regards. Bjorgvinj


... KitchenAid Dishwashers

I have purchased a repalcement detergent dispenser-assembly and do not know how to take old one out and relpace with new part. The new part has a face plate that snaps on to the screw mounted base plate assembly which attaches to the door. I need to know how to remove the old dispenser and install the new dispenser without breaking parts and scratching the door. Is there a schematic or exploded repair view I can check out or even written directions?


Hello\015\012& Welcome to FixYa\015\012\015\012To replace the detergent\015\012dispenser you can check this video. The video gives you step by step\015\012instructions:\015\012\015 ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

I bought a Frigidaire Dishwasher on November 2006. Model #PLD4375RFCO. (I paid K&N Sales $549.00) In October 2008 I called your toll free Number to report Er code was flashing. You recommended Best Service. I called them and the repairman said the"vent was not closing - fault on Drying fan - vent is closed. Sensor bad on assembly." I needed a new drying fan assembly (for $148). With his service fee and labor after he returned to put in the new assembly, the total paid to Best service was $318.25


... Dishwashers

GSD4911X02SS leaks from the bottom. Opened the bottom cover to see where the leak is and it looks like it's leaking in two places. The leak is ont by the door. It looks like the leake is by the pump or motor dripping down. The diswasher still works, but the leak needs to be fixed. Also I have pictures if you need to see


... GE 24 in. GLD6200L Built-in Dishwasher

I have a go kart with a honda power washer motor that I just purchased.It lacks power at start and stalls alot.Put new pull in,sprayed carb cleaner,adjusted carb,new air filter,need to know if it need a fuel pump and were to get one


Hondas are gravity feed no pump needed .You might need to clean the card though. ... Karcher 2500 PSI Pressure Washer

LG dishwasher LDS4821BB just started making a new grinding sound while washing. No similar sounds while filling or draining, so I wouldn't think it is the motor assembly like many answers suggest. We installed it March 2009. This sound may be similar to one which led to the motor assembly being replaced while still under warranty about nine months ago. Unfortunately, the LG repairman was too hard of hearing to be able to diagnose that replacement, so he did it based on our description of


... LG LDS4821BB 24 in Builtin Dishwasher

My bosch dishwasher sgs09a15 is leaking on or from the pump assembly can i repair the pump or do i need to replace the pump motor assembly completely en which do i need


I consulted another website ... Bosch Dishwashers

Ld-1416T I have an LG LD-1416T dishwasher and the lower spray arm does not turn. The top arm turns and the top rack is washed well. I pulled everyting out and cleaned all the filters (which weren't that dirty) but still no luck. I could only get so much stuff out to clean before it looked like to go any further, I would need to gain access through the bottom. Are there more filters in the motor area which might need cleaning? I read that it could be the vario motor. Can I test this? and if s


If you have one spray bar working then there is enough pressure. There is only one pump. So you should check the spray bar to see if it is plugged. Also check the seals to see if they are bad. ... LG Dishwashers

Buzzing sound we have a gold quiet lll edition , it is now buzzing when we start it. we have had a repair man here twice each time he has taken it apart and cleaned it. he has said because we have hard water, the water oxidized and some sediment has broke though the seal into the motor and now we need a new motor. does this sound right? we have had dishwashers from whirlpool for years prior. never had to change a motor. please can you offer some suggestions? thanks very much desperate in Mexico.


If buzzing while it is washing then probably is a motor problem but mostly not from hard water just poor quality parts ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

2000 epw Northstar Item # 157942E 230v 2000 psi 3.5 gal/min #5 nozzle Problem: No pressure. Motor running...seems to be in bypass. Checked starter...but not finding power to the pressure regulator. May need a new starter/relay/contactor. Was working fine..May wish to order a starter and a possibly a pressure regulator...I have photo's of the complete set up if needed. Need to know part numbers to order and what company to order from. Thanks, Greg Scott


... North Star Stainless Steel Under Car Cleaner 16in

The little actuator type motor in the dispenser goes off buzzing like crazy and its random. This motor is used to open the dispenser door. I bought a replacement dispenser assembly which includes new motor and it still has the same random buzzing sound. Would this be some type of issue with a relay or something?


Hello.\015\012Thank you for using Fixya.\015\012\015\012this is the troubleshooting of your problem:\015\012\015\012Unjam the motor \015\012Unjam the pump \015\012Test t ... Kenmore 24 in. 16352 / 16354 / 16359 Built-in Dishwasher

Good Morning, I don't need any help except to get rid of my lg dishwasher because it is the worst dishwasher I have ever had!!! I have had it fixed once(new motor ,new soap tray,new board) and it still does not work good and still smell like it is burning up. I have not been as unhappy with anything in my life. WISH I HAD NOT HEARD OF LG AND WASTED A LOT OF MONEY!!!!!!!!!


Hi,You might be interested in this.....http://www.contacthelp.com/directory/Shopping/Electronics/LG?ListingID=386heatman101 ... LG Dishwashers

Kenmore Dishwasher Model #110703412 leaks, likely around the motor shaft. Are there motor shafts seals and how are they replaced? Does the motor assembly remove through the tub or does it require being removed from the bottom? Do you have to remove the dishwasher from the cabinet to do this job?


... Kenmore Dishwashers

I purchased a NEW Whirlpool dishwasher from Appliance Direct in Daytona Beach FL. The dishwasher was delivered broken. It needs a new motor pump. I asked for a new machine and they said it's their policy to fix a machine that's been delivered. I think I have a lemon. It's been a month now since delivery and they haven't even repaired the machine. Do you have any advise on how I should proceed? Glenda


You must go with the fact and hold the company accountable. 1 call speakto manager get his name and direct #. give him 3days to resolve the problem. ask him will it be repaired monday or teusday because both of those days are convinent for you.then f ... Dishwashers

My Karcher 205 M is leaking water from the bottom of the casing during normal operation. I have bled the system and the water flows through fine until you turn on the motor, then it starts to leak, can you help, I have rung Karcher and been told it sounds like the pressurised motor system faulty and a new motor is £50.- Many thanks, Glynn


... Pressure Washers

Kitchenaid kuds01dj model. washer fills with water then stops and then the motor hums and does not seem to engage. after a couple of minutes water drains out and the fill process starts again. as before motor hums gets really hot but doesnot engage. does this mean i need a new motor, capacitor? please help


... KitchenAid KUDS01DJ - Multiple Color Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2071 seconds