Having problems with your Fisher and Paykel 24 in. DD-602 Built-in Dishwasher ?

I have a F&P Model DD602I. I had a repairman out to change out hoses that were bad and now I have this problem: When I just run the bottom unit, it works fine, but a bunch of water ends up in the top unit that I have to drain out. If I just run the top unit, water collects in that unit causing a default. Now if I run both units together and I start the top unit about 3 seconds after starting the bottom unit, both units work fine! When I look at the hoses under the sink, they loop down quite a bi


Answers :

Try to isolate the drain hose of the top drawer by disconnecting from the U hose. Run the bottom drawer.
\015\012
\015\012Similarly isolate bottom drawer and then run top drawer.
\015\012
\015\012See if problem is linked to back flow from drain.
\015\012
\015\012I am assuming by now you may have already solved the problem.
Repair Help & Product Troubleshooting for Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a F&P Model DD602I. I had a repairman out to change out hoses that were bad and now I have this problem: When I just run the bottom unit, it works fine, but a bunch of water ends up in the top unit that I have to drain out. If I just run the top unit, water collects in that unit causing a default. Now if I run both units together and I start the top unit about 3 seconds after starting the bottom unit, both units work fine! When I look at the hoses under the sink, they loop down quite a bi


Try to isolate the drain hose of the top drawer by disconnecting from the U hose. Run the bottom drawer. \015\012\015\012Similarly isolate bottom drawer and then run top drawer.\015\012\015\012See if problem is linked to back ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

LG LDF6810ST had OE error. Disassembled found no obstructions blew air through and vacuumed hoses to air gap and to disposer, no obstructions. Never heard pump run when starting cycle, so replaced drain pump. Still doesn't run. Looked at the service manual, and the only other suggestion is repair circuit? Is this the circuit on the bottom right of unit or the pcb up top? Wires and connections all look fine. What else could it be. Any suggestions appreciated!


Hi,Usually my First Response to this Common Error is :-Most likely pump trap is clogged up. Access it behind small door at front. Drain water out through small hose that is there otherwise water will be all over the floor when ... LG LDF6810ST Stainless Steel Built-in Dishwasher

My Professional series dishwasher does not work properly. It is only 1.5 years old and glasses on top rack get sprayed with fine layer of particles every time I use it. Other items, top and bottom, are often not clean as well, but glasses are the hardest to re-clean. I have tried evacuating the water left at the bottom of the dishwasher before running, pre-running the hot water in the sink and ensuring that the disposal was run, removing and cleaning the filter at the bottom of the washer. None


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Frigidaire PLD4375RFC Dishwasher

I have an shx65905uc bosch dishwasher that runs and works except for that there is not enough water pressure to rotate the top wand or operate the top sprinkler. The bottom wand does have water and turn and does the top but it is not enough to turn it. If i remove the bottom wand and plug it off then the top will work properly. I have cleaned all screens and removed the plate to access the pump and all seems fine. Any Thoughts


... Bosch SHX65P05UC Dishwasher

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Top dishwasher codes f 1 & shows picture of wrench bottom unit works fine it is a fisher&paykel


Forums.whirlpool.net.au/archive/584206 give this a go. has a few solutions ... Dishwashers

Water does not pump to the top, there does not seem to be any obstructions any where, the unit fills with enough water and seems to pump fine but only to the bottom of the unit.


Have you checked the pump? ... Dishwashers

About a month ago, our dishwasher stopped working properly. It runs fine and the soap is being used, but the dishes are not being cleaned and especially on the top rack. I opened the dishwasher this morning while it was running and I noticed that the coil on the bottom was red (maybe heating water) but only about 1/16th of it. Could this be the problem?


Hi\015\012In a dishwasher you can see the water trickle upward to the upper nozzle in dishwasher...but if it does not have enough pressure,it will not function properly.tap the delivery tube that feeds this nozzle and you will see the water pre ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Terrible smell When I run the dishwasher there is a terrible smell.  It cleans fine.  I run the top one and there is water in the bottom trap that seems to be the source of the problem.  I turkey basted it out.  Ran rinse cycle with baking soda but it still stinks.


Yea disposers are most likely cause of odores backin up into the d/w's you can try running through a cycle with a bowl full of vinegar. the vinegar will flush put of the bowl during wash and get all the nooks and crannies clean ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Northstar pressure washer powered by a honda GC160 engine. The last time i used it, water leaks from the bottom of the unit, whether it is running or not. When running, the pressure is fine. I have felt underneath and it appears that the water is coming from the second opening from the rear. Is there a pressure relief valve there. I have a manual but cannot find any descriptors for underneath the motor.


This is a piston seal issue. You can get a kit to rebuild the pump. ... Comet AXD 3020 G Pressure Washer Pump

During wash cycle it gets stuck and won't move past the wash cycle. On a regular wash it is at 28minutes and when it is on a fast wash it is at 25 minutes. If I stop it and turn on the rinse cycle it will run through the 12minute rinse cycle with no problems. It is only the top dishwasher that does this, the bottom one is running just fine.


I've got the same problem with the bottom drawer on the DD605. No fault codes were set. I checked the heating element and it produced heat quickly. I suspect that the water temp sensor isn't satisfied, and the timer is waiting for the water to rea ... Fisher and Paykel DD605BK Dishwasher

Bottom sprayer does not clean or work, all items on bottom are the same as put in. Top is fine. runs through whole cycle.2 hr 29 min


Check the free rotation of the spray arm. If arm jets are clogged clean them.After placing the dishes see to it that, the arm is freely rotating without any obstacles. ... LG 24 in. LDS 5811 Built-in Dishwasher

Dishwasher drain is hooked to a food disposer and until recently the unit worked fine. Last week following a cycle a couple of inches of water did not drain out. All food is removed from dishes, silverware, etc. prior to loading and the food trap in the bottom is completely clear. I ran the unit empty through a Lightwash cycle and afterwards the water level (that which didn't drain out) looked to be the same as before. The dishwasher is run 2-3 times weekly whereas the food disposal is


Hi, The I don't think the problem is with the loop and the 32" above the floor.If the dish washer was removed from one house to another, did *********** ever have a dish washer in the house before that he replaced this one with? The reason I am aski ... Dishwashers

The top washing spinner isn't cleaning dishes, there doesn't seem to be any water flowing through the spinning unit. Bottom cleans fine only top rack washer is not working


Hello there:This is normally a condition that is due to a filter that could be getting clogged or that the sprayer arms are clogging up so what i would do is first clean the sprayer arm holes a tooth pick works well for this ne ... Kenmore Dishwashers

I have a Bosch SHU9955UC/14 dishwasher. I am having problems with the top rack not cleaning. The dishes on the bottom rack are cleaning just fine. I have taken the rotating spray arm off and cleaned it out and replaced it. I have also taken all of the filters out of the bottom of the unit and cleaned them. Any other suggestions for fixing this problem?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch SHU9955UC Built-in Dishwasher

Hi, I have a fisher and Paykel double dish drawer model DD605. A couple of days ago when we opened the top drawer all the lights flashed and beeped in sequence repeatedly and would only stop when the power was turned off or the dishdrawer closed. Today I went to turn the top dish drawer on and cannot change the cycle off rinse. I can push the eco button and the rinse cycle works no problem but I cannot change the cycle. The bottom drawer is running as I write this and appears to be fine. An


Hi\015\012\015\012\015\012Could you please let me know which all lights are blinking/lit solid in sequence from right to left. This could be an issue of drawer lock mechanism or flood switch issue. PLease post back with detai ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi My F&P dishdrawer flooded. Dried it all out etc, the top drawer doesn't complete the cycle and it beeps continually even when it's not running. I am wondering if I can reset the drawer using the front buttons to get it back to factory default. Bottom drawer works fine. There is no error code on the screen only the lock icon which won't go away. Any ideas?


Not sure if you tried turning the power off at the main switch. Lock icon can gone away if you press the necessary keys as shown in the user guide. Also the sequence of keys to press for getting factory defaults of different options is also in the us ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi experts - My dishwasher won't drain properly. There's several inches of standing water in the bottom of the unit. During the drain phases of the wash, the motor underneath doesn't spin and a buzzing is coming out of the motor relay. During the wash and rinse phases, the motor runs fine and all appears well. Any thoughts? Thanks!


Either the water outtake or the pump are clogged - you will have to remove it to see where's the problem. ... Frigidaire 24 in. FDB679GF Built-in Dishwasher

Dirty dishes after a reg. wash the dishes are not clean. this happens mostly on the top rack, right side. the bottom rack seems to be doing fine. this problem was not there when we got the unit however it is getting worse.


... Bosch Evolution 500 SHE45M06UC Built-in Dishwasher

My Fisher Paykel dishwasher is model #DD6051. After about 1 1/2 years, the top drawer is not filling with water. The fault code looks to be U1. The bottom drawer fills and runs fine. Would you have any idea what the issue might be? Thank you very much.


Hi,Unplug the Washer for Few Minutes, say 30 minutes and then Turn it ON. If the problem Persists, then read :-U1 Heavy and Rinse LEDMachine has failed to prime with water within approx. 3 minutesReason ... Fisher and Paykel Dishwashers

The top drawer started getting very loud - maybe the water pump? Now it looks as if no water is getting into the drawer so dishes remain dirty. The bottom works fine, and is not loud when running.


Yes it is likely the pump rotor is seized. I am assuming the water goes in to the drawer but does not get moved around by the washer arm. This i ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Kitchen Aid Dishwasher KUDR24SEBLO does not drain 100%. I have removed the drain hose and chcked the sink P-Trap, [it drains thru the garbage disposer]. Unit is 10 years old, otherwise works fine. I am having difficulty removing the impeller and items above the pump to see if it is clogged. Do you think I have a partially clogged pump or a timer issue that prevents the pump from completely emptying the bottom of the dishwasher? We have run the dishwasher 20-30 times since observing the problem.


Hi there,\012Please check out the following -Pump - Your dishwasher pump ejects the water. The pump is usually mounted directly to the motor, then attached to the bottom of the dishwasher. You can reach the pu ... KitchenAid Dishwashers

Unit is leaking. Just bought it used, runs fine but leaks water out the bottom of the motor. Can this be repaired ? Is there a gasket or o-ring or something to replace ?


It might be the pcv(positive crankcase ventilation) valve. Go to a parts store and ask for a new valve($5-$10) and also ask where it is. It's usually right on top in the back of the engine where you described. If the hose is all cracked then yo ... McCulloch FHH18A Electric Pressure Washer

Frigidaire dishwasher Water does not go through arms, bottom or top, at all (does not wash). You can hear motor running. Pump works fine; discharges water as normal and fills to proper level. Problem just started with no warning; no strange noises etc.


CHECK WATER INLET SOLENOID OR TIMER ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1301 seconds