Having problems with your Fisher and Paykel DD24DCFX6 Dishwasher ?

Both dish drawers showing code F1 - Fisher and Paykel DD24DCFX6 Dishwasher


Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel DD24DCFX6 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Both dish drawers showing code F1 - Fisher and Paykel DD24DCFX6 Dishwasher


... Fisher and Paykel DD24DCFX6 Dishwasher

FISHER PAYKEL DISH DRAWER U3 FAULT CODE - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


LP is a setting for Low pressure. To reset your pressure to HP, hold the Programme and Eco touch switches simultaneously for 5 seconds. Once the setup mode is entered a beep is emitted andthe LCD is red with ‘HP’ or 'LP' displayed. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

F2 Code Hey, I have a single drawer built in Fisher & Paykel dish drawer and today I pulled the spray arm, filter and large metal screen out to clean them as we have been starting to get a bit of stuff left behind after washing lately. That was all good After putting it all back in though I went to use the dishwasher and it stopped and came up with an F2 fault, I thought I may not have put the bits back in properly so pulled them out again and noticed that on the rotor that connects the motor to


Fault F2 means the rotor is not rotating. If you say some of the vanes have broken off, they could have been jamming it. This should spin freely with minimal force when installed correctly. If you removed the rotor itself, you do ned to take care whe ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

What is error code 00 on dish drawer - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Fisher & Paykel dishwasher drawer won't run, beeps F2 error code


Craig, we had virtually the same situation.  The repair man  came and it took 2 minutes to fix.  The problem was that the bottom drawer had not been used for a couple of years and thus the impellor had jammed.  to fix it take out ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Fisher paykel dish drawer f9 - Fisher and Paykel Dishwashers


... Fisher and Paykel Dishwashers

I have a Fisher and Paykel DD605i dish drawer. We have a U1 error code on the top drawer and had this same problem just over a year ago. A repair person replaced the inlet valve I believe. I am wondering if there are any tests I can put the machine through or if this is something I can fix myself to see what is causing this code.


... Fisher and Paykel DD605I Dishwasher

Top dishwasher codes f 1 & shows picture of wrench bottom unit works fine it is a fisher&paykel


Forums.whirlpool.net.au/archive/584206 give this a go. has a few solutions ... Dishwashers

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

Fisher & Paykel 2 drawer dishwasher: I too cannot get power to top drawer. 4 days ago we had an F1 code. My husband pulled out drawer, wiped up water, and dried it out. Put it back in overnight, and both drawers worked fine. Now the bottom drawer is okay, but no power to top. Help!


He might have unplugged something in the proccess of drying the bottom ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

We have a Fisher & Paykel two drawer dishwasher, model DD603. The top drawer doesn't work - when you push the Start button, there is a series of 4 quick beeps, and there is some symbol of a dish with 3 drops of water, but it doesn't do a wash. The bottom drawer works fine. Though the unit is level, the drawers do not appear to be well aligned. Any ideas?


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Our 2 drawer Fisher and Paykel dishwasher is automatically starting its own washing cycle (well, motor starts, but no water appears to be entering), then it shows F1 error message and a spanner icon flashes. Within 30 secs of this occurring on one drawer, this starts on the other drawer. Only way to stop is to switch off at power socket. Any idea what the error message is telling me?


... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

The top drawer of my fisher paykel dishwasher stops during the cycle and shows an icon of a tap with a line threw it (assume that means no or low water pressure). the bottom works fine so I assume water pressure is not the issue; is there a sensor that could be bad? Also, I did switch the controllers between drawers (good instructions on the fisherpaykelparts.net website) but the problem stayed with the drawer, ruling out the controller.


Did it fill with water? could be 1 of your water valves is faulty, or the little filter for the inlet water is blocked. please reply 4 more help. i"m sure i can fix this problem for you. good luck. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dishwasher Dilema Hi, Can someone help me solve this problem. Last time I had a problem with my dishwashers I was pretty successful in solving it on this site. I was running a reg wash on the top drawer of my Fisher&Paykel when I suddendly had to stop it in the middle of a wash to add more dishes (something I do all the time) suddenly both screens started beeping with an F1 along with a wrench. It sounds like both motors top and bottom are running full blast. I tried shutting the power for a few


You need to remove the bottom drawer and dry out the water with towels and a hair dryer when this is done it should operate normally. most likely when you pulled out the drawer the water sloshed back and out of the drawer making the dishdrawer think ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

My Fisher Paykel dishwasher is model #DD6051. After about 1 1/2 years, the top drawer is not filling with water. The fault code looks to be U1. The bottom drawer fills and runs fine. Would you have any idea what the issue might be? Thank you very much.


Hi,Unplug the Washer for Few Minutes, say 30 minutes and then Turn it ON. If the problem Persists, then read :-U1 Heavy and Rinse LEDMachine has failed to prime with water within approx. 3 minutesReason ... Fisher and Paykel Dishwashers

F4 fault on fisher paykal dish drawer - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


F4 fault would inidicate the temperature sensor that senses the water temperature is faulty or the heating element is not working.\015\012\015\012Looks like you will need a technician to visit and have a look. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a two drawer Fisher and Paykel dishwasher. The lower drawer initially displayed an F1 and now shows nothing. It does not currently display a message even after starting it. It does not appear to engage at all - no water is released into the washer.


Hello,This is a flood error code. The bottom drawer needs to be removed to dry up the water. The video below explains how to do this. It's actually pretty easy. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a DD603 Double drawer Fisher and Paykel dishwasher, it is leaving a residue on the dishes. I currently have Jet Dry in the rinse aid reservoir. What is causing the dishes not to get clean?


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

F1 error code on both dishwasher drawers. - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher


Unit is in flood protection mode (caused by leak), can be cleared by removing bottom draw and drying the residual water around and under the Rfi/flood sensor board. This problem is usually caused by iether the support that suspends the wiring and hos ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I have a Fisher and Paykel Dish Drawer dishwasher. The top drawer is not closing properly


It is likely the lid seal is stuck. You will have to get the drawer out and check the underside of the cabinet at the top.\015\012\015\012The lid seal is a rubber lining which is actuated by a pair of motors. If the motors are faulty or t ... Fisher DD603FCSS Dishwasher

My dishwasher's lid is stuck down and won't retract. I have a Fisher and Paykel DD605 dishwasher, and I think I must have placed some dishes in there that were too big for it and the lid got stuck. It's now showing an F7 error and refuses to do anything other than beep at me. I've tried turning the power off and back on, but it persists with the error. Is there a way to get it to reset and retract the lid? I've read that in situations like this, when people get repair technicians to com


The error code f7 stating that "the communication time out error"this are all the reason for the error1.the motor control micro has crashed and is not responding to communication request.2.the hardware communication link from ... Dishwashers

Hi I have a fisher paykel double drawer dishwasher that is displaying F1 code for flood alert ie a leak somewhere,we cannot however find how to remove the dishdrawer? The plumber has the runner located but it doesn appear to want to give, any ideas? Should this pehaps be seen by a local dishwasher expert? Many Thanks


... Fisher DS603W / DS603B / DS603I Dishwasher

Fisher paykel Hi I have a fisher paykel dd603 dishwasher. when I run the bottom drawer on its own ,,it also fill the top drawer with water ! so after the dishwashing cycle , im left with water in the top drawer. im guessing that a valve should close on the top drawer to stop this happening? is there a part I could order and replace myself? thanks [email protected]


Check your email ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

My fisher and paykel dishwasher drawers is giving me an F1 error code, won't stop running and is acting like it's possessed.


... Fisher Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2035 seconds