Having problems with your Fisher and Paykel DD24DCFX6 Dishwasher ?

My dishwasher keeps flooding - Fisher and Paykel DD24DCFX6 Dishwasher


Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel DD24DCFX6 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher keeps flooding - Fisher and Paykel DD24DCFX6 Dishwasher


... Fisher and Paykel DD24DCFX6 Dishwasher

Paykel&fisher dishwasher keeps running - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Flood sensor location fisher & paykel DD603 - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Fisher and paykel dish washer keeps running - Fisher and Paykel Dishwashers


It will help to come up with a cause and solution if you can please specify the model number of the dishwasher.\015\012\015\012Also please confirm if you hear the pump motor start during the cycle. How do you stop the dishwasher. Is there wat ... Fisher and Paykel Dishwashers

Dishwasher keeps flashing F1 - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


F1 on your dishwasher is the fault code for leaking inside the machine. the water has caused the flood switch to activate. have you put any detergent rather than your normal dishwasher detergent into the machine? if you have, the water probably leake ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Fisher Paykel Dishwasher Model 920 that floods (F1 fault) since the Inlet soloniod was replaced. What determines the water level? I dont see any detectors other than the flood switch sensor in the base.


Just had the same F1 error message. I figured the drain lines were clogged so i hooked my compressor up to them and blew air in the lines for about 5 seconds at 60 psi. It is not giving me the error message anymore and seems to be running fine. ... Dishwashers

Hi I have a fisher paykel double drawer dishwasher that is displaying F1 code for flood alert ie a leak somewhere,we cannot however find how to remove the dishdrawer? The plumber has the runner located but it doesn appear to want to give, any ideas? Should this pehaps be seen by a local dishwasher expert? Many Thanks


... Fisher DS603W / DS603B / DS603I Dishwasher

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

My Fisher and Paykel dishwasher will not keep running.


It may be that the DW thinks the drawer may have been pulled open. On the right side, near the top. there are two light pipes on the\015\012drawer. One sends an infrared beam of light to a reflective area on the\015\012cabinet, the other receives thi ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and paykel elba dishwasher flood switch


... Dishwashers

My fisher and paykel dishwasher model DWDW60CSW1 keeps turning itself on and off even during a cycle. What is the problem?


... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

Code F1 keeps draining constantly - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher


Turn off the main power to the dishwasher.\015\012\015\012I am assuming you are getting F1 error code flashing on the LCD display. This occurs if the flood switch is activated.\015\012\015\012The flood switch is located at the ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Fisher paykel dishwasher dd601I runs complete normal cycle and finishes normally. 2-3 sec. after completion the washer motor srarts to run and the f1 fault (flood sw. activated) is dislayed. When the power button is pushed the fault spontaneously disappears and the motor stops. no moisture is in thre bottom under the tub and the normal cycle can be ru again with the same results.


Hi\015\012\015\012F1 code indicates an overfill condition which may cause when dishwasher can’t pump out dirty water due to a plugged drain hose.\015\012open dishwasher fully ,dry up as much water as possible the ... Dishwashers

The flood switch has been activated on our Fisher & Paykel 2-drawer dishwasher. How do we reset the button?


Turn off the main power to the dishwasher.\015\012\015\012I am assuming you are getting F1 error code flashing (if your drawers have LCD display) or the LEDs are flashing if you have intergrated drawers.\015\012\015\012The flo ... Fisher and Paykel Dishwashers

We keep getting an E4 error on our Fisher and Paykel DW60CSX1 dishwasher. It is only new and initially worked fine, now the error indicates the drainage hose is too high, however it is where it says to locate it according to the diagram


... Fisher and Paykel Dishwashers

Hi - I've been all over your web site and keep getting rejected - alas. I have one of those wonderful Fisher Paykell double drawer dishwasher unit Model # 88445 (I think but also see another number LIM725367) I bought in new in 2007 worked fantastic but tore down my b ungalow now have a new kitchen ready for it. Carol 303 320 1697 [email protected] May 6 2011 11:30 AM MDT I would like to obtain an installation manual so I can make sure I packed all the parts and then put it in m


Hello Carol - \015\012\015\012\015\012The full model number for future reference is DD603-88445. I've uploaded the installation manual for all Fisher & Paykel DD603 double-drawer dishwashers to Rapidshare. Please follow the instruc ... Dishwashers

Hi, I have a fisher and Paykel Nemo dishwasher. It takes water in with no problem. But it stops after fill up the water and the led near "start" button keeps flashing. (flash 6 times and stop for a second, then flash another 6 times, so on) By the way, Heat element has been confirmed works. Any comments? Many thanks.


... Fisher and Paykel Dishwashers

Display frozen My DW920 Fisher and Paykel dishwasher display is frozen on 91 and the normal button keeps on flashing. Also the unit does not respond to any buttom pressed - merely beeps. Thanks in advance.


I think if you push the heated wash and heated dry buttom several times until all the buttoms light up this may fix your problem.You may have different kind of light flashing indicator, but the same solution.Possibly check the sequence sw ... Dishwashers

Hello I have a Fisher & Paykel dishwasher, model DW681ES. The problem is that it stops in its cycle. The reset button keeps flashing. I open the door and there is water at the bottom. It will not drain away. Is there a way to reset the system? Is there something else I can do?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the cycle doesn't complete, then the first thing\015\012that should be checked is the Timer and then ... Dishwashers

My Fisher and Paykel Nautilus dishwasher keeps going and wont finish the cycle, timer gets stuck on 15 and wont count past this.


... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

Fisher and paykel nemo dishwasher keeps stopping and the start rest button is flashing.


... Fisher Dishwashers

I have a Fisher and Paykel DD24D Dishwasher just installed and the fault code U keeps coming on, which says no water, I checked the water supply, it is try on, so now I'm at a lost.....thanks


If the unit is new do not try fix it or have it fixed, or even look into it, call the dealer or take it back to him as you will invalidate your warranty if you do anything to the unit, and that is not worth it. Let the dealer worry about it. ... Fisher and Paykel DD24D Dishwasher

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

Fisher & Paykel DD60DCX6 Top drawer timer stops mid way through clean but dishwasher keeps going - does not prgress to rinse cycle and makes random unsual noises


Hi, from the explanation made above, i sounds like the motor is faulty and needs to be replaced.......Take care ... Fisher and Paykel DD605FD Stainless Steel Built-in Dishwasher

Trying to install a double drawer fisher & paykel dishwasher but the y connector keeps leaking on the rinse test .I think it's because of where I am tightening the ring to the air gap y .Do I tigh ten below the lip of the rubber y or further down?


Hi, welcome to FixYA!Don't use a Y-connector with a single air gap, it will end up having cross-drain issue down the road if not right away.Your double dishdrawer is two machines in one enclosure. Do it right and install a dual air gap, w ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2126 seconds