Having problems with your Fisher and Paykel DD605SS Stainless Steel Dishwasher ?

Hi. The water from the top drawer of my fisher and paykel DD605 dishwasher will not drain away The bottom drawer is workimg perfectly. Please can you advise on repair? Thanks.


Answers :

Hi
\015\012Dishwasher not draining issue usually occurs due\015\012to kinked drain pipe, clogged drain filter or drain pump. First make sure that\015\012the drain going towards the bottom is not clogged and remove clogs if present. If no visible lint is\015\012present then check the drain filter and\015\012drain pump for any clogs, you'll need to clean the drain filter and drain pump\015\012completely. Also, check for any food pieces stuck near the pump impeller &\015\012clean the chopper assembly. Hope this helps...\015\012Please post back for any further assistance.
\015\012Daniel

Repair Help & Product Troubleshooting for Fisher and Paykel DD605SS Stainless Steel Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi. The water from the top drawer of my fisher and paykel DD605 dishwasher will not drain away The bottom drawer is workimg perfectly. Please can you advise on repair? Thanks.


Hi \015\012Dishwasher not draining issue usually occurs due\015\012to kinked drain pipe, clogged drain filter or drain pump. First make sure that\015\012the drain going towards the bottom is not clogged and re ... Fisher and Paykel DD605SS Stainless Steel Dishwasher

The bottom drawer is filling with excess water after the top drawer cycles. It doesn't hamper the use of the bottom drawer as the excess water drains during the cycle, but I am concerned about rust, etc. from the excess water standing in the drawer. Please advise. Denise Arnold


Hi\015\012 \015\012This means that you have an overflow leak problem. You need to shut off circuit breaker or pull fuse. Next let it dry out for up to 4 days ,peak under dryer and feel metal drip pan and ... Fisher and Paykel Dishwashers

Dishwasher top drawer was dead so i was told to change the heater under the drawer i did that but now i got more broblems the top drawer lights up just beeps for a second and does nothing as for the bottom which did work before now works for 1 full minute and then just flashes on and off iam confused can tou please advise me joseph.


Hi,Whenever the Drawer is Dead, there could be a couple of Reasons. First, it could be a Bad Heater Plate or Bad Control Board on the Front.You could remove the Control Board and Check.More often, you would find visually, that they are Ho ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Rusted drawers Please advise where we can get replacement drawers as the bottom tray where plates are stacked has rusted with the plastic coating peeling off.


Go to any used appliance shop and see if they have any for sale or if they can order one for you ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

HI I have a 2 drawer F&P unit. the bottom draw works perfect, the top has not power and no display at all. Please help, Cheers.


Hello,Here is a video that explains how to take the drawer out. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Fisher and paykel dishwasher drawers are showing a F1 fault on the top drawer screen, But it was the bottom drawer that was in use at the time of the fault occured. The top drawer will open but the bottom drawer is locked. I need to unlock this drawer to get my cooking equpiment out. Please Help. I know that the F1 fault is a flood fault but how do fix it.


... Fisher and Paykel Dishwashers

This is the 2nd time I've had problems with my dish drawer. After I cleaned the filter and replaced it, I had standing water on the bottom of the drawer. The last time this happened, I had someone come to repair it - ended up it was me. I didn't put it together properly. This time I did the same thing I was told to do. I still have the standing water. What should I do. By the way, the coils are not kinked in the back either. Can you please give me some advice? Please respond to me at F


Unfortunately I have to respond to you through this post per policy of fixya.com. This s to ensure we have a visibility on the quality of the solution and also allow other consultants to help if necessary.\015\012\015\012Water standing a ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Pykal Dual Drawer Dishwasher. Suspect after young child played with control buttoms on top drawer the power won't come on. Bottom Drawer works perfectly. Have tried turning unit off at power socket but this has not fixed the problem. Is there a sequence of buttons I have to press to re-set or is there in fact a re-set button?


Press and hold the key or lock button for 5 sec or till you here a beep to unlock. Or till the light goes out above the lock button. You can get your manual here just find your dishwasher.\015\012\015\012 ... Fisher Dishwashers

I have a mdd8000aws dishwasher. After a power outage (2 days) the power came back on, and the bottom drawer no longer works. It still make the chiming noise when the drawer is opened, but the control panel is not fully lit up and the washer will not start in any mode. The lights seem to flicker for a short moment and then they all stay very lightly lit up. Is this just a bad control panel or is there some other circuit that needs replaced? BTW, the top drawer works perfectly.


... Maytag MDD8000AWS Builtin Dishwasher

On our double drawer dishwasher, we are getting a code--which illustrates no water--this is for the top drawer, the bottom drawer, works fine--and the water supply is on--please help.


Sorry to read about your problem, I hope this helps you out.you must have a defective water inlet valve, for the 2nd drawer. or a bad control relay for the valve.I tried to help you. Please help me and Rate/Vote on my response ... Fisher Dishwashers

I have F1 flashing on my dish drawer....turn it off a couple of months ago because of the same issue and have not used it since....turned it back on and used the bottom drawer...all OK...went to use the top drawer again and the F1 returned??? please help


Please confirm if the F1 on top drawer shows up immediately you press the Start button or part through a wash cycle? What happens when you turn off the power and back on. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

The top drawer will not take in water. The tap symbol flashes. The bottom drawer is working perfectly. I have cleaned and checked it - no obvious obstruction in the drawer.


1 the inlet valve need replacing its bottom of the draw bit tricky to replace it to check it just unclip bottom draw to the side disconect the hose from the inlet top draw valve and turn it on for a sec see if water pumps out make sure you got small ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

When I use my Karcher pressure washer it works perfectly until I release the trigger. Instead of remaining silent until I pull the trigger again the motor intermittently, at approx 2/3 second intervals, starts and stops. Could you please advise what is causing this to happen please.


What it is doing is keeping the pressure up in the hose. It is completely normal for it to do that. they all do it. Listen to others in use and it will do the same thing. Nothing to worry about. ... Karcher Pressure Washers

My Kenmore 13743 is 3 years old and was washing perfectly until a couple of months ago. It has become so bad that it won't clean anything on the top rack and barely anything on the bottom rack. In fact, I just pulled a butter knife out of the rack that still had butter on it! Not normal... I do not know how to remove the bottom washer arm to get at the chopper, filter, etc. Please help


Hello,\015\012\015\012Welcome to FixYa,\015\012\015\012You are likely right on, this is very common with these unfortunately. Hopefully this will help.\015\012\015\012**Unplug the unit or turn off the powe ... Kenmore 13743 Staimless Steel Built-in Dishwasher

My drawers are both flashing F1 and sound as though they are in high gear. I have unplugged them. Please advise. Please give detailed instructions.


F1 signifies that the flood sensor in the rear of the cavity on the \015\012bottom drawer has been activated. This is caused by water leaking into \015\012the rear of the drawer. I have had the same problem with my own and \015\012also repaired a ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Bosch SHE44C02UC/46 that will finish all of the cycle but leaves a couple inches of water in the bottom. If I pull out the dishwasher and manually active the drain pump float it will drain the remaining water out of the dishwasher. I heard about a cold solder joint on the main controller board but I am not sure if this could be the issue. Please advise wat advise you can. Thanks.


... Dishwashers

I have a Fisher and Paykel 2-drawer dishwasher. The top drawer is stuck in the rinse cycle and I cannot change it to another cycle. Please advise.


Assuming the controller of the top drawer is still ok, take a clean damp cloth and wipe the top panel where the program keys are located. \015\012\015\012If nothing happens, you will have to check if the controller connector is not loose. ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

My kids put liquid dish soap (not for dish washers) into the hole where you put special rinse product. We got all the soap out of the hole and took towels to dry out the tub, but F1 comes on even when the washer is turned off. We have the double tall dish drawer in stainless steel. Even though they did not put anything in the bottom drawer it too comes on by it self and shows F1. I can not find our manual. Please help. Thank you so much. Kim Toth


You can download the user manual but that may not help you solve the problem.\015\012\015\012I can see that there has been foam ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

F2 code. Followed listed guidance of removing assmebly and checking...unfortunately, however, my impellar has separated from the rotor assembly and the rotor assembly is stuck in the drawer. I tried to pull up on the shaft with some pliers, but that didn't work and I didn't want to pull too hard and cause damage. Please advise as to how to remove the broken rotor assembly from the drawer. Thanks


There are no wires underneath the rotor - it is just suspended in the cavity. So you cannot do any damage except make scratches around that area. Maybe take a straightened wire coat hanger and insert from the side hole in the filter sump area. You mi ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Leaking dishwasher leaks intermittently. I removed the side panels and there is no sign of water in the base of machine. Door seal seams to be intact. What else can I check. Seal that needs replacing? Machine is 18 months old. seams to leak on the right side of the machine. Please advise. many thanks. My dishwasher showed the error code either OE or E1, I think it was more OE. I stuck my hand in the filter in the bottom of the machine and then it was okay but the next time it was used it leake


What sort of soap powder do you use\015\012some soap powders foam a lot in machine causing dishwasher to leak through seals\015\012also check that the machine is square that is the door is closing parallel with cabinet\015\012do no ... Dishwashers

Fisher and paykel DD bottom drawer jams on closing because internal cover that drops down impedes it. How do I adjust/secure internal cover please?


If you remove the screws at each side on the kick plate you can just pull it straight off, you'll see it has cut lines along the back to guide you, just cut to required size and refit... ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Our top rack is not getting cleaned at all-- although the rinser seems to spin freely when pushed, and fits correctly into the hole back. We were using powder detergent, and a little residue was always left in the compartment. So we tried liquid detergent, to see if it would help, and now it seems like almost none of the detergent is dissolving out, at all. The compartment's full and a goopy mess after each cycle. So now the bottom rack isn't very clean, either! Please advise. Thanks!


Welcome to FixYa,Based on your description... I`d suspect a plugged or really dirty wash pump. It could ultimately be a worn out wash impeller/chopper assembly, but I'd certainly try my suggestions before considering that. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I purchased a dishwasher @ Ikea called Renlig Integratd, serial/model # W10254949B. it did not come with the parts. I can not find the waterline for the bottom blue plastic fittig for the water line. I went to three hardware stores and home depot. No luck. Please advise


... Whirlpool Dishwashers

Sears dishwasher 665.15882000 part number 8268296 spinner fell off. I have the spinner. The plastic rivet fell through the bottom of the inside of the machine to who knows where. Please advise what is needed to repair spinner and if the dishwasher can run with the rivot that is somewhere out of site in the botton.


... Kenmore Dishwashers

Dishwasher Hi I have a Asko bench top dish washer and it is leaking from the bottom underneath other wise it works perfectly and I love it Please help me fix it wendy fitzgerald & Allen Street Methven New Zealand


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0681 seconds