Having problems with your Fisher and Paykel Dishwashers ?

Fisher and paykel nautilus dishwasher, F7 has come up


Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

F4 error fisher & paykel nautilus dishwasher sometimes this error comes up and it seems to occur about 10 minutes from the end of the cycle. it doesn't happen all the time. the user guide does not specifically address this error code.


F4 is a heating error- dishwasher has not reached temperature in allocated time. If intermittent fault, problem is usually with electronic board, which has temperature sensor attached. Sometimes the wiring to the control board burns out and can give ... Fisher Dishwashers

Fisher and paykel nautilus dishwasher, F7 has come up


... Fisher and Paykel Dishwashers

My fisher and paykel nautilus dishwasher isn't draining properly


Remove strainers and clean and try again ... Fisher Dishwashers

Fisher & Paykel Nautilus dishwasher stops during cycle


... Fisher and Paykel Dishwashers

Fisher & Paykel double dishwasher bottom dishwasher starts to fill with water then a noise comes on and a flashing F2


F2 is indicating a fault for the motor. This motor has 2 directional operations. One direction of rotating for spraying water for washing. The other for draining at the end of washing cycle. I don't think it is a problem with the motor, but there is ... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Motor problems? I have a fisher paykel DS6031SS -top drawer dishwasher that the motor makes a loud sound when cycle first starts. Sound seems to be coming from the front of the dishwasher. It is 7 years old. Anyone else have this problem? I llive in a small town in Washington state (Lacey) and have been told the closest place to get parts is Seattle! Thanks.


... Fisher and Paykel DS603SS Stainless Steel Built-in Dishwasher

I have a Fisher and Paykel Nautilus DW920 dishwasher. However, the door to the detergent dispenser does not open reliably every load -- usually I have to open the dishwasher door about 20 minutes into the load and open the soap dispenser myself. The catch on the dispenser will have released, but the dispenser door will not have sprung open. I am not sure exactly what the problem is -- the soap dispenser door simply seems a bit stiff in its holster. Given a little nudge, it springs open fine. I h


... Dishwashers

Dishwasher comes up with e4 message. - Fisher and Paykel Dishwashers


Check the ilet water ... Fisher and Paykel Dishwashers

Fisher & Paykel Nautilus Dishwasher


F4 is a fault code telling the controller that the water is not heating up. This can be caused by either a faulty heater plate, a bad connection between the plate and controller, or the controller itself. If you wish to fix this yourself, changing th ... Dishwashers

Fisher & paykel Nautilus dishwasher


Pull the dishwasher out and push down on the top of the dishwasher were the door latch is ,its not making conntact with the microswitch.but you could also have a broken handle.these are both common faults on this model.hope this helps. ... Dishwashers

Fisher and paykel nautilus dishwasher


Does it fill with water? I would guess a fill/ drain/ heating problem. See if you can eliminate any of those. ... Fisher and Paykel Dishwashers

We are now getting a U1 error code on a Fisher and Paykel Nautilus dishwasher which was in the house we purchased 3 years ago and has functioned perfectly until now. There was no manual left when we took over the house. We would appreciate any help you can provide.


U1 means the unit has failed to prime with water within 3-4 minutes. \015\012Its taking longer than expected to fill with water. \015\012Check the fill valve, water supply problem, excessive sudzing.,reduce your detergent. ... Fisher and Paykel Dishwashers

Fisher & Paykel Dishwasher stops when it still has about 18 minutes to run and a code U1 comes up.


Can you provide model and serial number? ... Fisher Dishwashers

Fault c3 on model 87605920 820 nautilus dishwasher Fisher & Paykel - continuous beeping and will not start


... Fisher and Paykel Dishwashers

I have a Fisher & Paykel Model #DD603 double dishwasher it is coming on with a code F1 with a little wrench Whats going on ?


An F1 fault means that the Mains Filter board on the bottom pan has detected water, a leak. There are, unfortunately, a few possibilities of the cause of this. Most likely it is bad lid motors (the motors that lift and pull down the lid to seal ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I have a Fisher & Paykel 913T soft touch dishwasher. On all types of washes when the wash cycle starts there is no 230 volts on the element & after 5 minutes the wash cycle finishes & then goes onto to the next cycle. None of the wash or rinse cycles heat the water but on the dry cycle their is 230 volts onto the element & dries the dishes OK. Is my problem the power supply PCB or could it be the Controller PCB? Does the 230 volts to the element on dry cycle come from the same cicuit on the po


Have you considered the possibility the water temperature sensor may be faulty.\015\012\015\012If the controller is getting false water temp reading then it may never turn the heater on.\015\012\015\012Generally with FP dishwa ... Dishwashers

Hi ya. we have a fisher and paykel nautilus dishwasher. and it has a fault. f4 is on the panel. and its not draining water. help please


This means something wrong with the water heater. \015\012\015\012Most likely you will need to replace it. It will look something list ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I am looking for a user manual for a Fisher & Paykel ''Nautilus'' dishwasher


Hi,You will get all the manual from the link below...http://kitchen.manualsonline.com/ma ... Fisher Dishwashers

F1 coming up on screen - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


You must be having F1 code flashing on door display of one of the drawers of your dishwasher.\015\012\015\012This means the flood switch has been activated. Check if there is water inside the dishwasher (turn power off at the mains suppl ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel Q 2 drawer dishwasher, comes on randomly, sounds like washing, but no water and beeps. Also, is there a manual online which I can download?


... Fisher and Paykel DD605HSS 23 in. Built-in Dishwasher

Hi, I have a Fisher & paykel DD603. A really bad smell has developed which appears to come from under the top panel encasing the dishwasher. How do I remove this panel to locate the source of this smell?


HI- If you mean the front panel they are removed by taking out the plastic retainers that are on each side of the drawer near the front and bottom of the drawer. They are round and about 1/2" in diameter and have a raised straight portion in the mi ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Nautilus Fisher & Paykel dishwasher, lower spray arm, release cap


Same happened to me. Sorry I bought this. ... GE Nautilus 24" Built-in Dishwasher

The power on the top draw doesnt come on - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


Most likely the thermal fuse has blown which shuts of the control power.\015\012You will need to replace the heater assembly at the base of the drawer as the thermal cutoff is integrated with it.\015\012The parts are listed in this docume ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Keeps coming up with fault "F1" - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


Is that in one drawer or both?\015\012\015\012Generally it means the flood switch under the drawer (inside the housing is activated). This means water is leaking from somewhere - foam in detergent, cracked or crinked hoses, door seal leak ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

How does the front of the tub come off - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher


I have dish drawer model DD601V2 and after fixing a U3 error on the top drawer, by clearing pump line and into the hose, water is leaking through the floor cavity where to dishwasher sits, into the downstairs of our home. I'm guessing the hose is pe ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1462 seconds