Having problems with your Fisher and Paykel Dishwashers ?

How do we correct an F1 fault?? [email protected]


Answers :

Hello &\015\012Welcome to FixYa
\015\012\015\012

F1 error in\015\012fisher & paykel dishwashers have become quiet common. The error means that\015\012flood switch has been activated and to solve this error unplug the unit. After\015\012the unit is unplugged, check that there are no blockages in the drain hose.\015\012After this is done pull the bottom dishdrawer out and then dry all the water\015\012from there, you can also remove the circuit board cover and blow hair dryer for\015\012around 15 minutes so that the area get completely dried. After this inspect the\015\012area for possible leakage and then plug back the unit. Please get back to me if\015\012you have any other questions.
\015\012\015\012

Kevin

Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dish Washer, Electrolux Home Products, Model FDB2510LCC0, Serial NO: 7H34962223 Machine does not drain or add water. The machine has been worked for a couple of years. I checked the following: 1. Overfill Protector not stuck 2. Motor turns on and the machine cycles correctly 3. Since the machine has been running correctly the unit is hooked up correctly: hoses, garbage disposal, knockout plug. Again everything has worked and the motor does cycle and the machine will perform the different cycles


... Electrolux 23 in. ESI602 Free-standing Dishwasher

I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an


Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your mod ... Dishwashers

I have a Candy Range 4 CDS 68 dishwasher. when you turn it on in any programme it makes a noise, all the lights flash and it beeps. There are no leaks, i have turned the mains power off and on. it appears to have drained correctly. When last used it completed the programme correctly. Hope you can help Peter


... Candy Dishwashers

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

No pressure, the inlet filter is clean, all hoses and connections are tight, oil levels are correct, hose size to pump is correct with no kinks. Has the pump gone?


In this case it sounds as though either your unloader valve has failed, the water seals have failed or the check valves in the pump need replaced. Unfortunately there are no tests that can be done on this unit to verify which component has failed bec ... Karcher 4000 PSI 36 GPM Gas Pressure Washer G 4000 OH

Whirlpool Gold Dishwasher - GU2700XTSB The top rack of the dishwasher is not cleaning. The bottom rack dishes clean fine. There are no clogs in either the bottom or top spinner arms, the plastic tube feeding water from the bottom pump to the top rack spinner arm is clean, the spinner arms all rotate freely and do not bind. Water pressure is correct and water temperature is correct. There are no lime or hardwater deposits or clogs. What could be the issue?


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Whirlpool GU2700XTSB / GU2700XTSQ / GU2700XTST Built-in Dishwasher

Bosch sgs43eo2gb dishwasher. wash programme completes, water drains out, but machine goes on draining, forever, stuck at around 50 minutes on the facia clock. there is no leak on the machine and everything else has been cleaned and operates perfectly. ie,fills correctly,heats correctly and drains fully but won"t stop draining & refill. Cancel programme and reset and it works perfectly until end of wash cycle again, when it continues to drain even with the door open. There is no leak in the machi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. Please once again check that the hoses are not kinked or drain pump and filter ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

MDBH969AWW MY DISHWSHER DOESN'T RUN. The panel lights don't work correctly and although I changed the control panel it still does the same thing. What is stopping it from working correctly?


... Dishwashers

I'm trying to find the correct filter for a Bosch dishwasher Model SHE55M02UC. I find two different one's online and am not sure which is the correct one I need. Thanks


... Bosch Evolution 500 SHE55M05UC Stainless Steel Built-in Dishwasher

Hi, I need to replace the swash plate on the kacher K2.94M. What is the correct oil and what is the correct level to fill to ?


Hello. The recommended oil is 15W-40. Fill it to full which is the correct level. J. ... Karcher Pressure Washers

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

Soap dispenser releases hardened soap from dispenser down inside of and front of dishwasher and down front of inside of door and does not clean dishes on top and bottom racks. How do I correct the problem so dishwasher dispenser will act correctly? Thsn you.


You can either change out the dispenser itself, possibly bad door not full opening, or use a different detergent. Make sure you water gets nice and hot as well. ... GE Dishwashers

My serial #TH24050632 has an occational control board failure and requires a reset. That is my current problem. In the past I turned of the circuit breaker for thirty minutes, and then pressed sertain control buttons inseries or at the same time for ten to twenty seconds. I have misplaced the information I wrote down to correct my problem. Can you help me with the correct procedure to reset my control panel? Thank you.


Check if this works.\015\012\015\012Press normal wash and heated dry one after the other about 5 times.All lights on panel will light.Wait until all lights go out and it resets itself.It will go into a mode on it's own.Then press cancel a ... Dishwashers

Hi. We have a Bosch 4072 6301 which is about 9 years old and has always worked well. Recently is has begun to leave dishes unclean, particularily on the top shelf but also on the bottom. I have checked the water jets for blockages, checked the drain (as far as it is accessible). The heating element stills works as there is steam when the door is opened. If I open in the middle of the cycle I can see water coming out of the jets correctly, I can't tell if the pressure is correct. Any th


... Bosch 24 in. SGS4072 Free-standing Dishwasher

It sounded like something was jammed in the bottom of dishwasher. Took it apart, not sure if put it back together correctly because now it is not turning (bottom). Is there a diagram to look at on how to put back together correctly? Whirlpool Quiet Partner II Serial # FP1386450 Model # DU943PWKQO


Go to sears part sales web site adn look at parts breakdown. ... Dishwashers

Door seal Hi i have just brought a new seal for the bottom of the door but it has a peice cut out of the seal about 8inches from the end is this correct the door does not seam to have any thing that would fit in this missing peice if it is correct which way would the shortest edge face


Generally the notched out section fits around latch hope this helps ... Dishwashers

I have a brand new Whirlpool dishwasher #DU810SWPU4 - Model #. No instruction manual was left with me, so I want to be sure I'm using it correctly. When I run it and set the drying cycle to Heat - after it shuts off and I open it up, there is still water on the door and on some of the dishes. Is this correct? Jane Walker


... Whirlpool Dishwashers

WHAT IS THE CORRECT WASH TEMP FOR THIS MACHINE?


Between 150 and 165 is good for wash. between 180 and 195 is good for rinse. ... Jackson 24 in. JPX-300H Built-in Dishwasher

Wont idle correctly


... Pressure Washers

Whirlpool Quiet partner 1dishwasher (model DU1055XTSQ2) that is not filling all the way--water supply is working correctly. Also, the water is not getting hot, the heater coil looks very mottled.


... Whirlpool DU1055XTSQ Built-in Dishwasher

My Danby DDW1802W is not working correctly. Here


... Danby 17 in. DDW1802W Designer Series Built-in Dishwasher

I need to put the lower pieces of my dishwasher back correctly.


Try this website:\015\012 ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I bought a galaxy 665 portable dishwasher, and the hose seems to be too short - only about 20 inches. Is this correct?


... Dishwashers

Corrected serial # on Nautilus dishwasher


Ok, great! I found the correct part for your model number. To view the pump/motor assembly, click here. Hope this w ... GE Nautilus 24" Built-in Dishwasher

Cant put carb assembly back on correctly on powerwasher


... Northstar Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0400 seconds