Having problems with your Fisher and Paykel Dishwashers ?

Hi my F &P dishdrawer unit (DD603) won't drain


Answers :

Hi
\015\012Dishwasher not draining issue usually occurs due\015\012to kinked drain pipe, clogged drain filter or drain pump. First make sure that\015\012the drain is not clogged and remove clogs if present. If no visible lint is\015\012present then remove the lower front access panel to check the drain filter and\015\012drain pump for any clogs, you'll need to clean the drain filter and drain pump\015\012completely. Also, check for any food pieces stuck near the pump impeller &\015\012clean the chopper assembly. Please note that dishwashers don't drain out the\015\012complete water such that heating element doesn't overheat. Hope this helps...\015\012Please post back for any further assistance.
\015\012Daniel

Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi my F &P dishdrawer unit (DD603) won't drain


Hi \015\012Dishwasher not draining issue usually occurs due\015\012to kinked drain pipe, clogged drain filter or drain pump. First make sure that\015\012the drain is not clogged and remove clogs if present. If ... Fisher and Paykel Dishwashers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

My lawn mower with a Briggs motor Wont start, has spark fuel is good , the unit is approx 5 years old, but seldom used, worked great last year, drained the fuel, and stored it for the winter.Refueled it and wont start. I can getting started if I pour a little gas down the carb, but naturally it wont run long. I'm thinking needle and seat, any help would be appreciated. Thanks


... Craftsman 2700 PSI Briggs Stratton Powered Pressure Washer

Unit wont drain checked drain hose for kink, no kinks. replaced garbage disposal approximately 2 weeks ago, not sure if this has anything to do with it. What should I try next?


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

Back where the screen is the water will not drain sometimes it wont drain at the whole bottom of the unit.


... Kenmore 17459 Free-standing Dishwasher

My model number is DD603 The top dishdrawer is draining into the bottom dishdrawer. What is the code to reset the drawers?


The check valve in the bottom drawer may be clogged or defective. the two drain hoses are probly connected to become one. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Thermador dishwasher lights go on when door is open but go off when door is clossed the motor hums when door is closed but the unit will not operate there is water in the bottom but it wont drain


... Thermador DWHD43 Dishwasher

Wont drain the water in my fisher and paykel 2 drawer dish washer but only in the top unit as it was used a lot more than the bottom one. i suspect it is the pump - any ideas and how hard is it to replace?


Hello- Try swapping rotor - the blue bladed thing at bottom of drawer - from top to bottom. If it works, then replace with new part. Let me know if this info helps- have more if needed. Thanks- Ed ... Dishwashers

Unit wont drain. nothing appears to be blocked


Hi, Please check the link bellow to have a detailed idea to diagnose your problem: ... Dishwashers

Dishdrawer model DD603 gives fault F2 (Motor). Unit has only been used a few times. What to do? Out of warranty.


Ok this is what you do you need to swap over the motor rotors from top drawer to bottom drawer. check for anything jammming the rotor etc when you take it out. if it works with the other drawers rotor then you need a new motor rotor. cheers\015 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi, I have a Fisher Paykel DD603I (integrated) dishdrawer unit. The bottom drawer soap dispenser has water in it after it runs (and leftover soap), and there is a small amount of water sitting in the bottom of the drawer. The dishes don't get totally clean. I have removed and cleaned the spray arm, drain filter, filter plate and bottom of tub. Found nothing clogged or particularly dirty. Put all the parts back in and everything moves freely. Ran it empty, and same problem occurred.


Hi Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doe ... Fisher and Paykel Dishwashers

Got a Miele G2220sci dishwasher unit, getting an undocumented error code of F19 with flashing lights, help! what does F19 mean? WONT DRAIN. PROGRAM FINISHES WITH F11


F19 is water in the cabinet takes too long to heat up. you can reset the heater limiter..\015\012\015\012Reset the error message as follows: To cancel the error message, turn the rotary selector switch to "Stop/End" or press the "Start/St ... Dishwashers

Bosch Dishwasher wont drain


Have you removed the filter? if it gets clogged the dishwasher wont drain. other wise is sounds like a faulty drain pump ... Bosch 24 in. SHY56A05 Stainless Steel Built-In Dishwasher

Drain Clogged I have a Kenmore Quiet Guard Plus dish washer. The water will not drain from the unti. I believe the drian in the dish washer is pluged. I removed the 8 screws from the pump/strainer unit at the bottom of the unit I removed the top that the screws were holding donw, but can't figre out how to get to the drain to unplug it. The center metal unit is exposed and nut head is exposed. What do I do next to get to the drain hose to unplug it?


You might try pouring liquid plummer in the drain part and jet it set it shouold eat through whatever is in there ... Dishwashers

The water discharge line is connected to a unit that is mounted to the sink. This unit in turn has another line that is connected the the house drain. This unit is sparying all over the sink, counter and floor. What is the purpose of this unit and why couldn't the drain from the dishwasher be connected directly to the house drain?


It is a unit to stop water flowing back into the Washer... I suspect it is blocked... You probably need a Plumber? ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My Maytag Dishwasher mdbd880awq wont finish a wash cycle. It will wash and rise then when there is 32 minutes left it wont drain and wont dry the dishes, It just makes a clicking sound. I have to dry the dishes by hand and then use the rise only cycle to get the tub to drain. The drain only doesn't work either


... Dishwashers

I have a Frigidaire dishwasher. Model FDB520RHS0, Serial TH92539147. The drum fills with water but will not drain. I purchased the unit about 2 years ago. It has been used sparingly and mostly on light wash. I removed the basket and could find nothing blocking the drain. Is there a fix? Can I replace the drain pump? The unit is making a noise as if it is trying to drain but nothing is happening. I have checked the drain line for clogs and it is clear and the terminal end is conn


... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

LDS4821WW loses water in wash and rinse cyle then gives E1 error. there are no leaks on the floor.The drain hose is looped high at the back of unit. so the unit is doubled looped first loop is at the side attached to the unit then the second is at the back of unit then to drain.


... LG LDS4821WW 24 in. Built-in Dishwasher

Removed rear toe-plate to detect leak. Leak caused by broken drain hose. Hose replaced. To do this the unit was tipped forward onto its front door to allow access to the base area. Water allowed to drain out the front base area. Unit re-assembled but now does not switch on. Water connected. Base-plate dry. No water was detected at upper-front control panel. Power is connected and reaching unit ( multi-meter test ). Tipping the unit forward seems to be the cause. Is there any fuse,


The micro switches are frequently replaced on the door handle and they don't need to ever get wet. A lot of amp draw burns those switches up while they are dry. If they were wet and power was applied then they got fried my friend. The good news is th ... Dishwashers

Wont drain, no pump


Hi it sounds like a blocked pump needs cleaning out ... Dishwashers

My prima lpr661 dishwasher wont drain it will wash but not drain


E4 light flashs on my prima lpr661 dishwasher ... Dishwashers

Fisher and paykel dishdraw model DD603


P2 is for drain. Make sure there is a bit of water in the base of drawer before you start P2 otherwise the rotor may rub and burn. You can run the diagnostic with drawer open. Be careful not to start P1 as the wash water will splash and flood the dis ... Fisher and Paykel Dishwashers

Kitchenaid Dishwasher model # KUDS25SHBS1 has started making noise. Noise happens when unit is draining so perhaps its the same mechanism that houses the grinder. Can definetly hear a clicking as something spins around to drain the unit. I have removed the washing armature and plastic skirt around bottom and felt underneath the skirted area, but don't feel anything caught or jammed. Noise is getting louder as more draining cycles are being utilized (i.e. as we use the machine more). Anyone have


Looks like motor noise. Check the pump. ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Dishwasher drain is hooked to a food disposer and until recently the unit worked fine. Last week following a cycle a couple of inches of water did not drain out. All food is removed from dishes, silverware, etc. prior to loading and the food trap in the bottom is completely clear. I ran the unit empty through a Lightwash cycle and afterwards the water level (that which didn't drain out) looked to be the same as before. The dishwasher is run 2-3 times weekly whereas the food disposal is


Hi, The I don't think the problem is with the loop and the 32" above the floor.If the dish washer was removed from one house to another, did *********** ever have a dish washer in the house before that he replaced this one with? The reason I am aski ... Dishwashers

Model JPX-300H, the unit does not fill, but it will drain if you fill with water from a bucket. Also when the unit drains there is water coming from under the unit. How do I check the fill valve for proper operation. Thanks


The fill valve is easy just take the coil off and there is a hole in it put a metel screwdriver in the hole and turn the unit on if it pulls the screwdriver like a mganet it works is more likely i bad diaphram now as for the draining it drains bu ... Jackson 24 in. JPX-300H Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1069 seconds