Having problems with your Fisher and Paykel Dishwashers ?

Fisher & Paykel DW6OCDW1 Error codes

\015 Error code E1 showing\015

Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

DS603 Fisher & Paykel U1 error code ..(see our previous errors we've listed) we have now pulled out the yellow water valve that goes up behind the front panel and at the other end by removing the drawer and plastic protector thingy - we checked that there were no bedris or calcium buildup in the valves ends and filters and replaced it all. So we put it all back to gether as we could not see what would cause this error, only to find that it worked - water came into the machine but about 4 mins in


This product is total ****.\015\012Pull it out, call whoever sold the **** to you\015\012and tell the to come get it and shove it up their ***.\015\012Then buy a Bosch and live a happy life.\015\012The design is moronic. The machine is like the old\ ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

F4 error fisher & paykel nautilus dishwasher sometimes this error comes up and it seems to occur about 10 minutes from the end of the cycle. it doesn't happen all the time. the user guide does not specifically address this error code.


F4 is a heating error- dishwasher has not reached temperature in allocated time. If intermittent fault, problem is usually with electronic board, which has temperature sensor attached. Sometimes the wiring to the control board burns out and can give ... Fisher Dishwashers

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Error code. Fisher and Paykel Dishwasher


Well since you asked on the 5th July, and no reply, doesnt look like you may get one. I thought thats what this site was about?? ... Dishwashers

Error code e8 on a fisher and pykel dw60ccx1


... Fisher and Paykel Dishwashers

Fisher Paykel Dishwasher Door Open error code


If it is a dish drawer type there is a clip at the rear of the drawer that holds the drawer closed. you will need to withdraw the drawer partially to look in. with the drawer open the fingers should be facing towards you. If not you will need to reac ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

F1 Error code on fisher paykel softouch dishwasher


F1 means that water is in your basepan--- you can pull the bottom\015\012drawer out and soak up the water with a towel... you will have to use a\015\012hair dryer to dry underneath the control sensor in the back left corner. ... Fisher Dishwashers

I have a Fisher and Paykel DD605i dish drawer. We have a U1 error code on the top drawer and had this same problem just over a year ago. A repair person replaced the inlet valve I believe. I am wondering if there are any tests I can put the machine through or if this is something I can fix myself to see what is causing this code.


... Fisher and Paykel DD605I Dishwasher

Fisher & Paykel DD603 Error code F2. My top dish draw is showing the error F2 , I have taken out the baskets, spray arm, propellors. The metal shaft is completley frozen, I can't move it at all. I see other posts say to wiggle it to free it but that doesn't work here. Can I get a copy of the service manual too? We are along way from a repair man to come look and I like to try myself before spending more money on it. My e-mail is [email protected] Thanks.


... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Fisher and Paykel Error code Ho - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

How do i fix an F5 error code on a Fisher & Paykel Dishdraw DS605. I have turned the power off but the error keeps returning?


I am assuming you have the DD605 double drawer dishwasher. Is the problem F5 on both drawers or just one?\015\012\015\012F5 code involves the drawer lid seal and will need a bit of effort to check and fix.\015\012\015\012Take ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

My fisher paykel DD603 fills with water at the start of the cycle and stops with the following error code and a beeping noise: - error U1 spanner symbol - crossed out faucet symbol. The water level is high enough that the spray arm is floating in the water. I am able to drain the water by entering the hardware diagnostics mode and running the motor in the drain direction. By removing the filter plate and examining the impellers I am not able to see visible damage. All filters are clean. The


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are spot on as error U1\015\012indicates that the dishwasher has twice tried to fill with the required amou ... Dishwashers

Fisher & Paykel DW6OCDW1 Error codes


... Fisher and Paykel Dishwashers

List of error codes fisher & Paykel dw60


... Dishwashers

Fisher & Paykel dishwasher drawer won't run, beeps F2 error code


Craig, we had virtually the same situation.  The repair man  came and it took 2 minutes to fix.  The problem was that the bottom drawer had not been used for a couple of years and thus the impellor had jammed.  to fix it take out ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Error code F4, Fisher and Paykel dish-washer?


... Fisher and Paykel Dishwashers

My fisher and paykel dishwasher drawers is giving me an F1 error code, won't stop running and is acting like it's possessed.


... Fisher Dishwashers

F1 error code on both dishwasher drawers. - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher


Unit is in flood protection mode (caused by leak), can be cleared by removing bottom draw and drying the residual water around and under the Rfi/flood sensor board. This problem is usually caused by iether the support that suspends the wiring and hos ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I had an "f2" error code on Fisher Paykel DD603


I will but need your email address ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

U3 error code - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


Error code U3 could mean the drain pump could be blocked.Remove the trays and the impeller arm. Empty the water with small container or towel. Open the filter plate and drain filter. Get the motor out and check the cavity for any rubbish ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a fisher paykel dishdrawer dishwasher that i get a F1 error code then it shuts down i have dried up the bottom tray but it will only work for about 1 week and it does it again


Perhaps you need to find out the source of the problem. The F1 code is due to the flood switch at the base of the housing getting triggered by water collecting. You could have a cracked hose or broken actuator arm (this is piece of plastic at the bac ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Fisher paykel dd603 stops while in cycle and beeps but no error codes show


Does it open the lid?... and does the display flash, as if paused?... if so, just clean the closed sensor lenses, top right hand corner of the drawer, and the little piece of plastic they shine into on the housing. ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

My Fisher and Paykel flashed a F2 error code. What does it mean and what can be done to clear it.


F2 error means motor problem. This could be due to several reasons. The most common is grime going in from the drain filter and getting stuck around the motor rotor cavity.\015\012\015\012Follow instructions in your user guide to clean th ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

F2 Error code beeping - Fisher and Paykel 23 in. DD-603 Built-in Dishwasher


Your pump has seized.To check remove all the dishes followed by the grey dish wrack wedged in the bottom. Lift off the plastic spray arm to reveal a grey plastic ring around the outside of the stainless mesh, and you will also see the blue plastic im ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

I am getting an F2 error code on an DD603. - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


There is something jamming in the rotor , lift the spray arm and try spinning the blue fan , or if u havent used the btm drawer in ages it is a seized rotor , around 80 $ to buy new ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0665 seconds