Having problems with your Fisher and Paykel Dishwashers ?

Main filter board on my fisher paykel dishdrawer board burned

\015 Board burned. if i replace it will other components still work?\015

Answers :

Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Main filter board on my fisher paykel dishdrawer board burned


... Fisher and Paykel Dishwashers

Fisher Paykel DD603 Problem. Top drawer shows F1 and pump runs continuously. Lower drawer does nothing, no display. I think the Electronic Controller in lower drawer is fried and maybe the Mains Filter Board. Please help.


Yup, definately the bottom drawer controller, for some reason you can run a DD603 with no board in the top, so long as you have a board in the bottom, but not the other way around. This is the fault you get, constant F1 from the top drawer. If you ar ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I got a double drawer fisher and paykel dishwasher and the first drawer was not working and after a few days we saw that it was smoking and smells burn so we turn off the main switch and took out the burned box. my question: is replacing the parts will solve the problem? but whats reason that got burned?


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers…Dishwasher Problems The ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi, I have a Fisher Paykel DD603I (integrated) dishdrawer unit. The bottom drawer soap dispenser has water in it after it runs (and leftover soap), and there is a small amount of water sitting in the bottom of the drawer. The dishes don't get totally clean. I have removed and cleaned the spray arm, drain filter, filter plate and bottom of tub. Found nothing clogged or particularly dirty. Put all the parts back in and everything moves freely. Ran it empty, and same problem occurred.


Hi Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doe ... Fisher and Paykel Dishwashers

Fisher Paykel DD602 burning smell


The red light is the indicatior light for the rinse aid (jet dry) when you look at the fill cap, the center of it will light up when you need to refill. there is a float inside that blocks the light when full, and uncovers the light when the rinse ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

I have F1 fault on Fisher & Paykel DD601V2...how can you tell if mains filter is bad?


... Dishwashers

Errors and restarts - Fisher Paykel Fisher & Paykel DishDrawer DD24DCB7 Semi-Integrated Double DishDrawer with 14 Place Settings, 9 Cycles, Eco Option, 163 Degree Sanitizing Temperature, Delay Start and Adjustable Racks: Black


Will need a description of the problem. Some of the common fault codes are F1, F2 and F3. All these fault codes stop the dishwasher and will not go away until the cause is removed. Please indicate the problem you are experiencing. ... Fisher Paykel Fisher & Paykel DishDrawer DD24DCB7 Semi-Integrated Double DishDrawer with 14 Place Settings, 9 Cycles, Eco Option, 163 Degree Sanitizing Temperature, Delay Start and Adjustable Racks: Black

Fisher Paykel No power to bottow drawer


The board you checked has the sensor have you removed and dried off both of them? and check the actuator motors that hold the lid down these fail causing the F! due to the lid not sealing tight' ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Leaking fisher & Paykel DS603 Dishdrawer


I think there is a hole in the grey sump underneath rotor motor, the motor is the grey blades u took out of sump. pull out drawer, take filter tray and rotor motor out of drawer, dry all of water out of drawer , then look underneath unit , pour a lit ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and Paykel Dishdrawer-DS605SS F4 fault code


No temperature increase ... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher

Fisher and Paykel Dishdrawer pausing - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher paykel dishdrawer f2 with wrench - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher


... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel DD603. Bottom drawer filling when powered off and both drawers won't complete the cycle


... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

F&P dd603 fried roach on mains filter board, when bottom drawer was running overnight, woke up to F9 I think and continuous drain cycle, had to replace said board, upper harness, and upper thermo


... Dishwashers

Fisher and Paykel dishdrawer, lid not retracting, no power.


By no power you may be implying there is no display etc and the swithces are not working. Most likely the controller of the top drawer has had it. The controller is mounted on the front of the drawer behind the door panel. Hope things are better than ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher and Paykel DS603 no power


Hi,\012\012There is a thermo fuse in this unit and it can cause the controller not to power up. It is located on the heater plate, if the unit got too hot this will cause this fuse to blow and cause not power to the controller to a singe dra ... Fisher DS603W / DS603B / DS603I Dishwasher

Current service manual for the Fisher & Paykel DD603SS dishdrawer


Http://www.fisherpaykel.com/admin/pdfs/pdf_usecares/527971B_DD_user_guide_USw.pdf ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Blocked drainage hose in Fisher and Paykel top dishdrawer DD603


Hello there..How do you know the hose is blocked at all? It's rare for that to happen, I work on these machines daily as I am a Factory Authorized tech. You need to be careful in your approach to this, that is an expensive machine and it can be ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Fisher & Paykel single SS Dishdrawer. Cycle's stuck. Normally sticks at 137mins and 33 mins, has stuck on other times too but it's always on those times. Have tried pausing and opeiong the drawer int he hope to kick it back into working but doesn't help. A normal cycle of 151mins is taking 4 hours.rnI normally have to let the cycle run till it sticks on 33 mins then I trun it off letting the dishdrawer empty and kick into dry mode. I hate to see my next electricity bill, its been a month n


My dd603 takes 3 hrs to do a 55 minute cycle-who can help me ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

Mains supply trips once connected ac mains. - Fisher and Paykel DD605HSS 23 in. Built-in Dishwasher


This can only be some sort of "Short Circuit" to Earth. This can be Very serious. Please do NOT touch the unit when powered up, as it may be LIVE. This need to be looked at by an Electrician. ... Fisher and Paykel DD605HSS 23 in. Built-in Dishwasher

My fisher paykel DD603 fills with water at the start of the cycle and stops with the following error code and a beeping noise: - error U1 spanner symbol - crossed out faucet symbol. The water level is high enough that the spray arm is floating in the water. I am able to drain the water by entering the hardware diagnostics mode and running the motor in the drain direction. By removing the filter plate and examining the impellers I am not able to see visible damage. All filters are clean. The


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are spot on as error U1\015\012indicates that the dishwasher has twice tried to fill with the required amou ... Dishwashers

I am experienceing the U1 code on my fisher paykel 603 single dishdrawer. I have seen that I should check the fill valve. Where is the fill valve located on the dishdrawer?


... Fisher and Paykel Dishwashers

Have Fisher-Paykel DD603 double-drawer dishwasher. Top drawer motor making loud noise. )Bottom drawer fine.) Still seems to wash and definitely pumps water but sounds like a "motor with a broken belt." Checked filter and rotating spray arm - no problems. (Found a little broken glass in filter; could be very old.) Suggestions?


If glass has gotten past the screen and into the pump, you may have a pcs. logged in the pump housing.\015\012Best way to correct this, is to remove the pump inlet and outlet lines and flush out with a water hose.\015\012Keep ... Dishwashers

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Service manual F&P DD605 Dishdrawer - Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher


... Fisher and Paykel DishDrawer DS605FDSM Stainless Steel 23 in Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0858 seconds