Having problems with your Fisher and Paykel Dishwashers ?

I have a dishdrawer (2) and following the use of a dishwasher cleaner, the bottom drawer appears to have developed a blockage. It will not empty, gets to the pump out part of the cycle and shows the red error code F3, to which there is no reference in the trouble shooting guide. The top drawer has also developed minute leak, sufficient enough to leave dribble marks on the lower drawer and over time, a white deposit on the floor. Is there anything we can do for the blockage problem before reso


Answers :

Remove the small basket from each drawer and lift up the removable plastic cover and take the drain filters out , empty them of food by products and try it again.. If you've never cleaned them then that's your problem with the drain process.. Hope that helps.
Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a dishdrawer (2) and following the use of a dishwasher cleaner, the bottom drawer appears to have developed a blockage. It will not empty, gets to the pump out part of the cycle and shows the red error code F3, to which there is no reference in the trouble shooting guide. The top drawer has also developed minute leak, sufficient enough to leave dribble marks on the lower drawer and over time, a white deposit on the floor. Is there anything we can do for the blockage problem before reso


Remove the small basket from each drawer and lift up the removable plastic cover and take the drain filters out , empty them of food by products and try it again.. If you've never cleaned them then that's your problem with the drain process.. Hope th ... Fisher and Paykel Dishwashers

Dishwasher top drawer was dead so i was told to change the heater under the drawer i did that but now i got more broblems the top drawer lights up just beeps for a second and does nothing as for the bottom which did work before now works for 1 full minute and then just flashes on and off iam confused can tou please advise me joseph.


Hi,Whenever the Drawer is Dead, there could be a couple of Reasons. First, it could be a Bad Heater Plate or Bad Control Board on the Front.You could remove the Control Board and Check.More often, you would find visually, that they are Ho ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Dishwasher not getting enough water in either drawer, although top drawer gets more. Dishwasher keeps beeping during cycle and reads not enough water and then stops running until you press the start button. Need Help, any ideas?


This sounds like a hard water deposit problem.Check your water inlet valve for a screen and see if its clogged. Also it may just be a water valve/solenoid problem. As in, it's too crusted up to float up and down.Some models have a water f ... Fisher and Paykel DD605FD Stainless Steel Built-in Dishwasher

When I start the top drawer it defaults to 5 minutes (with the lights Heavy, Fast, Rinse highlighted) runs for a couple minutes, then stops and the LED starts randomly cycling through all kinds of codes very quickly. There is water in the tub that has not drained after completing the couple minutes of operation. This cycle repeats itself if I hit the power button again after the LED starts freaking out. The 5 min cycle shows in the LED, sometimes with the no circulation error, sometimes with the


Here is the solution: \015\012http://applianceguru.com/forum1/24814.html ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Had the double drawers for 3 years now and all of a sudden, the top drawer is having problems. A few minutes after I start a load, the blue light on the front starts blinking red, it beeps, and when I open the drawer, it is set on heavy and eco (when it was originally set on just normal). I have to turn the unit off and then back on for it to start up again and continue its cycle. What's going on?


First thing to do is to take a clean damp cloth and lightly wipe the grime off the drawer lid especially on top of the membrane keys.\015\012\015\012Wonder how often it has gone into this blinking red state. ... Fisher and Paykel 24 in. DS603MFC Built-in Dishwasher

I HAVE A TWIN DRAWER MACHINE ABOUT 5 YEARS OLD THE TOP DRAWER IS WASHING DISHES BUT LEAVING WATER IN THE BOTTOM OF THE DRAWER WHICH I AM NOW HAVING TO EMPTY MANUALLY HOW CAN I FIX THIS PROBLEM


Have you tried running the rinse cycle to check if the water drains out?\015\012\015\012If you are not getting any fault codes, then it might be simply a matter of cleaning the base filter plate and the sump. The user manual will tell you ... Fisher and Paykel Dishwashers

Frigidaire dishwasher model FDB857RJS1 not pumping water to the top arm. runs then makes a grinding sound like the motor skipping a gear then back to moving water but not enough pressure to get to the top arm.Unit drains normal runs all cycles but leaves the soap on the door not used.


HI, under the sump housing, there is a major issue concerning the circulation motor. there is a wash impeller that is connected to the circulation motor, via drive shaft and stud. this assembly has been stripped ... Frigidaire Dishwashers

Top drawer runs for a while, the timer stops after two minutes and then I get a U2 code. Bottom drawer working fine.


Hi there,Usually a U2 code means there is a problem with closing the draw fully, and hence the dishwasher thinks the door isnt closed and will not start up. This could be because A) there is something impeding the draw from closing (check ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher

The top drawer is running through all the setting numbers in rapid fashion. even when it is powered off it restarts the series over after a few minutes. the lower drawer operates properly


I suggest take a clean damp cloth and wipe the edges of the drawer door top and sides, especially the sensor switches that control the programs. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Bosch dishwasher is 6 months old and is starting to leave food on items in the top drawer. It also sometimes leaves a grainy residual in the cups and glasses. I have put through a dishwasher cleaning solution, but find it isn't doing anything to resolve the problem.


Hi shanandpop\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: Your Bosch dishwasher is 6 months old and is starting to leave food on items in the top drawer. It also sometimes leaves a grainy re ... Bosch Dishwashers

Intermitttent beeping on bottom drawer of dish washer no error code only cycle to work all the way through is rinse cycle. Have turned off power supply over night did not fix problem. When you press pause button restarts for about five minutes then beeps again. No problem with top drawer. All inside cleaned using correct powder and rinse aid.


Panel control board Call Encompass Parts 1-800-638-3328 ... Fisher Dishwashers

The top drawer in the wash cycle after starting will only run three to four minutes and it drops into pause. have to go and push the start button again for the cycle to continue a few more minutes before it drops out. and I have to do the procedure again. The cycle continues where it left off. I had an issue with a missing rubber gasket initially. The service person came out and removed the front, and this is when the problem started. It might be a coincidence. The repair person does not wish to


\015\012\015\012\015\012\015\012If the cycle doesn't complete, or pauses again n again in between then check these:\015\012\015\012\015\012Water-heating cycle\015\012\015\012Many dishwashers heat the wash and/or ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My DD603SS dishwasher (top drawer) leaves a residue to powder and does not rinse well. I have tried to clean everything, but I think something is broken in water pump


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

During circulation, top drawer seems to leak water through the rubber seal, located on the lid assembly. What would commonly cause this problem. Would it be the actuator, yoke, seal, etc... Please answer only if you've seen enough of this problem, with this model, in particular. Will provide monetary full rating if you can provide both, what part and why... and of course, if it resolves the problem :)


... Fisher and Paykel DD605I Dishwasher

During circulation, top drawer seems to leak water through the rubber seal, located on the lid assembly. What would commonly cause this problem. Would it be the actuator, yoke, seal, etc... Please answer only if you've seen enough of this problem, with this model, in particular. Will provide monetary full rating if you can provide both, what part and why... and of course, if it resolves the problem :)


Lid seal not sitting properly can be due to several reasons as you have eluded to.\015\012\015\012The simplest is that the actuator is not getting any power. But if you hear the actuator operate at Start then this is not a problem. Howeve ... Fisher and Paykel 23 in. DD-603 Built-in Dishwasher

Have a Miele G1220SC dishwasher. It recently developed a strange problem: when switching it on ALL program lights come on and the machine starts taking water. after a while it stops taking water and starts to pump water, all the time all program indicators remain on. if you leave it on a while ( about 4 or 5 minutes) it is impossible to switch off the machine with the main switch, all you can do to stop it is unplug it. anyone experienced something like this and have any idea what part is malfun


Follow this steps and fix it. God bless you\012 \012 Heating Element\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Miele Dishwashers

I have a kenmore ultra wash quietguard 3 . It fills but not enough to cover the heating coil. It washes poorly and leaves schmutz on the dishes. I have checked all the sprayers. They are not clogged. The top rack doesn't seem to wash as well as the bottom. What should I look at next?


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Kenmore Dishwashers

We were hit by lighting and now my dishwasher top blinks from the minutes to an error code that look like a 118 but i don't see an error code in the book for that. It is a two drawer model


When lightning hits an appliance it hits toward least resistance, you need to replace the board in your dishwasher. ... Dishwashers

When i run the washer after 10 minutes it starts to leak oil the motor starts to labour and then gives up iof you ask it to wash it just hums if you leave for half an hour it goes again but then develops the same problem


... Karcher K2.26 Electric Power Washer

DW (top drawer) will not start.Green light comes on when pushed to start but after 1-2 minutes, DW starts beeping and start button light turns red.


Turn the mains power off and back on after a little delay. If no change, some sensor in the drawer is faulty - most likely the drawer close sensor as it is telling the controller the drawer is not closed. ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

My top dishdrawer stopped working half fill of water. I put it on rinse cycle and it drained the water. I found a bit of sand in the bottom of drawer. I wiped the sand out and then put onto a cycle. After a couple of minutes the dishwasher started flashing a tap symbol with a slash through it and stopped working. Any help please:) Jacki


... Fisher and Paykel 23 in. DD603H SS Free-standing Dishwasher

Bottom drawer drains into top drawer


I can offer a PERMANENT fix for this! That machine has never been installed properly since day 1 I would bet, and a series of techs have come thru unable to fix it right, or they keep selling you those "flappers" that fix the issue for a short period ... Fisher DD603B / DD603W / DD603H Dishwasher

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a F and P 603 dishwasher with a similar problem as to a recent post here. My top drawer doesn't turn on and my bottom drawer does. Well it just has after I swapped the "blue" motor inside from my top one. Now, I have tried and opened as far as the translucent "X" plastic from the bottom of my bottom drawer showing the motor and it looks fine. I have even swapped the control board from my top drawer to try and see if it works and it actually does. So, problem persists. Top drawer do


Alright, open up the outer panel of the machine. Note the positions of the wires on the switches and\015\012remove them, unclip the switch housing from the base panel. The\015\012switch housing contains one switch for each drawer. The switches are\01 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Lid on top drawer is in the down position and drawer will not ope


You have a bad pair of Lid actuator for the top Part 528112 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1003 seconds