Having problems with your Fisher and Paykel Dishwashers ?
What is an F1 error? - Fisher and Paykel Dishwashers
Flood switch error. There is water in the bottom of your machine. You will need to find the reson for the leak and if you have a drawer dishwasher you may also need the flood switch which is actually a pc board in the bottom rear.
Repair Help & Product Troubleshooting for Fisher and Paykel Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
My dishwasher's lid is stuck down and won't retract. I have a Fisher and Paykel DD605 dishwasher, and I think I must have placed some dishes in there that were too big for it and the lid got stuck. It's now showing an F7 error and refuses to do anything other than beep at me. I've tried turning the power off and back on, but it persists with the error. Is there a way to get it to reset and retract the lid? I've read that in situations like this, when people get repair technicians to com
The error code f7 stating that "the communication time out error"this are all the reason for the error1.the motor control micro has crashed and is not responding to communication request.2.the hardware communication link from ... Dishwashers
Fisher and Paykel Error code Ho - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
Error code. Fisher and Paykel Dishwasher
Well since you asked on the 5th July, and no reply, doesnt look like you may get one. I thought thats what this site was about?? ... Dishwashers
Fisher Paykel Dishwasher Door Open error code
If it is a dish drawer type there is a clip at the rear of the drawer that holds the drawer closed. you will need to withdraw the drawer partially to look in. with the drawer open the fingers should be facing towards you. If not you will need to reac ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
F4 error fisher & paykel nautilus dishwasher sometimes this error comes up and it seems to occur about 10 minutes from the end of the cycle. it doesn't happen all the time. the user guide does not specifically address this error code.
F4 is a heating error- dishwasher has not reached temperature in allocated time. If intermittent fault, problem is usually with electronic board, which has temperature sensor attached. Sometimes the wiring to the control board burns out and can give ... Fisher Dishwashers
Fisher & Paykel dishwasher drawer won't run, beeps F2 error code
Craig, we had virtually the same situation. The repair man came and it took 2 minutes to fix. The problem was that the bottom drawer had not been used for a couple of years and thus the impellor had jammed. to fix it take out ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
E4 error fisher and paykel dishwasher
There is a Y shape pipe under the sink's piping & it was blocked so I drilled & open a hole then the machine could has drained & worked. ... Fisher and Paykel Dishwashers
We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w
HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers
Our 2 drawer Fisher and Paykel dishwasher is automatically starting its own washing cycle (well, motor starts, but no water appears to be entering), then it shows F1 error message and a spanner icon flashes. Within 30 secs of this occurring on one drawer, this starts on the other drawer. Only way to stop is to switch off at power socket. Any idea what the error message is telling me?
... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
Error code 888 fisher & Paykel dishwasher - Dishwashers
We keep getting an E4 error on our Fisher and Paykel DW60CSX1 dishwasher. It is only new and initially worked fine, now the error indicates the drainage hose is too high, however it is where it says to locate it according to the diagram
... Fisher and Paykel Dishwashers
Dishwasher error have a fisher paykel ds603i, top draw is receiving an error, constantly beeping with red light showing, bottom drawer is running
The error was a flood fault, water was not draining from either of the drawere, I removed the bottom drawer, dried drip pan and used hairdryer to dry fault sensor, the dishwasher then reset itself and works fine. ... Fisher DS603W / DS603B / DS603I Dishwasher
F1 error code on both dishwasher drawers. - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
Unit is in flood protection mode (caused by leak), can be cleared by removing bottom draw and drying the residual water around and under the Rfi/flood sensor board. This problem is usually caused by iether the support that suspends the wiring and hos ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
My fisher and paykel dishwasher drawers is giving me an F1 error code, won't stop running and is acting like it's possessed.
... Fisher Dishwashers
F1 Error code on fisher paykel softouch dishwasher
F1 means that water is in your basepan--- you can pull the bottom\015\012drawer out and soak up the water with a towel... you will have to use a\015\012hair dryer to dry underneath the control sensor in the back left corner. ... Fisher Dishwashers
U2 Error Fisher Paykel dd-602 dishwasher
Hi there, Error U2 -Possible Causes - LoadingCheck loading to ensure no items extendbeyond the height of the drawer.Good Luck!neo ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher
My fisher and paykel dishwash has and error F1
Since you did not provide the specific model, I checked a few different models at the FisherPaykel website and F1 appears to mean your flood switch has been activated and to shut off power and call a repair man.. Please provide specific model numbe ... Dishwashers
Fisher & Paykel dishwasher model dd602 error code F4
Hi there,\012It means your filter is dirty. Remove metal plate at bottom & scrub with a toothbrush. Clean arms as well.Clean all around the door & pull out the lift out filter, scrub clean with a toothbrush. ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher
We are now getting a U1 error code on a Fisher and Paykel Nautilus dishwasher which was in the house we purchased 3 years ago and has functioned perfectly until now. There was no manual left when we took over the house. We would appreciate any help you can provide.
U1 means the unit has failed to prime with water within 3-4 minutes. \015\012Its taking longer than expected to fill with water. \015\012Check the fill valve, water supply problem, excessive sudzing.,reduce your detergent. ... Fisher and Paykel Dishwashers
U3 error code - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
Error code U3 could mean the drain pump could be blocked.Remove the trays and the impeller arm. Empty the water with small container or towel. Open the filter plate and drain filter. Get the motor out and check the cavity for any rubbish ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
Bottom draw displaying U1 error message - Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
There is no water coming to the drawer.\015\012\015\012This could be due to several reasons. The tap must be on as I presume the top drawer is working.\015\012\015\012Could be one or more issues like Inlet solenoid,controller ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
Whar does f1 error mean - Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
The flood switch at the base of the dishwasher cabinet has activated. This occurs if moisture has leaked into the base of the dishwasher.\015\012There are several posts on the fixya.com site on causes and solutions.\015\012\015\012I ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher
Error 'u1' on fisher paykel dishwasher
Water Inlet Valve! ... Dishwashers
Hi My Fisher and Paykel Soft Touch dishwasher on a daily basis shows the error code F5 and beeps until I pull it out from the wall and turn it off and on again. How can I fix this?
There is no f5 fault in any of the soft touch f7p dishwashers, sure its not something else whats the model no , i fix f&p for a living ... Dishwashers
F4 error - Fisher and Paykel 24 in. DD-602 Built-in Dishwasher
It means your filter is dirty. Remove metal plate at bottom & scrub with a toothbrush. Clean arms as well.Clean all around the door & pull out the lift out filter, scrub clean with a toothbrush.good luck ... Fisher and Paykel 24 in. DD-602 Built-in Dishwasher